Translation of EEG spatial filters from resting to motor imagery using independent component analysis.

Electroencephalogram (EEG)-based brain-computer interfaces (BCIs) often use spatial filters to improve signal-to-noise ratio of task-related EEG activities. To obtain robust spatial filters, large amounts of labeled data, which are often expensive and labor-intensive to obtain, need to be collected in a training procedure before online BCI control. Several studies have recently developed zero-training methods using a session-to-session scenario in order to alleviate this problem. To our knowledge, a state-to-state translation, which applies spatial filters derived from one state to another, has never been reported. This study proposes a state-to-state, zero-training method to construct spatial filters for extracting EEG changes induced by motor imagery. Independent component analysis (ICA) was separately applied to the multi-channel EEG in the resting and the motor imagery states to obtain motor-related spatial filters. The resultant spatial filters were then applied to single-trial EEG to differentiate left- and right-hand imagery movements. On a motor imagery dataset collected from nine subjects, comparable classification accuracies were obtained by using ICA-based spatial filters derived from the two states (motor imagery: 87.0%, resting: 85.9%), which were both significantly higher than the accuracy achieved by using monopolar scalp EEG data (80.4%). The proposed method considerably increases the practicality of BCI systems in real-world environments because it is less sensitive to electrode misalignment across different sessions or days and does not require annotated pilot data to derive spatial filters

Oscillatory Source Tensor Discriminant Analysis (OSTDA): A regularized tensor pipeline for SSVEP-based BCI systems

Periodic signals called Steady-State Visual Evoked Potentials (SSVEP) are elicited in the brain by flickering stimuli. They are usually detected by means of regression techniques that need relatively long trial lengths to provide feedback and/or sufficient number of calibration trials to be reliably estimated in the context of brain-computer interface (BCI). Thus, for BCI systems designed to operate with SSVEP signals, reliability is achieved at the expense of speed or extra recording time. Furthermore, regardless of the trial length, calibration free regression-based methods have been shown to suffer from significant performance drops when cognitive perturbations are present affecting the attention to the flickering stimuli. In this study we present a novel technique called Oscillatory Source Tensor Discriminant Analysis (OSTDA) that extracts oscillatory sources and classifies them using the newly developed tensor-based discriminant analysis with shrinkage. The proposed approach is robust for small sample size settings where only a few calibration trials are available. Besides, it works well with both low- and high-number-of-channel settings, using trials as short as one second. OSTDA performs similarly or significantly better than other three benchmarked state-of-the-art techniques under different experimental settings, including those with cognitive disturbances (i.e. four datasets with control, listening, speaking and thinking conditions). Overall, in this paper we show that OSTDA is the only pipeline among all the studied ones that can achieve optimal results in all analyzed conditions

BCI controlled robotic arm as assistance to the rehabilitation of neurologically disabled patients

Purpose: Brain–computer interface (BCI)-controlled assistive robotic systems have been developed with increasing success with the aim to rehabilitation of patients after brain injury to increase independence and quality of life. While such systems may use surgically implanted invasive sensors, non-invasive alternatives can be better suited due to the ease of use, reduced cost, improvements in accuracy and reliability with the advancement of the technology and practicality of use. The consumer-grade BCI devices are often capable of integrating multiple types of signals, including Electroencephalogram (EEG) and Electromyogram (EMG) signals. Materials and Methods: This paper summarizes the development of a portable and cost-efficient BCI-controlled assistive technology using a non-invasive BCI headset “OpenBCI” and an open source robotic arm, U-Arm, to accomplish tasks related to rehabilitation, such as access to resources, adaptability or home use. The resulting system used a combination of EEG and EMG sensor readings to control the arm. To avoid risks of injury while the device is being used in clinical settings, appropriate measures were incorporated into the software control of the arm. A short survey was used following the system usability scale (SUS), to measure the usability of the technology to be trialed in clinical settings. Results: From the experimental results, it was found that EMG is a very reliable method for assistive technology control, provided that the user specific EMG calibration is done. With the EEG, even though the results were promising, due to insufficient detection of the signal, the controller was not adequate to be used within a neurorehabilitation environment. The survey indicated that the usability of the system is not a barrier for moving the system into clinical trials. Implication on rehabilitation For the rehabilitation of patients suffering from neurological disabilities (particularly those suffering from varying degrees of paralysis), it is necessary to develop technology that bypasses the limitations of their condition. For example, if a patient is unable to walk due to the unresponsiveness in their motor neurons, technology can be developed that used an alternate input to move an exoskeleton, which enables the patient to walk again with the assistance of the exoskeleton. This research focuses on neuro-rehabilitation within the framework of the NHS at the Kent and Canterbury Hospital in UK. The hospital currently does not have any system in place for self-driven rehabilitation and instead relies on traditional rehabilitation methods through assistance from physicians and exercise regimens to maintain muscle movement. This paper summarises the development of a portable and cost-efficient BCI controlled assistive technology using a non-invasive BCI headset “OpenBCI” and an open source robotic arm, U-Arm, to accomplish tasks related to rehabilitation, such as access to resources, adaptability or home use. The resulting system used a combination of EEG and EMG sensor readings to control the arm, which could perform a number of different tasks such as picking/placing objects or assist users in eating

Adaptive Filtering Techniques for the Detection of User - Independent Single Trial ERPs in Brain Computer Interfaces

El trabajo desarrollado es una presentación de los sistemas Brain Computer Interface (BCI) e involucra el entendimiento tanto de su funcionamiento como de las señales cerebrales en las que este está basado. Para este proyecto, cada una de las partes que forman uno de los tipos de sistema BCI más ampliamente usado serán desarrolladas. Se estudiarán diversas técnicas de procesado de señal para ser aplicadas en varias partes del sistema. Además, una interfaz adecuada será creada para validar los métodos implementados y evaluar el rendimiento del sistema. El resultado final del trabajo será un sistema BCI completo

Influencing brain waves by evoked potentials as biometric approach: taking stock of the last six years of research

The scientific advances of recent years have made available to anyone affordable hardware devices capable of doing something unthinkable until a few years ago, the reading of brain waves. It means that through small wearable devices it is possible to perform an electroencephalography (EEG), albeit with less potential than those offered by high-cost professional devices. Such devices make it possible for researchers a huge number of experiments that were once impossible in many areas due to the high costs of the necessary hardware. Many studies in the literature explore the use of EEG data as a biometric approach for people identification, but, unfortunately, it presents problems mainly related to the difficulty of extracting unique and stable patterns from users, despite the adoption of sophisticated techniques. An approach to face this problem is based on the evoked potentials (EPs), external stimuli applied during the EEG reading, a noninvasive technique used for many years in clinical routine, in combination with other diagnostic tests, to evaluate the electrical activity related to some areas of the brain and spinal cord to diagnose neurological disorders. In consideration of the growing number of works in the literature that combine the EEG and EP approaches for biometric purposes, this work aims to evaluate the practical feasibility of such approaches as reliable biometric instruments for user identification by surveying the state of the art of the last 6 years, also providing an overview of the elements and concepts related to this research area