Advanced digital modulation: Communication techniques and monolithic GaAs technology

Communications theory and practice are merged with state-of-the-art technology in IC fabrication, especially monolithic GaAs technology, to examine the general feasibility of a number of advanced technology digital transmission systems. Satellite-channel models with (1) superior throughput, perhaps 2 Gbps; (2) attractive weight and cost; and (3) high RF power and spectrum efficiency are discussed. Transmission techniques possessing reasonably simple architectures capable of monolithic fabrication at high speeds were surveyed. This included a review of amplitude/phase shift keying (APSK) techniques and the continuous-phase-modulation (CPM) methods, of which MSK represents the simplest case

Trellis phase codes for power-bandwith efficient satellite communications

Support work on improved power and spectrum utilization on digital satellite channels was performed. Specific attention is given to the class of signalling schemes known as continuous phase modulation (CPM). The specific work described in this report addresses: analytical bounds on error probability for multi-h phase codes, power and bandwidth characterization of 4-ary multi-h codes, and initial results of channel simulation to assess the impact of band limiting filters and nonlinear amplifiers on CPM performance

Capacity -based parameter optimization of bandwidth constrained CPM

Continuous phase modulation (CPM) is an attractive modulation choice for bandwidth limited systems due to its small side lobes, fast spectral decay and the ability to be noncoherently detected. Furthermore, the constant envelope property of CPM permits highly power efficient amplification. The design of bit-interleaved coded continuous phase modulation is characterized by the code rate, modulation order, modulation index, and pulse shape. This dissertation outlines a methodology for determining the optimal values of these parameters under bandwidth and receiver complexity constraints. The cost function used to drive the optimization is the information-theoretic minimum ratio of energy-per-bit to noise-spectral density found by evaluating the constrained channel capacity. The capacity can be reliably estimated using Monte Carlo integration. A search for optimal parameters is conducted over a range of coded CPM parameters, bandwidth efficiencies, and channels. Results are presented for a system employing a trellis-based coherent detector. To constrain complexity and allow any modulation index to be considered, a soft output differential phase detector has also been developed.;Building upon the capacity results, extrinsic information transfer (EXIT) charts are used to analyze a system that iterates between demodulation and decoding. Convergence thresholds are determined for the iterative system for different outer convolutional codes, alphabet sizes, modulation indices and constellation mappings. These are used to identify the code and modulation parameters with the best energy efficiency at different spectral efficiencies for the AWGN channel. Finally, bit error rate curves are presented to corroborate the capacity and EXIT chart designs

Simulator for the Performance Analysis of CPM Schemes in an Indoor Wireless Environment

A software simulator for characterising Continuous Phase Modulation (CPM) schemes in an indoor multipath environment has been developed using SIMULINK and MATLAB. The simulator is capable of simulating a wide range of CPM schemes to determine bandwidth efficiency and robustness to additive white Gaussian noise (AWGN) and Rician fading. Initial trials of the simulator indicate that the simulator is functioning correctly. Eventually, the simulator will be used to determine the most suitable modulation scheme for the development of an actual indoor wireless system

NUTS: Ground station with GNU Radio and USRP

Study and describe GNU Radio together with USRP as alternative ground station. Describe and analyze GMSK signal. NGHam link protcol implementation. Simulation on demodulation considering how frequency synchronization can be achieved. Discuss if and how GNU Radio suits the uneversity satellite project

Direct GMSK modulation at microwave frequencies

Congestion in the radio spectrum is forcing emerging high rate wireless communication systems into upper microwave and millimeterwave frequency bands, where transceiver hardware architectures are less mature. One way to realize a simple and elegant hardware solution for a microwave transmitter is to exploit the advantages of directly modulating the phase of the carrier signal. A modulation method requiring continuous phase control of the carrier signal over the full 360 degree range is Gaussian Minimum Shift Keying (GMSK). Unfortunately, it is very difficult to design a microwave circuit to provide linear phase control of a carrier signal over the full 360 degree range using traditional methods. A novel method of obtaining continuous, linear phase modulation of a microwave carrier signal over the full 360 degree range is proposed. This method is based on controlling a phase shifter, at a subharmonic of the desired output carrier frequency, and then using a frequency multiplier to obtain the desired output frequency. The phase shifter is designed to be highly linear over a fraction of the full 360 range. The frequency multiplier is a nonlinear circuit that shifts the frequency by *'N'. The subtle part of this nonlinear operation is that the multiplier also multiplies the instantaneous phase of the phase shifter output signal by *'N', thus expanding the linear phase shift range to the required 360 degrees. Using this nonlinear frequency multiplication principle, the modulator can readily be extended into the millimeterwave region. A prototype circuit is designed and performance results are presented for this method of carrier phase modulation at 18 GHz. The prototype circuit is realized with very simple hardware, containing only a single microwave active device. An extension to the modulator involving phase locking or injection locking of a power oscillator is also suggested for obtaining higher power modulated output signals. In addition to direct continuous phase modulation, the proposed method is also suitable for a wide variety of transceiver applications, including phase synchronization of antenna and oscillator arrays, phased array antenna beam steering, indirect frequency modulation, and ultra-small carrier frequency translation

Modulation/demodulation techniques for satellite communications. Part 2: Advanced techniques. The linear channel

A theory is presented for deducing and predicting the performance of transmitter/receivers for bandwidth efficient modulations suitable for use on the linear satellite channel. The underlying principle used is the development of receiver structures based on the maximum-likelihood decision rule. The application of the performance prediction tools, e.g., channel cutoff rate and bit error probability transfer function bounds to these modulation/demodulation techniques

Automatic modulation classification of communication signals

The automatic modulation recognition (AMR) plays an important role in various civilian and military applications. Most of the existing AMR algorithms assume that the input signal is only of analog modulation or is only of digital modulation. In blind environments, however, it is impossible to know in advance if the received communication signal is analogue modulated or digitally modulated. Furthermore, it is noted that the applications of the currently existing AMR algorithms designed for handling both analog and digital communication signals are rather restricted in practice. Motivated by this, an AMR algorithm that is able to discriminate between analog communication signals and digital communication signals is developed in this dissertation. The proposed algorithm is able to recognize the concrete modulation type if the input is an analog communication signal and to estimate the number of modulation levels and the frequency deviation if the input is an exponentially modulated digital communication signal. For linearly modulated digital communication signals, the proposed classifier will classify them into one of several nonoverlapping sets of modulation types. In addition, in M-ary FSK (MFSK) signal classification, two classifiers have also been developed. These two classifiers are also capable of providing good estimate of the frequency deviation of a received MFSK signal. For further classification of linearly modulated digital communication signals, it is often necessary to blindly equalize the received signal before performing modulation recognition. This doing generally requires knowing the carrier frequency and symbol rate of the input signal. For this purpose, a blind carrier frequency estimation algorithm and a blind symbol rate estimation algorithm have been developed. The carrier frequency estimator is based on the phases of the autocorrelation functions of the received signal. Unlike the cyclic correlation based estimators, it does not require the transmitted symbols being non-circularly distributed. The symbol rate estimator is based on digital communication signals\u27 cyclostationarity related to the symbol rate. In order to adapt to the unknown symbol rate as well as the unknown excess bandwidth, the received signal is first filtered by using a bank of filters. Symbol rate candidates and their associated confident measurements are extracted from the fourth order cyclic moments of the filtered outputs, and the final estimate of symbol rate is made based on weighted majority voting. A thorough evaluation of some well-known feature based AMR algorithms is also presented in this dissertation

Efficient Importance sampling Simulations for Digital Communication Systems

Importance sampling is a- modified. Monte Carlo simulation technique which can dramatically reduce the computational cost of the Monte Carlo method. A complete development is presented for its use in the estimation of bit error rates /V for digital communication systems with small Gaussian noise inputs. Emphasis is on the optimal mean-translation Gaussian simulation density function design and the event simulation method as applied to systems which employ quasi-regular trellis codes. These codes include the convolutional codes and many TCM (Ungerboeck) codes. Euclidean distance information of a code is utilized to facilitate the simulation. Also, the conditional importance sampling technique is presented which can handle many non-Gaussian system inputs. Theories as well as numerical examples are given. In particular, we study the simulations of an uncoded MSK and a trellis-coded 8- PSK transmissions over a general bandlimited nonlinear satellite channel model. Our algorithms are shown to be very efficient at low Pb compared to the ordinary Monte Carlo method. Many techniques we have developed are applicable to other system simulations as building blocks for their particular system configurations and channels