Iterative turbo beamforming for OFDM based hybrid terrestrial-satellite mobile system

In the context of orthogonal frequency division multiplexing (OFDM)-based systems, pilot-based beamforming (BF) exhibits a high degree of sensitivity to the pilot sub-carriers. Increasing the number of reference pilots significantly improves BF performance as well as system performance. However, this increase comes at the cost of data throughput, which inevitably shrinks due to transmission of additional pilots. Hence an approach where reference signals available to the BF process can be increased without transmitting additional pilots can exhibit superior system performance without compromising throughput. Thus, the authors present a novel three-stage iterative turbo beamforming (ITBF) algorithm for an OFDM-based hybrid terrestrial-satellite mobile system, which utilises both pilots and data to perform interference mitigation. Data sub-carriers are utilised as virtual reference signals in the BF process. Results show that when compared to non-iterative conventional BF, the proposed ITBF exhibits bit error rate gain of up to 2.5 dB with only one iteration

IST-2000-30148 I-METRA: D3.2 Implementation of relevant algorithms

This deliverable provides a high level description of the software developed within the I-METRA project following the selection reported in D3.1 "Design, Analysis and Selection of Suitable Algorithms".Preprin

Systèmes MIMO : conception, estimation du canal, et détection

The aim of this thesis is to investigate multiple input multiple output (MIMO) techniques from the reception algorithms, i.e., channel estimation, symbol detection, and interference suppression, to the advanced spatial modulation (SM) transmission schemes, i.e., the signal constellation design for high performance and energy efficiency. In the reception algorithms, the proposed schemes are derived based on the detection theory, i.e., maximum likelihood (ML), linear minimum mean square error (MMSE), successive interference cancellation (SIC), combining with the statistical analysis, i.e., Bayesian linear regression and Bayesian model comparison, in order to deal with the channel uncertainty, i.e., fading, correlations, thermal noise, multiple interference, and the impact of estimation errors.In the transmission schemes, the signal constellations are targeted to find a good trade off between the average transmit energy and the minimum Euclidean distance in the signal space. The proposed schemes, denoted by enhanced SM (ESM), introduce novel modulation/antenna combinations and use them as the information bits for transmission. The number of those combinations is the double or the quadruple of the number of active antenna indices (or index combinations) in conventional SM systems, and this increases the number of bits transmitted per channel use by one or two.The results of simulations show that good system performance can be achieved with the advanced MIMO techniques. Several examples are presented in this thesis to provide insights for the MIMO system designs.Cette thèse aborde plusieurs problèmes fondamentaux des systèmes de communications sans fil avec des antennes multiples, dites systèmes MIMO (multiple input, multiple output). Les contributions se situent aussi bien au niveau des algorithmes de réception qu’au niveau de la génération du signal à l’émission.La plus grande partie de la thèse est dédiée à l’étude des algorithmes de réception. Les points abordés comprennent la modélisation et l’estimation du canal, la détection robuste des symboles, et la suppression des interférences. Un nouveau modèle de canal est proposé dans le chapitre 3 en exploitant les corrélations dans les domaines temporel, fréquentiel et spatial, et en réduisant l’espace des paramètres aux termes dominants. Ce modèle est utilisé pour proposer ensuite un estimateur de canal à faible complexité et aussi un sélecteur de mots de code pour envoyer vers l’émetteur les informations sur l’état du canal. Dans le chapitre 4, la réception robuste est étudiée pour les systèmes MIMO-OFDM sans une connaissance parfaite du canal. Des récepteurs robustes sont proposés pour les cas avec ou sans connaissance statistique du canal. La conception de récepteurs pour les systèmes MIMO-OFDM en présence d’interférence est étudiée dans le chapitre 5 et des récepteurs robustes sont proposés prenant en compte séparément l’interférence causée par les ondes pilotes et celle causée par les symboles d’une part et l’asynchronisme entre le signal et l’interférence d’autre part.Dans la deuxième partie de la thèse (chapitre 6), nous abordons les modulations spatiales qui sont particulièrement adaptées aux systèmes MIMO dans lesquels le nombre de chaines d’émission est inférieur aux nombre d’antennes. Remarquant que l’efficacité spectrale de ces systèmes reste très faible par rapport à la technique de multiplexage spatiale, nous avons développé des modulations spatiales améliorées (ESM, pour Enhanced Spatial Modulation) qui augmentent substantiellement l’efficacité spectrale. Ces modulations sont basées sur l’introduction de modulations secondaires, obtenues par interpolation. La technique ESM gagne plusieurs décibels en rapport signal à bruit lorsque les constellations du signal sont choisies de façon à avoir la même efficacité spectrale que dans les modulations spatiales conventionnelles

Performance enhancement for LTE and beyond systems

A thesis submitted to the University of Bedfordshire, in partial fulfilment of the requirements for the degree of Doctor of PhilosophyWireless communication systems have undergone fast development in recent years. Based on GSM/EDGE and UMTS/HSPA, the 3rd Generation Partnership Project (3GPP) specified the Long Term Evolution (LTE) standard to cope with rapidly increasing demands, including capacity, coverage, and data rate. To achieve this goal, several key techniques have been adopted by LTE, such as Multiple-Input and Multiple-Output (MIMO), Orthogonal Frequency-Division Multiplexing (OFDM), and heterogeneous network (HetNet). However, there are some inherent drawbacks regarding these techniques. Direct conversion architecture is adopted to provide a simple, low cost transmitter solution. The problem of I/Q imbalance arises due to the imperfection of circuit components; the orthogonality of OFDM is vulnerable to carrier frequency offset (CFO) and sampling frequency offset (SFO). The doubly selective channel can also severely deteriorate the receiver performance. In addition, the deployment of Heterogeneous Network (HetNet), which permits the co-existence of macro and pico cells, incurs inter-cell interference for cell edge users. The impact of these factors then results in significant degradation in relation to system performance. This dissertation aims to investigate the key techniques which can be used to mitigate the above problems. First, I/Q imbalance for the wideband transmitter is studied and a self-IQ-demodulation based compensation scheme for frequencydependent (FD) I/Q imbalance is proposed. This combats the FD I/Q imbalance by using the internal diode of the transmitter and a specially designed test signal without any external calibration instruments or internal low-IF feedback path. The instrument test results show that the proposed scheme can enhance signal quality by 10 dB in terms of image rejection ratio (IRR). In addition to the I/Q imbalance, the system suffers from CFO, SFO and frequency-time selective channel. To mitigate this, a hybrid optimum OFDM receiver with decision feedback equalizer (DFE) to cope with the CFO, SFO and doubly selective channel. The algorithm firstly estimates the CFO and channel frequency response (CFR) in the coarse estimation, with the help of hybrid classical timing and frequency synchronization algorithms. Afterwards, a pilot-aided polynomial interpolation channel estimation, combined with a low complexity DFE scheme, based on minimum mean squared error (MMSE) criteria, is developed to alleviate the impact of the residual SFO, CFO, and Doppler effect. A subspace-based signal-to-noise ratio (SNR) estimation algorithm is proposed to estimate the SNR in the doubly selective channel. This provides prior knowledge for MMSE-DFE and automatic modulation and coding (AMC). Simulation results show that this proposed estimation algorithm significantly improves the system performance. In order to speed up algorithm verification process, an FPGA based co-simulation is developed. Inter-cell interference caused by the co-existence of macro and pico cells has a big impact on system performance. Although an almost blank subframe (ABS) is proposed to mitigate this problem, the residual control signal in the ABS still inevitably causes interference. Hence, a cell-specific reference signal (CRS) interference cancellation algorithm, utilizing the information in the ABS, is proposed. First, the timing and carrier frequency offset of the interference signal is compensated by utilizing the cross-correlation properties of the synchronization signal. Afterwards, the reference signal is generated locally and channel response is estimated by making use of channel statistics. Then, the interference signal is reconstructed based on the previous estimate of the channel, timing and carrier frequency offset. The interference is mitigated by subtracting the estimation of the interference signal and LLR puncturing. The block error rate (BLER) performance of the signal is notably improved by this algorithm, according to the simulation results of different channel scenarios. The proposed techniques provide low cost, low complexity solutions for LTE and beyond systems. The simulation and measurements show good overall system performance can be achieved

Multi-user spatial diversity techniques for wireless communication systems

Multiple antennas at the transmitter and receiver, formally known as multiple-input multiple-output (MIMO) systems have the potential to either increase the data rates through spatial multiplexing or enhance the quality of services through exploitation of diversity. In this thesis, the problem of downlink spatial multiplexing, where a base station (BS) serves multiple users simultaneously in the same frequency band is addressed. Spatial multiplexing techniques have the potential to make huge saving in the bandwidth utilization. We propose spatial diversity techniques with and without the assumption of perfect channel state information (CSI) at the transmitter. We start with proposing improvement to signal-to-leakage ratio (SLR) maximization based spatial multiplexing techniques for both fiat fading and frequency selective channels. [Continues.

Characterisation of MIMO radio propagation channels

Due to the incessant requirement for higher performance radio systems, wireless designers have been constantly seeking ways to improve spectrum efficiency, link reliability, service quality, and radio network coverage. During the past few years, space-time technology which employs multiple antennas along with suitable signalling schemes and receiver architectures has been seen as a powerful tool for the implementation of the aforementioned requirements. In particular, the concept of communications via Multiple-Input Multiple-Output (MIMO) links has emerged as one of the major contending ideas for next generation ad-hoc and cellular systems. This is inherently due to the capacities expected when multiple antennas are employed at both ends of the radio link. Such a mobile radio propagation channel constitutes a MIMO system. Multiple antenna technologies and in particular MIMO signalling are envisaged for a number of standards such as the next generation of Wireless Local Area Network (WLAN) technology known as 802.1 ln and the development of the Worldwide Interoperability for Microwave Access (WiMAX) project, such as the 802.16e. For the efficient design, performance evaluation and deployment of such multiple antenna (space-time) systems, it becomes increasingly important to understand the characteristics of the spatial radio channel. This criterion has led to the development of new sounding systems, which can measure both spatial and temporal channel information. In this thesis, a novel semi-sequential wideband MIMO sounder is presented, which is suitable for high-resolution radio channel measurements. The sounder produces a frequency modulated continuous wave (FMCW) or chirp signal with variable bandwidth, centre frequency and waveform repetition rate. It has programmable bandwidth up to 300 MHz and waveform repetition rates up to 300 Hz, and could be used to measure conventional high- resolution delay/Doppler information as well as spatial channel information such as Direction of Arrival (DOA) and Direction of Departure (DOD). Notably the knowledge of the angular information at the link ends could be used to properly design and develop systems such as smart antennas. This thesis examines the theory of multiple antenna propagation channels, the sounding architecture required for the measurement of such spatial channel information and the signal processing which is used to quantify and analyse such measurement data. Over 700 measurement files were collected corresponding to over 175,000 impulse responses with different sounder and antenna array configurations. These included measurements in the Universal Mobile Telecommunication Systems Frequency Division Duplex (UMTS-FDD) uplink band, the 2.25 GHz and 5.8 GHz bands allocated for studio broadcast MIMO video links, and the 2.4 GHz and 5.8 GHz ISM bands allocated for Wireless Local Area Network (WLAN) activity as well as for a wide range of future systems defined in the WiMAX project. The measurements were collected predominantly for indoor and some outdoor multiple antenna channels using sounding signals with 60 MHz, 96 MHz and 240 MHz bandwidth. A wide range of different MIMO antenna array configurations are examined in this thesis with varying space, time and frequency resolutions. Measurements can be generally subdivided into three main categories, namely measurements at different locations in the environment (static), measurements while moving at regular intervals step by step (spatial), and measurements while the receiver (or transmitter) is on the move (dynamic). High-scattering as well as time-varying MIMO channels are examined for different antenna array structures

Characteristics of chicken slaughterhouse wastewater

The chicken slaughterhouse wastewater is a class of wastewater, which is heavily polluted with organic matters including proteins, blood residues, fats and lard. Therefore, the direct discharged of untreated chicken slaughterhouse wastewater into the environment is associated with the occurrence of eutrophication phenomenon. In the present study, the characteristics of chicken slaughterhouse wastewater were investigated to ascertain the role of these wastes in the adverse effect on the environment and natural water system. The parameter tested included biological oxygen demand (BOD), chemical oxygen demand (COD), total suspended solid (TSS), total nitrogen (TN), total organic carbon (TOC), orthophosphate (PO4 3-), temperature and pH. The results revealed available high concentrations of BOD (1,341 - 1,821 ± 242.7 mg L1 ), COD (3,154.19 - 7,719.3 ± 2,282.69 mg L-1), TSS (377.67 - 5,462 ± 2,696.1 mg L-1) which have exceeded the EQA1974 standard limits for disposal of wastewater into the environment. The concentrations of TN (162.6 -563.8 ± 215 mg L-1) and PO4 3- (7.047 - 17.111 ± 4.25 mg L-1) were within the range required for microalgae growth which confirm their role in the occurrence of eutrophication phenomenon. It can be concluded that the direct discharge of chicken slaughterhouse wastewater contributes negatively on the environmental biodiversity and thus they should be subjected for an effective treated before the final disposal