43 research outputs found

    Design and Evaluation of the Efficiency of Channel Coding LDPC Codes for 5G Information Technology

    Get PDF
    This paper proposes a result of an investigation of a topical problem and the development of models for efficient coding in information networks based on codes with a low density of parity check. The main advantage of the technique is the presented recommendations for choosing a signal-code construction is carried out taking into account the code rate and the number of iterations decoding for envisaging the defined noise immunity indices. The noise immunity of signal-code constructions based on low-density codes has been increased by combining them with multi position digital modulation. This solution eventually allowed to develop a strategy for decoder designing of such codes and to optimize the code structure for a specific information network. To test the effectiveness of the proposed method, MATLAB simulations are carried out under for various Information channels binary symmetric channel (BSC), a channel with additive white Gaussian noise (AWGN), binary asymmetric channel (BAC), asymmetric channel Z type. In addition, different code rates were used during the experiment. The study of signal-code constructions with differential modulation is presented. The efficiency of different decoding algorithms is investigated. The advantage of the obtained results over the known ones consists in determining the maximum noise immunity for the proposed codes. The energy gain was on the order of 6 dB, and an increase in the number of decoding iterations from 3 to 10 leads to a gain in coding energy of 5 dB. Envisaged that the results obtained can be very useful in the development of practical coding schemes in 5G networks

    A protection scheme for multimedia packet streams in bursty packet loss networks based on small block low-density parity-check codes

    Get PDF
    This paper proposes an enhanced forward error correction (FEC) scheme based on small block low-density parity-check (LDPC) codes to protect real-time packetized multimedia streams in bursty channels. The use of LDPC codes is typically addressed for channels where losses are uniformly distributed (memoryless channels) and for large information blocks. This work suggests the use of this type of FEC codes at the application layer, in bursty channels (e.g., Internet protocol (IP)-based networks) and for real-time scenarios that require low transmission latency. To fulfil these constraints, the appropriate configuration parameters of an LDPC scheme have been determined using small blocks of information and adapting the FEC code to be capable of recovering packet losses in bursty environments. This purpose is achieved in two steps. The first step is performed by an algorithm that estimates the recovery capability of a given LDPC code in a burst packet loss network. The second step is the optimization of the code: an algorithm optimizes the parity matrix structure in terms of recovery capability against the specific behavior of the channel with memory. Experimental results have been obtained in a simulated transmission channel to show that the optimized LDPC matrices generate a more robust protection scheme against bursty packet losses for small information blocks

    Cross-layer hybrid automatic repeat request error control with turbo processing for wireless system

    Get PDF
    The increasing demand for wireless communication system requires an efficient design in wireless communication system. One of the main challenges is to design error control mechanism in noisy wireless channel. Forward Error Correction (FEC) and Automatic Repeat reQuest (ARQ) are two main error control mechanisms. Hybrid ARQ allows the use of either FEC or ARQ when required. The issues with existing Hybrid ARQ are reliability, complexity and inefficient design. Therefore, the design of Hybrid ARQ needs to be further improved in order to achieve performance close to the Shannon capacity. The objective of this research is to develop a Cross-Layer Design Hybrid ARQ defined as CLD_ARQ to further minimize error in wireless communication system. CLD_ARQ comprises of three main stages. First, a low complexity FEC defined as IRC_FEC for error detection and correction has been developed by using Irregular Repetition Code (IRC) with Turbo processing. The second stage is the enhancement of IRC_FEC defined as EM_IRC_FEC to improve the reliability of error detection by adopting extended mapping. The last stage is the development of efficient CLD_ARQ to include retransmission for error correction that exploits EM_IRC_FEC and ARQ. In the proposed design, serial iterative decoding and parallel iterative decoding are deployed in the error detection and correction. The performance of the CLD_ARQ is evaluated in the Additive White Gaussian Noise (AWGN) channel using EXtrinsic Information Transfer (EXIT) chart, bit error rate (BER) and throughput analysis. The results show significant Signal-to-Noise Ratio (SNR) gain from the theoretical limit at BER of 10-5. IRC_FEC outperforms Recursive Systematic Convolutional Code (RSCC) by SNR gain up to 7% due to the use of IRC as a simple channel coding code. The usage of CLD_ARQ enhances the SNR gain by 53% compared to without ARQ due to feedback for retransmission. The adoption of extended mapping in the CLD_ARQ improves the SNR gain up to 50% due to error detection enhancement. In general, the proposed CLD_ARQ can achieve low BER and close to the Shannon‘s capacity even in worse channel condition

    Error-Correction Coding and Decoding: Bounds, Codes, Decoders, Analysis and Applications

    Get PDF
    Coding; Communications; Engineering; Networks; Information Theory; Algorithm

    On the Average Rate of HARQ-Based Quasi-Static Spectrum Sharing Networks

    Get PDF
    Spectrum sharing networks are communication setups in which unlicensed secondary users are permitted to work within the spectrum resources of primary licensees. Considering quasi-static fading environments, this paper studies the effect of hybrid automatic repeat request (HARQ) feedback on the average rate of unlicensed spectrum sharing channels. The results are obtained for different scenarios; Under both peak and average secondary user transmission power constraints, the channel average rate is determined under primary user limited received interference power conditions when there is perfect information about the interference available at the secondary user transmitter. An approximate solution for power allocation between incremental redundancy (INR) HARQ-based data retransmissions is proposed which can be applied in single-user networks as well. Then, we investigate the effect of imperfect secondary-primary channel state information on the interference-limited average rate of the secondary channel. Finally, we restudy all mentioned scenarios in the case where the data transmission is constrained to have limited outage probability. Substantial performance improvement is observed with even a single HARQ-based retransmission in all simulations

    Cross-Layer design and analysis of cooperative wireless networks relying on efficient coding techniques

    Get PDF
    2011/2012This thesis work aims at analysing the performance of efficient cooperative techniques and of smart antenna aided solutions in the context of wireless networks. Particularly, original contributions include a performance analysis of distributed coding techniques for the physical layer of communication systems, the design of practical efficient coding schemes that approach the analytic limiting bound, the cross-layer design of cooperative medium access control systems that incorporate and benefit from advanced physical layer techniques, the study of the performance of such solutions under realistic network assumptions, and, finally the design of access protocols where nodes are equipped with smart antenna systems.XXV Ciclo198

    Evaluation of 3GPP Technology Candidate Towards Fourth Generation Mobile

    Full text link
    [ES] LTE-Advanced es una de las tecnologías candidatas para convertirse en la próxima generación de comunicaciones móviles (4G). Es responsabilidad de la Unión Internacional de las Telecomunicaciones (UIT) evaluar esta tecnología a través de los Grupos de Evaluación Externos (GEE), entre los cuales se encuentra el consorcio WINNER+ (Wireless World Initiative New Radio +). El Grupo de Comunicaciones Móviles (GCM) del Instituto de Telecomunicaciones y Aplicaciones Multimedia, como socio de WINNER+, está analizando diferentes técnicas para optimizar la red de acceso radio LTEAdvanced. Esta tesina de máster se enmarca dentro de este trabajo, y especialmente, en la comparación de los turbo-códigos (TC) y Low Density Partity Check (LDPC) para anchos de banda de hasta 100 MHz. Los resultados obtenidos muestran que tanto los TC como los LDPC son buenos codificadores para esos tamaños de bloque. Los códigos LDPC representan una mejora de 0.5 dB como máximo respecto a los TC. Además, se ha realizado un estudio de prestaciones de la capa física de LTE en el enlace ascendente y descendente, junto con una propuesta de calibración de este tipo de simulaciones de enlace.[EN] LTE-Advanced is one promising candidate technology to become part of the next generation mobile (4G). It is up to the International Telecommunication Union (ITU) standardization body to assess this technology through the External Evaluation Groups (EEG), being one of them the WINNER+ project (Wireless World Initiative New Radio +). The Mobile Communications Group (MCG) of the Institute of Telecommunications and Multimedia Applications, as a partner of WINNER+, is currently analyzing and proposing different techniques with the aim of optimizing the LTE-Advanced radio access network. This Master Thesis is part of this activity and, especially, on the comparison of Turbo (TC) and Low Density Parity Check (LDPC) codes for bandwidths up to 100 MHz. Results prove that both TC and LDPC codes are good encoders for those block sizes. The LDPC codes only entail a maximum 0.5 dB improvement as compared with TC. In addition to this assessment, a performance study of LTE downlink/uplink (DL/ UL) physical layer together with a calibration proposal for link level simulations has been carried out.Cabrejas Peñuelas, J. (2009). Evaluation of 3GPP Technology Candidate Towards Fourth Generation Mobile. http://hdl.handle.net/10251/27347.Archivo delegad

    Physical-Layer Cooperation in Coded OFDM Relaying Systems

    Get PDF
    Mobile communication systems nowadays require ever-increasing data rate and coverage of wide areas. One promising approach to achieve this goal is the application of cooperative communications enabled by introducing intermediate nodes known as relays to support the transmission between terminals. By processing and forwarding the receive message at the relays, the path-loss effect between the source and the destination is mitigated. One major limit factor for relay assisted communications is that a relay cannot transmit and receive using the same physical resources. Therefore, a half-duplex constraint is commonly assumed resulting in halved spectral efficiency. To combat this drawback, two-way relaying is introduced, where two sources exchange information with each. On the other hand, due to the physical limitation of the relays, e.g., wireless sensor nodes, it's not possible to implement multiple antennas at one relay, which prohibits the application of multiple-input multiple-output (MIMO) techniques. However, when treating multiple relays as a cluster, a virtual antenna array is formed to perform MIMO techniques in a distributed manner. %This thesis aims at designing efficient one-way and two-way relaying schemes. Specifically, existing schemes from the literature are improved and new schemes are developed with the emphasis on coded orthogonal frequency division multiplexing (OFDM) transmissions. Of special interest is the application of physical-layer network coding (PLNC) for two-phase two-way relaying. In this case, a network coded message is estimated from the superimposed receive signal at the relay using PLNC schemes. The schemes are investigated based on a mutual information analysis and their performance are improved by a newly proposed phase control strategy. Furthermore, performance degradation due to system asynchrony is mitigated depending on different PLNC schemes. When multiple relays are available, novel cooperation schemes allowing information exchange within the relay cluster are proposed that facilitate distributed MIMO reception and transmission. Additionally, smart signaling approaches are presented to enable the cooperation at different levels with the cooperation overhead taken into account adequately in system performance evaluation
    corecore