81 research outputs found
Channel Estimation and ICI Cancelation in Vehicular Channels of OFDM Wireless Communication Systems
Orthogonal frequency division multiplexing (OFDM) scheme increases bandwidth efficiency (BE) of data transmission and eliminates inter symbol interference (ISI). As a result, it has been widely used for wideband communication systems that have been developed during the past two decades and it can be a good candidate for the emerging communication systems such as fifth generation (5G) cellular networks with high carrier frequency and communication systems of high speed vehicles such as high speed trains (HSTs) and supersonic unmanned aircraft vehicles (UAVs). However, the employment of OFDM for those upcoming systems is challenging because of high Doppler shifts. High Doppler shift makes the wideband communication channel to be both frequency selective and time selective, doubly selective (DS), causes inter carrier interference (ICI) and destroys the orthogonality between the subcarriers of OFDM signal. In order to demodulate the signal in OFDM systems and mitigate ICIs, channel state information (CSI) is required. In this work, we deal with channel estimation (CE) and ICI cancellation in DS vehicular channels. The digitized model of the DS channels can be short and dense, or long and sparse. CE methods that perform well for short and dense channels are highly inefficient for long and sparse channels. As a result, for the latter type of channels, we proposed the employment of compressed sensing (CS) based schemes for estimating the channel. In addition, we extended our CE methods for multiple input multiple output (MIMO) scenarios. We evaluated the CE accuracy and data demodulation fidelity, along with the BE and computational complexity of our methods and compared the results with the previous CE procedures in different environments. The simulation results indicate that our proposed CE methods perform considerably better than the conventional CE schemes
Advanced receivers and waveforms for UAV/Aircraft aeronautical communications
Nowadays, several studies are launched for the design of reliable and safe communications systems that introduce Unmanned Aerial Vehicle (UAV), this paves the way for UAV communication systems to play an important role in a lot of applications for non-segregated military and civil airspaces. Until today, rules for integrating commercial UAVs in airspace still need to be defined, the design of secure, highly reliable and cost effective communications systems still a challenging task. This thesis is part of this communication context. Motivated by the rapid growth of UAV quantities and by the new generations of UAVs controlled by satellite, the thesis aims to study the various possible UAV links which connect UAV/aircraft to other communication system components (satellite, terrestrial networks, etc.). Three main links are considered: the Forward link, the Return link and the Mission link. Due to spectrum scarcity and higher concentration in aircraft density, spectral efficiency becomes a crucial parameter for largescale deployment of UAVs. In order to set up a spectrally efficient UAV communication system, a good understanding of transmission channel for each link is indispensable, as well as a judicious choice of the waveform. This thesis begins to study propagation channels for each link: a mutipath channels through radio Line-of-Sight (LOS) links, in a context of using Meduim Altitude Long drones Endurance (MALE) UAVs. The objective of this thesis is to maximize the solutions and the algorithms used for signal reception such as channel estimation and channel equalization. These algorithms will be used to estimate and to equalize the existing muti-path propagation channels. Furthermore, the proposed methods depend on the choosen waveform. Because of the presence of satellite link, in this thesis, we consider two low-papr linear waveforms: classical Single-Carrier (SC) waveform and Extented Weighted Single-Carrier Orthogonal Frequency-Division Multiplexing (EW-SC-OFDM) waveform. channel estimation and channel equalization are performed in the time-domain (SC) or in the frequency-domain (EW-SC-OFDM). UAV architecture envisages the implantation of two antennas placed at wings. These two antennas can be used to increase diversity gain (channel matrix gain). In order to reduce channel equalization complexity, the EWSC- OFDM waveform is proposed and studied in a muti-antennas context, also for the purpose of enhancing UAV endurance and also increasing spectral efficiency, a new modulation technique is considered: Spatial Modulation (SM). In SM, transmit antennas are activated in an alternating manner. The use of EW-SC-OFDM waveform combined to SM technique allows us to propose new modified structures which exploit exces bandwidth to improve antenna bit protection and thus enhancing system performances
A White Paper on Broadband Connectivity in 6G
Executive Summary
This white paper explores the road to implementing broadband connectivity in future 6G wireless systems. Different categories of use cases are considered, from extreme capacity with peak data rates up to 1 Tbps, to raising the typical data rates by orders-of-magnitude, to support broadband connectivity at railway speeds up to 1000 km/h. To achieve these goals, not only the terrestrial networks will be evolved but they will also be integrated with satellite networks, all facilitating autonomous systems and various interconnected structures.
We believe that several categories of enablers at the infrastructure, spectrum, and protocol/algorithmic levels are required to realize the intended broadband connectivity goals in 6G. At the infrastructure level, we consider ultra-massive MIMO technology (possibly implemented using holographic radio), intelligent reflecting surfaces, user-centric and scalable cell-free networking, integrated access and backhaul, and integrated space and terrestrial networks. At the spectrum level, the network must seamlessly utilize sub-6 GHz bands for coverage and spatial multiplexing of many devices, while higher bands will be used for pushing the peak rates of point-to-point links. The latter path will lead to THz communications complemented by visible light communications in specific scenarios. At the protocol/algorithmic level, the enablers include improved coding, modulation, and waveforms to achieve lower latencies, higher reliability, and reduced complexity. Different options will be needed to optimally support different use cases. The resource efficiency can be further improved by using various combinations of full-duplex radios, interference management based on rate-splitting, machine-learning-based optimization, coded caching, and broadcasting. Finally, the three levels of enablers must be utilized not only to deliver better broadband services in urban areas, but also to provide full-coverage broadband connectivity must be one of the key outcomes of 6G
Spatial diversity in MIMO communication systems with distributed or co-located antennas
The use of multiple antennas in wireless communication systems has gained much attention during the last decade. It was shown that such multiple-input multiple-output (MIMO) systems offer huge advantages over single-antenna systems. Typically, quite restrictive assumptions are made concerning the spacing of the individual antenna elements. On the one hand, it is typically assumed that the antenna elements at transmitter and receiver are co-located, i.e., they belong to some sort of antenna array. On the other hand, it is often assumed that the antenna spacings are sufficiently large, so as to justify the assumption of independent fading. In this thesis, the above assumptions are relaxed. In the first part, it is shown that MIMO systems with distributed antennas and MIMO systems with co-located antennas can be treated in a single, unifying framework. In the second part this fact is utilized, in order to develop appropriate transmit power allocation strategies for co-located and distributed MIMO systems. Finally, the third part focuses on specific synchronization problems that are of interest for distributed MIMO systems
Recommended from our members
Adaptive Coded Modulation Classification and Spectrum Sensing for Cognitive Radio Systems. Adaptive Coded Modulation Techniques for Cognitive Radio Using Kalman Filter and Interacting Multiple Model Methods
The current and future trends of modern wireless communication systems place heavy demands on fast data transmissions in order to satisfy end users’ requirements anytime, anywhere. Such demands are obvious in recent applications such as smart phones, long term evolution (LTE), 4 & 5 Generations (4G & 5G), and worldwide interoperability for microwave access (WiMAX) platforms, where robust coding and modulations are essential especially in streaming on-line video material, social media and gaming. This eventually resulted in extreme exhaustion imposed on the frequency spectrum as a rare natural resource due to stagnation in current spectrum management policies. Since its advent in the late 1990s, cognitive radio (CR) has been conceived as an enabling technology aiming at the efficient utilisation of frequency spectrum that can lead to potential direct spectrum access (DSA) management. This is mainly attributed to its internal capabilities inherited from the concept of software defined radio (SDR) to sniff its surroundings, learn and adapt its operational parameters accordingly. CR systems (CRs) may commonly comprise one or all of the following core engines that characterise their architectures; namely, adaptive coded modulation (ACM), automatic modulation classification (AMC) and spectrum sensing (SS).
Motivated by the above challenges, this programme of research is primarily aimed at the design and development of new paradigms to help improve the adaptability of CRs and thereby achieve the desirable signal processing tasks at the physical layer of the above core engines. Approximate modelling of Rayleigh and finite state Markov channels (FSMC) with a new concept borrowed from econometric studies have been approached. Then insightful channel estimation by using Kalman filter (KF) augmented with interacting multiple model (IMM) has been examined for the purpose of robust adaptability, which is applied for the first time in wireless communication systems. Such new IMM-KF combination has been facilitated in the feedback channel between wireless transmitter and receiver to adjust the transmitted power, by using a water-filling (WF) technique, and constellation pattern and rate in the ACM algorithm. The AMC has also benefited from such IMM-KF integration to boost the performance against conventional parametric estimation methods such as maximum likelihood estimate (MLE) for channel interrogation and the estimated parameters of both inserted into the ML classification algorithm. Expectation-maximisation (EM) has been applied to examine unknown transmitted modulation sequences and channel parameters in tandem. Finally, the non-parametric multitaper method (MTM) has been thoroughly examined for spectrum estimation (SE) and SS, by relying on Neyman-Pearson (NP) detection principle for hypothesis test, to allow licensed primary users (PUs) to coexist with opportunistic unlicensed secondary users (SUs) in the same frequency bands of interest without harmful effects. The performance of the above newly suggested paradigms have been simulated and assessed under various transmission settings and revealed substantial improvements
- …