Mapreduce performance model for Hadoop 2.x

MapReduce is a popular programming model for distributed processing of large data sets. Apache Hadoop is one of the most common open-source implementations of such paradigm. Performance analysis of concurrent job executions has been recognized as a challenging problem, at the same time, that may provide reasonably accurate job response time estimation at significantly lower cost than experimental evaluation of real setups. In this paper, we tackle the challenge of defining MapReduce performance model for Hadoop 2.x. While there are several efficient approaches for modeling the performance of MapReduce workloads in Hadoop 1.x, they could not be applied to Hadoop 2.x due to fundamental architectural changes and dynamic resource allocation in Hadoop 2.x. Thus, the proposed solution is based on an existing performance model for Hadoop 1.x, but taking into consideration architectural changes and capturing the execution flow of a MapReduce job by using queuing network model. This way, the cost model reflects the intra-job synchronization constraints that occur due the contention at shared resources. The accuracy of our solution is validated via comparison of our model estimates against measurements in a real Hadoop 2.x setup.Peer ReviewedPostprint (author's final draft

Experimental analysis of computer system dependability

This paper reviews an area which has evolved over the past 15 years: experimental analysis of computer system dependability. Methodologies and advances are discussed for three basic approaches used in the area: simulated fault injection, physical fault injection, and measurement-based analysis. The three approaches are suited, respectively, to dependability evaluation in the three phases of a system's life: design phase, prototype phase, and operational phase. Before the discussion of these phases, several statistical techniques used in the area are introduced. For each phase, a classification of research methods or study topics is outlined, followed by discussion of these methods or topics as well as representative studies. The statistical techniques introduced include the estimation of parameters and confidence intervals, probability distribution characterization, and several multivariate analysis methods. Importance sampling, a statistical technique used to accelerate Monte Carlo simulation, is also introduced. The discussion of simulated fault injection covers electrical-level, logic-level, and function-level fault injection methods as well as representative simulation environments such as FOCUS and DEPEND. The discussion of physical fault injection covers hardware, software, and radiation fault injection methods as well as several software and hybrid tools including FIAT, FERARI, HYBRID, and FINE. The discussion of measurement-based analysis covers measurement and data processing techniques, basic error characterization, dependency analysis, Markov reward modeling, software-dependability, and fault diagnosis. The discussion involves several important issues studies in the area, including fault models, fast simulation techniques, workload/failure dependency, correlated failures, and software fault tolerance

A Strategy for Performance Evaluation and Modeling of Cloud Computing Services

On-demand services and reduced costs made cloud computing a popular mechanism to provide scalable resources according to the user’s expectations. This paradigm is an important role in business and academic organizations, supporting applications and services deployed based on virtual machines and containers, two different technologies for virtualization. Cloud environments can support workloads generated by several numbers of users, that request the cloud environment to execute transactions and its performance should be evaluated and estimated in order to achieve clients satisfactions when cloud services are offered. This work proposes a performance evaluation strategy composed of a performance model and a methodology for evaluating the performance of services configured in virtual machines and containers in cloud infrastructures. The performance model for the evaluation of virtual machines and containers in cloud infrastructures is based on stochastic Petri nets. A case study in a real public cloud is presented to illustrate the feasibility of the performance evaluation strategy. The case study experiments were performed with virtual machines and containers supporting workloads related to social networks transactions

Design for dependability: A simulation-based approach

This research addresses issues in simulation-based system level dependability analysis of fault-tolerant computer systems. The issues and difficulties of providing a general simulation-based approach for system level analysis are discussed and a methodology that address and tackle these issues is presented. The proposed methodology is designed to permit the study of a wide variety of architectures under various fault conditions. It permits detailed functional modeling of architectural features such as sparing policies, repair schemes, routing algorithms as well as other fault-tolerant mechanisms, and it allows the execution of actual application software. One key benefit of this approach is that the behavior of a system under faults does not have to be pre-defined as it is normally done. Instead, a system can be simulated in detail and injected with faults to determine its failure modes. The thesis describes how object-oriented design is used to incorporate this methodology into a general purpose design and fault injection package called DEPEND. A software model is presented that uses abstractions of application programs to study the behavior and effect of software on hardware faults in the early design stage when actual code is not available. Finally, an acceleration technique that combines hierarchical simulation, time acceleration algorithms and hybrid simulation to reduce simulation time is introduced

Software fault tolerance in computer operating systems

This chapter provides data and analysis of the dependability and fault tolerance for three operating systems: the Tandem/GUARDIAN fault-tolerant system, the VAX/VMS distributed system, and the IBM/MVS system. Based on measurements from these systems, basic software error characteristics are investigated. Fault tolerance in operating systems resulting from the use of process pairs and recovery routines is evaluated. Two levels of models are developed to analyze error and recovery processes inside an operating system and interactions among multiple instances of an operating system running in a distributed environment. The measurements show that the use of process pairs in Tandem systems, which was originally intended for tolerating hardware faults, allows the system to tolerate about 70% of defects in system software that result in processor failures. The loose coupling between processors which results in the backup execution (the processor state and the sequence of events occurring) being different from the original execution is a major reason for the measured software fault tolerance. The IBM/MVS system fault tolerance almost doubles when recovery routines are provided, in comparison to the case in which no recovery routines are available. However, even when recovery routines are provided, there is almost a 50% chance of system failure when critical system jobs are involved

MapReduce performance models for Hadoop 2.x

MapReduce is a popular programming model for distributed processing of large data sets. Apache Hadoop is one of the most common open-source implementations of such paradigm. Performance analysis of concurrent job executions has been recognized as a challenging problem, at the same time, that it may provide reasonably accurate job response time at significantly lower cost than experimental evaluation of real setups. In this paper, we tackle the challenge of defining MapReduce performance models for Hadoop 2.x. While there are several efficient approaches for modeling the performance of MapReduce workloads in Hadoop 1.x, the fundamental architectural changes of Hadoop 2.x require that the cost models are also reconsidered. The proposed solution is based on an existing performance model for Hadoop 1.x, but it takes into consideration the architectural changes of Hadoop 2.x and captures the execution flow of a MapReduce job by using queuing network model. This way the cost model adheres to the intra-job synchronization constraints that occur due the contention at shared resources. The accuracy of our solution is validated via comparison of our model estimates against measurements in a real Hadoop 2.x setup. According to our evaluation results, the proposed model produces estimates of average job response time with error within the range of 11% - 13.5%.Peer ReviewedPostprint (published version

Periodic Application of Concurrent Error Detection in Processor Array Architectures

Processor arrays can provide an attractive architecture for some applications. Featuring modularity, regular interconnection and high parallelism, such arrays are well-suited for VLSI/WSI implementations, and applications with high computational requirements, such as real-time signal processing. Preserving the integrity of results can be of paramount importance for certain applications. In these cases, fault tolerance should be used to ensure reliable delivery of a system's service. One aspect of fault tolerance is the detection of errors caused by faults. Concurrent error detection (CED) techniques offer the advantage that transient and intermittent faults may be detected with greater probability than with off-line diagnostic tests. Applying time-redundant CED techniques can reduce hardware redundancy costs. However, most time-redundant CED techniques degrade a system's performance

Revenue maximization problems in commercial data centers

PhD ThesisAs IT systems are becoming more important everyday, one of the main concerns is that users may face major problems and eventually incur major costs if computing systems do not meet the expected performance requirements: customers expect reliability and performance guarantees, while underperforming systems loose revenues. Even with the adoption of data centers as the hub of IT organizations and provider of business efficiencies the problems are not over because it is extremely difficult for service providers to meet the promised performance guarantees in the face of unpredictable demand. One possible approach is the adoption of Service Level Agreements (SLAs), contracts that specify a level of performance that must be met and compensations in case of failure. In this thesis I will address some of the performance problems arising when IT companies sell the service of running ‘jobs’ subject to Quality of Service (QoS) constraints. In particular, the aim is to improve the efficiency of service provisioning systems by allowing them to adapt to changing demand conditions. First, I will define the problem in terms of an utility function to maximize. Two different models are analyzed, one for single jobs and the other useful to deal with session-based traffic. Then, I will introduce an autonomic model for service provision. The architecture consists of a set of hosted applications that share a certain number of servers. The system collects demand and performance statistics and estimates traffic parameters. These estimates are used by management policies which implement dynamic resource allocation and admission algorithms. Results from a number of experiments show that the performance of these heuristics is close to optimal.QoSP (Quality of Service Provisioning)British Teleco

DEPEND: A Simulation-Based Environment for System Level Dependability Analysis

Coordinated Science Laboratory was formerly known as Control Systems LaboratoryNational Aeronautics and Space Administration / NASA NAG-1-613 and NASA NGT-5083