Transient Moisture Gradient in Fire-Exposed Wood Slab

Improved fire endurance design procedures for heavy timber members may require the input of moisture content-dependent allowable stresses. Therefore, experiments were conducted to characterize the transient moisture gradient in a wood slab subjected to fire on one face. Electrodes and thermocouples embedded within the wood sections monitored moisture and temperature levels at selected locations. Time-moisture content curves indicated an increase in moisture content that appeared to be associated with the vaporization of the bound water in the wood. For the eight slabs tested, the average peak moisture content was 1.26 to 2.00 times greater than the initial moisture content

Replicate Fire Endurance Tests of an Unprotected Wood Joist Floor Assembly

To encourage new developments in building technology, a solid basis for building code requirements is needed. Fire endurance is a code requirement, yet no objective procedure exists for computing a structure's chances of failing (degree of risk) in a fire. However, a model for predicting the fire endurance of part of a structure, a conventional unprotected wood joist floor, is available. The aim of this study was to determine the fire endurance performance of an unprotected wood joist floor for use in the model.Eleven ASTM Standard E 119 floor tests were conducted. All the floors were 2 by 10 Douglas-fir wood joists, sixteen inches on center with 23/32-inch-thick plywood as the floor sheathing. In addition to one trial test, five tests were conducted using a live load of 11.35 lb/ft2. For the other five tests, the live load was 79.2 lb/ft2. Twenty joists were tested for modulus of elasticity and modulus of rupture.The joist population had a mean modulus of rupture of 5.280 lb/in.2 and a mean modulus of elasticity of 1,530,000 lb/in.2. For the five floors loaded to 11.35 lb/ft2, the mean time for initial joist failure was 17.9 min with a coefficient of variation (COV) of 3.7%. For the five floors loaded to 79.2 lb/ft2, the mean time was 6.5 min with a COV of 11.6%. Based on linear interpolation of these results, first joist failure would have occurred in 13.1 min if a 40 lb/ft2 live load had been used, which is the typical live loading specified in the building codes for residential one- and two-family dwellings.As a result of this study, fire-resistance performance of a wood floor is known for a specific population of wood joists with known structural properties. These results can be used to verify and revise the model for predicting fire endurance

Canadian Network for Mood and Anxiety Treatments (CANMAT) and International Society for Bipolar Disorders (ISBD) 2018 guidelines for the management of patients with bipolar disorder.

The Canadian Network for Mood and Anxiety Treatments (CANMAT) previously published treatment guidelines for bipolar disorder in 2005, along with international commentaries and subsequent updates in 2007, 2009, and 2013. The last two updates were published in collaboration with the International Society for Bipolar Disorders (ISBD). These 2018 CANMAT and ISBD Bipolar Treatment Guidelines represent the significant advances in the field since the last full edition was published in 2005, including updates to diagnosis and management as well as new research into pharmacological and psychological treatments. These advances have been translated into clear and easy to use recommendations for first, second, and third- line treatments, with consideration given to levels of evidence for efficacy, clinical support based on experience, and consensus ratings of safety, tolerability, and treatment-emergent switch risk. New to these guidelines, hierarchical rankings were created for first and second- line treatments recommended for acute mania, acute depression, and maintenance treatment in bipolar I disorder. Created by considering the impact of each treatment across all phases of illness, this hierarchy will further assist clinicians in making evidence-based treatment decisions. Lithium, quetiapine, divalproex, asenapine, aripiprazole, paliperidone, risperidone, and cariprazine alone or in combination are recommended as first-line treatments for acute mania. First-line options for bipolar I depression include quetiapine, lurasidone plus lithium or divalproex, lithium, lamotrigine, lurasidone, or adjunctive lamotrigine. While medications that have been shown to be effective for the acute phase should generally be continued for the maintenance phase in bipolar I disorder, there are some exceptions (such as with antidepressants); and available data suggest that lithium, quetiapine, divalproex, lamotrigine, asenapine, and aripiprazole monotherapy or combination treatments should be considered first-line for those initiating or switching treatment during the maintenance phase. In addition to addressing issues in bipolar I disorder, these guidelines also provide an overview of, and recommendations for, clinical management of bipolar II disorder, as well as advice on specific populations, such as women at various stages of the reproductive cycle, children and adolescents, and older adults. There are also discussions on the impact of specific psychiatric and medical comorbidities such as substance use, anxiety, and metabolic disorders. Finally, an overview of issues related to safety and monitoring is provided. The CANMAT and ISBD groups hope that these guidelines become a valuable tool for practitioners across the globe

Water Content in the SW USA Mantle Lithosphere: FTIR Analysis of Dish Hill and Kilbourne Hole Pyroxenites

Kilbourne Hole (NM, USA) and Dish Hill (CA, USA) mantle xenoliths sample continental mantle in two different tectonic settings. Kilbourne Hole (KH) is located in the Rio Grande rift. Dish Hill (DH) is located in the southern Mojave province, an area potentially affected by subduction of the Farallon plate beneath North America. FTIR analyses were obtained on well characterized pyroxenite, dunite and wehrlite xenoliths, thought to represent crystallized melts at mantle depths. PUM normalized REE patterns of the KH bulk-rocks are slightly LREE enriched and consistent with those of liquids generated by 6% melting of a spinel peridotite source. Pyroxenite pyroxenes have no detectable water but one DH wehrlite, which bulk-rock is LREE enriched, has 4 ppm H2O in orthopyroxene and 2 Ga. The Farallon subduction appears to have enriched in water the southwestern United States lithospheric mantle further east than DH, beneath the Colorado plateau

Global gene expression analysis of apple fruit development from the floral bud to ripe fruit

<p>Abstract</p> <p>Background</p> <p>Apple fruit develop over a period of 150 days from anthesis to fully ripe. An array representing approximately 13000 genes (15726 oligonucleotides of 45–55 bases) designed from apple ESTs has been used to study gene expression over eight time points during fruit development. This analysis of gene expression lays the groundwork for a molecular understanding of fruit growth and development in apple.</p> <p>Results</p> <p>Using ANOVA analysis of the microarray data, 1955 genes showed significant changes in expression over this time course. Expression of genes is coordinated with four major patterns of expression observed: high in floral buds; high during cell division; high when starch levels and cell expansion rates peak; and high during ripening. Functional analysis associated cell cycle genes with early fruit development and three core cell cycle genes are significantly up-regulated in the early stages of fruit development. Starch metabolic genes were associated with changes in starch levels during fruit development. Comparison with microarrays of ethylene-treated apple fruit identified a group of ethylene induced genes also induced in normal fruit ripening. Comparison with fruit development microarrays in tomato has been used to identify 16 genes for which expression patterns are similar in apple and tomato and these genes may play fundamental roles in fruit development. The early phase of cell division and tissue specification that occurs in the first 35 days after pollination has been associated with up-regulation of a cluster of genes that includes core cell cycle genes.</p> <p>Conclusion</p> <p>Gene expression in apple fruit is coordinated with specific developmental stages. The array results are reproducible and comparisons with experiments in other species has been used to identify genes that may play a fundamental role in fruit development.</p

Identification and Quantification of Proteoforms by Mass Spectrometry

A proteoform is a defined form of a protein derived from a given gene with a specific amino acid sequence and localized post-translational modifications. In top-down proteomic analyses, proteoforms are identified and quantified through mass spectrometric analysis of intact proteins. Recent technological developments have enabled comprehensive proteoform analyses in complex samples, and an increasing number of laboratories are adopting top-down proteomic workflows. In this review, we outline some recent advances and discuss current challenges and future directions for the field

The Atacama Cosmology Telescope: Data Characterization and Map Making

We present a description of the data reduction and mapmaking pipeline used for the 2008 observing season of the Atacama Cosmology Telescope (ACT). The data presented here at 148 GHz represent 12% of the 90 TB collected by ACT from 2007 to 2010. In 2008 we observed for 136 days, producing a total of 1423 hours of data (11 TB for the 148 GHz band only), with a daily average of 10.5 hours of observation. From these, 1085 hours were devoted to a 850 deg^2 stripe (11.2 hours by 9.1 deg) centered on a declination of -52.7 deg, while 175 hours were devoted to a 280 deg^2 stripe (4.5 hours by 4.8 deg) centered at the celestial equator. We discuss sources of statistical and systematic noise, calibration, telescope pointing, and data selection. Out of 1260 survey hours and 1024 detectors per array, 816 hours and 593 effective detectors remain after data selection for this frequency band, yielding a 38% survey efficiency. The total sensitivity in 2008, determined from the noise level between 5 Hz and 20 Hz in the time-ordered data stream (TOD), is 32 micro-Kelvin sqrt{s} in CMB units. Atmospheric brightness fluctuations constitute the main contaminant in the data and dominate the detector noise covariance at low frequencies in the TOD. The maps were made by solving the least-squares problem using the Preconditioned Conjugate Gradient method, incorporating the details of the detector and noise correlations. Cross-correlation with WMAP sky maps, as well as analysis from simulations, reveal that our maps are unbiased at multipoles ell > 300. This paper accompanies the public release of the 148 GHz southern stripe maps from 2008. The techniques described here will be applied to future maps and data releases.Comment: 20 pages, 18 figures, 6 tables, an ACT Collaboration pape

Biomarkers for Early and Late Stage Chronic Allograft Nephropathy by Proteogenomic Profiling of Peripheral Blood

Despite significant improvements in life expectancy of kidney transplant patients due to advances in surgery and immunosuppression, Chronic Allograft Nephropathy (CAN) remains a daunting problem. A complex network of cellular mechanisms in both graft and peripheral immune compartments complicates the non-invasive diagnosis of CAN, which still requires biopsy histology. This is compounded by non-immunological factors contributing to graft injury. There is a pressing need to identify and validate minimally invasive biomarkers for CAN to serve as early predictors of graft loss and as metrics for managing long-term immunosuppression.We used DNA microarrays, tandem mass spectroscopy proteomics and bioinformatics to identify genomic and proteomic markers of mild and moderate/severe CAN in peripheral blood of two distinct cohorts (n = 77 total) of kidney transplant patients with biopsy-documented histology.Gene expression profiles reveal over 2400 genes for mild CAN, and over 700 for moderate/severe CAN. A consensus analysis reveals 393 (mild) and 63 (moderate/severe) final candidates as CAN markers with predictive accuracy of 80% (mild) and 92% (moderate/severe). Proteomic profiles show over 500 candidates each, for both stages of CAN including 302 proteins unique to mild and 509 unique to moderate/severe CAN.This study identifies several unique signatures of transcript and protein biomarkers with high predictive accuracies for mild and moderate/severe CAN, the most common cause of late allograft failure. These biomarkers are the necessary first step to a proteogenomic classification of CAN based on peripheral blood profiling and will be the targets of a prospective clinical validation study

Stone formation in peach fruit exhibits spatial coordination of the lignin and flavonoid pathways and similarity to Arabidopsis dehiscence

<p>Abstract</p> <p>Background</p> <p>Lignification of the fruit endocarp layer occurs in many angiosperms and plays a critical role in seed protection and dispersal. This process has been extensively studied with relationship to pod shatter or dehiscence in <it>Arabidopsis</it>. Dehiscence is controlled by a set of transcription factors that define the fruit tissue layers and whether or not they lignify. In contrast, relatively little is known about similar processes in other plants such as stone fruits which contain an extremely hard lignified endocarp or stone surrounding a single seed.</p> <p>Results</p> <p>Here we show that lignin deposition in peach initiates near the blossom end within the endocarp layer and proceeds in a distinct spatial-temporal pattern. Microarray studies using a developmental series from young fruits identified a sharp and transient induction of phenylpropanoid, lignin and flavonoid pathway genes concurrent with lignification and subsequent stone hardening. Quantitative polymerase chain reaction studies revealed that specific phenylpropanoid (phenylalanine ammonia-lyase and cinnamate 4-hydroxylase) and lignin (caffeoyl-CoA O-methyltransferase, peroxidase and laccase) pathway genes were induced in the endocarp layer over a 10 day time period, while two lignin genes (<it>p-</it>coumarate 3-hydroxylase and cinnamoyl CoA reductase) were co-regulated with flavonoid pathway genes (chalcone synthase, dihydroflavanol 4-reductase, leucoanthocyanidin dioxygen-ase and flavanone-3-hydrosylase) which were mesocarp and exocarp specific. Analysis of other fruit development expression studies revealed that flavonoid pathway induction is conserved in the related Rosaceae species apple while lignin pathway induction is not. The transcription factor expression of peach genes homologous to known endocarp determinant genes in <it>Arabidopsis </it>including <it>SHATTERPROOF</it>, <it>SEEDSTCK </it>and <it>NAC SECONDARY WALL THICENING PROMOTING FACTOR 1 </it>were found to be specifically expressed in the endocarp while the negative regulator <it>FRUITFU</it>L predominated in exocarp and mesocarp.</p> <p>Conclusions</p> <p>Collectively, the data suggests, first, that the process of endocarp determination and differentiation in peach and <it>Arabidopsis </it>share common regulators and, secondly, reveals a previously unknown coordination of competing lignin and flavonoid biosynthetic pathways during early fruit development.</p