655 research outputs found
Interwire contact forces and the static, hysteretic and fatigue properties of multi-layer structural strands
Imperial Users onl
The impact of poor cementing casing damage: A numerical simulation study
A good knowledge of the parameters causing casing damage is critically important due to vital role of casing during the life of a well. Cement sheath, which fills in the gap between the casing and wellbore wall, has a profound effect on the resistance of the casing against applied loads. Most of the empirical equations proposed to estimate the collapse resistance of casing ignore the effects of the cement sheath on collapse resistance and rather assume uniform loading on the casing. This paper aims to use numerical modeling to show how a bad cementing job may lead to casing damage. Two separate cases were simulated where the differences between good and bad cementation on casing resistance were studied. In both cases, the same values of stresses were applied at the outer boundary of the models. The results revealed that a good cementing job can provide a perfect sheath against the tangential stress induced by far-field stresses and reduce the chance of casing to be damaged
The New Pretender: A Large UK Case Series of Retinal Injuries in Children Secondary to Handheld Lasers
Purpose: To characterize a large single-center series of retinal injuries in children secondary to handheld laser devices, with emphasis on potential prognostic factors. / Design: Retrospective case series. / Methods: Sixteen children (24 eyes) with retinal injuries secondary to handheld lasers were identified from our electronic patient record system. Case notes, digital fundus photography, and spectral-domain optical coherence tomography images were reviewed. / Results: The mean age of affected children was 12.7 years (range 9–16 years), with 12 male and 4 female subjects. Mean follow up was 5.4 months (range 1–23 months). Five children (31%) were referred as suspected retinal dystrophies. The mean logMAR visual acuity at presentation was 0.30 (20/40) (range −0.20 [20/12.5] to 1.6 [20/800]). Eleven children (69%; 15 eyes) had “mild” injuries with focal retinal disruption confined to the photoreceptor and ellipsoid layers; such injuries were associated with a better prognosis, the mean visual acuity at presentation being 0.10 (20/25). “Moderate” injuries were seen in 3 eyes of 2 children, with retinal disruption confined to the outer retinal layer but diffuse rather than focal in nature. Three patients (4 eyes) had “severe” injuries, with subfoveal outer retinal architecture loss and overlying hyperreflective material in inner retinal layers. / Conclusion: Retinal injuries secondary to handheld laser devices may be difficult to diagnose and are likely underreported. It is important that such data are in the public domain, so regulatory authorities recognize the importance of laser retinopathy as an avoidable cause of childhood visual impairment and take steps to minimize the incidence and impact of laser injuries
Data on experimental investigation of Methyl Ester Sulphonate and nanopolystyrene for rheology improvement and filtration loss control of water-based drilling fluid
Data presented in this article focused on the application of Methyl Ester Sulphonate (MES) surfactant and nanopolystyrene in water based drilling fluid. Data from rheology study using Bingham and Power law models showed that the synergy of MES and nanopolystyrene improved the formulated drilling fluid. Filtration study under LPLT and HPHT conditions showed that MES and nanopolystyrene drilling fluid reduced filtration loss by 50.7% at LPLT and 61.1% at HPHT conditions. These filtration data were validated by filter cake permeability and scanning electron microscope images
A methodology for wellbore stability analysis of drilling into presalt formations: A case study from southern Iran
Drilling into presalt formations has been a long-standing issue due to the rapid changes in the diameter of the borehole during drilling operations either because of creep or wash-out dissolution. There have been many studies on characterization of salts, with many mathematical models being presented to estimate the pressure induced due to the squeezing salt sheets. However, the results of none of these models have been fully validated against real field data and some recommendations have been made based on numerical simulations. In this study, attempts were made to introduce a methodology based on damage mechanics for wellbore stability analysis of a wells drilled in the southern part of Iran. The results obtained indicated that the presence of a thick salt layer in the well has resulted in significant wellbore closure in the intervals above the reservoir section. It was also found that the salt exhibits viscoelastic behaviour during drilling due to the homogeneous temperature which has not reached the threshold limit of viscoplastic boundary. A complicated change in the stress regime was also observed which could be linked to the existence of the thick salt layer or presences of a fault crossing the well. Therefore, it is recommended to further validate this model in other wells using the methodology presented
Levels of Glucose-6-phosphate Dehydrogenase in Type 1 Diabetes Mellitus patients with Nephropathy and Cardiovascular disease complication
The aim of this study is to evaluate oxidative stress in diabetes mellitus (DM) Type1 by the measurement of Glucose-6-phosphate Dehydrogenase (G-6-PD), an enzyme expressed in human RBCs, is important in the generation of reduced glutathione which is the key product in oxidative stress controls. The Study was carried on 80 samples of blood and serum of National Diabetes Center (NDC). The study groups under fasting conditions and they divided as:20 samples of diabetes mellitus patients without complications and 20 samples of diabetes mellitus with cardiovascular (CV) complications and 20 samples of diabetes mellitus with Nephropathy (Neph) complications compared with 20 control group with average age (13-67) years.. The results showed an elevation in the lipid profile and urea levels in patients groups compared with control group and a decrease in glucose-6-phosphate Dehydrogenase, HDL levels in all patients groups compared with control group
TRM versus FRP in flexural strengthening of RC beams: behaviour at high temperatures
The flexural behaviour of RC beams strengthened with TRM and FRP composites was experimentally investigated and compared both at ambient and high temperatures. The investigated parameters were: (a) the strengthening material, namely TRM versus FRP, (b) the number of strengthening layers, (c) the textile surface condition (dry and coated), (d) the textile material (carbon, basalt or glass fibres) and (e) the end-anchorage of the flexural reinforcement. A total of 23 half-scale beams were constructed, strengthened in flexure and tested to assess these parameters and the effectiveness of the TRM versus FRP at high temperatures. TRM exhibited excellent performance as strengthening material in increasing the flexural capacity at high temperature; in fact, TRM maintained an average effectiveness of 55%, compared to its effectiveness at ambient temperature, contrary to FRP which totally lost its effectiveness when subjected to high temperature. In specific, from the high temperature test it was found that by increasing the number of layers, the TRM effectiveness was considerably enhanced and the failure mode was altered; coating enhanced the TRM effectiveness; and the end-anchorage at high temperature improved significantly the FRP and marginally the TRM effectiveness. Finally, the formula proposed by the Fib Model Code 2010 was used to predict the mean debonding stress in the TRM reinforcement, and using the experimental results obtained in this study, a reduction factor to account for the effect of high temperature on the flexural strengthening with TRM was proposed
Determining Irrigation Depths for Soybean Using a Simulation Model of Water Flow and Plant Growth and Weather Forecasts
A new scheme to determine irrigation depths using a two-point of predicted cumulative transpiration over irrigation interval is presented. Rather than maximizing water use efficiency, this scheme aims to maximize net income. The volumetric water price is considered to give farmers an incentive to save irrigation water. A field experiment for soybeans was carried out in the Arid Land Research Center, Tottori University, Japan in 2019. The total irrigation amount yield and net income by the proposed scheme were compared to those by a tensiometer-operated automated irrigation. The scheme could save irrigation water by 16% with a yield increment of 20%; resulting in a 22% increase in net income compared to the automated irrigation. The model simulated the volumetric water content in the effective root zone of the plant in fair agreement. These results indicate the effectiveness of the proposed scheme that may replace an automated irrigation system even considering uncertainty in weather forecast to determine irrigation depth and secure investment costs
ISOLATION OF ASTRAGALIN FROM IRAQI CHENOPODIUM ALBUM
Objective: Chenopodium album L is the species of the genus chenopodium. The Greek name Chenopodium means goosefoot. The plant is native to Asia and Europe. The analysis of the constituents of the Iraqi plant was performed using gas chromatography and high-performance liquid chromatography techniques.Methods: Thin-layer chromatography (TLC) and high-performance TLC chromatographic techniques were used for the detection and isolation of the active constituent found in the plant. Spectral analysis such as nuclear magnetic resonance (NMR) and UV was used to confirm the chemical structure of the compound isolated.Results: Astragalin was isolated and identified by comparison with standard kaempferol 3-O-β-glucoside (astragalin) which was detected as the major glycoside in the polar fraction of the plant. Further, identification of the compound was performed by 1H-NMR spectroscopy.Conclusion: Astragalin is the major flavonoid glycoside found in the plant.Â
A new transient method for determining soil hydraulic conductivity function
Instantaneous profile method (IPM) is a transient method for measuring a soil hydraulic conductivity function (SHCF), which relates soil hydraulic conductivity with suction. In the existing interpretation method of the IPM, boundary flux during testing must be known to integrate instantaneous profiles of water content for obtaining water flow rate. However, it is usually difficult and expensive to measure a boundary flux and if not known, assumptions that may not be easily justified (especially in the field condition) have to be made. In this study, a new method is proposed so that any boundary flux needs not to be measured, controlled or assumed during a test. The new method is evaluated through (i) hypothetical column tests using transient seepage analyses and (ii) five case studies. The new method is capable of determining a SHCF with good accuracy. Normalised root-mean-square deviation (NRMSD) for the old and new methods is less than 5% and 10%, respectively. The accuracy of the new method can be increased substantially (i.e., NRMSDThe accepted manuscript in pdf format is listed with the files at the bottom of this page. The presentation of the authors' names and (or) special characters in the title of the manuscript may differ slightly between what is listed on this page and what is listed in the pdf file of the accepted manuscript; that in the pdf file of the accepted manuscript is what was submitted by the author
- …