171 research outputs found
The design and commissioning of the MICE upstream time-of-flight system
In the MICE experiment at RAL the upstream time-of-flight detectors are used
for particle identification in the incoming muon beam, for the experiment
trigger and for a precise timing (sigma_t ~ 50 ps) with respect to the
accelerating RF cavities working at 201 MHz. The construction of the upstream
section of the MICE time-of-flight system and the tests done to characterize
its individual components are shown. Detector timing resolutions ~50-60 ps were
achieved. Test beam performance and preliminary results obtained with beam at
RAL are reported.Comment: accepted on Nuclear Instruments and Methods
Proposal for SPS beam time for the baby MIND and TASD neutrino detector prototypes
The design, construction and testing of neutrino detector prototypes at CERN
are ongoing activities. This document reports on the design of solid state baby
MIND and TASD detector prototypes and outlines requirements for a test beam at
CERN to test these, tentatively planned on the H8 beamline in the North Area,
which is equipped with a large aperture magnet. The current proposal is
submitted to be considered in light of the recently approved projects related
to neutrino activities with the SPS in the North Area in the medium term
2015-2020
Baby MIND: A magnetised spectrometer for the WAGASCI experiment
The WAGASCI experiment being built at the J-PARC neutrino beam line will
measure the difference in cross sections from neutrinos interacting with a
water and scintillator targets, in order to constrain neutrino cross sections,
essential for the T2K neutrino oscillation measurements. A prototype Magnetised
Iron Neutrino Detector (MIND), called Baby MIND, is being constructed at CERN
to act as a magnetic spectrometer behind the main WAGASCI target to be able to
measure the charge and momentum of the outgoing muon from neutrino charged
current interactions.Comment: Poster presented at NuPhys2016 (London, 12-14 December 2016). Title +
4 pages, LaTeX, 6 figure
Synchronization of the Distributed Readout Frontend Electronics of the Baby MIND Detector
Baby MIND is a new downstream muon range detector for the WGASCI experiment. This article discusses the distributed readout system and its timing requirements. The paper presents the design of the synchronization subsystem and the results of its test
Baby MIND Experiment Construction Status
Baby MIND is a magnetized iron neutrino detector, with novel design features,
and is planned to serve as a downstream magnetized muon spectrometer for the
WAGASCI experiment on the T2K neutrino beam line in Japan. One of the main
goals of this experiment is to reduce systematic uncertainties relevant to
CP-violation searches, by measuring the neutrino contamination in the
anti-neutrino beam mode of T2K. Baby MIND is currently being constructed at
CERN, and is planned to be operational in Japan in October 2017.Comment: Poster presented at NuPhys2016 (London, 12-14 December 2016). 4
pages, LaTeX, 7 figure
Baby MIND: A magnetized segmented neutrino detector for the WAGASCI experiment
T2K (Tokai-to-Kamioka) is a long-baseline neutrino experiment in Japan
designed to study various parameters of neutrino oscillations. A near detector
complex (ND280) is located 280~m downstream of the production target and
measures neutrino beam parameters before any oscillations occur. ND280's
measurements are used to predict the number and spectra of neutrinos in the
Super-Kamiokande detector at the distance of 295~km. The difference in the
target material between the far (water) and near (scintillator, hydrocarbon)
detectors leads to the main non-cancelling systematic uncertainty for the
oscillation analysis. In order to reduce this uncertainty a new
WAter-Grid-And-SCintillator detector (WAGASCI) has been developed. A magnetized
iron neutrino detector (Baby MIND) will be used to measure momentum and charge
identification of the outgoing muons from charged current interactions. The
Baby MIND modules are composed of magnetized iron plates and long plastic
scintillator bars read out at the both ends with wavelength shifting fibers and
silicon photomultipliers. The front-end electronics board has been developed to
perform the readout and digitization of the signals from the scintillator bars.
Detector elements were tested with cosmic rays and in the PS beam at CERN. The
obtained results are presented in this paper.Comment: In new version: modified both plots of Fig.1 and added one sentence
in the introduction part explaining Baby MIND role in WAGASCI experiment,
added information for the affiliation
MICE: the Muon Ionization Cooling Experiment. Step I: First Measurement of Emittance with Particle Physics Detectors
The Muon Ionization Cooling Experiment (MICE) is a strategic R&D project intended to demonstrate the only practical solution to providing high brilliance beams necessary for a neutrino factory or muon collider. MICE is under development at the Rutherford Appleton Laboratory (RAL) in the United Kingdom. It comprises a dedicated beamline to generate a range of input muon emittances and momenta, with time-of-flight and Cherenkov detectors to ensure a pure muon beam. The emittance of the incoming beam will be measured in the upstream magnetic spectrometer with a scintillating fiber tracker. A cooling cell will then follow, alternating energy loss in Liquid Hydrogen (LH2) absorbers to RF cavity acceleration. A second spectrometer, identical to the first, and a second muon identification system will measure the outgoing emittance. In the 2010 run at RAL the muon beamline and most detectors were fully commissioned and a first measurement of the emittance of the muon beam with particle physics (time-of-flight) detectors was performed. The analysis of these data was recently completed and is discussed in this paper. Future steps for MICE, where beam emittance and emittance reduction (cooling) are to be measured with greater accuracy, are also presented
Interim Design Report
The International Design Study for the Neutrino Factory (the IDS-NF) was
established by the community at the ninth "International Workshop on Neutrino
Factories, super-beams, and beta- beams" which was held in Okayama in August
2007. The IDS-NF mandate is to deliver the Reference Design Report (RDR) for
the facility on the timescale of 2012/13. In addition, the mandate for the
study [3] requires an Interim Design Report to be delivered midway through the
project as a step on the way to the RDR. This document, the IDR, has two
functions: it marks the point in the IDS-NF at which the emphasis turns to the
engineering studies required to deliver the RDR and it documents baseline
concepts for the accelerator complex, the neutrino detectors, and the
instrumentation systems. The IDS-NF is, in essence, a site-independent study.
Example sites, CERN, FNAL, and RAL, have been identified to allow site-specific
issues to be addressed in the cost analysis that will be presented in the RDR.
The choice of example sites should not be interpreted as implying a preferred
choice of site for the facility
MICE: The muon ionization cooling experiment. Step I: First measurement of emittance with particle physics detectors
Copyright @ 2011 APSThe Muon Ionization Cooling Experiment (MICE) is a strategic R&D project intended to demonstrate the only practical solution to providing high brilliance beams necessary for a neutrino factory or muon collider. MICE is under development at the Rutherford Appleton Laboratory (RAL) in the United Kingdom. It comprises a dedicated beamline to generate a range of input muon emittances and momenta, with time-of-flight and Cherenkov detectors to ensure a pure muon beam. The emittance of the incoming beam will be measured in the upstream magnetic spectrometer with a scintillating fiber tracker. A cooling cell will then follow, alternating energy loss in Liquid Hydrogen (LH2) absorbers to RF cavity acceleration. A second spectrometer, identical to the first, and a second muon identification system will measure the outgoing emittance. In the 2010 run at RAL the muon beamline and most detectors were fully commissioned and a first measurement of the emittance of the muon beam with particle physics (time-of-flight) detectors was performed. The analysis of these data was recently completed and is discussed in this paper. Future steps for MICE, where beam emittance and emittance reduction (cooling) are to be measured with greater accuracy, are also presented.This work was supported by NSF grant PHY-0842798
The LBNO long-baseline oscillation sensitivities with two conventional neutrino beams at different baselines
The proposed Long Baseline Neutrino Observatory (LBNO) initially consists of
kton liquid double phase TPC complemented by a magnetised iron
calorimeter, to be installed at the Pyh\"asalmi mine, at a distance of 2300 km
from CERN. The conventional neutrino beam is produced by 400 GeV protons
accelerated at the SPS accelerator delivering 700 kW of power. The long
baseline provides a unique opportunity to study neutrino flavour oscillations
over their 1st and 2nd oscillation maxima exploring the behaviour, and
distinguishing effects arising from and matter. In this paper we
show how this comprehensive physics case can be further enhanced and
complemented if a neutrino beam produced at the Protvino IHEP accelerator
complex, at a distance of 1160 km, and with modest power of 450 kW is aimed
towards the same far detectors. We show that the coupling of two independent
sub-MW conventional neutrino and antineutrino beams at different baselines from
CERN and Protvino will allow to measure CP violation in the leptonic sector at
a confidence level of at least for 50\% of the true values of
with a 20 kton detector. With a far detector of 70 kton, the
combination allows a sensitivity for 75\% of the true values of
after 10 years of running. Running two independent neutrino
beams, each at a power below 1 MW, is more within today's state of the art than
the long-term operation of a new single high-energy multi-MW facility, which
has several technical challenges and will likely require a learning curve.Comment: 21 pages, 12 figure
- …