636 research outputs found
Completely monotone regression estimates of software failure rates
A method for estimating the present failure rate of a program is presented. A crude nonparameter estimate of the failure rate function is obtained from past failure times. This estimate is then smoothed by fitting a completely monotonic function, which is the solution of a quadratic programming problem. The value of the smoothed function at present time is used as the estimate of present failure rate. Results of a Monte Carlo study of performance are given
THERMAL PROPERTIES AND HOMOGENITY RANGE OF Bi24+xCo2-xO39 CERAMICS
Samples with different Bi2O3/Co2O3 ratio were prepared by ceramic route. Based on the results of DTA, XRD and SEM – EDX a section of phase diagram of the Bi–Co–O diagram in air atmosphere was calculated using the FactSage software. The sillenite structure of Bi24+xCo2-xO39 was confirmed and described. The Rietveld analysis confirmed SEM – EDX results. The heat capacity and enthalpy increments of Bi24Co2O39 were measured by differential scanning calorimetry (DSC) from 258 K to 355 K and by the drop calorimetry from 573 K to 973 K. Above room temperature the temperature dependence of the molar heat capacity in the form Cpm = (1467.87 + 0.299410 · T – 15888378 · T-2) J K-1 mol-1 was derived by least-squares method from the experimental data
Optical markers of magnetic phase transition in CrSBr
Here, we investigate the role of the interlayer magnetic ordering of CrSBr in
the framework of calculations and by using optical
spectroscopy techniques. These combined studies allow us to unambiguously
determine the nature of the optical transitions. In particular,
photoreflectance measurements, sensitive to the direct transitions, have been
carried out for the first time. We have demonstrated that optically induced
band-to-band transitions visible in optical measurement are remarkably well
assigned to the band structure by the momentum matrix elements and energy
differences for the magnetic ground state (A-AFM). In addition, our study
reveals significant differences in electronic properties for two different
interlayer magnetic phases. When the magnetic ordering of A-AFM to FM is
changed, the crucial modification of the band structure reflected in the
direct-to-indirect band gap transition and the significant splitting of the
conduction bands along the direction are obtained. In addition,
Raman measurements demonstrate a splitting between the in-plane modes
/, which is temperature dependent and can be assigned to
different interlayer magnetic states, corroborated by the DFT+U study.
Moreover, the mode has not been experimentally observed before.
Finally, our results point out the origin of interlayer magnetism, which can be
attributed to electronic rather than structural properties. Our results reveal
a new approach for tuning the optical and electronic properties of van der
Waals magnets by controlling the interlayer magnetic ordering in adjacent
layers.Comment: 33 pages, 15 figure
Postextubation pulmonary edema: A case series and review
SummaryWe report a series of patients with postextubation pulmonary edema who had no obvious risk factors for the development of this syndrome.MethodsPatients identified by the pulmonary consultation service at an academic medical center were reviewed.ResultsFourteen cases were collected and analyzed. The average age was 34.5 years; 12 patients were male. The average BMI was 25.5. None had documented previous lung disease. Most operations were scheduled as outpatient procedures, and the type of surgery ranged from an incision and drainage of a bite wound to an open reduction- internal fixation of the radius. None of the patients had upper airway surgery. The length of surgeries ranged from 27 to 335min. Laryngospasm was the most commonly identified obstructing event postextubation. Treatment involved airway support when needed, supplemental oxygen, and diuretics.ConclusionsIt would appear that all patients, especially young men, are at risk for the development of this syndrome and that the pathogenesis remains uncertain in many cases
Redox-Active Metaphosphate-Like Terminals Enable High-Capacity MXene Anodes for Ultrafast Na-Ion Storage
D transition metal carbides and/or nitrides, so-called MXenes, are noted as ideal fast-charging cation-intercalation electrode materials, which nevertheless suffer from limited specific capacities. Herein, it is reported that constructing redox-active phosphorus−oxygen terminals can be an attractive strategy for NbC MXenes to remarkably boost their specific capacities for ultrafast Na storage. As revealed, redox-active terminals with a stoichiometric formula of PO- display a metaphosphate-like configuration with each P atom sustaining three P-O bonds and one P=O dangling bond. Compared with conventional O-terminals, metaphosphate-like terminals empower NbC (denoted PO-NbC) with considerably enriched carrier density (fourfold), improved conductivity (12.3-fold at 300 K), additional redox-active sites, boosted Nb redox depth, nondeclined Na-diffusion capability, and buffered internal stress during Na intercalation/de-intercalation. Consequently, compared with O-terminated NbC, PO-NbC exhibits a doubled Na-storage capacity (221.0 mAh g), well-retained fast-charging capability (4.9 min at 80% capacity retention), significantly promoted cycle life (nondegraded capacity over 2000 cycles), and justified feasibility for assembling energy−power-balanced Na-ion capacitors. This study unveils that the molecular-level design of MXene terminals provides opportunities for developing simultaneously high-capacity and fast-charging electrodes, alleviating the energy−power tradeoff typical for energy-storage devices
Mendelian randomization of inorganic arsenic metabolism as a risk factor for hypertension- And diabetes-related traits among adults in the Hispanic Community Health Study/Study of Latinos (HCHS/SOL) cohort
Background: Hypertension and diabetes have been associated with inefficient arsenic metabolism, primarily through studies undertaken in populations exposed through drinking water. Recently, rice has been recognized as a source of arsenic exposure, but it remains unclear whether populations with high rice consumption but no known water exposure are at risk for the health problems associated with inefficient arsenic metabolism. Methods: The relationships between arsenic metabolism efficiency (% inorganic arsenic, % monomethylarsenate and % dimethylarsinate in urine) and three hypertension- and seven diabetes-related traits were estimated among 12 609 participants of the Hispanic Community Health Study/Study of Latinos (HCHS/SOL). A two-sample Mendelian randomization approach incorporated genotype-arsenic metabolism relationships from literature, and genotype-trait relationships from HCHS/SOL, with a mixed-effect linear model. Analyses were stratified by rice consumption and smoking. Results: Among never smokers with high rice consumption, each percentage point increase in was associated with increases of 1.96 mmHg systolic blood pressure (P = 0.034) and 1.85 mmHg inorganic arsenic diastolic blood pressure (P = 0.003). Monomethylarsenate was associated with increased systolic (1.64 mmHg/percentage point increase; P = 0.021) and diastolic (1.33 mmHg/percentage point increase; P = 0.005) blood pressure. Dimethylarsinate, a marker of efficient metabolism, was associated with lower systolic (-0.92 mmHg/percentage point increase; P = 0.025) and diastolic (-0.79 mmHg/percentage point increase; P = 0.004) blood pressure. Among low rice consumers and ever smokers, the results were consistent with no association. Evidence for a relationship with diabetes was equivocal. Conclusions: Less efficient arsenic metabolism was associated with increased blood pressure among never smokers with high rice consumption, suggesting that arsenic exposure through rice may contribute to high blood pressure in the Hispanic/Latino community
Stabilization of black phosphorus by sonication-assisted simultaneous exfoliation and functionalization
Black phosphorus (BP) has extraordinary properties, but its ambient instability remains a critical challenge. Functionalization has been employed to overcome the sensitivity of BP to ambient conditions while preserving its properties. Herein, a simultaneous exfoliation–functionalization process is reported that functionalizes BP flakes during exfoliation and thus provides increased protection, which can be attributed to minimal exposure of the flakes to ambient oxygen and water. A tetrabutylammonium salt was employed for intercalation of BP, resulting in the formation of flakes with large lateral dimensions. The addition of an aryl iodide or an aryl iodonium salt to the exfoliation solvent creates a scalable strategy for the production of functionalized few‐layer BP flakes. The ambient stability of functionalized BP was prolonged to a period of one week, as revealed by STEM, AFM, and X‐ray photoelectron spectroscopy
UV to near-IR observations of the DART-Dimorphos collision
The impact of the Double Asteroid Redirection Test (DART) spacecraft with
Dimorphos allows us to study asteroid collision physics, including momentum
transfer, the ejecta properties, and the visibility of such events in the Solar
System. We report observations of the DART impact in the ultraviolet (UV),
visible light, and near-infrared (IR) wavelengths. The observations support the
existence of at least two separate components of the ejecta: a fast and a slow
component. The fast-ejecta component is composed of a gaseous phase, moving at
about 1.6 km/s with a mass of <10^4 kg. The fast ejecta is detected in the UV
and visible light, but not in the near-IR -band observations. Fitting a
simplified optical thickness model to these observations allows us to constrain
some of the properties of the fast ejecta, including its scattering efficiency
and the opacity of the gas. The slow ejecta component is moving at typical
velocities of up to about 10 m/s. It is composed of micrometer-size particles,
that have a scattering efficiency, at the direction of the observer, of the
order of 10^-3 and a total mass of about 10^6 kg. The larger particles in the
slow ejecta, whose size is bound to be in the range between ~1 mm to ~1 m,
likely have a scattering efficiency larger than that of the pre-impact Didymos
system.Comment: Submitted to MNRA
Recommended from our members
Interfacial Covalent Bonds Regulated Electron-Deficient 2D Black Phosphorus for Electrocatalytic Oxygen Reactions
Developing resource-abundant and sustainable metal-free bifunctional oxygen electrocatalysts is essential for the practical application of zinc–air batteries (ZABs). 2D black phosphorus (BP) with fully exposed atoms and active lone pair electrons can be promising for oxygen electrocatalysts, which, however, suffers from low catalytic activity and poor electrochemical stability. Herein, guided by density functional theory (DFT) calculations, an efficient metal-free electrocatalyst is demonstrated via covalently bonding BP nanosheets with graphitic carbon nitride (denoted BP-CN-c). The polarized P-N covalent bonds in BP-CN-c can efficiently regulate the electron transfer from BP to graphitic carbon nitride and significantly promote the OOH* adsorption on phosphorus atoms. Impressively, the oxygen evolution reaction performance of BP-CN-c (overpotential of 350 mV at 10 mA cm−2, 90% retention after 10 h operation) represents the state-of-the-art among the reported BP-based metal-free catalysts. Additionally, BP-CN-c exhibits a small half-wave overpotential of 390 mV for oxygen reduction reaction, representing the first bifunctional BP-based metal-free oxygen catalyst. Moreover, ZABs are assembled incorporating BP-CN-c cathodes, delivering a substantially higher peak power density (168.3 mW cm−2) than the Pt/C+RuO2-based ZABs (101.3 mW cm−2). The acquired insights into interfacial covalent bonds pave the way for the rational design of new and affordable metal-free catalysts. © 2021 The Authors. Advanced Materials published by Wiley-VCH Gmb
- …