2,157 research outputs found
Corrosion of simulated bearing components of three bearing steels in the presence of chloride-contaminated lubricant
Corrosion tests were run with AISI 52100, AISI M-50 and AMS 5794 under conditions that simulate the crevice corrosion found in aircraft ball and roller bearings rejected at overhaul for corrosion. Test specimens were fabricated that simulated the contacts of balls or rollers and the raceways. Corrosion cells were assembled in the presence of a lubricant contaminated with water and chloride ions. The cell was then thermally cycled between 339 K (150 F) and 276 K (37 F). The corrosion observed after 14 cycles was that of crevice and pitting corrosion typically found in aircraft bearings. AMS 5749 showed a very slight amount of corrosion. No appreciable differences were noted between AISI 52100 and AISI M-50, but both showed much greater corrosion than AMS 5749. The corrosion pits observed in AISI M-50 appeared to be fewer in number but generally deeper and larger than in AISI 52100
Improving the representational strategies of children in a music-listening and playing task: an intervention-based study.
This intervention-based study focuses on the relation between music and its graphic representation from a meta-representational point of view. It aims to determine whether middle school students show an increase in meta-representational competence (MRC) after an educational intervention. Three classes of 11 to 14-year-old students participated in the teaching experiment: one experimental class (E) and two control classes (C). An intervention on MRC was carried out on the E class during the hours that were allocated for the regular music lessons, while students from the C classes followed the regular music curriculum. E and C classes were given the same pretest and posttest, which measured students' MRC by means of six representational criteria. One month after the posttest, all classes completed a retention test. The results reveal an overall effect in favour of the E group, despite the negative results for two representational criteria. Moreover, the overall gain, to a great extent, was due to a decrease in the score of the C classes, while the gains in the E class were rather small. Theoretical, methodological and educational implications are discussed
suppression in Pb+Pb collisions and broadening
We have analysed the NA50 data, on the centrality dependence of
broadening of 's, in Pb+Pb collisions, at the CERN-SPS. The data were
analysed in a QCD based model, where 's are suppressed in 'nuclear'
medium. Without any free parameter, the model could explain the NA50
broadening data. The data were also analysed in a QGP based threshold model,
where suppression is 100% above a critical density. The QGP based
model could not explain the NA50 broadening data. We have also predicted
the centrality dependence of suppression and broadening at RHIC
energy. Both the models, the QGP based threshold model and the QCD based
nuclear absorption model, predict broadening very close to each other.Comment: The paper was completely revised. The conclusion is also changed. 5
pages, 4 figure
Hidden cusps
International audienceThis paper investigates a situation pointed out in a recent paper, in which a non-singular change of assembly mode of a planar 2-RPR-PR parallel manipulator was realized by encircling a point of multiplicity 4. It is shown that this situation is, in fact, a non-generic one and gives rise to cusps under a small perturbation. Furthermore , we show that, for a large class of singularities of multiplicity 4, there are only two types of stable singularities occurring in a small perturbation: these two types are given by the complex square mapping and the quarto mapping. Incidentally , this paper confirms the fact that, generically, a local non-singular change of solution must be accomplished by encircling a cusp point
Signaling in Secret: Pay-for-Performance and the Incentive and Sorting Effects of Pay Secrecy
Key Findings: Pay secrecy adversely impacts individual task performance because it weakens the perception that an increase in performance will be accompanied by increase in pay; Pay secrecy is associated with a decrease in employee performance and retention in pay-for-performance systems, which measure performance using relative (i.e., peer-ranked) criteria rather than an absolute scale (see Figure 2 on page 5); High performing employees tend to be most sensitive to negative pay-for- performance perceptions; There are many signals embedded within HR policies and practices, which can influence employees’ perception of workplace uncertainty/inequity and impact their performance and turnover intentions; and When pay transparency is impractical, organizations may benefit from introducing partial pay openness to mitigate these effects on employee performance and retention
Correlation measurements in high-multiplicity events
Requirements for correlation measurements in high--multiplicity events are
discussed. Attention is focussed on detection of so--called hot spots,
two--particle rapidity correlations, two--particle momentum correlations (for
quantum interferometry) and higher--order correlations. The signal--to--noise
ratio may become large in the high--multiplicity limit, allowing meaningful
single--event measurements, only if the correlations are due to collective
behavior.Comment: MN 55455, 20 pages, KSUCNR-011-92 and TPI-MINN-92/47-T (revised).
Revised to correct typo in equation (30), and to fill in a few steps in
calculations. Now published as Phys. Rev. C 47 (1993) 232
The Presampler for the Forward and Rear Calorimeter in the ZEUS Detector
The ZEUS detector at HERA has been supplemented with a presampler detector in
front of the forward and rear calorimeters. It consists of a segmented
scintillator array read out with wavelength-shifting fibers. We discuss its
desi gn, construction and performance. Test beam data obtained with a prototype
presampler and the ZEUS prototype calorimeter demonstrate the main function of
this detector, i.e. the correction for the energy lost by an electron
interacting in inactive material in front of the calorimeter.Comment: 20 pages including 16 figure
Hydrodynamical assessment of 200 AGeV collisions
We are analyzing the hydrodynamics of 200 A GeV S+S collisions using a new
approach which tries to quantify the uncertainties arising from the specific
implementation of the hydrodynamical model. Based on a previous
phenomenological analysis we use the global hydrodynamics model to show that
the amount of initial flow, or initial energy density, cannot be determined
from the hadronic momentum spectra. We additionally find that almost always a
sizeable transverse flow deve- lops, which causes the system to freeze out,
thereby limiting the flow velocity in itself. This freeze-out dominance in turn
makes a distinction between a plasma and a hadron resonance gas equation of
state very difficult, whereas a pure pion gas can easily be ruled out from
present data. To complete the picture we also analyze particle multiplicity
data, which suggest that chemical equilibrium is not reached with respect to
the strange particles. However, the over- population of pions seems to be at
most moderate, with a pion chemical potential far away from the Bose
divergence.Comment: 19 pages, 11 figs in separate uuencoded file, for LateX, epsf.tex,
dvips, TPR-94-5 and BNL-(no number yet
Recommended from our members
Strategy Plan A Methodology to Predict the Uniformity of Double-Shell Tank Waste Slurries Based on Mixing Pump Operation
This document presents an analysis of the mechanisms influencing mixing within double-shell slurry tanks. A research program to characterize mixing of slurries within tanks has been proposed. The research program presents a combined experimental and computational approach to produce correlations describing the tank slurry concentration profile (and therefore uniformity) as a function of mixer pump operating conditions. The TEMPEST computer code was used to simulate both a full-scale (prototype) and scaled (model) double-shell waste tank to predict flow patterns resulting from a stationary jet centered in the tank. The simulation results were used to evaluate flow patterns in the tank and to determine whether flow patterns are similar between the full-scale prototype and an existing 1/12-scale model tank. The flow patterns were sufficiently similar to recommend conducting scoping experiments at 1/12-scale. Also, TEMPEST modeled velocity profiles of the near-floor jet were compared to experimental measurements of the near-floor jet with good agreement. Reported values of physical properties of double-shell tank slurries were analyzed to evaluate the range of properties appropriate for conducting scaled experiments. One-twelfth scale scoping experiments are recommended to confirm the prioritization of the dimensionless groups (gravitational settling, Froude, and Reynolds numbers) that affect slurry suspension in the tank. Two of the proposed 1/12-scale test conditions were modeled using the TEMPEST computer code to observe the anticipated flow fields. This information will be used to guide selection of sampling probe locations. Additional computer modeling is being conducted to model a particulate laden, rotating jet centered in the tank. The results of this modeling effort will be compared to the scaled experimental data to quantify the agreement between the code and the 1/12-scale experiment. The scoping experiment results will guide selection of parameters to be varied in the follow-on experiments. Data from the follow-on experiments will be used to develop correlations to describe slurry concentration profile as a function of mixing pump operating conditions. This data will also be used to further evaluate the computer model applications. If the agreement between the experimental data and the code predictions is good, the computer code will be recommended for use to predict slurry uniformity in the tanks under various operating conditions. If the agreement between the code predictions and experimental results is not good, the experimental data correlations will be used to predict slurry uniformity in the tanks within the range of correlation applicability
- …