Stress corrosion cracking in Al-Zn-Mg-Cu aluminum alloys in saline environments

Copyright 2013 ASM International. This paper was published in Metallurgical and Materials Transactions A, 44A(3), 1230 - 1253, and is made available as an electronic reprint with the permission of ASM International. One print or electronic copy may be made for personal use only. Systematic or multiple reproduction, distribution to multiple locations via electronic or other means, duplications of any material in this paper for a fee or for commercial purposes, or modification of the content of this paper are prohibited.Stress corrosion cracking of Al-Zn-Mg-Cu (AA7xxx) aluminum alloys exposed to saline environments at temperatures ranging from 293 K to 353 K (20 °C to 80 °C) has been reviewed with particular attention to the influences of alloy composition and temper, and bulk and local environmental conditions. Stress corrosion crack (SCC) growth rates at room temperature for peak- and over-aged tempers in saline environments are minimized for Al-Zn-Mg-Cu alloys containing less than ~8 wt pct Zn when Zn/Mg ratios are ranging from 2 to 3, excess magnesium levels are less than 1 wt pct, and copper content is either less than ~0.2 wt pct or ranging from 1.3 to 2 wt pct. A minimum chloride ion concentration of ~0.01 M is required for crack growth rates to exceed those in distilled water, which insures that the local solution pH in crack-tip regions can be maintained at less than 4. Crack growth rates in saline solution without other additions gradually increase with bulk chloride ion concentrations up to around 0.6 M NaCl, whereas in solutions with sufficiently low dichromate (or chromate), inhibitor additions are insensitive to the bulk chloride concentration and are typically at least double those observed without the additions. DCB specimens, fatigue pre-cracked in air before immersion in a saline environment, show an initial period with no detectible crack growth, followed by crack growth at the distilled water rate, and then transition to a higher crack growth rate typical of region 2 crack growth in the saline environment. Time spent in each stage depends on the type of pre-crack (“pop-in” vs fatigue), applied stress intensity factor, alloy chemistry, bulk environment, and, if applied, the external polarization. Apparent activation energies (E a) for SCC growth in Al-Zn-Mg-Cu alloys exposed to 0.6 M NaCl over the temperatures ranging from 293 K to 353 K (20 °C to 80 °C) for under-, peak-, and over-aged low-copper-containing alloys (~0.8 wt pct), they are typically ranging from 20 to 40 kJ/mol for under- and peak-aged alloys, and based on limited data, around 85 kJ/mol for over-aged tempers. This means that crack propagation in saline environments is most likely to occur by a hydrogen-related process for low-copper-containing Al-Zn-Mg-Cu alloys in under-, peak- and over-aged tempers, and for high-copper alloys in under- and peak-aged tempers. For over-aged high-copper-containing alloys, cracking is most probably under anodic dissolution control. Future stress corrosion studies should focus on understanding the factors that control crack initiation, and insuring that the next generation of higher performance Al-Zn-Mg-Cu alloys has similar longer crack initiation times and crack propagation rates to those of the incumbent alloys in an over-aged condition where crack rates are less than 1 mm/month at a high stress intensity factor

The road to deterministic matrices with the restricted isometry property

The restricted isometry property (RIP) is a well-known matrix condition that provides state-of-the-art reconstruction guarantees for compressed sensing. While random matrices are known to satisfy this property with high probability, deterministic constructions have found less success. In this paper, we consider various techniques for demonstrating RIP deterministically, some popular and some novel, and we evaluate their performance. In evaluating some techniques, we apply random matrix theory and inadvertently find a simple alternative proof that certain random matrices are RIP. Later, we propose a particular class of matrices as candidates for being RIP, namely, equiangular tight frames (ETFs). Using the known correspondence between real ETFs and strongly regular graphs, we investigate certain combinatorial implications of a real ETF being RIP. Specifically, we give probabilistic intuition for a new bound on the clique number of Paley graphs of prime order, and we conjecture that the corresponding ETFs are RIP in a manner similar to random matrices.Comment: 24 page

Hysteretic giant magnetoimpedance effect analyzed by first-order reversal curves

Hysteretic giant magnetoimpedance (GMI) of amorphous ribbons with a well-defined transversal domain structure is investigated by means of first-order reversal curves (FORC) analysis. The FORCs are not confined to the hysteretic area, exceeding the major curve amplitude. Irreversible switches of the transverse permeability, caused by domain wall structure transitions, may be the origin of the observed FORC distribution. An interlinked hysteron/anti-hysteron model is proposed to interpret it, which allows analyzing the influence of frequency and magnetostriction upon the hysteretic GMI effect.Comment: 19 pages, 9 figure

Mid- And Late-Life Leisure-Time Physical Activity and Global Brain Amyloid Burden- And Atherosclerosis Risk in Communities (ARIC)-PET Study

Background: Physical activity (PA) may slow the development of dementia by reducing the accumulation of amyloid. Objective: We tested the hypothesis that higher levels of leisure-time PA in mid- or late-life were associated with lower brain amyloid burden in late-life among 326 non-demented participants from the Atherosclerosis Risk in Communities Study of brain florbetapir positron emission tomography (ARIC-PET) ancillary. Methods: Self-reported PA was quantified using a past-year recall, interviewer-administered questionnaire in mid-life (1987-1989, aged 45-64 years) and late-life (2011-2013, aged 67-89 years). Continuous PA estimates were classified as 1) any leisure-time PA participation (yes/no); 2) meeting the 2018 United States' PA guidelines (yes/no); and 3) per 1 standard deviation (SD) higher metabolic equivalent of task (MET) minutes per week (MET min wk-1). A brain magnetic resonance imaging scan with Florbetapir PET was performed in late-life. Adjusted odds ratios (OR) of elevated amyloid burden, defined as a global cortical standardized uptake value ratio (>1.2), compared to no elevated amyloid burden were estimated according to PA measures. Results: Among the 326 participants (mean age: 76 years, 42% male, 41% Black), 52% had elevated brain amyloid burden. Mid-life leisure-time PA did not show a statistically significant lower odds of elevated late-life amyloid burden (OR = 0.71, 95% CI: 0.43-1.18). A 1 SD (970 MET. min. wk-1) higher PA level in mid-life was also not significantly associated with elevated amyloid burden (OR = 0.89, 95% CI: 0.69-1.15). Similar estimates were observed for meeting versus not meeting PA guidelines in both mid- and late-life. Conclusion: Self-reported higher mid- and late-life leisure-time PA were not significantly associated with lower amyloid burden. Data show a trend of an association, which is, however, imprecise, suggesting replication in larger studies

Primordial Nucleosynthesis Constraints on Z' Properties

In models involving new TeV-scale Z' gauge bosons, the new U(1)' symmetry often prevents the generation of Majorana masses needed for a conventional neutrino seesaw, leading to three superweakly interacting ``right-handed'' neutrinos nu_R, the Dirac partners of the ordinary neutrinos. These can be produced prior to big bang nucleosynthesis by the Z' interactions, leading to a faster expansion rate and too much ^4He. We quantify the constraints on the Z' properties from nucleosynthesis for Z' couplings motivated by a class of E_6 models parametrized by an angle theta_E6. The rate for the annihilation of three approximately massless right-handed neutrinos into other particle pairs through the Z' channel is calculated. The decoupling temperature, which is higher than that of ordinary left-handed neutrinos due to the large Z' mass, is evaluated, and the equivalent number of new doublet neutrinos Delta N_nu is obtained numerically as a function of the Z' mass and couplings for a variety of assumptions concerning the Z-Z' mixing angle and the quark-hadron transition temperature T_c. Except near the values of theta_E6 for which the Z' decouples from the right-handed neutrinos, the Z' mass and mixing constraints from nucleosynthesis are much more stringent than the existing laboratory limits from searches for direct production or from precision electroweak data, and are comparable to the ranges that may ultimately be probed at proposed colliders. For the case T_c = 150 MeV with the theoretically favored range of Z-Z' mixings, Delta N_nu 4.3 TeV for any value of theta_E6. Larger mixing or larger T_c often lead to unacceptably large Delta N_nu except near the nu_R decoupling limit.Comment: 22 pages, 5 figures; two additional references adde

Influence of Anodic Conditions on Self-ordered Growth of Highly Aligned Titanium Oxide Nanopores

Self-aligned nanoporous TiO2templates synthesized via dc current electrochemical anodization have been carefully analyzed. The influence of environmental temperature during the anodization, ranging from 2 °C to ambient, on the structure and morphology of the nanoporous oxide formation has been investigated, as well as that of the HF electrolyte chemical composition, its concentration and their mixtures with other acids employed for the anodization. Arrays of self-assembled titania nanopores with inner pores diameter ranging between 50 and 100 nm, wall thickness around 20–60 nm and 300 nm in length, are grown in amorphous phase, vertical to the Ti substrate, parallel aligned to each other and uniformly disordering distributed over all the sample surface. Additional remarks about the photoluminiscence properties of the titania nanoporous templates and the magnetic behavior of the Ni filled nanoporous semiconductor Ti oxide template are also included

Calibration of activity-related energy expenditure in the Hispanic Community Health Study/Study of Latinos (HCHS/SOL)

Objectives: Usual physical activity (PA) is a complex exposure and typical instruments to measure aspects of PA are subject to measurement error, from systematic biases and biological variability. This error can lead to biased estimates of associations between PA and health outcomes. We developed a calibrated physical activity measure that adjusts for measurement error in both self-reported and accelerometry measures of PA in adults from the US Hispanic Community Health Study/Study of Latinos (HCHS/SOL), a community-based cohort study. Design: Total energy expenditure (TEE) from doubly labeled water and resting energy expenditure (REE) from indirect calorimetry were measured in 445 men and women aged 18–74 years in 2010–2012, as part of the HCHS/SOL Study of Latinos: Nutrition & Physical Activity Assessment Study (SOLNAS). Measurements were repeated in a subset (N = 98) 6 months later. Method: Calibration equations for usual activity-related energy expenditure (AEE = 0.90 × TEE-REE) were developed by regressing this objective biomarker on self-reported PA and sedentary behavior, Actical accelerometer PA, and other subject characteristics. Results: Age, weight and height explained a significant amount of variation in AEE. Actical PA and wear-time were important predictors of AEE; whereas, self-reported PA was not independently associated with AEE. The final calibration equation explained fifty percent of variation in AEE. Conclusions: The developed calibration equations can be used to obtain error-corrected associations between PA and health outcomes in HCHS/SOL. Our study represents a unique opportunity to understand the measurement characteristics of PA instruments in an under-studied Hispanic/Latino cohort

Specific detection of fungal pathogens by 18S rRNA gene PCR in microbial keratitis

<p>Abstract</p> <p>Background</p> <p>The sensitivity and specificity of 18S rRNA polymerase chain reaction (PCR) in the detection of fungal aetiology of microbial keratitis was determined in thirty patients with clinical diagnosis of microbial keratitis.</p> <p>Methods</p> <p>Corneal scrapings from patients were used for Gram stain, culture and PCR analysis. PCR was performed with primer pairs targeted to the 18S rRNA gene. The result of the PCR was compared with conventional culture and Gram staining method. The PCR positive samples were identified by DNA sequencing of the internal transcribed spacer (ITS) region of the rRNA gene. Main outcome measures were sensitivity and specificity of PCR in the detection of fungus in corneal keratitis.</p> <p>Results</p> <p>Combination of microscopy and culture gave a positive result in 11 of 30 samples of microbial keratitis. PCR detected 10 of 11 samples that were positive by conventional method. One of the 19 samples that was negative by conventional method was positive by PCR. Statistical analysis revealed that the PCR to have a sensitivity of 90.9% and specificity of 94.7% in the detection of a fungal aetiology in microbial keratitis.</p> <p>Conclusion</p> <p>PCR is a rapid, sensitive and useful method to detect fungal aetiology in microbial keratitis.</p

The role of emotions on consumers’ satisfaction within the fitness context

Previous studies have suggested that consumption-related emotions are important to understand post-purchase reactions. This study examines the relationship between fitness consumers’ emotions and overall satisfaction. After an initial step of free-thought listing and content validity, followed by a pre-test, a survey was conducted among consumers of five different fitness centers (n=786). The questionnaire included measures to assess positive and negative emotions, as well as overall satisfaction with the fitness center. The results gathered through a structural equation model provide evidence that negative emotion experienced by consumers impacts negatively overall satisfaction, while positive emotion have a positive effect on overall satisfaction. These findings suggest managerial implications, such as the need to collect consumers’ perceptions of both tangible and intangible aspects of the services, listen costumers’ opinions in a regular basis, and provide regular training to staff members, in order to identify the triggers of positive emotions and contribute to increased levels of overall satisfaction. Guidelines for future research within the fitness context are also suggested.Estudos precedentes sugerem que as emoções relacionadas com o consumo são importantes para compreender as reações dos consumidores após a compra. Este estudo analisa a relação entre as emoções dos consumidores de fitness e satisfação global. Depois de uma etapa inicial de listagem de pensamento-livre e validade de conteúdo, seguido de um pré-teste, foi realizada uma pesquisa entre os consumidores de cinco centros de fitness diferentes (n = 786). O questionário incluiu medidas para avaliar as emoções positivas e negativas, bem como a satisfação global com o centro de fitness. Os resultados obtidos através de um modelo de equações estruturais forneceram evidências de que as emoções negativas vivenciadas pelos consumidores impactam negativamente a satisfação global, enquanto as emoções positivas têm um efeito positivo sobre a satisfação global. Estes resultados sugerem implicações para os gestores, tais como a necessidade de recolher informação sobre a perceção dos consumidores dos aspetos tangíveis e intangíveis dos serviços, ouvir regularmente as opiniões dos consumidores e facultar formação regular aos colaboradores. Isto permitirá identificar os aspetos que desencadeiam emoções positivas e contribuir para o aumento dos níveis de satisfação global. Orientações para futuras pesquisas no contexto de fitness também são sugeridas.Sin financiación0.185 SJR (2015) Q3, 1090/1779 Medicine (miscellaneous); Q4, 177/229 Health (social science), 112/128 Sports scienceUE