Spin-tunnel investigation of a 1/13-scale model of the NASA AD-1 oblique-wing research aircraft

The spin and recovery characteristics of a 1/13-scale model of the NASA AD-1 oblique-wing research aircraft at wing-skew positions of 0, 25, 45, and 60 deg (right wing forward) were investigated. Spins were obtained for all wing-skew positions tested. For the unskewed wing position, two spin modes were possible. One spin mode was very steep and recoveries were obtained within 1 turn or less by rudder reversal. The second spin mode was flat and fast; the angle of attack was about 75 deg and the spin rate was about 145 deg/sec (2.5 seconds per turn). For the skewed wing positions, spins were obtained only in the direction of the forward-skewed wing (right wing forward). No spins were obtained to the left when the wing was skewed with the right wing forward. Recoveries should be attempted by deflecting the rudder to full against the spin, the ailerons to full with the spin, and movement of the wings to 0 deg skew. If the wing is skewed, the recovery may not be effected until the wing skew approaches 0 deg

Spin-Tunnel Investigation of the Spinning Characteristics of Typical Single-Engine General Aviation Airplane Designs. 1. Low-Wing Model A: Effects of Tail Configurations

The effects of tail design on spin and recovery were investigated in a spin tunnel. A 1/11-scale model of a research airplane which represents a typical low-wing, single engine, light general aviation airplane was used. A tail design criterion for satisfactory spin recovery for light airplanes was evaluated. The effects of other geometric design features on the spin and recovery characteristics were also determined. Results indicate that the existing tail design criterion for light airplanes, which uses the tail damping power factor as a parameter, cannot be used to predict spin-recovery characteristics

Spin-tunnel investigation of the spinning characteristics of typical single-engine general aviation airplane designs. 2: Low-wing model A; tail parachute diameter and canopy distance for emergency spin recovery

A spin tunnel study is reported on a scale model of a research airplane typical of low-wing, single-engine, light general aviation airplanes to determine the tail parachute diameter and canopy distance (riser length plus suspension-line length) required for energency spin recovery. Nine tail configurations were tested, resulting in a wide range of developed spin conditions, including steep spins and flat spins. The results indicate that the full-scale parachute diameter required for satisfactory recovery from the most critical conditions investigated is about 3.2 m and that the canopy distance, which was found to be critical for flat spins, should be between 4.6 and 6.1 m

Consumer Sensitivity to Interest Rates: An Empirical Study of New Car Buyers and Auto Loans

ALTHOUGH it has never been clear whether the consumer needs to be protected from his own folly or from the rapaciousness of those who feed on him, consumer protection is a topic of intense current interest in the courts, in the legislatures, and in the law schools. A number of recent court decisions have attempted to attack problems confronting the consumer; unfortunately, these judicial efforts have succeeded primarily in disclosing the limitations in the courts\u27 ability to deal with such problems. State and federal legislative bodies have pursued more carefully designed remedies. Congress has passed the Truth-in-Lending Act; the National Conference of Commissioners on Uniform State Laws has proposed the Uniform Consumer Credit Code; and many states have enacted retail installment sales acts to update and supplement their long-standing usury laws. These legisJative and judicial acts have always relied, at best, on anecdotal knowledge of consumer behavior. In this Article we offer the results of an empirical study of a small slice of consumer behavior in the use of installment credit

Assessment of practicality of remote sensing techniques for a study of the effects of strip mining in Alabama

Because of the volume of coal produced by strip mining, the proximity of mining operations, and the diversity of mining methods (e.g. contour stripping, area stripping, multiple seam stripping, and augering, as well as underground mining), the Warrior Coal Basin seemed best suited for initial studies on the physical impact of strip mining in Alabama. Two test sites, (Cordova and Searles) representative of the various strip mining techniques and environmental problems, were chosen for intensive studies of the correlation between remote sensing and ground truth data. Efforts were eventually concentrated in the Searles Area, since it is more accessible and offers a better opportunity for study of erosional and depositional processes than the Cordova Area

Transcriptional repression by ApiAP2 factors is central to chronic toxoplasmosis

Tachyzoite to bradyzoite development in Toxoplasma is marked by major changes in gene expression resulting in a parasite that expresses a new repertoire of surface antigens hidden inside a modified parasitophorous vacuole called the tissue cyst. The factors that control this important life cycle transition are not well understood. Here we describe an important transcriptional repressor mechanism controlling bradyzoite differentiation that operates in the tachyzoite stage. The ApiAP2 factor, AP2IV-4, is a nuclear factor dynamically expressed in late S phase through mitosis/cytokinesis of the tachyzoite cell cycle. Remarkably, deletion of the AP2IV-4 locus resulted in the expression of a subset of bradyzoite-specific proteins in replicating tachyzoites that included tissue cyst wall components BPK1, MCP4, CST1 and the surface antigen SRS9. In the murine animal model, the mis-timing of bradyzoite antigens in tachyzoites lacking AP2IV-4 caused a potent inflammatory monocyte immune response that effectively eliminated this parasite and prevented tissue cyst formation in mouse brain tissue. Altogether, these results indicate that suppression of bradyzoite antigens by AP2IV-4 during acute infection is required for Toxoplasma to successfully establish a chronic infection in the immune-competent host

Analysis of simulated multispectral data from earth resources satellites

The validity of the applicability assumption was determined through the simulation of ERTS and Skylab data using available aircraft scanner systems. The research techniques compared aircraft multispectral scanner data obtained under nominal conditions at low altitudes. Maximum likelihood decision criteria algorithms implemented on a digital computer were used to classify training set data. Comparisons between percentages of correct classifications were made, along with implications as to the techniques of satellite analysis

The Hubble Space Telescope high speed photometer

The Hubble Space Telescope will provide the opportunity to perform precise astronomical photometry above the disturbing effects of the atmosphere. The High Speed Photometer is designed to provide the observatory with a stable, precise photometer with wide dynamic range, broad wavelenth coverage, time resolution in the microsecond region, and polarimetric capability. Here, the scientific requirements for the instrument are examined, the unique design features of the photometer are explored, and the improvements to be expected over the performance of ground-based instruments are projected

A Two-dimensional Infinte System Density Matrix Renormalization Group Algorithm

It has proved difficult to extend the density matrix renormalization group technique to large two-dimensional systems. In this Communication I present a novel approach where the calculation is done directly in two dimensions. This makes it possible to use an infinite system method, and for the first time the fixed point in two dimensions is studied. By analyzing several related blocking schemes I find that there exists an algorithm for which the local energy decreases monotonically as the system size increases, thereby showing the potential feasibility of this method.Comment: 5 pages, 6 figure

Scanning Electron Microscopic Examination of Intracanal Wall Dentin: Hand Versus Laser Treatment

Conventional cleaning and shaping of root canal spaces involves the use of hand and rotary instruments with irrigation. The procedure results in the formation of a smear layer consisting of dentin shavings, organic tissue remnants and microorganisms. The laser has been suggested as an aid in root canal preparation. In this study, pulsed and continuous wave 1.06 μm wavelength Nd:YAG lasers were used to compare their abilities to clean and shape root canal spaces to conventional methods. After preparation, the test teeth were sectioned longitudinally and examined by scanning electron microscopy. The results demonstrated that the laser was capable of removing the smear layer in its entirety and could occasionally alter dentin walls