272 research outputs found
The influence of oxidative-thermal degradation of polypropylene on measured interface strength of glass fibre-polypropylene
It was previously found that thermal-oxidative degradation of the polypropylene could significantly affect the measured interfacial strength of glass fibre reinforced polypropylene (GF-PP) micro-composite. In this work, different approaches have been employed to justify this influence. Hot-stage microscopy was used to establish a degradation profile of PP microdroplets that had different initial dimensions and results revealed that the reduction in droplet dimensions was affected by not only its initial droplet size and but also the presence of the fibre in the droplet. The Young's moduli of PP microdroplets with different heat treatments were examined by using nanoindentation technique and the results showed that there was significant stiffness deterioration in degraded samples and the severity is also related to the droplet size for a given heat treatment. Comparison of adhesion for GF-PP was also made between degraded and non-degraded samples. It shows that non-degraded samples give much higher values for interface strength of GF-PP than degraded ones
Structural Strength and Service Life of the Extrusion Forming Die for Agricultural Engine Piston Heads
Three-tier high-strength prestressed combination concave dies are designed to manifacture highpower corn combine harvester engine piston heads. This design integrates the advantages of traditional casting or hot die forging and warm extrusion. The following key parameters, viz radial dimensions of each mating layer, axial bonding and radial contact interaction, are obtained by theoretical calculation. Nonlinear analysis of the contact interaction was carried out, and the die contact condition was studied at no-load and full-load. Based on the Archard wear theory, thermomechanical bonding was studied in operation of the die. Through numerical simulation of the die wear in each operation cycle, the univariate linear regression equation of the die service life was derived, and the reliability of this equation was verified. The results show that the die contact is both stable and reliable if the radial contact interaction of the inner and outer layers is δ₂= 1.9716 mm and δ₃= 1.3870 mm, respectively. With the nitriding layer thickness of 0.24 mm, the extrusion die service life in the production of piston heads corresponds to 6357 pieces.Разработаны трехъярусные высокопрочные предварительно-напряженные многоместные вогнутые головки для изготовления днищ поршня двигателя мощного кукурузоуборочного комбайна. Конструкция соединяет в себе преимущества литья или горячей ковки и горячей экструзии. Радиальные размеры каждого соединяемого слоя, осевое сцепление и радиальное контактное взаимодействие рассчитаны теоретически. Выполнен нелинейный анализ контактного взаимодействия, изучены условия контактирования в головке при нулевой и полной нагрузке. На основании теории износа Арчарда выполнена оценка термомеханического сцепления в процессе эксплуатации головки. Путем численного моделирования износа головки в каждом рабочем цикле получено однопараметрическое уравнение линейной регрессии для срока ее службы; проверена достоверность данного уравнения. Показано, что контакт в головке устойчив и надежен, при радиальном контактном взаимодействии внутреннего и наружного слоев δ₂= 1.9716 мм и δ₃= 1.3870 мм соответственно. При толщине нитридного слоя 0,24 мм срок службы экструзионной головки в производстве днищ поршня соответствует 6357 изделиям
Pion-Muon Asymmetry Revisited
Long ago an unexpected and unexplainable phenomena was observed. The
distribution of muons from positive pion decay at rest was anisotropic with an
excess in the backward direction relative to the direction of the proton beam
from which the pions were created. Although this effect was observed by several
different groups with pions produced by different means, the result was not
accepted by the physics community, because it is in direct conflict with a
large set of other experiments indicating that the pion is a pseudoscalar
particle. It is possible to satisfy both sets of experiments if helicity-zero
vector particles exist and the pion is such a particle. Helicity-zero vector
particles have direction but no net spin. For the neutral pion to be a vector
particle requires an additional modification to conventional theory as
discussed herein. An experiment is proposed which can prove that the asymmetry
in the distribution of muons from pion decay is a genuine physical effect
because the asymmetry can be modified in a controllable manner. A positive
result will also prove that the pion is NOT a pseudoscalar particle.Comment: 9 pages, 3 figure
Multi-gap superconductivity in a BaFe1.84Co0.16As2 film from optical measurements at terahertz frequencies
We measured the THz reflectance properties of a high quality epitaxial thin
film of the Fe-based superconductor BaFeCoAs with
T=22.5 K. The film was grown by pulsed laser deposition on a DyScO
substrate with an epitaxial SrTiO intermediate layer. The measured
spectrum, i.e. the reflectivity ratio between the superconducting and
normal state reflectance, provides clear evidence of a superconducting gap
close to 15 cm. A detailed data analysis shows that a
two-band, two-gap model is absolutely necessary to obtain a good description of
the measured spectrum. The low-energy gap results to be
well determined (=15.50.5 cm), while the value of the
high-energy gap is more uncertain (=557 cm).
Our results provide evidence of a nodeless isotropic double-gap scenario, with
the presence of two optical gaps corresponding to 2 values close
to 2 and 7.Comment: Published Versio
A Study of Cosmic Ray Secondaries Induced by the Mir Space Station Using AMS-01
The Alpha Magnetic Spectrometer (AMS-02) is a high energy particle physics
experiment that will study cosmic rays in the to range and will be installed on the International Space Station
(ISS) for at least 3 years. A first version of AMS-02, AMS-01, flew aboard the
space shuttle \emph{Discovery} from June 2 to June 12, 1998, and collected
cosmic ray triggers. Part of the \emph{Mir} space station was within the
AMS-01 field of view during the four day \emph{Mir} docking phase of this
flight. We have reconstructed an image of this part of the \emph{Mir} space
station using secondary and emissions from primary cosmic rays
interacting with \emph{Mir}. This is the first time this reconstruction was
performed in AMS-01, and it is important for understanding potential
backgrounds during the 3 year AMS-02 mission.Comment: To be submitted to NIM B Added material requested by referee. Minor
stylistic and grammer change
Protons in near earth orbit
The proton spectrum in the kinetic energy range 0.1 to 200 GeV was measured
by the Alpha Magnetic Spectrometer (AMS) during space shuttle flight STS-91 at
an altitude of 380 km. Above the geomagnetic cutoff the observed spectrum is
parameterized by a power law. Below the geomagnetic cutoff a substantial second
spectrum was observed concentrated at equatorial latitudes with a flux ~ 70
m^-2 sec^-1 sr^-1. Most of these second spectrum protons follow a complicated
trajectory and originate from a restricted geographic region.Comment: 19 pages, Latex, 7 .eps figure
Search for antihelium in cosmic rays
The Alpha Magnetic Spectrometer (AMS) was flown on the space shuttle
Discovery during flight STS-91 in a 51.7 degree orbit at altitudes between 320
and 390 km. A total of 2.86 * 10^6 helium nuclei were observed in the rigidity
range 1 to 140 GV. No antihelium nuclei were detected at any rigidity. An upper
limit on the flux ratio of antihelium to helium of < 1.1 * 10^-6 is obtained.Comment: 18 pages, Latex, 9 .eps figure
Cosmic-ray positron fraction measurement from 1 to 30 GeV with AMS-01
A measurement of the cosmic ray positron fraction e+/(e+ + e-) in the energy range of 1-30 GeV is presented. The measurement is based on data taken by the AMS-01 experiment during its 10 day Space Shuttle flight in June 1998. A proton background suppression on the order of 10^6 is reached by identifying converted bremsstrahlung photons emitted from positrons
Consumo e digestibilidade aparente total em bovinos sob suplementação com enzimas fibrolíticas
- …