An Investigation of Waste Glass-Based Geopolymers Supplemented with Alumina

An increased consideration of sustainability throughout society has resulted in a surge of research investigating sustainable alternatives to existing construction materials. A new binder system, called a geopolymer, is being investigated to supplement ordinary portland cement (OPC) concrete, which has come under scrutiny because of the CO2 emissions inherent in its production. Geopolymers are produced from the alkali activation of a powdered aluminosilicate source by an alkaline solution, which results in a dense three-dimensional matrix of tetrahedrally linked aluminosilicates. Geopolymers have shown great potential as a building construction material, offering similar mechanical and durability properties to OPC. Additionally, geopolymers have the added value of a considerably smaller carbon footprint than OPC. This research considered the compressive strength, microstructure and composition of geopolymers made from two types of waste glass with varying aluminum contents. Waste glass shows great potential for mainstream use in geopolymers due to its chemical and physical homogeneity as well as its high content of amorphous silica, which could eliminate the need for sodium silicate. However, the lack of aluminum is thought to negatively affect the mechanical performance and alkali stability of the geopolymer system. Mortars were designed using various combinations of glass and metakaolin or fly ash to supplement the aluminum in the system. Mortar made from the high-Al glass (12% Al2O3) reached over 10,000 psi at six months. Mortar made from the low-Al glass (\u3c1% Al2O3) did not perform as well and remained sticky even after several weeks of curing, most likely due to the lack of Al which is believed to cause hardening in geopolymers. A moderate metakaolin replacement (25-38% by mass) was found to positively affect the compressive strength of mortars made with either type of glass. Though the microstructure of the mortar was quite indicative of mechanical performance, composition was also found to be important. The initial stoichiometry of the bulk mixture was maintained fairly closely, especially in mixtures made with fine glass. This research has shown that glass has great potential for use in geopolymers, when care is given to consider the compositional and physical properties of the glass in mixture design

A Danish Nonsense Syllable Speech Material

Nonsense syllable speech materials are often used when investigating speech perception in quiet and under adverse conditions. The main advantage of using nonsense syllables over words and sentences is that the acoustic as well as linguistic context is minimal. This paper describes the considerations involved in producing three anechoic recordings of 14 male and 14 female native talkers of Danish each speaking 65 nonsense syllables repeated three times with falling F0 (total of 16380 syllables)

N=2-Maxwell-Chern-Simons model with anomalous magnetic moment coupling via dimensional reduction

An N=1--supersymmetric version of the Cremmer-Scherk-Kalb-Ramond model with non-minimal coupling to matter is built up both in terms of superfields and in a component-field formalism. By adopting a dimensional reduction procedure, the N=2--D=3 counterpart of the model comes out, with two main features: a genuine (diagonal) Chern-Simons term and an anomalous magnetic moment coupling between matter and the gauge potential.Comment: 15 pages, Latex; one reference corrected; To be published in the Int. J. Mod. Phys.

Self-dual vortices in a Maxwell-Chern-Simons model with non-minimal coupling

We find self-dual vortex solutions in a Maxwell-Chern-Simons model with anomalous magnetic moment. From a recently developed N=2-supersymmetric extension, we obtain the proper Bogomol'nyi equations together with a Higgs potential allowing both topological and non-topological phases in the theory.Comment: 12 pages, 9 figures, 2 tables; some typos corrected, one reference updated. To be published in the Int. J. Mod. Phys. A (1999

Exact Periodic Solutions of Shells Models of Turbulence

We derive exact analytical solutions of the GOY shell model of turbulence. In the absence of forcing and viscosity we obtain closed form solutions in terms of Jacobi elliptic functions. With three shells the model is integrable. In the case of many shells, we derive exact recursion relations for the amplitudes of the Jacobi functions relating the different shells and we obtain a Kolmogorov solution in the limit of infinitely many shells. For the special case of six and nine shells, these recursions relations are solved giving specific analytic solutions. Some of these solutions are stable whereas others are unstable. All our predictions are substantiated by numerical simulations of the GOY shell model. From these simulations we also identify cases where the models exhibits transitions to chaotic states lying on strange attractors or ergodic energy surfaces.Comment: 25 pages, 7 figure

Towards fully integrated photonic displacement sensors

Funding: European Union Horizon 2020 research and innovation programme under the Future and Emerging Technologies Open grant agreement Super-pixels No 829116.The field of optical metrology with its high precision position, rotation and wavefront sensors represents the basis for lithography and high resolution microscopy. However, the on-chip integration a task highly relevant for future nanotechnological devices necessitates the reduction of the spatial footprint of sensing schemes by the deployment of novel concepts. A promising route towards thisgoal is predicated on the controllable directional emission of the fundamentally smallest emitters of light, i.e. dipoles, as an indicator. Here we realize an integrated displacement sensor based on the directional emission of Huygens dipoles excited in an individual dipolar antenna. The position of the antenna relative to the excitation field determines its directional coupling into a six-way crossing of photonic crystal waveguides. In our experimental study supported by theoretical calculations, we demonstrate the first prototype of an integrated displacement sensor with a standard deviation of the position accuracy below λ=300 at room temperature and ambient conditions.Publisher PDFPeer reviewe

EffectS of non-nutritive sWeetened beverages on appetITe during aCtive weigHt loss (SWITCH): Protocol for a randomized, controlled trial assessing the effects of non-nutritive sweetened beverages compared to water during a 12-week weight loss period and a follow up weight maintenance period

Background Acute and medium-term intervention studies suggest that non-nutritive sweeteners (NNS) are beneficial for weight loss, however there is limited human data on the long-term effects of consuming NNS on weight loss, maintenance, and appetite. Further research is therefore required to elucidate the prolonged impact of NNS consumption on these outcome measures. Methods/design A randomized parallel groups design will be used to assess whether regular NNS beverage intake is equivalent to a water control in promoting weight loss over 12-weeks (weekly weight loss sessions; Phase I), then supporting weight maintenance over 40-weeks (monthly sessions; Phase II) and subsequently independent weight maintenance over 52-weeks (Phase III) in 432 participants. A subset of these participants (n = 116) will complete laboratory-based appetite probe days (15 sessions; 3 sessions each at baseline, at the start of phase I and the end of each phase). A separate subset (n = 50) will complete body composition scans (DXA) at baseline and at the end of each phase. All participants will regularly be weighed and will complete questionnaires and cognitive tasks to assess changes in body weight and appetitive behaviours. Measures of physical activity and biochemical markers will also be taken. Discussion The trial will assess the efficacy of NNS beverages compared to water during a behavioural weight loss and maintenance programme. We aim to understand whether the impact of NNS on weight, dietary adherence and well-being are beneficial or transient and effects on prolonged successful weight loss and weight maintenance through sustained changes in appetite and eating behaviour. Trial registration: Clinical Trials: NCT02591134; registered: 23.10.201

Plasma level of mannose-binding lectin is associated with the risk of recurrent pregnancy loss but not pregnancy outcome after the diagnosis

STUDY QUESTION: Are low or high plasma mannose-binding lectin (p-MBL) levels associated with recurrent pregnancy loss (RPL) and the reproductive and perinatal outcomes before and after RPL? SUMMARY ANSWER: The prevalence of low p-MBL levels was significantly higher in RPL patients, while high levels were significantly less prevalent. No association was found between p-MBL level and reproductive and perinatal outcomes before and after RPL. WHAT IS KNOWN ALREADY: Mannose-binding lectin (MBL) is an important component in the innate immune system. Low p-MBL levels have been associated with RPL, while the correlation with high levels has been poorly studied. Adverse perinatal outcomes are generally more frequent among RPL patients, but reports concerning the association between maternal p-MBL levels and perinatal outcomes, including birth weight (BW) and gestational age (GA), are conflicting. STUDY DESIGN, SIZE, DURATION: This study was a combined cross-sectional and cohort study of 267 RPL patients admitted to the RPL Center of Western Denmark between January 2016 and March 2020. RPL patients were followed until birth of a liveborn child or until end of follow-up, March 2021. A sample of 185 healthy female blood donors of reproductive age was used as a MBL reference group. PARTICIPANTS/MATERIALS, SETTING, METHODS: All RPL patients had ≥3 consecutive pregnancy losses, a regular menstrual cycle and no known significant chromosomal or uterine malformations. At the first consultation, routine blood samples including p-MBL measurement and detailed obstetrical and perinatal information were collected. p-MBL levels in RPL patients were compared to the MBL reference group. A logistic regression analysis adjusted for relevant confounders assessed the association between low p-MBL levels and an unsuccessful reproductive outcome in RPL patients in first pregnancy after admission. Perinatal outcomes before and after RPL were compared between RPL subgroups according to low (≤500 µg/l), intermediate (501–3000 µg/l) and high (>3000 µg/l) p-MBL levels. MAIN RESULTS AND THE ROLE OF CHANCE: Significantly more RPL patients had low p-MBL levels (prevalence proportion ratio (PPR): 1.79, 95% CI: 1.34–2.38) and fewer had high p-MBL levels (PPR: 0.56, 95% CI: 0.40–0.79) compared to the reference group, while the prevalence of intermediate p-MBL level was not different between the groups (PPR: 0.86, 95% CI: 0.69–1.08). In the prospective study, low p-MBL level was not a significant risk factor for a pregnancy loss in the first pregnancy after admission after adjustment for age, BMI and smoking. Neither before nor after the RPL diagnosis were maternal p-MBL levels significantly associated with BW or GA. LIMITATIONS, REASONS FOR CAUTION: Only 161 (60.3%) patients had given birth after RPL during the follow-up period, which limited the possibility to detect clear associations between p-MBL levels and perinatal outcomes after RPL. WIDER IMPLICATIONS OF THE FINDINGS: In agreement with several previous studies, low p-MBL levels are strongly associated with RPL, while this study for the first time documents that high levels may play a protective role, which suggests a causal relationship. We suggest that larger prospective studies evaluate the association between p-MBL levels and RPL prognosis. STUDY FUNDING/COMPETING INTEREST(S): No external funding was received. We acknowledge the Department of Obstetrics and Gynaecology at Aalborg University Hospital for financial support. U.S.K. has reported personal fees from Merck, consulting fees from IBSA Nordic, and a grant from Gedeon Richter, Merck and IBSA Nordic outside of the submitted work. TRIAL REGISTRATION NUMBER: ID from clinicaltrials.gov is NCT04017754