70 research outputs found

    Three-dimensional diffraction mapping by tuning the X-ray energy

    Get PDF
    Three-dimensional reciprocal-space maps of a single SiGe island around the Si(004) Bragg peak are recorded using an energy-tuning technique with a microfocused X-ray beam with compound refractive lenses as focusing optics

    Surface morphology and magnetic anisotropy in (Ga,Mn)As

    Full text link
    Atomic Force Microscopy and Grazing incidence X-ray diffraction measurements have revealed the presence of ripples aligned along the [11ˉ0][1\bar{1}0] direction on the surface of (Ga,Mn)As layers grown on GaAs(001) substrates and buffer layers, with periodicity of about 50 nm in all samples that have been studied. These samples show the strong symmetry breaking uniaxial magnetic anisotropy normally observed in such materials. We observe a clear correlation between the amplitude of the surface ripples and the strength of the uniaxial magnetic anisotropy component suggesting that these ripples might be the source of such anisotropy.Comment: 3 pages, 4 figures, 1 table. Replaced with published versio

    X-ray zoom lens allows for energy scans in X-ray microscopy

    Get PDF

    Surface phase transitions in BiFeO3 below room temperature

    Get PDF
    We combine a wide variety of experimental techniques to analyze two heretofore mysterious phase transitions in multiferroic bismuth ferrite at low temperature. Raman spectroscopy, resonant ultrasound spectroscopy, EPR, X-ray lattice constant measurements, conductivity and dielectric response, specific heat and pyroelectric data have been collected for two different types of samples: single crystals and, in order to maximize surface/volume ratio to enhance surface phase transition effects, BiFeO3 nanotubes were also studied. The transition at T=140.3K is shown to be a surface phase transition, with an associated sharp change in lattice parameter and charge density at the surface. Meanwhile, the 201K anomaly appears to signal the onset of glassy behaviour

    Interface Aspects in All‐Solid‐State Li‐Based Batteries Reviewed

    Full text link
    Extensive efforts have been made to improve the Li-ionic conductivity of solid electrolytes (SE) for developing promising all-solid-state Li-based batteries (ASSB). Recent studies suggest that minimizing the existing interface problems is even more important than maximizing the conductivity of SE. Interfaces are essential in ASSB, and their properties significantly influence the battery performance. Interface problems, arising from both physical and (electro)chemical material properties, can significantly inhibit the transport of electrons and Li-ions in ASSB. Consequently, interface problems may result in interlayer formation, high impedances, immobilization of moveable Li-ions, loss of active host sites available to accommodate Li-ions, and Li-dendrite formation, all causing significant storage capacity losses and ultimately battery failures. The characteristic differences of interfaces between liquid- and solid-type Li-based batteries are presented here. Interface types, interlayer origin, physical and chemical structures, properties, time evolution, complex interrelations between various factors, and promising interfacial tailoring approaches are reviewed. Furthermore, recent advances in the interface-sensitive or depth-resolved analytical tools that can provide mechanistic insights into the interlayer formation and strategies to tailor the interlayer formation, composition, and properties are discussed

    Excitation Intensity Driven PL Shifts of SiGe Islands on Patterned and Planar Si(001) Substrates: Evidence for Ge-rich Dots in Islands

    Get PDF
    For randomly nucleated SiGe/Si(001) islands, a significantly stronger blue-shift of the PL spectra as a function of the excitation intensity is observed when compared to islands grown on patterned substrates side by side within the same run in a solid source molecular beam epitaxy chamber. We ascribe this different PL behavior to the much larger inhomogeneity of the Ge distribution in islands on planar substrates when compared to islands grown on pit-patterned ones, as observed previously. 3D band-structure calculations show that Ge-rich inclusions of approximately 5 nm diameter at the apex of the islands can account for the observed differences in the PL spectra. The existence of such inclusions can be regarded as a quantum dot in an island and is in agreement with recent nano-tomography experiments

    Crystal Phase Transitions in the Shell of PbS CdS Core Shell Nanocrystals Influences Photoluminescence Intensity

    Get PDF
    ABSTRACT We reveal the existence of two different crystalline phases, i.e., the metastable rock salt and the equilibrium zinc blende phase within the CdS shell of PbS CdS core shell nanocrystals formed by cationic exchange. The chemical composition profile of the core shell nanocrystals with different dimensions is determined by means of anomalous small angle X ray scattering with subnanometer resolution and is compared to X ray diffraction analysis. We demonstrate that the photoluminescence emission of PbS nanocrystals can be drastically enhanced by the formation of a CdS shell. Especially, the ratio of the two crystalline phases in the shell significantly influences the photoluminescence enhancement. The highest emission was achieved for chemically pure CdS shells below 1 nm thickness with a dominant metastable rock salt phase fraction matching the crystal structure of the PbS core. The metastable phase fraction decreases with increasing shell thickness and increasing Exchange times. The photoluminescence intensity depicts a constant decrease with decreasing metastable rock salt phase fraction but Shows an abrupt drop for shells above 1.3 nm thickness. We relate this effect to two different transition mechanisms for changing from the metastable rock salt phase to the equilibrium zinc blende phase depending on the shell thicknes
    corecore