3,716 research outputs found
Pupil remapping for high contrast astronomy: results from an optical testbed
The direct imaging and characterization of Earth-like planets is among the
most sought-after prizes in contemporary astrophysics, however current optical
instrumentation delivers insufficient dynamic range to overcome the vast
contrast differential between the planet and its host star. New opportunities
are offered by coherent single mode fibers, whose technological development has
been motivated by the needs of the telecom industry in the near infrared. This
paper presents a new vision for an instrument using coherent waveguides to
remap the pupil geometry of the telescope. It would (i) inject the full pupil
of the telescope into an array of single mode fibers, (ii) rearrange the pupil
so fringes can be accurately measured, and (iii) permit image reconstruction so
that atmospheric blurring can be totally removed. Here we present a laboratory
experiment whose goal was to validate the theoretical concepts underpinning our
proposed method. We successfully confirmed that we can retrieve the image of a
simulated astrophysical object (in this case a binary star) though a pupil
remapping instrument using single mode fibers.Comment: Accepted in Optics Expres
Experimental evaluation of compliant surfaces at low speeds
An experimental study was devised to determine the profile drag on a subsonic wind tunnel model partially covered with various compliant surface materials. The model consisted of a large section of constant thickness bounded fore and aft by symmetric airfoil fairings. A flat rigid plate, the control surface, could be exchanged for four contiguous complaint panels. The flexible media generally consisted of thin polyvinylchloride membranes stretched to various tensions over trapped fluid cavities of air, water, or polyethelene oxide solution, or over dry or flooded open-celled polyurethane foams. On the basis of very accurate direct-force cell measurements, all configurations were found to yield profile drags equal to or slightly higher than that obtained for the conventional rigid surface case. The results indicate that the potential for practical drag-reducing applications will be limited to either high-density or high-speed flows where more sensible pressure perturbations occur
The Ages of A-Stars I: Interferometric Observations and Age Estimates for Stars in the Ursa Major Moving Group
We have observed and spatially resolved a set of seven A-type stars in the
nearby Ursa Major moving group with the Classic, CLIMB, and PAVO beam combiners
on the CHARA Array. At least four of these stars have large rotational
velocities ( 170 ) and are expected to
be oblate. These interferometric measurements, the stars' observed photometric
energy distributions, and values are used to computationally
construct model oblate stars from which stellar properties (inclination,
rotational velocity, and the radius and effective temperature as a function of
latitude, etc.) are determined. The results are compared with MESA stellar
evolution models (Paxton et al. 2011, 2013) to determine masses and ages. The
value of this new technique is that it enables the estimation of the
fundamental properties of rapidly rotating stars without the need to fully
image the star. It can thus be applied to stars with sizes comparable to the
interferometric resolution limit as opposed to those that are several times
larger than the limit. Under the assumption of coevality, the spread in ages
can be used as a test of both the prescription presented here and the MESA
evolutionary code for rapidly rotating stars. With our validated technique, we
combine these age estimates and determine the age of the moving group to be 414
23 Myr, which is consistent with, but much more precise than previous
estimates.Comment: Accepted by Ap
Fundamental Properties of Cool Stars with Interferometry
We present measurements of fundamental astrophysical properties of nearby,
low-mass, K- and M-dwarfs from our DISCOS survey (DIameterS of COol Stars). The
principal goal of our study is the determination of linear radii and effective
temperatures for these stars. We calculate their radii from angular diameter
measurements using the CHARA Array and Hipparcos distances. Combined with
bolometric flux measurements based on literature photometry, we use our angular
diameter results to calculate their effective surface temperatures. We present
preliminary results established on an assortment of empirical relations to the
stellar effective temperature and radius that are based upon these
measurements. We elaborate on the discrepancy seen between theoretical and
observed stellar radii, previously claimed to be related to stellar activity
and/or metallicity. Our preliminary conclusion, however, is that convection
plays a larger role in the determination of radii of these late-type stars.
Understanding the source of the radius disagreement is likely to impact other
areas of study for low-mass stars, such as the detection and characterization
of extrasolar planets in the habitable zones.Comment: Contribution to Proceedings of Cool Stars 16 Workshop; 8 pages in ASP
format; 9 figure
Wrist-worn physical activity trackers progressively underestimate steps with increasing walking speeds
Imaging the Algol Triple System in H Band with the CHARA Interferometer
Algol (Beta Per) is an extensively studied hierarchical triple system whose
inner pair is a prototype semi-detached binary with mass transfer occurring
from the sub-giant secondary to the main-sequence primary. We present here the
results of our Algol observations made between 2006 and 2010 at the CHARA
interferometer with the Michigan Infrared Combiner in the H band. The use of
four telescopes with long baselines allows us to achieve better than 0.5 mas
resolution and to unambiguously resolve the three stars. The inner and outer
orbital elements, as well as the angular sizes and mass ratios for the three
components are determined independently from previous studies. We report a
significantly improved orbit for the inner stellar pair with the consequence of
a 15% change in the primary mass compared to previous studies. We also
determine the mutual inclination of the orbits to be much closer to
perpendicularity than previously established. State-of-the-art image
reconstruction algorithms are used to image the full triple system. In
particular an image sequence of 55 distinct phases of the inner pair orbit is
reconstructed, clearly showing the Roche-lobe-filling secondary revolving
around the primary, with several epochs corresponding to the primary and
secondary eclipses
Radial Structure in the TW Hya Circumstellar Disk
We present new near-infrared interferometric data from the CHARA array and the Keck Interferometer on the circumstellar disk of the young star, TW Hya, a proposed "transition disk." We use these data, as well as previously published, spatially resolved data at 10 μm and 7 mm, to constrain disk models based on a standard flared disk structure. We find that we can match the interferometry data sets and the overall spectral energy distribution with a three-component model, which combines elements at spatial scales proposed by previous studies: optically thin, emission nearest the star, an inner optically thick ring of emission at roughly 0.5 AU followed by an opacity gap and, finally, an outer optically thick disk starting at ~4 AU. The model demonstrates that the constraints imposed by the spatially resolved data can be met with a physically plausible disk but this requires a disk containing not only an inner gap in the optically thick disk as previously suggested, but also a gap between the inner and outer optically thick disks. Our model is consistent with the suggestion by Calvet et al. of a planet with an orbital radius of a few AU. We discuss the implications of an opacity gap within the optically thick disk
- …