Silicon fractionation in Mollic Fluvisols along the Central Elbe River, Germany

Quantification of Si in its different forms in soil is a prerequisite to understand the geochemical distribution and fate of Si along with their driving biogeochemical processes. However, different Si fractions in floodplain soils have not been quantified yet, and little is known about the processes driving Si fractionation in these soils. The aim of this study was to clarify the processes that drive formation and distribution of Si among fractions in floodplain soils. We obtained and quantified these fractions using a sequential Si extraction method (Georgiadis et al., 2013) in three Mollic Fluvisols along the Central Elbe River. The highest Si proportion apart from the residual fraction was found in minerogenic amorphous silica (up to 5.6% of total Si), followed by Si occluded in pedogenic oxides and hydroxides (up to 0.7% of total Si). Silicon from biogenic amorphous silica amounted to 0.02-0.6% of total Si. The smallest proportion of Si was found in the mobile Si fraction and made up about 0.01% of the total Si. The results of this study demonstrate the importance of the soil water budget on the accumulation of easy-to-mobilise Si, Si occluded in pedogenic oxides and hydroxides and amorphous silica. Reductive dissolution of Fe and Mn oxides may induce Si release into the soil solution, subsequent oxidizing conditions may induce Si accumulation by adsorption, co-precipitation and occlusion of Si on/with newly formed Fe and Mn oxides. Accumulation of bio-opal after flooding may induce larger amounts of biogenic amorphous silica in floodplain soils than in terrestrial soils. Finally, floodplain soils may accumulate larger amounts of Si bound to occluded particulate SOM than terrestrial soils, which experience less input of particulate SOM than floodplain soils

Exposure to Leptospira spp. and associated risk factors in the human, cattle and dog populations in Bhutan

Leptospirosis is a neglected worldwide zoonotic bacterial disease with a high prevalence in subtropical and tropical countries. The prevalence of Leptospira spp. in humans, cattle and dogs is unknown in Bhutan. Therefore, we sought to find out whether humans, cattle or dogs had been infected in the past with leptospires by measuring antibodies in the serum. We therefore collected blood from 864 humans >/=13 years of age, 130 bovines and 84 dogs from different rural and urban areas in Bhutan and tested the serum for antibodies specific for leptospires with a screening of enzyme-linked immunosorbent assays (ELISA) and a confirmatory microscopic agglutination test (MAT). In humans, 17.6% were seropositive by ELISA and 1.6% by MAT. The seropositivity was stronger in bovines (36.9%) and dogs (47.6%). "Having had a fever recently" (OR 5.2, p = 0.004), "working for the military" (OR 26.6, p = 0.028) and "being unemployed" (OR 12.9, p = 0.041) (reference category = housemaker) were statistically significantly associated with seropositivity when controlled for the effects of other risk factors. However, due to the small number of positive test results, the findings on risk factors should be interpreted with caution. Based on the serogroups found in the three species, dogs could be a source of infection for humans, or dogs and humans are exposed to the same environmental risk factors Clinical leptospirosis in humans and domestic animals should be investigated by testing blood and urine for the presence of leptospires by molecular methods (qPCR)

Seroprevalence of Leptospira spp. infection in Cattle from Central and Northern Madagascar

Leptospirosis is a zoonotic disease of global importance, especially in tropical countries. The current Leptospira spp. seroprevalence in cattle from central and northern Madagascar is unknown. Thus, the aim of this study was to determine the seroprevalence resulting from infections with pathogenic Leptospira spp. in zebu cattle from these areas. Serum samples from 194 animals were tested by microscopic agglutination test (MAT) using a panel of 12 serovars as antigens. Samples with a titer of ≥1:100 were considered positive. The overall seroprevalence was 59.3% (95% CI; 52.0-66.2%) with titers ranging from 1:100 to 1:1600. Among the seropositive animals, the most frequent antibody reactions were against serovar L. Tarassovi (serogroup L. Tarassovi) with 40.2% (33.3-47.5%), followed by L. Hardjo (L. Sejroe) with 13.9% (9.5-19.8%), L. Grippotyphosa (L. Grippotyphosa) with 9.8% (6.2-15.1%), L. Pomona (L. Pomona) with 7.7% (4.5-12.7%) and L. Autumnalis (L. Autumnalis) with 5.2% (2.6-9.5%). Less than 5% of the samples reacted positively against the remaining serovars. These results indicate a very high exposure of Malagasy cattle to Leptospira spp. which, consequently, poses a definite risk for people working with cattle acquiring this zoonotic infection

Self-assembly of ordered wurtzite/rock salt heterostructures—A new view on phase separation in MgxZn1−xO

The self-assembled formation of ordered, vertically stacked rocksalt/wurtzite Mg x Zn 1−xO heterostructures by planar phase separation is shown. These heterostructures form quasi “natural” two-dimensional hetero-interfaces between the different phases upon annealing of MgO-oversaturated wurtzite Mg x Zn 1−xO layers grown by plasma-assisted molecular beam epitaxy on c-plane sapphire substrates. The optical absorption spectra show a red shift simultaneous with the appearance of a cubic phase upon annealing at temperatures between 900 °C and 1000 °C. Transmission electron microscopy reveals that these effects are caused by phase separation leading to the formation of a vertically ordered rock salt/wurtzite heterostructures. To explain these observations, we suggest a phase separation epitaxy model that considers this process being initiated by the formation of a cubic (Mg,Zn)Al2O4 spinel layer at the interface to the sapphire substrate, acting as a planar seed for the epitaxial precipitation of rock salt Mg x Zn 1−xO. The equilibrium fraction x of magnesium in the resulting wurtzite (rock salt) layers is approximately 0.15 (0.85), independent of the MgO content of the as-grown layer and determined by the annealing temperature. This model is confirmed by photoluminescence analysis of the resulting layer systems after different annealing temperatures. In addition, we show that the thermal annealing process results in a significant reduction in the density of edge- and screw-type dislocations, providing the possibility to fabricate high quality templates for quasi-homoepitaxial growth

AlN overgrowth of nano-pillar-patterned sapphire with different offcut angle by metalorganic vapor phase epitaxy

We present overgrowth of nano-patterned sapphire with different offcut angles by metalorganic vapor phase epitaxy. Hexagonal arrays of nano-pillars were prepared via Displacement Talbot Lithography and dry-etching. 6.6 µm crack-free and fully coalesced AlN was grown on such substrates. Extended defect analysis comparing X-ray diffraction, electron channeling contrast imaging and selective defect etching revealed a threading dislocation density of about 109 cm−2. However, for c-plane sapphire offcut of 0.2° towards m direction the AlN surface shows step bunches with a height of 10 nm. The detrimental impact of these step bunches on subsequently grown AlGaN multi-quantum-wells is investigated by cathodoluminescence and transmission electron microscopy. By reducing the sapphire offcut to 0.1° the formation of step bunches is successfully suppressed. On top of such a sample an AlGaN-based UVC LED heterostructure is realized emitting at 265 nm and showing an emission power of 0.81 mW at 20 mA (corresponds to an external quantum efficiency of 0.86%)

AlN overgrowth of nano-pillar-patterned sapphire with different offcut angle by metalorganic vapor phase epitaxy

We present overgrowth of nano-patterned sapphire with different offcut angles by metalorganic vapor phase epitaxy. Hexagonal arrays of nano-pillars were prepared via Displacement Talbot Lithography and dry-etching. 6.6 µm crack-free and fully coalesced AlN was grown on such substrates. Extended defect analysis comparing X-ray diffraction, electron channeling contrast imaging and selective defect etching revealed a threading dislocation density of about 109 cm-2. However, for c-plane sapphire offcut of 0.2° towards m direction the AlN surface shows step bunches with a height of 10 nm. The detrimental impact of these step bunches on subsequently grown AlGaN multi-quantum-wells is investigated by cathodoluminescence and transmission electron microscopy. By reducing the sapphire offcut to 0.1° the formation of step bunches is successfully suppressed. On top of such a sample an AlGaN-based UVC LED heterostructure is realized emitting at 265 nm and showing an emission power of 0.81 mW at 20 mA (corresponds to an external quantum efficiency of 0.86 %)

Docetaxel-loaded liposomes: The effect of lipid composition and purification on drug encapsulation and in vitro toxicity

Docetaxel (DTX)-loaded liposomes have been formulated to overcome DTX solubility issue, improve its efficacy and reduce its toxicity. This study investigated the effect of steric stabilisation, varying liposome composition, and lipid:drug molar ratio on drug loading and on the physicochemical properties of the DTX-loaded liposomes. Size exclusion chromatography (SEC) was used to remove free DTX from the liposomal formulation, and its impact on drug loading and in vitro cytotoxicity was also evaluated. Liposomes composed of fluid, unsaturated lipid (DOPC:Chol:DSPE-PEG2000) showed the highest DTX loading compared to rigid, saturated lipids (DPPC:Chol:DSPE-PEG2000 and DSPC:Chol:DSPE-PEG2000). The inclusion of PEG showed a minimum effect on DTX encapsulation. Decreasing lipid:drug molar ratio from 40:1 to 5:1 led to an improvement in the loading capacities of DOPC-based liposomes only. Up to 3.6-fold decrease in drug loading was observed after liposome purification, likely due to the loss of adsorbed and loosely entrapped DTX in the SEC column. Our in vitro toxicity results in PC3 monolayer showed that non-purified, DTX-loaded DOPC:Chol liposomes were initially (24h) more potent than the purified ones, due to the fast action of the surface- adsorbed drug. However, we hypothesize that over time (48 and 72h) the purified, DTX-loaded DOPC:Chol liposomes became more toxic due to high intracellular release of encapsulated DTX. Finally, our cytotoxicity results in PC3 spheroids showed the superior activity of DTX-loaded liposomes compared to free DTX, which could overcome the DTX poor tissue penetration, drug resistance, and improve its therapeutic efficacy following systemic administration

The cost effectiveness of vaccinating against Lyme disease.

To determine the cost effectiveness of vaccinating against Lyme disease, we used a decision tree to examine the impact on society of six key components. The main measure of outcome was the cost per case averted. Assuming a 0.80 probability of diagnosing and treating early Lyme disease, a 0.005 probability of contracting Lyme disease, and a vaccination cost of $50 per year, the mean cost of vaccination per case averted was$4,466. When we increased the probability of contracting Lyme disease to 0.03 and the cost of vaccination to $100 per year, the mean net savings per case averted was$3,377. Since few communities have average annual incidences of Lyme disease >0. 005, economic benefits will be greatest when vaccination is used on the basis of individual risk, specifically, in persons whose probability of contracting Lyme disease is >0.01