1,622 research outputs found
A new search for anomalous neutrino oscillations at the CERN-PS
The LSND experiment has observed a 3.8 sigma excess of anti-nu_e events from
an anti-nu_mu beam coming from pions at rest. If confirmed, the LSND anomaly
would imply new physics beyond the standard model, presumably in the form of
some additional sterile neutrinos. The MiniBooNE experiment at FNAL-Booster has
further searched for the LSND anomaly. Above 475 MeV, the nu_e result is
excluding the LSND anomaly to about 1.6 sigma but it introduces an unexplained,
new 3.0 sigma anomaly at lower energies, down to 200 MeV. The nu_e data have so
far an insufficient statistics to be conclusive with LSND's anti-nu_e. The
present proposal at the CERN-PS is based on two strictly identical LAr-TPC
detectors in the near and far positions, respectively at 127 and 850 m from the
neutrino (or antineutrino) target and focussing horn, observing the
electron-neutrino signal. This project will benefit from the already developed
technology of ICARUS T600, well tested on surface in Pavia, without the need of
any major R&D activity and without the added problems of an underground
experiment (CNGS-2). The superior quality of the Liquid Argon imaging TPC and
its unique electron - pi-zero discrimination allow full rejection of the NC
background, without efficiency loss for electron neutrino detection. In two
years of exposure, the far detector mass of 600 tons and a reasonable
utilization of the CERN-PS with the refurbished previous TT7 beam line will
allow to collect about 10^6 charged current events, largely adequate to settle
definitely the LSND anomaly.Comment: 23 pages, 17 figures, added watermark, better referencin
Operation of a LAr-TPC equipped with a multilayer LEM charge readout
A novel detector for the ionization signal in a single phase LAr-TPC, based
on the adoption of a multilayer Large Electron Multiplier (LEM) replacing the
traditional anodic wire arrays, has been experimented in the ICARINO test
facility at the INFN Laboratories in Legnaro. Cosmic muon tracks were detected
allowing the measurement of energy deposition and a first determination of the
signal to noise ratio. The analysis of the recorded events demonstrated the 3D
reconstruction capability of ionizing events in this device in liquid Argon,
collecting a fraction of about 90% of the ionization signal with signal to
noise ratio similar to that measured with more traditional wire chambersComment: 9 pages, 7 Figure
Free electron lifetime achievements in Liquid Argon Imaging TPC
A key feature for the success of the liquid Argon imaging TPC (LAr-TPC)
technology is the industrial purification against electro-negative impurities,
especially Oxygen and Nitrogen remnants, which have to be continuously kept at
an exceptionally low level by filtering and recirculating liquid Argon.
Improved purification techniques have been applied to a 120 liters LAr-TPC test
facility in the INFN-LNL laboratory. Through-going muon tracks have been used
to determine the free electron lifetime in liquid Argon against
electro-negative impurities. The short path length here observed (30 cm) is
compensated by the high accuracy in the observation of the specific ionization
of cosmic ray muons at sea level as a function of the drift distance. A free
electron lifetime of (21.4+7.3-4.3) ms, namely > 15.8 ms at 90 % C.L. has been
observed over several weeks under stable conditions, corresponding to a
residual Oxygen equivalent of about 15 ppt (part per trillion). At 500 V/cm,
the free electron speed is 1.5 m/ms. In a LAr-TPC a free electron lifetime in
excess of 15 ms corresponds for instance to an attenuation of less than 15 %
after a drift path of 5 m, opening the way to the operation of the LAr-TPC with
exceptionally long drift distances.Comment: 15 pages, 10 figures; Accepted for publication in JINS
A hardware implementation of Region-of-Interest selection in LAr-TPC for data reduction and triggering
Large Liquid Argon TPC detectors in the range of multikton mass for neutrino
and astroparticle physics require the extraction and treatment of signals from
some 105 wires. In order to enlarge the throughtput of the DAQ system an
on-line lossless data compression has been realized reducing almost a factor 4
the data flow. Moreover a trigger system based on a new efficient on-line
identification algorithm of wire hits was studied, implemented on the actual
ICARUS digital read- out boards and fully tested on the ICARINO LAr-TPC
facility operated at LNL INFN Laboratory with cosmic-rays. Capability to
trigger isolated low energy events down to 1 MeV visible energy was also
demonstrated.Comment: 26 pages, 26 Figure; to be submitted to JINS
Daedalus: A hardware signal analyser for Icarus
Icarus detector [1] is a large-volume (400 cm) liquid Argon TPC that requires continuous high rate sampling signal recording on each channel (about 50 000) to produce event images quite similar to the ones from bubble chambers. In order to optimize the memory usage, a signal feature extractor, that commands memory writing only upon signal detection, has been designed in VLSI CMOS. ( 1998 Elsevier Science B.V. All rights reserved
Precise 3D track reconstruction algorithm for the ICARUS T600 liquid argon time projection chamber detector
Liquid Argon Time Projection Chamber (LAr TPC) detectors offer charged
particle imaging capability with remarkable spatial resolution. Precise event
reconstruction procedures are critical in order to fully exploit the potential
of this technology. In this paper we present a new, general approach of
three-dimensional reconstruction for the LAr TPC with a practical application
to track reconstruction. The efficiency of the method is evaluated on a sample
of simulated tracks. We present also the application of the method to the
analysis of real data tracks collected during the ICARUS T600 detector
operation with the CNGS neutrino beam.Comment: Submitted to Advances in High Energy Physic
A local trigger system for the large LAr-TPC detector
A special dedicated double-rebinning algorithm has been successfully developed in order to extract the physical hit signal from the TPC wires. This solution has been implemented on digital boards, allowing to realize a local trigger able to identify even localized low-energy small events
- …