202 research outputs found
Efficient fully blade-coated perovskite solar cells in air with nanometer-thick bathocuproine buffer layer
Fully printed perovskite solar cells (PSCs) were fabricated in air with all constituent layers, except for electrodes, deposited by the blade coating technique. The PSCs incorporated, for the first time, a nanometer-thick printed bathocuproine (BCP) hole blocking buffer using blade coating and deposited at relative humidity up to 50%. The PSCs with a p-i-n structure (glass/indium tin oxide (ITO)/poly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS)/CH3NH3PbI3/[6,6]-phenyl-C61-butyric acid methyl ester (PCBM)/BCP/Ag) delivered a maximum power conversion efficiency (PCE) of 14.9% on an active area of 0.5 cm2 when measured under standard test conditions. The PSCs with a blade coated BCP delivered performance of 10% and 63% higher (in relative terms) than those incorporating a spin coated BCP or without any BCP film, respectively. The atomic force microscopy (AFM) showed that blade coated films were more homogeneous and acted also as a surface planarizer leading to a reduction of roughness which improved BCP/Ag interface lowering charge recombination. The demonstration of 15% efficient devices with all constituent layers, including nanometer-thick BCP (âź 10 nm), deposited by blade coating in air, demonstrates a route for industrialization of this technology
IMPACT OF THE WASTEWATER-MIXING ZONE ON ATTENUATION OF PHARMACEUTICALS IN NATURAL WATERS: IMPLICATIONS FOR AN IMPACT ZONE INCLUSIVE ENVIRONMENTAL RISK ASSESSMENT
Sorption of active pharmaceutical ingredients in untreated wastewater effluent and effect of dilution in freshwater: Implications for an âimpact zoneâ environmental risk assessment approach
Š 2017 Elsevier B.V. Evidence of ecotoxicological effects of active pharmaceuticals ingredients (APIs) has increased research into their environmental fate. In low and low-middle income countries (LLMICs) the main source of APIs to surface waters is from discharge of untreated wastewater. Consequently, concentrations of APIs can be relatively high in the âimpact zoneâ downstream of a discharge point. Little is known about the fate of APIs in these impact zones. In this laboratory scale investigation, the effect of successive dilution of synthetic untreated wastewater (dilution factor 1 to 10) on the distribution of APIs was studied. The sorption was consistent with the chemical properties of each compound: charge, lipophilicity, and structure. Dilution increased desorption of the basic and neutral APIs (up to 27.7%) and correlated with their lipophilicity (R 2 > 0.980); the positive charge was of secondary importance. Anions did not significantly desorb ( < 10% loss). Increased concentrations of dissolved organic matter at dilutions of 8 and 10 times that of untreated wastewater coincided with lower dissolved API concentrations. The data showed a clear trend in the desorption process of APIs that may lead to higher exposure risk than anticipated. Therefore, it is suggested that these aspects should be accounted for in the development of dedicated environmental risk assessment approach for APIs in riverine impact zones of LLMICs countries
Twist and Degrade-Impact of Molecular Structure on the Photostability of Nonfullerene Acceptors and Their Photovoltaic Blends
Nonfullerene acceptors (NFAs) dominate organic photovoltaic (OPV) research due to their promising efficiencies and stabilities. However, there is very little investigation into the molecular processes of degradation, which is critical to guiding design of novel NFAs for longâlived, commercially viable OPVs. Here, the important role of molecular structure and conformation in NFA photostability in air is investigated by comparing structurally similar but conformationally different promising NFAs: planar OâIDTBR and nonplanar OâIDFBR. A threeâphase degradation process is identified: i) initial photoinduced conformational change (i.e., torsion about the coreâbenzothiadiazole dihedral), induced by noncovalent interactions with environmental molecules, ii) followed by photoâoxidation and fragmentation, leading to chromophore bleaching and degradation product formation, and iii) finally complete chromophore bleaching. Initial conformational change is a critical prerequisite for further degradation, providing fundamental understanding of the relative stability of IDTBR and IDFBR, where the already twisted IDFBR is more prone to degradation. When blended with the donor polymer poly(3âhexylthiophene), both NFAs exhibit improved photostability while the photostability of the polymer itself is significantly reduced by the more miscible twisted NFA. The findings elucidate the important role of NFA molecular structure in photostability of OPV systems, and provide vital insights into molecular design rules for intrinsically photostable NFAs
Charge transfer complex formation between organic interlayers drives light-soaking in large area perovskite solar cells
Light soaking (LS) is a well-known but poorly understood phenomenon in perovskite solar cells (PSCs) which significantly affects device efficiency and stability. LS is greatly reduced in large-area inverted PSCs when a PC61BM electron transport layer (ETL) is replaced with C60, where the ETL is commonly in contact with a thin bathocuproine (BCP) interlayer. Herein, we identify the key molecular origins of this LS effect using a combination of surface photovoltage, ambient photoemission spectroscopy, Raman spectroscopy, integrated with density functional theory simulations. We find that BCP forms a photoinduced charge-transfer (CT) complex with both C60 and PC61BM. The C60/BCP complex accelerates C60 dimer formation, leading to a favourable cascading energetic landscape for electron extraction and reduced recombination loss. In contrast, the PC61BM/BCP complex suppresses PC61BM dimer formation, meaning that PC61BM dimerisation is not the cause of LS. Instead, it is the slow light-induced formation of the PC61BM/BCP CT complex itself, and the new energetic transport levels associated with it, which cause the much slower and stronger LS effect of PC61BM based PSCs. These findings provide key understanding of photoinduced ETL/BCP interactions and their impact on the LS effect in PSCs
Characterization of the Nairobi River catchment impact zone and occurrence of pharmaceuticals: implications for an impact zone inclusive environmental risk assessment
The largely uncontrolled release of active pharmaceuticals ingredients (APIs) within untreated wastewater discharged to waterbodies, associated with many rapidly urbanising centres is of growing concern owing to potential antimicrobial resistance, endocrine disruption and potential toxicity. A sampling campaign has been undertaken to assess the source, occurrence, magnitude and risk associated with APIs and other chemicals within the Nairobi/Athi river basin, in Kenya, East Africa. The catchment showed an extensive downstream impact zone estimated to extend 75 km, mostly, but not exclusively, derived from the direct discharge of untreated wastewater from the urban centre of Nairobi city. The exact extent of the downstream boundary of the Nairobi city impact zone was unclear owing to the inputs of untreated wastewater sources from the continuous urbanized areas along the river, which counteracted the natural attenuation caused by dilution and degradation. The most frequently detected APIs and chemicals were caffeine, carbamazepine, trimethoprim, nicotine, and sulfamethoxazole. Paracetamol, caffeine, sulfamethoxazole, and trimethoprim alone contributed 86% of the total amount of APIs determined along the Nairobi/Athi catchment. In addition to direct discharge of untreated domestic wastewater attributed to the informal settlements within the conurbation, other sources were linked to the industrial area in Nairobi City where drug formulation is known to occur, the Dandora landfill and veterinary medicines from upstream agriculture. It was shown that there was a possible environmental risk of API ecotoxicological effects beyond the end of the traditional impact zone defined by elevated biochemical oxygen demand concentrations; with metronidazole and sulfamethoxazole exhibiting the highest risk
Development and crossânational investigation of a model explaining participation in WHOârecommended and placebo behaviours to prevent COVIDâ19 infection
To protect themselves from COVID-19, people follow the recommendations of the authorities, but they also resort to placebos. To stop the virus, it is important to understand the factors underlying both types of preventive behaviour. This study examined whether our model (developed based on the Health Belief Model and the Transactional Model of Stress) can explain participation in WHO-recommended and placebo actions during the pandemic. Model was tested on a sample of 3346 participants from Italy, Japan, Poland, Korea, Sweden, and the US. It was broadly supported: objective risk and cues to action showed both direct and indirect (through perceived threat) associations with preventive behaviours. Moreover, locus of control, decision balance, health anxiety and preventive coping moderated these relationships. Numerous differences were also found between countries. We conclude that beliefs about control over health and perceived benefits of actions are critical to the development of interventions to improve adherence to recommendations
Utilization of a deoxynucleoside diphosphate substrate by HIV reverse transcriptase
Background: Deoxynucleoside triphosphates (dNTPs) are the normal substrates for DNA sysnthesis is catalyzed by polymerases such as HIV-1 reverse transcriptase (RT). However, substantial amounts of deoxynucleoside diphosphates (dNDPs) are also present in the cell. Use of dNDPs in HIV-1 DNA sysnthesis could have significant implications for the efficacy of nucleoside RT inhibitors such as AZT which are first line therapeutics fro treatment of HIV infection. Our earlier work on HIV-1 reverse transcriptase (RT) suggested that the interaction between the Îł phosphate of the incoming dNTP and RT residue K65 in the active site is not essential for dNTP insertion, implying that this polymerase may be able to insert dNPs in addition to dNTPs. Methodology/Principal Findings: We examined the ability of recombinant wild type (wt) and mutant RTs with substitutions at residue K65 to utilize a dNDP substrate in primer extension reactions. We found that wild type HIV-1 RT indeed catalyzes incorporation of dNDP substrates whereas RT with mutations of residue K645 were unable to catalyze this reaction. Wild type HIV-1 RT also catalyzed the reverse reaction, inorganic phosphate-dependent phosphorolysis. Nucleotide-mediated phosphorolytic removal of chain-terminating 3â˛-terminal nucleoside inhibitors such as AZT forms the basis of HIV-1 resistance to such drugs, and this removal is enhanced by thymidine analog mutations (TAMs). We found that both wt and TAM-containing RTs were able to catalyze Pi-mediated phosphorolysis of 3â˛-terminal AZT at physiological levels of Pi with an efficacy similar to that for ATP-dependent AZT-excision. Conclusion: We have identified two new catalytic function of HIV-1 RT, the use of dNDPs as substrates for DNA synthesis, and the use of Pi as substrate for phosphorolytic removal of primer 3â˛-terminal nucleotides. The ability to insert dNDPs has been documented for only one other DNA polymerase The RB69 DNA polymerase and the reverse reaction employing inorganic phosphate has not been documented for any DNA polymerase. Importantly, our results show that Pi-mediated phosphorolysis can contribute to AZT resistance and indicates that factors that influence HIV resistance to AZT are more complex than previously appreciated. Š 2008 Garforth et al
Development and cross-national investigation of a model explaining participation in WHO-recommended and placebo behaviours to prevent COVID-19 infection
To protect themselves from COVID-19, people follow the recommendations of the authorities, but they also resort to placebos. To stop the virus, it is important to understand the factors underlying both types of preventive behaviour. This study examined whether our model (developed based on the Health Belief Model and the Transactional Model of Stress) can explain participation in WHO-recommended and placebo actions during the pandemic. Model was tested on a sample of 3346 participants from Italy, Japan, Poland, Korea, Sweden, and the US. It was broadly supported: objective risk and cues to action showed both direct and indirect (through perceived threat) associations with preventive behaviours. Moreover, locus of control, decision balance, health anxiety and preventive coping moderated these relationships. Numerous differences were also found between countries. We conclude that beliefs about control over health and perceived benefits of actions are critical to the development of interventions to improve adherence to recommendations
Tuna labels matter in Europe: Mislabelling rates in different tuna products
Tuna fisheries and processing represent economic activities of paramount importance around the world. Most of these products are traded for human consumption and in general are highly demanded commodities. However, not all tuna products achieve the same market price, some consumers are willing to pay a huge amount of money for certain species (i.e. Japanese market for Bluefin tuna) while other species are rather affordable (i.e. Skipjack tuna), therefore mislabelling has been observed frequently. We collected and analysed 545 tuna samples in six European countries, including fresh, frozen and canned products, and we have investigated whether or not these products were correctly labelled under European and national legislations. We found an overall mislabelling rate of 6.79%; in particular, 6.70% of the fresh and frozen tuna products and 7.84% of canned tuna were mislabelled, and only in the case of fresh and frozen tuna samples significant differences among countries were found. Mislabelling rates for Atlantic Bluefin tuna labelled products were very high, ranging from 50 up to 100%. In general, mislabelling was higher when specific names were included in the labels. The âtunaâ umbrella term is a very popular one with consumers, but also one that remains vulnerable to ambiguity, hampering efforts towards market transparency and with potential negative consequences to the adequate management of tuna species stocks
- âŚ