111 research outputs found
Recommended from our members
A wind-tunnel study of flow distortion at a meteorological sensor on top of the BT Tower, London, UK
High quality wind measurements in cities are needed for numerous applications including wind engineering. Such data-sets are rare and measurement platforms may not be optimal for meteorological observations. Two years' wind data were collected on the BT Tower, London, UK, showing an upward deflection on average for all wind directions. Wind tunnel simulations were performed to investigate flow distortion around two scale models of the Tower. Using a 1:160 scale model it was shown that the Tower causes a small deflection (ca. 0.5°) compared to the lattice on top on which the instruments were placed (ca. 0–4°). These deflections may have been underestimated due to wind tunnel blockage. Using a 1:40 model, the observed flow pattern was consistent with streamwise vortex pairs shed from the upstream lattice edge. Correction factors were derived for different wind directions and reduced deflection in the full-scale data-set by <3°. Instrumental tilt caused a sinusoidal variation in deflection of ca. 2°. The residual deflection (ca. 3°) was attributed to the Tower itself. Correction of the wind-speeds was small (average 1%) therefore it was deduced that flow distortion does not significantly affect the measured wind-speeds and the wind climate statistics are reliable
Modelling extreme concentration from a source in a turbulent flow over rough wall
The concentration fluctuations in passive plumes from an elevated and a groundlevel
source in a turbulent boundary layer over a rough wall were studied using
large eddy simulation and wind tunnel experiment. The predictions of statistics
up to second order moments were thereby validated. In addition, the trend of relative
fluctuations far downstream for a ground level source was estimated using
dimensional analysis. The techniques of extreme value theory were then applied
to predict extreme concentrations by modelling the upper tail of the probability
density function of the concentration time series by the Generalised Pareto Distribution.
Data obtained from both the simulations and experiments were analysed in
this manner. The predicted maximum concentration (?0) normalized by the local
mean concentration (Cm) or by the local r.m.s of concentration fluctuation (crms),
was extensively investigated. Values for ?0/Cm and ?0/crms as large as 50 and 20
respectively were found for the elevated source and 10 and 15 respectively for the
ground-level source
Recommended from our members
Wake characteristics of tall buildings in a realistic urban Canopy
The presence of tall buildings in cities affects momentum and scalar exchange within and above the urban canopy. As wake effects can be important over large distances, they are crucial for urban-flow modelling on and across different spatial scales. We explore the aerodynamic effects of tall buildings on the microscale to local scales with a focus on the interaction between the wake structure, canopy and roughness sublayer (RSL) flow of the surroundings in a realistic urban setting in central London. Flow experiments in a boundary-layer wind tunnel use a 1:200 scale model with two tall buildings (81 m and 134.3 m) for two wind directions. Large changes in mean flow, turbulence statistics and instantaneous flow structure of the wake are evident when tall buildings are part of the complex urban canopy rather than isolated. In the near–wake, the presence of lower buildings displaces the core of the recirculation zone upwards, thereby reducing the vertical depth over which flow reversal occurs. This amplifies vertical shear at the rooftop and enhances turbulent momentum exchange. In the near part of the main–wake, lateral velocity fluctuations and hence turbulence kinetic energy are reduced compared to the isolated building case as eddies generated in the urban canopy and RSL distribute energy down to smaller scales that dissipate more rapidly. Evaluation of a wake model for flow past isolated buildings suggests model refinements are needed to account for such flow-structure changes in tall-building canopies
Recommended from our members
In-street wind direction variability in the vicinity of a busy intersection in central London
We present results from fast-response wind measurements within and above a busy intersection between two street canyons (Marylebone Road and Gloucester Place) in Westminster, London taken as part of the DAPPLE (Dispersion of Air Pollution and Penetration into the Local Environment; www.dapple.org.uk) 2007 field campaign. The data reported here were collected using ultrasonic anemometers on the roof-top of a building adjacent to the intersection and at two heights on a pair of lamp-posts on opposite sides of the intersection. Site characteristics, data analysis and the variation of intersection flow with the above-roof wind direction (θref) are discussed. Evidence of both flow channelling and recirculation was identified within the canyon, only a few metres from the intersection for along-street and across-street roof-top winds respectively. Results also indicate that for oblique rooftop flows, the intersection flow is a complex combination of bifurcated channelled flows, recirculation and corner vortices. Asymmetries in local building geometry around the intersection and small changes in the background wind direction (changes in 15-min mean θref of 5–10 degrees) were also observed to have profound influences on the behaviour of intersection flow patterns. Consequently, short time-scale variability in the background flow direction can lead to highly scattered in-street mean flow angles masking the true multi-modal features of the flow and thus further complicating modelling challenges
Comparative quantification of health risks: Conceptual framework and methodological issues
Reliable and comparable analysis of risks to health is key for preventing disease and injury. Causal attribution of morbidity and mortality to risk factors has traditionally been conducted in the context of methodological traditions of individual risk factors, often in a limited number of settings, restricting comparability. In this paper, we discuss the conceptual and methodological issues for quantifying the population health effects of individual or groups of risk factors in various levels of causality using knowledge from different scientific disciplines. The issues include: comparing the burden of disease due to the observed exposure distribution in a population with the burden from a hypothetical distribution or series of distributions, rather than a single reference level such as non-exposed; considering the multiple stages in the causal network of interactions among risk factor(s) and disease outcome to allow making inferences about some combinations of risk factors for which epidemiological studies have not been conducted, including the joint effects of multiple risk factors; calculating the health loss due to risk factor(s) as a time-indexed "stream" of disease burden due to a time-indexed "stream" of exposure, including consideration of discounting; and the sources of uncertainty
Interventions Delivered in Clinical Settings are Effective in Reducing Risk of HIV Transmission Among People Living with HIV: Results from the Health Resources and Services Administration (HRSA)’s Special Projects of National Significance Initiative
To support expanded prevention services for people living with HIV, the US Health Resources and Services Administration (HRSA) sponsored a 5-year initiative to test whether interventions delivered in clinical settings were effective in reducing HIV transmission risk among HIV-infected patients. Across 13 demonstration sites, patients were randomized to one of four conditions. All interventions were associated with reduced unprotected vaginal and/or anal intercourse with persons of HIV-uninfected or unknown status among the 3,556 participating patients. Compared to the standard of care, patients assigned to receive interventions from medical care providers reported a significant decrease in risk after 12 months of participation. Patients receiving prevention services from health educators, social workers or paraprofessional HIV-infected peers reported significant reduction in risk at 6 months, but not at 12 months. While clinics have a choice of effective models for implementing prevention programs for their HIV-infected patients, medical provider-delivered methods are comparatively robust
Comparison of the behaviour of manufactured and other airborne nanoparticles and the consequences for prioritising research and regulation activities
Currently, there are no air quality regulations in force in any part of the world to control number concentrations of airborne atmospheric nanoparticles (ANPs). This is partly due to a lack of reliable information on measurement methods, dispersion characteristics, modelling, health and other environmental impacts. Because of the special characteristics of manufactured (also termed engineered or synthesised) nanomaterials or nanoparticles (MNPs), a substantial increase is forecast for their manufacture and use, despite understanding of safe design and use, and health and environmental implications being in its early stage. This article discusses a number of underlining technical issues by comparing the properties and behaviour of MNPs with anthropogenically produced ANPs. Such a comparison is essential for the judicious treatment of the MNPs in any potential air quality regulatory framework for ANPs
- …