Environmental study of miniature slip rings

Investigation studied the long term operation of miniature slip ring assembles in high vacuum of space and included the influence of ring, brush, and insulator materials on electrical noise and mechanical wear. Results show that soft metal vapor plating and niobium diselenide miniature slip rings are beneficial

Hegel on the Double Movement of Aufhebung

Contrary to the popular image of Hegel's philosophy as one of linear progression, I argue that the logic of the double movement in The Science of Logic presents a complication and a challenge to this trite conception of Hegelianism

In situ monitoring of the influence of water on DNA radiation damage by near-ambient pressure X-ray photoelectron spectroscopy

Ionizing radiation damage to DNA plays a fundamental role in cancer therapy. X-ray photoelectron-spectroscopy (XPS) allows simultaneous irradiation and damage monitoring. Although water radiolysis is essential for radiation damage, all previous XPS studies were performed in vacuum. Here we present near-ambient-pressure XPS xperiments to directly measure DNA damage under water atmosphere. They permit in-situ monitoring of the effects of radicals on fully hydrated double-stranded DNA. The results allow us to distinguish direct damage, by photons and secondary low-energy electrons (LEE), from damage by hydroxyl radicals or hydration induced modifications of damage pathways. The exposure of dry DNA to x-rays leads to strand-breaks at the sugar-phosphate backbone, while deoxyribose and nucleobases are less affected. In contrast, a strong increase of DNA damage is observed in water, where OH-radicals are produced. In consequence, base damage and base release become predominant, even though the number of strand-breaks increases further

New techniques for deeper insights

To gain deeper insights into the old questions about the influence of water on radiation interaction with DNA, new spectroscopic techniques had to be applied

The influence of chemical transport via vapour phase on the properties of chloride and caesium doped V-Fe mixed oxide catalysts in the oxidation of butadiene to furan

Chloride and caesium doped V-Fe mixed oxides prepared by different methods and calcined under vapour-phase transport-restricted conditions showed a high initial furan yield of up to 40 mol-% in the oxidation of butadiene. However,after only a few hours on stream a significant loss of activity and selectivity was observed. The reason for this undesirable property was investigated using different bulk and surface-sensitive characterisation methods such as x-ray diffraction, x-ray photoelectron spectroscopy, ransmission electron microscopy and chemical methods. The data obtained for the structure, morphology, and composition of the fresh and used catalysts were correlated with their activity and selectivity properties. The presence of chloride ions was found to be surprisingly necessary for the origin of furan selectivity even up to 50 %, which was however stable only for a short period of time. Chemical transport via chlorides or bromides was observed to be essential for the formation as well as the maintenance of the activity and selectivity properties of the system. The results obtained are interpreted with an assumption that the formation of volatile halides is necessary to form disperse VOx species, which act as active and selective centres for the present reaction. Models for the formation and deactivation of these centres are discussed in this work. In addition, the possible roles of caesium and iron oxides in the catalytic system are also described and disputed

Mechanochemical Synthesis of Fluorine-Containing Co-Doped Zeolitic Imidazolate Frameworks for Producing Electrocatalysts

Catalysts derived from pyrolysis of metal organic frameworks (MOFs) are promising candidates to replace expensive and scarce platinum-based electrocatalysts commonly used in polymer electrolyte membrane fuel cells. MOFs contain ordered connections between metal centers and organic ligands. They can be pyrolyzed into metal- and nitrogen-doped carbons, which show electrocatalytic activity toward the oxygen reduction reaction (ORR). Furthermore, metal-free heteroatom-doped carbons, such as N-F-Cs, are known for being active as well. Thus, a carbon material with Co-N-F doping could possibly be even more promising as ORR electrocatalyst. Herein, we report the mechanochemical synthesis of two polymorphs of a zeolitic imidazole framework, Co-doped zinc 2-trifluoromethyl-1H-imidazolate (Zn0.9Co0.1(CF3-Im)2). Time-resolved in situ X-ray diffraction studies of the mechanochemical formation revealed a direct conversion of starting materials to the products. Both polymorphs of Zn0.9Co0.1(CF3-Im)2 were pyrolyzed, yielding Co-N-F containing carbons, which are active toward electrochemical ORR.Peer Reviewe

Metal-support interaction: The key factor governing activity of Pd/SnO2 catalyst for denitration of ground water

Two mesoporous nanocristalline Pd/SnO2 catalysts were prepared by modified solgel technique differing in the pH conditions (pH = 2 and 9.5) of the synthesis of their supports. Samples achieved different activity and selectivity in water denitration reaction using hydrogen. XPS results of reduced samples indicate a strong interaction between the Pd and the Sn possibly as a result of electron shift from Sn to Pd. The solid solution of Pd2+ and SnO2 is formed by taking O from the surface of the support. In such a way some SnO2-X species may stay onto the surface and be responsible for its pronounced activity

Assessing the protective effects of different surface coatings on NaYF4:Yb3+, Er3+ upconverting nanoparticles in buffer and DMEM

We studied the dissolution behavior of β NaYF4:Yb(20%), Er(2%) UCNP of two different sizes in biologically relevant media i.e., water (neutral pH), phosphate buffered saline (PBS), and Dulbecco’s modified Eagle medium (DMEM) at different temperatures and particle concentrations. Special emphasis was dedicated to assess the influence of different surface functionalizations, particularly the potential of mesoporous and microporous silica shells of different thicknesses for UCNP stabilization and protection. Dissolution was quantified electrochemically using a fluoride ion selective electrode (ISE) and by inductively coupled plasma optical emission spectrometry (ICP OES). In addition, dissolution was monitored fluorometrically. These experiments revealed that a thick microporous silica shell drastically decreased dissolution. Our results also underline the critical influence of the chemical composition of the aqueous environment on UCNP dissolution. In DMEM, we observed the formation of a layer of adsorbed molecules on the UCNP surface that protected the UCNP from dissolution and enhanced their fluorescence. Examination of this layer by X-ray photoelectron spectroscopy (XPS) and mass spectrometry (MS) suggested that mainly phenylalanine, lysine, and glucose are adsorbed from DMEM. These findings should be considered in the future for cellular toxicity studies with UCNP and other nanoparticles and the design of new biocompatible surface coatings