Structures of a deAMPylation complex rationalise the switch between antagonistic catalytic activities of FICD.

The endoplasmic reticulum (ER) Hsp70 chaperone BiP is regulated by AMPylation, a reversible inactivating post-translational modification. Both BiP AMPylation and deAMPylation are catalysed by a single ER-localised enzyme, FICD. Here we present crystallographic and solution structures of a deAMPylation Michaelis complex formed between mammalian AMPylated BiP and FICD. The latter, via its tetratricopeptide repeat domain, binds a surface that is specific to ATP-state Hsp70 chaperones, explaining the exquisite selectivity of FICD for BiP's ATP-bound conformation both when AMPylating and deAMPylating Thr518. The eukaryotic deAMPylation mechanism thus revealed, rationalises the role of the conserved Fic domain Glu234 as a gatekeeper residue that both inhibits AMPylation and facilitates hydrolytic deAMPylation catalysed by dimeric FICD. These findings point to a monomerisation-induced increase in Glu234 flexibility as the basis of an oligomeric state-dependent switch between FICD's antagonistic activities, despite a similar mode of engagement of its two substrates - unmodified and AMPylated BiP

Potential of interdigitated back contact silicon heterojunction solar cells for liquid phase crystallized silicon on glass with efficiency above 14

Liquid phase crystallization of silicon LPC Si on glass is a promising method to produce high quality multi crystalline Si films with macroscopic grains. In this study, we report on recent improvements of our interdigitated back contact silicon heterojunction contact system IBC SHJ , which enabled open circuit voltages as high as 661 mV and efficiencies up to 14.2 using a 13 m thin n type LPC Si absorbers on glass. The influence of the BSF width on the cell performance is investigated both experimentally and numerically. We combine 1D optical simulations using GenPro4 and 2D electrical simulations using Sentaurus TCAD to determine the optical and electrical loss mechanisms in order to estimate the potential of our current LPC Si absorbers. The simulations reveal an effective minority carrier diffusion length of 26 m and further demonstrate that a doping concentration of 4 1016 cm 3 and a back surface field width of 60 m are optimum values to further increase cell efficiencie

Top-down and bottom-up aerosol–cloud closure: towards understanding sources of uncertainty in deriving cloud shortwave radiative flux

Top-down and bottom-up aerosol–cloud shortwave radiative flux closures were conducted at the Mace Head Atmospheric Research Station in Galway, Ireland, in August 2015. This study is part of the BACCHUS (Impact of Biogenic versus Anthropogenic emissions on Clouds and Climate: towards a Holistic UnderStanding) European collaborative project, with the goal of understanding key processes affecting aerosol–cloud shortwave radiative flux closures to improve future climate predictions and develop sustainable policies for Europe. Instrument platforms include ground-based unmanned aerial vehicles (UAVs)1 and satellite measurements of aerosols, clouds and meteorological variables. The ground-based and airborne measurements of aerosol size distributions and cloud condensation nuclei (CCN) concentration were used to initiate a 1-D microphysical aerosol–cloud parcel model (ACPM). UAVs were equipped for a specific science mission, with an optical particle counter for aerosol distribution profiles, a cloud sensor to measure cloud extinction or a five-hole probe for 3-D wind vectors. UAV cloud measurements are rare and have only become possible in recent years through the miniaturization of instrumentation. These are the first UAV measurements at Mace Head. ACPM simulations are compared to in situ cloud extinction measurements from UAVs to quantify closure in terms of cloud shortwave radiative flux. Two out of seven cases exhibit sub-adiabatic vertical temperature profiles within the cloud, which suggests that entrainment processes affect cloud microphysical properties and lead to an overestimate of simulated cloud shortwave radiative flux. Including an entrainment parameterization and explicitly calculating the entrainment fraction in the ACPM simulations both improved cloud-top radiative closure. Entrainment reduced the difference between simulated and observation-derived cloud-top shortwave radiative flux (δRF) by between 25 and 60 W m−2. After accounting for entrainment, satellite-derived cloud droplet number concentrations (CDNCs) were within 30 % of simulated CDNC. In cases with a well-mixed boundary layer, δRF is no greater than 20 W m−2 after accounting for cloud-top entrainment and up to 50 W m−2 when entrainment is not taken into account. In cases with a decoupled boundary layer, cloud microphysical properties are inconsistent with ground-based aerosol measurements, as expected, and δRF is as high as 88 W m−2, even high (> 30 W m−2) after accounting for cloud-top entrainment. This work demonstrates the need to take in situ measurements of aerosol properties for cases where the boundary layer is decoupled as well as consider cloud-top entrainment to accurately model stratocumulus cloud radiative flux

Silicon solar cells on glass with power conversion efficiency above 13 at thickness below 15 micrometer

Liquid phase crystallized silicon on glass with a thickness of 10 40 amp; 956;m has the potential to reduce material costs and the environmental impact of crystalline silicon solar cells. Recently, wafer quality open circuit voltages of over 650 mV and remarkable photocurrent densities of over 30 mA cm 2 have been demonstrated on this material, however, a low fill factor was limiting the performance. In this work we present our latest cell progress on 13 amp; 956;m thin poly crystalline silicon fabricated by the liquid phase crystallization directly on glass. The contact system uses passivated back side silicon hetero junctions, back side KOH texture for light trapping and interdigitated ITO Ag contacts. The fill factors are up to 74 and efficiencies are 13.2 under AM1.5 g for two different doping densities of 1 10 17 cm 3 and 2 10 16 cm 3 . The former is limited by bulk and interface recombination, leading to a reduced saturation current density, the latter by series resistance causing a lower fill factor. Both are additionally limited by electrical shading and losses at grain boundaries and dislocations. A small 1 0.1 cm 2 test structure circumvents limitations of the contact design reaching an efficiency of 15.9 clearly showing the potential of the technolog

First observations of high-temperature submarine hydrothermal vents and massive anhydrite deposits off the north coast of Iceland

High-temperature (250°C) hydrothermal vents and massive anhydrite deposits have been found in a shallow water, sediment-filled graben near 66°36′N in the Tjornes Fracture Zone north of Iceland. The site is located about 30 km offshore, near the small island of Grimsey. The main vent field occurs at a depth of 400 m and consists of about 20 large-diameter (up to 10 m) mounds and 1–3 m chimneys and spires of anhydrite and talc. A north–south alignment of the mounds over a 1-km strike length of the valley floor suggests that their distribution is controlled by a buried fault. Widespread shimmering water and extensive white patches of anhydrite in the sediment between the mounds indicates that the entire 1-km2 area occupied by the vents is thermally active. A 2-man research submersible JAGO was used to map the area and to sample vent waters, gases, and chimneys. Actively boiling hydrothermal vents occur on most of the mounds, and extensive two-phase venting indicates that the field is underlain by a large boiling zone (200×300 m). The presence of boiling fluids in shallow aquifers beneath the deposits was confirmed by sediment coring. The highest-temperature pore fluids were encountered in talc- and anhydrite-rich sedimentary layers that occur up to 7 m below the mounds. Baked muds underlie the talc and anhydrite layers, and pyrite is common in stockwork-like fractures and veins in the hydrothermally altered sediments. However, massive sulfides (pyrite–marcasite crusts) were found in only one relict mound. Subseafloor boiling has likely affected the metal-carrying capacity of the hydrothermal fluids, and deposition of sulfides may be occurring at greater depth. Although the mounds and chimneys at Grimsey resemble other deposits at sedimented ridges (e.g. Middle Valley, Escanaba Trough, Guaymas Basin), the shallow water setting and extensive boiling of the hydrothermal fluids represent a distinctive new type of seafloor hydrothermal system

Does the majority always know best? Young children's flexible trust in majority opinion

Copying the majority is generally an adaptive social learning strategy but the majority does not always know best. Previous work has demonstrated young children's selective uptake of information from a consensus over a lone dissenter. The current study examined children's flexibility in following the majority: do they overextend their reliance on this heuristic to situations where the dissenting individual has privileged knowledge and should be trusted instead? Four- to six- year-olds (N = 103) heard conflicting claims about the identity of hidden drawings from a majority and a dissenter in two between-subject conditions: in one, the dissenter had privileged knowledge over the majority (he drew the pictures); in the other he did not (they were drawn by an absent third party). Overall, children were less likely to trust the majority in the Privileged Dissenter condition. Moreover, 5- and 6- year-olds made majority-based inferences when the dissenter had no privileged knowledge but systematically endorsed the dissenter when he drew the pictures. The current findings suggest that by 5 years, children are able to make an epistemic-based judgment to decide whether or not to follow the majority rather than automatically following the most common view

Attentional learning helps language acquisition take shape for atypically developing children, not just children with Autism Spectrum Disorders

The shape bias-generalising labels to same shaped objects-has been linked to attentional learning or referential intent. We explore these origins in children with typical development (TD), autism spectrum disorders (ASD) and other developmental disorders (DD). In two conditions, a novel object was presented and either named or described. Children selected another from a shape, colour or texture match. TD children choose the shape match in both conditions, children with DD and 'high-verbal mental age' (VMA) children with ASD (language age > 4.6) did so in the name condition and 'low-VMA' children with ASD never showed the heuristic. Thus, the shape bias arises from attentional learning in atypically developing children and is delayed in ASD

Drawing firmer conclusions: autistic children show no evidence of a local processing bias in a controlled copying task

Drawing tasks are frequently used to test competing theories of visuospatial skills in autism. Yet, methodological differences between studies have led to inconsistent findings. To distinguish between accounts based on local bias or global deficit, we present a simple task that has previously revealed dissociable local/global impairments in neuropsychological patients. Autistic and typical children copied corner elements, arranged in a square configuration. Grouping cues were manipulated to test whether global properties affected the accuracy of reproduction. All children were similarly affected by these manipulations. There was no group difference in the reproduction of local elements, although global accuracy was negatively related to better local processing for autistic children. These data speak against influential theories of visuospatial differences in autism