7,636 research outputs found
Frame synchronization performance and analysis
The analysis used to generate the theoretical models showing the performance of the frame synchronizer is described for various frame lengths and marker lengths at various signal to noise ratios and bit error tolerances
Development of a low-maintenance measurement approach to continuously estimate methane emissions: a case study
The chemical breakdown of organic matter in landfills represents a significant source of methane gas (CH4). Current estimates suggest that landfills are responsible for between 3% and 19% of global anthropogenic emissions. The net CH4 emissions resulting from biogeochemical processes and their modulation by microbes in landfills are poorly constrained by imprecise knowledge of environmental constraints. The uncertainty in absolute CH4 emissions from landfills is therefore considerable. This study investigates a new method to estimate the temporal variability of CH4 emissions using meteorological and CH4 concentration measurements downwind of a landfill site in Suffolk, UK from July to September 2014, taking advantage of the statistics that such a measurement approach offers versus shorter-term, but more complex and instantaneously accurate, flux snapshots. Methane emissions were calculated from CH4 concentrations measured 700 m from the perimeter of the landfill with observed concentrations ranging from background to 46.4 ppm. Using an atmospheric dispersion model, we estimate a mean emission flux of 709 μg m−2 s−1 over this period, with a maximum value of 6.21 mg m−2 s−1, reflecting the wide natural variability in biogeochemical and other environmental controls on net site emission. The emissions calculated suggest that meteorological conditions have an influence on the magnitude of CH4 emissions. We also investigate the factors responsible for the large variability observed in the estimated CH4 emissions, and suggest that the largest component arises from uncertainty in the spatial distribution of CH4 emissions within the landfill area. The results determined using the low-maintenance approach discussed in this paper suggest that a network of cheaper, less precise CH4 sensors could be used to measure a continuous CH4 emission time series from a landfill site, something that is not practical using far-field approaches such as tracer release methods. Even though there are limitations to the approach described here, this easy, low-maintenance, low-cost method could be used by landfill operators to estimate time-averaged CH4 emissions and their impact downwind by simultaneously monitoring plume advection and CH4 concentrations
Composite Repairs To Cracked Metallic Components- Experiment and Theory
In this paper we show how the published literature reveals that the analytical solution for a composite repair to a cracked metallic plate is inconsistent with experimental data, and that the fibre bridging effect is often a second order effect. The result is that prediction of the effect of a composite repair on the structural integrity of cracked components repaired by an externally bonded composite repair is dramatically simplified
Aldosterone status associates with insulin resistance in patients with heart failure-data from the ALOFT study
<b>Background</b>: Aldosterone plays a key role in the pathophysiology of heart failure. In around 50% of such patients, aldosterone 'escapes' from inhibition by drugs that interrupt the renin-angiotensin axis; such patients have a worse clinical outcome. Insulin resistance is a risk factor in heart failure and cardiovascular disease. The relationship between aldosterone status and insulin sensitivity was investigated in a cohort of heart failure patients.
<b>Methods</b>: 302 patients with New York Heart Association (NYHA) class II-IV heart failure on conventional therapy were randomized in ALiskiren Observation of heart Failure Treatment study (ALOFT), designed to test the safety of a directly acting renin inhibitor. Plasma aldosterone and 24-hour urinary aldosterone excretion as well as fasting insulin and Homeostasis model assessment of insulin resistance (HOMA-IR) were measured. Subjects with aldosterone escape and high urinary aldosterone were identified according to previously accepted definitions.
<b>Results</b>: Twenty per-cent of subjects demonstrated aldosterone escape and 34% had high urinary aldosterone levels. At baseline, there was a positive correlation between fasting insulin and plasma(r=0.22 p<0.01) and urinary aldosterone(r=0.19 p<0.03). Aldosterone escape and high urinary aldosterone subjects both demonstrated higher levels of fasting insulin (p<0.008, p<0.03), HOMA-IR (p<0.06, p<0.03) and insulin-glucose ratios (p<0.006, p<0.06) when compared to low aldosterone counterparts. All associations remained significant when adjusted for potential confounders.
<b>Conclusions</b>: This study demonstrates a novel direct relationship between aldosterone status and insulin resistance in heart failure. This observation merits further study and may identify an additional mechanism that contributes to the adverse clinical outcome associated with aldosterone escape
Restoration and Monitoring of the River Otter Population in Iowa
Northern river otters (Lontra canadensis) were widespread in North America at the time of European settlement. However, river otters were extirpated from most of Iowa in the early 1900s due to habitat degradation and unregulated harvest. In 1985, the Iowa Department of Natural Resources began an effort to restore the river otter population throughout the state, including a pilot study of survival to determine if establishment was feasible. Annual survival was estimated to be 86% during the pilot study. River otters dispersed an average of about 11 km from the point of release and exhibited habitat use typical for the species. Based on the successful pilot study, 261 river otters were released in the state of Iowa from 1986-2001. More recently we examined the age structure and reproductive effort of 81 river otters (43 females and 38 males) collected in Iowa from 1999-2001 to document the characteristics of the reestablished population. We found that 41% of the otters sampled were juveniles, 38% were yearlings and 21% were adults. Fifty-five percent of all female otters were pregnant, and 80% of adult females were pregnant. We observed a mean of 2.9 corpora lutea/female and calculated that female’s ≥ 1 year old could potentially produce an average 5.7 female offspring during an average life span. Based on the widespread distribution, healthy reproductive characteristics, and high survival rates it is feasible that a limited harvest of river otter could be implemented in Iowa
Simulation of gain stability of THGEM gas-avalanche particle detectors
Charging-up processes affecting gain stability in Thick Gas Electron
Multipliers (THGEM) were studied with a dedicated simulation toolkit.
Integrated with Garfield++, it provides an effective platform for systematic
phenomenological studies of charging-up processes in MPGD detectors. We
describe the simulation tool and the fine-tuning of the step-size required for
the algorithm convergence, in relation to physical parameters. Simulation
results of gain stability over time in THGEM detectors are presented, exploring
the role of electrode-thickness and applied voltage on its evolution. The
results show that the total amount of irradiated charge through electrode's
hole needed for reaching gain stabilization is in the range of tens to hundreds
of pC, depending on the detector geometry and operational voltage. These
results are in agreement with experimental observations presented previously
Recommended from our members
Inter-sectoral Transfer of the Food for Life Settings Framework in England
Organisational settings such as schools, workplaces and hospitals are well recognised as key environments for health promotion. Whilst there is extensive literature on specific types of settings, little empirical research has investigated the transfer of frameworks between sectors. This study analyses Food for Life, an England-wide healthy and sustainable food programme that evolved in schools and is being adapted for children's centres, universities, care homes, and hospital settings. Following a case study design, we interviewed 85 stakeholders in nine settings. Food for Life's systemic framework of 'food education, skills and experience' 'food and catering quality', 'community and partnerships' and 'leadership' carried salience in all types of settings. These were perceived to act both as principles and operational priorities for driving systemic change. However, each setting type differed in terms of the mix of facilitating factors and appropriate indicators for change. Barriers in common included the level of culture-shift required, cost perceptions and organisational complexity. For settings based health promotion practice, this study points to the importance of 'frame-working' (the systematic activity of scoping and categorising the field of change) alongside the development and application of benchmarks to stimulate change. These processes are critical in the transfer of learning from between sectors in a form that balances commonality with sufficient flexibility to adapt to specific settings. Synergy between types of settings is an under-recognised, but critical, part of action to address complex issues such as those emerging from the intersection between food, health and sustainability
First in-beam studies of a Resistive-Plate WELL gaseous multiplier
We present the results of the first in-beam studies of a medium size
(1010 cm) Resistive-Plate WELL (RPWELL): a single-sided THGEM
coupled to a pad anode through a resistive layer of high bulk resistivity
(10cm). The 6.2~mm thick (excluding readout electronics)
single-stage detector was studied with 150~GeV muons and pions. Signals were
recorded from 11 cm square copper pads with APV25-SRS readout
electronics. The single-element detector was operated in Ne\(5%
) at a gas gain of a few times 10, reaching 99
detection efficiency at average pad multiplicity of 1.2. Operation at
particle fluxes up to 10 Hz/cm resulted in 23 gain drop
leading to 5 efficiency loss. The striking feature was the
discharge-free operation, also in intense pion beams. These results pave the
way towards robust, efficient large-scale detectors for applications requiring
economic solutions at moderate spatial and energy resolutions.Comment: Accepted by JINS
- …