35,058 research outputs found
Fundamental constants and tests of theory in Rydberg states of one-electron ions
The nature of the theory of circular Rydberg states of hydrogenlike ions
allows highly-accurate predictions to be made for energy levels. In particular,
uncertainties arising from the problematic nuclear size correction which beset
low angular-momentum states are negligibly small for the high angular-momentum
states. The largest remaining source of uncertainty can be addressed with the
help of quantum electrodynamics (QED) calculations, including a new
nonperturbative result reported here. More stringent tests of theory and an
improved determination of the Rydberg constant may be possible if predictions
can be compared with precision frequency measurements in this regime. The
diversity of information can be increased by utilizing a variety of
combinations of ions and Ryberg states to determine fundamental constants and
test theory.Comment: 10 pages; LaTe
Noisy pre-processing facilitating a photonic realisation of device-independent quantum key distribution
Device-independent quantum key distribution provides security even when the
equipment used to communicate over the quantum channel is largely
uncharacterized. An experimental demonstration of device-independent quantum
key distribution is however challenging. A central obstacle in photonic
implementations is that the global detection efficiency, i.e., the probability
that the signals sent over the quantum channel are successfully received, must
be above a certain threshold. We here propose a method to significantly relax
this threshold, while maintaining provable device-independent security. This is
achieved with a protocol that adds artificial noise, which cannot be known or
controlled by an adversary, to the initial measurement data (the raw key).
Focusing on a realistic photonic setup using a source based on spontaneous
parametric down conversion, we give explicit bounds on the minimal required
global detection efficiency.Comment: 5+16 pages, 4 figure
A re-evaluation of finite-element models and stress-intensity factors for surface cracks emanating from stress concentrations
A re-evaluation of the 3-D finite-element models and methods used to analyze surface crack at stress concentrations is presented. Previous finite-element models used by Raju and Newman for surface and corner cracks at holes were shown to have ill-shaped elements at the intersection of the hole and crack boundaries. These ill-shaped elements tended to make the model too stiff and, hence, gave lower stress-intensity factors near the hole-crack intersection than models without these elements. Improved models, without these ill-shaped elements, were developed for a surface crack at a circular hole and at a semi-circular edge notch. Stress-intensity factors were calculated by both the nodal-force and virtual-crack-closure methods. Both methods and different models gave essentially the same results. Comparisons made between the previously developed stress-intensity factor equations and the results from the improved models agreed well except for configurations with large notch-radii-to-plate-thickness ratios. Stress-intensity factors for a semi-elliptical surface crack located at the center of a semi-circular edge notch in a plate subjected to remote tensile loadings were calculated using the improved models. The ratio of crack depth to crack length ranged form 0.4 to 2; the ratio of crack depth to plate thickness ranged from 0.2 to 0.8; and the ratio of notch radius to the plate thickness ranged from 1 to 3. The models had about 15,000 degrees-of-freedom. Stress-intensity factors were calculated by using the nodal-force method
Mechanistic and pathological study of the genesis, growth, and rupture of abdominal aortic aneurysms
Postprint (published version
Distinct order of Gd 4f and Fe 3d moments coexisting in GdFe4Al8
Single crystals of flux-grown tetragonal GdFe4Al8 were characterized by
thermodynamic, transport, and x-ray resonant magnetic scattering measurements.
In addition to antiferromagnetic order at TN ~ 155 K, two low-temperature
transitions at T1 ~ 21 K and T2 ~ 27 K were identified. The Fe moments order at
TN with an incommensurate propagation vector (tau,tau,0) with tau varying
between 0.06 and 0.14 as a function of temperature, and maintain this order
over the entire T<TN range. The Gd 4f moments order below T2 with a
ferromagnetic component mainly out of plane. Below T1, the ferromagnetic
components are confined to the crystallographic plane. Remarkably, at low
temperatures the Fe moments maintain the same modulation as at high
temperatures, but the Gd 4f moments apparently do not follow this modulation.
The magnetic phase diagrams for fields applied in [110] and [001] direction are
presented and possible magnetic structures are discussed.Comment: v2: 14 pages, 12 figures; PRB in prin
Effects of rapid thermal annealing on device characteristics of InGaAs/GaAs quantum dot infrared photodetectors
In this work, rapid thermal annealing was performed on InGaAs/GaAs quantum dot infrared photodetectors (QDIPs) at different temperatures. The photoluminescence showed a blueshifted spectrum in comparison with the as-grown sample when the annealing temperature was higher than 700 °C, as a result of thermal interdiffusion of the quantum dots (QDs). Correspondingly, the spectral response from the annealed QDIP exhibited a redshift. At the higher annealing temperature of 800 °C, in addition to the largely redshifted photoresponse peak of 7.4 µm (compared with the 6.1 µm of the as-grown QDIP), a high energy peak at 5.6 µm (220 meV) was also observed, leading to a broad spectrum linewidth of 40%. This is due to the large interdiffusion effect which could greatly vary the composition of the QDs and thus increase the relative optical absorption intensity at higher energy. The other important detector characteristics such as dark current, peak responsivity, and detectivity were also measured. It was found that the overall device performance was not affected by low annealing temperature, however, for high annealing temperature, some degradation in device detectivity (but not responsivity) was observed. This is a consequence of increased dark current due to defect formation and increased ground state energy. © 2006 American Institute of Physic
Surface Operators in N=2 Abelian Gauge Theory
We generalise the analysis in [arXiv:0904.1744] to superspace, and explicitly
prove that for any embedding of surface operators in a general, twisted N=2
pure abelian theory on an arbitrary four-manifold, the parameters transform
naturally under the SL(2,Z) duality of the theory. However, for
nontrivially-embedded surface operators, exact S-duality holds if and only if
the "quantum" parameter effectively vanishes, while the overall SL(2,Z) duality
holds up to a c-number at most, regardless. Nevertheless, this observation sets
the stage for a physical proof of a remarkable mathematical result by
Kronheimer and Mrowka--that expresses a "ramified" analog of the Donaldson
invariants solely in terms of the ordinary Donaldson invariants--which, will
appear, among other things, in forthcoming work. As a prelude to that, the
effective interaction on the corresponding u-plane will be computed. In
addition, the dependence on second Stiefel-Whitney classes and the appearance
of a Spin^c structure in the associated low-energy Seiberg-Witten theory with
surface operators, will also be demonstrated. In the process, we will stumble
upon an interesting phase factor that is otherwise absent in the "unramified"
case.Comment: 46 pages. Minor refinemen
- …