Temporal and Periodic Variations of Sunspot Counts in Flaring and Non-flaring Active Regions

We analyzed temporal and periodic behavior of sunspot counts (SSCs) in flaring (C, M, or X class flares), and non-flaring active regions (ARs) for the almost two solar cycles (1996 through 2016). Our main findings are as follows: i) The temporal variation of monthly means of daily total SSCs in flaring and non-flaring ARs are different and these differences are also varying from cycle to cycle; temporal profile of non-flaring ARs are wider than the flaring ones during the solar cycle 23, while they are almost the same during the current cycle 24. The second peak (second maximum) of flaring ARs are strongly dominate during current cycle 24, while this difference is not such a remarkable during cycle 23. The amplitude of SSCs in the non-flaring ARs are comparable during the first and second peaks (maxima) of the current solar cycle, while the first peak is almost not existent in case of the flaring ARs. ii) Periodic variations observed in SSCs of flaring and non-flaring ARs are quite different in both MTM spectrum and wavelet scalograms and these variations are also different from one cycle to another; the largest detected period in the flaring ARs is 113 days, while there are much higher periodicities (327, 312, and 256 days) in non-flaring ARs. There are no meaningful periodicities in MTM spectrum of flaring ARs exceeding 45 days during solar cycle 24, while a 113 days periodicity detected from flaring ARs of solar cycle 23. For the non-flaring ARs the largest period is 72 days during solar cycle 24, while the largest period is 327 days during current cycle.Comment: Submitted to Solar Physics, 17 pages, 5 figure

Atomic layer deposition of GaN at low temperatures

Cataloged from PDF version of article.The authors report on the self-limiting growth of GaNthin films at low temperatures. Films were deposited on Si substrates by plasma-enhanced atomic layer deposition using trimethylgallium (TMG) and ammonia (NH3) as the group-III and -V precursors, respectively. GaNdeposition rate saturated at 185 °C for NH3 doses starting from 90 s. Atomic layer deposition temperature window was observed from 185 to ∼385 °C. Deposition rate, which is constant at ∼0.51 Å/cycle within the temperature range of 250 – 350 °C, increased slightly as the temperature decreased to 185 °C. In the bulk film, concentrations of Ga, N, and O were constant at ∼36.6, ∼43.9, and ∼19.5 at. %, respectively. C was detected only at the surface and no C impurities were found in the bulk film. High oxygen concentration in films was attributed to the oxygen impurities present in group-V precursor. High-resolution transmission electron microscopy studies revealed a microstructure consisting of small crystallites dispersed in an amorphous matrix

Self-limiting low-temperature growth of crystalline AIN thin films by plasma-enhanced atomic layer deposition

Cataloged from PDF version of article.We report on the self-limiting growth and characterization of aluminum nitride (AlN) thin films. AlN films were deposited by plasma-enhanced atomic layer deposition on various substrates using trimethylaluminum (TMA) and ammonia (NH3). At 185 degrees C, deposition rate saturated for TMA and NH3 doses starting from 0.05 and 40 S. respectively. Saturative surface reactions between TMA and NH3 resulted in a constant growth rate of similar to 0.86 angstrom/cycle from 100 to 200 degrees C. Within this temperature range, film thickness increased linearly with the number of deposition cycles. At higher temperatures (>= 225 degrees C) deposition rate increased with temperature. Chemical composition and bonding states of the films deposited at 185 degrees C were investigated by Xray photoelectron spectroscopy. High resolution Al 2p and N 1s spectra confirmed the presence of AlN with peaks located at 73.02 and 396.07 eV, respectively. Films deposited at 185 degrees C were polycrystalline with a hexagonal wurtzite structure regardless of the substrate selection as determined by grazing incidence X-ray diffraction. High-resolution transmission electron microscopy images of the AlN thin films deposited on Si (100) and glass substrates revealed a microstructure consisting of nanometer sized crystallites. Films exhibited an optical band edge at similar to 5.8 eV and an optical transmittance of >95% in the visible region of the spectrum. (C) 2011 Elsevier B.V. All rights reserved

Robust Least Squares Methods Under Bounded Data Uncertainties

Cataloged from PDF version of article.We study the problem of estimating an unknown deterministic signal that is observed through an unknown deterministic data matrix under additive noise. In particular, we present a minimax optimization framework to the least squares problems, where the estimator has imperfect data matrix and output vector information. We define the performance of an estimator relative to the performance of the optimal least squares (LS) estimator tuned to the underlying unknown data matrix and output vector, which is defined as the regret of the estimator. We then introduce an efficient robust LS estimation approach that minimizes this regret for the worst possible data matrix and output vector, where we refrain from any structural assumptions on the data. We demonstrate that minimizing this worst-case regret can be cast as a semi-definite programming (SDP) problem. We then consider the regularized and structured LS problems and present novel robust estimation methods by demonstrating that these problems can also be cast as SDP problems. We illustrate the merits of the proposed algorithms with respect to the well-known alternatives in the literature through our simulations

Arterial, neural and muscular variations in the upper limb

During our routine dissection studies we observed arterial, neural and muscular variations in the upper limbs of an adult male cadaver. In this case we observed the superficial brachial artery origination from the third part of the axillary artery, communications between the musculocutaneous and median nerves, variant formation of the brachial plexus, origination of the profunda brachii artery from the posterior circumflex humeral artery and supernumerary tendons of the abductor pollicis longus muscle. We think that such variations should be kept in mind during surgical and diagnostic procedures

Electrical characteristics of B-GaN2O3 thin films grown by PEALD

Cataloged from PDF version of article.In this work, 7.5 nm Ga2O3 dielectric thin films have been deposited on p-type (111) silicon wafer using plasma enhanced atomic layer deposition (PEALD) technique. After the deposition, Ga2O3 thin films were annealed under N-2 ambient at 600, 700, and 800 degrees C to obtain beta-phase. The structure and microstructure of the beta-Ga2O3 thin films was carried out by using grazing-incidence X-ray diffraction (GIXRD). To show effect of annealing temperature on the microstructure of beta-Ga2O3 thin films, average crystallite size was obtained from the full width at half maximum (FWHM) of Bragg lines using the Scherrer formula. It was found that crystallite size increased with increasing annealing temperature and changed from 0.8 nm to 9.1 nm with annealing. In order to perform electrical characterization on the deposited films, Al/beta-Ga2O3/p-Si metal-oxide-semiconductor (MOS) type Schottky barrier diodes (SBDs) were fabricated using the beta-Ga2O3 thin films were annealed at 800 degrees C. The main electrical parameters such as leakage current level, reverse breakdown voltage, series resistance (R-S), ideality factor (n), zero-bias barrier height (phi(Bo)), and interface states (N-SS) were obtained from the current-voltage (I-V) and capacitance-voltage (C-V) measurements at room temperature. The RS values were calculated by using Cheung methods. The energy density distribution profile of the interface states as a function of (E-SS-E-V) was obtained from the forward bias I-V measurements by taking bias dependence of ideality factor, effective barrier height (phi(e)), and R-S into account. Also using the Norde function and C-V technique, phi(e) values were calculated and cross-checked. Results show that beta-Ga2O3 thin films deposited by PEALD technique at low temperatures can be used as oxide layer for MOS devices and electrical properties of these devices are influenced by some important parameters such as NSS, RS, and beta-Ga2O3 oxide layer. (C) 2014 Elsevier B.V. All rights reserved

Effect of post-deposition annealing on the electrical properties of B-Ga2O3 thin films grown on p-Si by plasma-enhanced atomic layer deposition

Cataloged from PDF version of article.Ga2O3 dielectric thin films were deposited on (111)-oriented p-type silicon wafers by plasma-enhanced atomic layer deposition using trimethylgallium and oxygen plasma. Structural analysis of the Ga 2O3 thin films was carried out using grazing-incidence x-ray diffraction. As-deposited films were amorphous. Upon postdeposition annealing at 700, 800, and 900°C for 30min under N2 ambient, films crystallized into β-form monoclinic structure. Electrical properties of the β-Ga2O3 thin films were then investigated by fabricating and characterizing Al/β-Ga2O3/p-Si metal-oxide-semiconductor capacitors. The effect of postdeposition annealing on the leakage current densities, leakage current conduction mechanisms, dielectric constants, flat-band voltages, reverse breakdown voltages, threshold voltages, and effective oxide charges of the capacitors were presented. The effective oxide charges (Qeff) were calculated from the capacitance-voltage (C-V) curves using the flat-band voltage shift and were found as 2.6×1012, 1.9×1012, and 2.5×10 12 cm-2 for samples annealed at 700, 800, and 900°C, respectively. Effective dielectric constants of the films decreased with increasing annealing temperature. This situation was attributed to the formation of an interfacial SiO2 layer during annealing process. Leakage mechanisms in the regions where current increases gradually with voltage were well fitted by the Schottky emission model for films annealed at 700 and 900°C, and by the Frenkel-Poole emission model for film annealed at 800°C. Leakage current density was found to improve with annealing temperature. β-Ga2O3 thin film annealed at 800°C exhibited the highest reverse breakdown field value. © 2014 American Vacuum Society

High carrier concentration induced effects on the bowing parameter and the temperature dependence of the band gap of Ga_xIn_1−xN

The influence of intrinsic carrier concentration on the compositional and temperature dependence of the bandgap of GaxIn1-xN is investigated in nominally undoped samples with Ga fractions of x = 0.019, 0.062, 0.324, 0.52, and 0.56. Hall Effect results show that the free carrier density has a very weak temperature dependence and increases about a factor of 4, when the Ga composition increases from x = 0.019 to 0.56. The photoluminescence (PL) peak energy has also weak temperature dependence shifting to higher energies and the PL line shape becomes increasingly asymmetrical and broadens with increasing Ga composition. The observed characteristics of the PL spectra are explained in terms of the transitions from free electron to localized tail states and the high electron density induced many-body effects. The bowing parameter of GaxIn1-xN is obtained from the raw PL data as 2.5 eV. However, when the high carrier density induced effects are taken into account, it increases by about 14% to 2.9 eV. Furthermore, the temperature dependence of the PL peak becomes more pronounced and follows the expected temperature dependence of the bandgap variation

Effect of Nigella sativa L. on heart rate and some haematological values of alloxan-induced diabetic rabbits

This study was designed to investigate the effect of an extract of Nigella sativa L. on the heart rate and  some haematological values in alloxan-induced diabetic rabbits. Fifteen New Zealand male rabbits were  divided into three experimental groups: control, diabetic and N. sativa L.-treated diabetic. At the end of the  experimental period (2 months), animals in all three groups were fasted for 12 hours and blood samples  were taken for the determination of glucose levels, RBC and WBC (red and white blood cell) counts,  packed cell volume (PCV), and haemoglobin (Hb) concentration. Heart rates were also measured by a  direct-writing electrocardiograph before the blood withdrawals. It was found that N. sativa L. treatment  increased the lowered RBC and WBC counts, PCV and neutrophil percentage in diabetic rabbits. However,  the WBC count of the N. sativa L. treated diabetic group was still lower than the control. N. sativa L.  treatment also decreased the elevated heart rate and glucose concentration of diabetic rabbits. It is concluded  that oral N. sativa L. treatment might decrease the diabetes-induced disturbances of heart rate and some  haematological parameters of alloxan-induced diabetic rabbits.

Polymer-inorganic core-shell nanofibers by electrospinning and atomic layer deposition: flexible nylon-znO core-shell nanofiber mats and their photocatalytic activity

Cataloged from PDF version of article.Polymer-inorganic core-shell nanofibers were produced by two-step approach; electrospinning and atomic layer deposition (ALD). First, nylon 6,6 (polymeric core) nanofibers were obtained by electrospinning, and then zinc oxide (ZnO) (inorganic shell) with precise thickness control was deposited onto electrospun nylon 6,6 nanofibers using ALD technique. The bead-free and uniform nylon 6,6 nanofibers having different average fiber diameters (∼80, ∼240 and ∼650 nm) were achieved by using two different solvent systems and polymer concentrations. ZnO layer about 90 nm, having uniform thickness around the fiber structure, was successfully deposited onto the nylon 6,6 nanofibers. Because of the low deposition temperature utilized (200 °C), ALD process did not deform the polymeric fiber structure, and highly conformal ZnO layer with precise thickness and composition over a large scale were accomplished regardless of the differences in fiber diameters. ZnO shell layer was found to have a polycrystalline nature with hexagonal wurtzite structure. The core-shell nylon 6,6-ZnO nanofiber mats were flexible because of the polymeric core component. Photocatalytic activity of the core-shell nylon 6,6-ZnO nanofiber mats were tested by following the photocatalytic decomposition of rhodamine-B dye. The nylon 6,6-ZnO nanofiber mat, having thinner fiber diameter, has shown better photocatalytic efficiency due to higher surface area of this sample. These nylon 6,6-ZnO nanofiber mats have also shown structural stability and kept their photocatalytic activity for the second cycle test. Our findings suggest that core-shell nylon 6,6-ZnO nanofiber mat can be a very good candidate as a filter material for water purification and organic waste treatment because of their photocatalytic properties along with structural flexibility and stability. © 2012 American Chemical Society