Effect of COD: SO42- Ratio, HRT and Linoleic Acid Concentration on Mesophilic Sulfate Reduction: Reactor Performance and Microbial Population Dynamics

Biological sulfate (SO42-) reduction was examined in anaerobic sequential batch reactors (ASBRs) operated under different hydraulic retention times (HRTs) ranging from 12 to 36 h and COD (Chemical Oxygen Demand)/SO42- ratios of 2.4, 1.6 and 0.8. Competition between SO42- reducing bacteria (SRBs), methane producing archaea (MPAs) and homoacetogens (HACs) was examined in controls and cultures treated with linoleic acid (LA). The ASBR performance was influenced by the COD/SO42- ratio in control cultures with a SO42- reduction of 87% at a COD/SO42- ratio of 0.8. At a 12 h HRT, in both control and LA treated cultures, greater than 75% SO42- removal was observed under all the conditions examined. In control reactors operating at a 36 h HRT, high levels of MPAs belonging to Methanobacteriales and Methanosarcinales were detected; however, in comparison, under low COD/SO42- ratio and with decreasing HRT conditions, a relative increase in SRBs belonging to Desulfovibrio and Desulfatibacillum was observed. Adding 0.5 gL(-1) LA suppressed Methanobacteriales, while increasing the LA concentration to 1 gL(-1) completely suppressed MPAs with a relative increase in SRBs. HACs belonging to Bacteroidetes were observed in the control and in cultures operated at 12 h HRT with a COD/SO42- ratio of 1.6 and fed 0.5 gL(-1) LA; however, with all other LA levels (0.5 and 1.0 gL(-1)) and HRTs (12, 24 and 36 h), HACs were not detected

Optimal Metal Dose of Alternative Cathode Catalyst Considering Organic Substances in Single Chamber Microbial Fuel Cells

Abstract Optimal preparation guidelines of a cathode catalyst layer by non-precious metal catalysts were evaluated based on electrochemical performance in single-chamber microbial fuel cells (MFCs). Experiments for catalyst loading rate revealed that iron(II) phthalocyanine (FePc) can be a promising alternative, comparable to platinum (Pt) and cobalt tetramethoxyphenylporphyrin (CoTMPP), including effects of substrate concentration. Results showed that using an optimal FePc loading of 1 mg/cm 2 was equivalent to a Pt loading of 0.35 mg/cm 2 on the basis of maximum power density. Given higher loading rates or substrate concentrations, FePc proved to be a better alternative for Pt than CoTMPP. Under the optimal loading rate, it was further revealed that 40 wt% of FePc to carbon support allowed for the best power generation. These results suggest that proper control of the non-precious metal catalyst layer and substrate concentration are highly interrelated, and reveal how those combinations promote the economic power generation of single-chamber MFCs