8 research outputs found
Diet and subsistence in Bronze Age pastoral communities from the southern Russian steppes and the North Caucasus
The flanks of the Caucasus Mountains and the steppe landscape to their north offered highly productive grasslands for Bronze Age herders and their flocks of sheep, goat, and cattle. While the archaeological evidence points to a largely pastoral lifestyle, knowledge regarding the general composition of human diets and their variation across landscapes and during the different phases of the Bronze Age is still restricted. Human and animal skeletal remains from the burial mounds that dominate the archaeological landscape and their stable isotope compositions are major sources of dietary information. Here, we present stable carbon and nitrogen isotope data of bone collagen of 105 human and 50 animal individuals from the 5th millennium BC to the Sarmatian period, with a strong focus on the Bronze Age and its cultural units including Maykop, Yamnaya, Novotitorovskaya, North Caucasian, Catacomb, post-Catacomb and late Bronze Age groups. The samples comprise all inhumations with sufficient bone preservation from five burial mound sites and a flat grave cemetery as well as subsamples from three further sites. They represent the Caucasus Mountains in the south, the piedmont zone and Kuban steppe with humid steppe and forest vegetation to its north, and more arid regions in the Caspian steppe. The stable isotope compositions of the bone collagen of humans and animals varied across the study area and reflect regional diversity in environmental conditions and diets. The data agree with meat, milk, and/or dairy products from domesticated herbivores, especially from sheep and goats having contributed substantially to human diets, as it is common for a largely pastoral economy. This observation is also in correspondence with the faunal remains observed in the graves and offerings of animals in the mound shells. In addition, foodstuffs with elevated carbon and nitrogen isotope values, such as meat of unweaned animals, fish, or plants, also contributed to human diets, especially among communities living in the more arid landscapes. The regional distinction of the animal and human data with few outliers points to mobility radii that were largely concentrated within the environmental zones in which the respective sites are located. In general, dietary variation among the cultural entities as well as regarding age, sex and archaeologically indicated social status is only weakly reflected. There is, however, some indication for a dietary shift during the Early Bronze Age Maykop period
The effect of climate change on avian offspring production: A global meta-analysis
Climate change affects timing of reproduction in many bird species, but few studies have investigated its influence on annual reproductive output. Here, we assess changes in the annual production of young by female breeders in 201 populations of 104 bird species (N = 745,962 clutches) covering all continents between 1970 and 2019. Overall, average offspring production has declined in recent decades, but considerable differences were found among species and populations. A total of 56.7% of populations showed a declining trend in offspring production (significant in 17.4%), whereas 43.3% exhibited an increase (significant in 10.4%). The results show that climatic changes affect offspring production through compounded effects on ecological and life history traits of species. Migratory and larger-bodied species experienced reduced offspring production with increasing temperatures during the chick-rearing period, whereas smaller-bodied, sedentary species tended to produce more offspring. Likewise, multi-brooded species showed increased breeding success with increasing temperatures, whereas rising temperatures were unrelated to repro- ductive success in single-brooded species. Our study suggests that rapid declines in size of bird populations reported by many studies from different parts of the world are driven only to a small degree by changes in the production of young
Selective Laser Melting of Hydroxyapatite: Perspectives for 3D Printing of Bioresorbable Ceramic Implants
Hydroxyapatite, being the major mineral component of tooth enamel and natural bones, is a good candidate for bone tissue engineering applications. One of the promising approaches for manufacturing of three-dimensional objects is selective laser sintering/melting which enables the creation of a dense structure directly during 3D printing by adding material layer-by-layer. The effect of laser irradiation with a wavelength of 10.6 μm on the behavior of mechanochemically synthesized hydroxyapatite under different treatment conditions was studied for the first time in this work. It was shown that, in contrast to laser treatment, the congruent melting is impossible under conditions of a relatively slow rate of heating in a furnace. Depending on the mode of laser treatment, hydroxyapatite can be sintered or melted, or partially decomposed into the more resorbable calcium phosphates. It was found that the congruent selective laser melting of hydroxyapatite can be achieved by treating the dense powder layer with a 0.2 mm laser spot at a power of 4 W and at a scanning speed of 700 mm/s. Melting was shown to be accompanied by the crystallization of a dense monolayer of oxyhydroxyapatite while preserving the initial apatite crystal lattice. The thickness of the melted layer, the presence of micron-sized pores, and the phase composition can be controlled by varying the scanning speed and laser power. This set of parameters permits the use of selective laser melting technology for the production of oxyhydroxyapatite biodegradable implants with acceptable properties by 3D printing
Effect of Mechanical Shaking on the Physicochemical Properties of Aqueous Solutions
Long-lived luminescence in the blue region was found to occur in deionized water saturated with atmospheric gases following mechanical shaking. Luminescence intensity decreased exponentially after the cessation of stress. During vigorous mechanical shaking, we observed gas bubbles in solution, and the liquid–gas interface area increased noticeably. At the same time, the concentration of molecular oxygen decreased, which could not be attributed to the water warming up with exposure to mechanical stress. However, deaerated water rapidly became saturated with gases following mechanical stress. The recommendation that cell culture media should be mixed after they are removed from the fridge in order to allow saturation with oxygen is probably misleading. It was shown that gases existed in water both in the form of individual molecules and nanobubbles. Mechanical stress did not influence the number or size of nanobubbles. While gas nanobubbles were absent in freshly prepared deaerated water, they appeared following exposure to mechanical stress. In addition, in mechanically treated gas-saturated water, there was seemingly an equilibrium shift towards the decomposition of carbonic acid to water and carbon dioxide. At the same time, the pH of water tended to increase immediately after mechanical stress. It was demonstrated that reactive oxygen species (ROS) form in gas-saturated water under mechanical stress (30 Hz, amplitude of 5 mm). The relative generation rate of hydrogen peroxide and of the hydroxyl radical was 1 nM/min and 0.5 nM/min, respectively. It was found that with an increase in the frequency of mechanical action (f), the rate of ROS generation increased in proportion to f 2. The major pathways for hydrogen peroxide generation are probably associated with the formation of singlet oxygen and its further reduction, and the alternative pathway is the formation of hydrogen peroxide as a result of hydroxyl radical recombination
Cu-10 wt.% Al Alloys Produced by Spark Plasma Sintering of Powder Blends and a Mechanically Alloyed Mixture: A Comparative Investigation
Cu–Al bronzes are interesting metallic materials, demonstrating higher hardness, higher wear resistance, higher corrosion resistance and a lower friction coefficient as compared with unalloyed copper. The powder metallurgy approach to the fabrication of these alloys presents opportunities to tailor their phase composition and grain size. In the present work, the structural characteristics, phase composition and properties of Cu-10 wt.% Al alloys obtained by spark plasma sintering (SPS) of powder blends and a powder obtained by mechanical alloying (based on Cu(Al) solid solution) are reported. Alloys with different interaction degrees between the metals were obtained by SPS. The blends demonstrated better sinterability than the mechanically alloyed powder: a nearly fully dense alloy was obtained by SPS of the blend at 480 °C, whereas a temperature of 800 °C was necessary to consolidate the mechanically alloyed powder. The hardness and electrical conductivity of the sintered alloys were comparatively analyzed. It was shown that the Cu-10 wt.% Al alloys obtained without the mechanical alloying stage possess hardness and electrical conductivity comparable to those of the alloys obtained from the mechanically milled powder
Mimics of Pincer Ligands: An Accessible Phosphine-Free N(Pyrimidin-2-yl)-1,2-azole-3-carboxamide Framework for Binuclear Pd(II) Complexes and High-Turnover Catalysis in Water
The effect of climate change on avian offspring production: A global meta-analysis
Climate change affects timing of reproduction in many bird species, but few stud-ies have investigated its influence on annual reproductive output. Here, we assess changes in the annual production of young by female breeders in 201 populations of 104 bird species (N = 745,962 clutches) covering all continents between 1970 and 2019. Overall, average offspring production has declined in recent decades, but considerable differences were found among species and populations. A total of 56.7% of populations showed a declining trend in offspring production (significant in 17.4%), whereas 43.3% exhibited an increase (significant in 10.4%). The results show that climatic changes affect offspring production through compounded effects on ecological and life history traits of species. Migratory and larger-bodied species experienced reduced offspring production with increasing temperatures during the chick-rearing period, whereas smaller-bodied, sedentary species tended to produce more offspring. Likewise, multi-brooded species showed increased breeding success with increasing temperatures, whereas rising temperatures were unrelated to repro-ductive success in single-brooded species. Our study suggests that rapid declines in size of bird populations reported by many studies from different parts of the world are driven only to a small degree by changes in the production of young
The effect of climate change on avian offspring production:a global meta-analysis
Abstract
Climate change affects timing of reproduction in many bird species, but few stud-ies have investigated its influence on annual reproductive output. Here, we assess changes in the annual production of young by female breeders in 201 populations of 104 bird species (N = 745,962 clutches) covering all continents between 1970 and 2019. Overall, average offspring production has declined in recent decades, but considerable differences were found among species and populations. A total of 56.7% of populations showed a declining trend in offspring production (significant in 17.4%), whereas 43.3% exhibited an increase (significant in 10.4%). The results show that climatic changes affect offspring production through compounded effects on ecological and life history traits of species. Migratory and larger-bodied species experienced reduced offspring production with increasing temperatures during the chick-rearing period, whereas smaller-bodied, sedentary species tended to produce more offspring. Likewise, multi-brooded species showed increased breeding success with increasing temperatures, whereas rising temperatures were unrelated to repro-ductive success in single-brooded species. Our study suggests that rapid declines in size of bird populations reported by many studies from different parts of the world are driven only to a small degree by changes in the production of young