A binary signature in the non-thermal radio-emitter Cyg OB2 #9

Aims: Non-thermal radio emission associated with massive stars is believed to arise from a wind-wind collision in a binary system. However, the evidence of binarity is still lacking in some cases, notably Cyg OB2 #9 Methods: For several years, we have been monitoring this heavily-reddened star from various observatories. This campaign allowed us to probe variations both on short and long timescales and constitutes the first in-depth study of the visible spectrum of this object. Results: Our observations provide the very first direct evidence of a companion in Cyg OB2 #9, confirming the theoretical wind-wind collision scenario. These data suggest a highly eccentric orbit with a period of a few years, compatible with the 2yr-timescale measured in the radio range. In addition, the signature of the wind-wind collision is very likely reflected in the behaviour of some emission lines.Comment: accepted by A&A, 4 p, 3figure

Direct measurement of the radiative lifetime of vibrationally excited OH radicals

Neutral molecules, isolated in the gas-phase, can be prepared in a long-lived excited state and stored in a trap. The long observation time afforded by the trap can then be exploited to measure the radiative lifetime of this state by monitoring the temporal decay of the population in the trap. This method is demonstrated here and used to benchmark the Einstein $A$-coefficients in the Meinel system of OH. A pulsed beam of vibrationally excited OH radicals is Stark decelerated and loaded into an electrostatic quadrupole trap. The radiative lifetime of the upper $\Lambda$-doublet component of the $X ^2\Pi_{3/2}, v=1, J=3/2$ level is determined as $59.0 \pm 2.0$ ms, in good agreement with the calculated value of $57.7 \pm 1.0$ ms.Comment: 4 pages, 3 figures, submitted to Phys. Rev. Let

Processing of strong flux trapping high T(subc) oxide superconductors: Center director's discretionary fund

Magnetic suspension effect was first observed in samples of YBa2Cu3O7/AgO(Y-123/AgO) composites. Magnetization measurements of these samples show a much larger hysteresis which corresponds to a large critical current density. In addition to the Y-123AgO composites, recently similar suspension effects in other RE-123/AgO, where RE stands for rare-Earth elements, were also observed. Some samples exhibit even stronger flux pinning than that of the Y-123/AgO sample. An interesting observation was that in order to form the composite which exhibits strong flux trapping effect the sintering temperature depends on the particular RE-123 compound used. The paper presents the detailed processing conditions for the formation of these RE-123/AgO composites, as well as the magnetization and critical field data

Stress Distribution in Mandible Regulated by Bone and Dental Implant Parameters: Part I - Methodology

The complicated inter-relationships between mandibular bone components and dental implants have attracted the attention of many a structural mechanics researcher as well as many a dental practitioner. This paper describes the methodology and analysis techniques employed to enable accurate evaluation of a vast range of the implant and bone parameters. The complex material and geometric properties of the bone and implant are modelled using two-dimensional (2D) triangular and quadrilateral plane strain elements. Assumptions made in the analysis include: (a) 50% osseointegration between bone and implant; (b) linear relationships exist between the stress value and the Young’s moduli of the cancellous and cortical bone at any specific point. In the companion paper (Part II) various bone, implant and loading parameters are evaluated for their influence on the stress distribution within the bone, in particular in the mandible

Microwave Components with MEMS Switches

RF MEMS switches with metal-metal contacts are being developed for microwave applications where broadband, high linearity performance is required. These switches provide less than 0.2 dB insertion loss through 40 GHz. This paper describes the integration of these switches into selected microwave components such as reconfigurable antenna elements, tunable filters, switched delay lines, and SPDT switches. Microwave and millimeter wave measured results from these circuits are presented