Detection and localization of continuous gravitational waves with pulsar timing arrays: the role of pulsar terms

A pulsar timing array is a Galactic-scale detector of nanohertz gravitational waves (GWs). Its target signals contain two components: the `Earth term' and the `pulsar term' corresponding to GWs incident on the Earth and pulsar respectively. In this work we present a Frequentist method for the detection and localization of continuous waves that takes into account the pulsar term and is significantly faster than existing methods. We investigate the role of pulsar terms by comparing a full-signal search with an Earth-term-only search for non-evolving black hole binaries. By applying the method to synthetic data sets, we find that (i) a full-signal search can slightly improve the detection probability (by about five percent); (ii) sky localization is biased if only Earth terms are searched for and the inclusion of pulsar terms is critical to remove such a bias; (iii) in the case of strong detections (with signal-to-noise ratio $\gtrsim$ 30), it may be possible to improve pulsar distance estimation through GW measurements.Comment: 12 pages, 9 figures, typos corrected. To match the published version. Code implementing this method is available at the PPTA Wiki pag

Time and frequency localized pulse shape for resolution enhancement in STFT-BOTDR

Short Time Fourier Transform-Brillouin Optical Time Domain Reflectometry (STFT-BOTDR) implements STFT over the full frequency spectrum to measure the distributed temperature and strain along the optic fiber, providing new research advances in dynamic distributed sensing. The spatial and frequency resolution of the dynamic sensing is limited by the Signal to Noise Ratio (SNR) and the Time-Frequency (T-F) localization of the input pulse shape. T-F localization is fundamentally important for the communication system, which suppresses interchannel interference (ICI) and intersymbol interference (ISI) to improve the transmission quality in multi-carrier modulation (MCM). This paper demonstrates that the T-F localized input pulse shape can enhance the SNR, the spatial and frequency resolution in STFT-BOTDR. Simulation and experiments of T-F localized different pulses shapes are conducted to compare the limitation of the system resolution. The result indicates that rectangular pulse should be selected to optimize the spatial resolution, Lorentzian pulse could be chosen to optimize the frequency resolution, while Gaussian shape pulse can be used in general applications for its balanced performance in both spatial and frequency resolution. Meanwhile, T-F localization is proved to be useful in the pulse shape selection for system resolution optimization

Rotor profile design and numerical analysis of 2–3 type multiphase twin-screw pumps

Increasing demands for high-performance handling of fluids in oil and gas as well as other applications require improvements of efficiency and reliability of screw pumps. Rotor profile plays the key role in the performance of such machines. This paper analyses difference in performance of 2–3 lobe combination of twin-screw pumps with different rotor profiles. A-type profile formed of involute–cycloid curves and D-type formed of cycloid curves are typical representatives for 2–3 type screw pumps. The investigation is performed by use of a full 3-D computational fluid dynamics analysis based on a single-domain structured moving mesh obtained by novel grid generation procedure. The real-time mass flow rate, rotor torque, pressure distribution and velocity field were obtained from 3D computational fluid dynamics calculations. The performance curves were produced for variable rotation speeds and variable discharge pressures. The computational fluid dynamics model was validated by comparing the simulation results of the A-type pump with the experimental data. In order to get the performance characteristics of D-type profile, two rotors with D-type profile were designed. The first has the same displacement volume as A-type while the second has the same lead and rotor length as A-type but different displacement volume. The comparison of results obtained with two rotor profiles gave an insight on the advantages and disadvantages of each of them

Guinea Pig Model for Evaluating the Potential Public Health Risk of Swine and Avian Influenza Viruses

BACKGROUND: The influenza viruses circulating in animals sporadically transmit to humans and pose pandemic threats. Animal models to evaluate the potential public health risk potential of these viruses are needed. METHODOLOGY/PRINCIPAL FINDINGS: We investigated the guinea pig as a mammalian model for the study of the replication and transmission characteristics of selected swine H1N1, H1N2, H3N2 and avian H9N2 influenza viruses, compared to those of pandemic (H1N1) 2009 and seasonal human H1N1, H3N2 influenza viruses. The swine and avian influenza viruses investigated were restricted to the respiratory system of guinea pigs and shed at high titers in nasal tracts without prior adaptation, similar to human strains. None of the swine and avian influenza viruses showed transmissibility among guinea pigs; in contrast, pandemic (H1N1) 2009 virus transmitted from infected guinea pigs to all animals and seasonal human influenza viruses could also horizontally transmit in guinea pigs. The analysis of the receptor distribution in the guinea pig respiratory tissues by lectin histochemistry indicated that both SAα2,3-Gal and SAα2,6-Gal receptors widely presented in the nasal tract and the trachea, while SAα2,3-Gal receptor was the main receptor in the lung. CONCLUSIONS/SIGNIFICANCE: We propose that the guinea pig could serve as a useful mammalian model to evaluate the potential public health threat of swine and avian influenza viruses

The Mock LISA Data Challenges: from Challenge 1B to Challenge 3

The Mock LISA Data Challenges are a programme to demonstrate and encourage the development of LISA data-analysis capabilities, tools and techniques. At the time of this workshop, three rounds of challenges had been completed, and the next was about to start. In this article we provide a critical analysis of entries to the latest completed round, Challenge 1B. The entries confirm the consolidation of a range of data-analysis techniques for Galactic and massive--black-hole binaries, and they include the first convincing examples of detection and parameter estimation of extreme--mass-ratio inspiral sources. In this article we also introduce the next round, Challenge 3. Its data sets feature more realistic waveform models (e.g., Galactic binaries may now chirp, and massive--black-hole binaries may precess due to spin interactions), as well as new source classes (bursts from cosmic strings, isotropic stochastic backgrounds) and more complicated nonsymmetric instrument noise.Comment: 20 pages, 3 EPS figures. Proceedings of the 12th Gravitational Wave Data Analysis Workshop, Cambridge MA, 13--16 December 2007. Typos correcte

The synergetic effects of surface texturing and MoDDP additive applied to ball-on-disk friction subject to both flooded and starved lubrication conditions

This paper reports a novel work on the synergetic effects of microscale surface texturing and lubricant friction modifier additive of molybdenum dialkyldithiophosphate (MoDDP) subject to both flooded and starved lubrication conditions. The experiments were performed on reciprocating ball-on-disk friction in GTL8 base oil with and without MoDDP. In the flooded lubrication condition, the test results demonstrated that the presence of the MoDDP additive contributed to lower friction coefficients, and also more pronounced effect of surface textures on friction than in the case of the bare base oil. In the starved lubrication experiments, textured and texture-free surfaces in the oils with and without MoDDP additive were tested until an abrupt rising of friction coefficient was detected. The results showed that the magnitude of friction coefficient before terminating each test was the almost same for various tests, while the endurance time in different test conditions was significantly different. The textured surface exhibited longer endurance time than the texture-free surface, especially when the MoDDP additive was used. The mechanism of the synergetic effects of surface textures and MoDDP additive has been discussed based on the experimental observations in the following sections. This study provides a new idea for the application of surface texture in boundary lubrication when lubricant additive is contained in the lubricating oils

Preparation of chitosan derivatives containing aromatic five-membered heterocycles for efficient antimicrobial and antioxidant activities

In this study, nine chitosan derivatives containing aromatic five-membered heterocycles were prepared and the effects of different grafting methods on the biological activities of chitosan derivatives were investigated. The structures of all the compounds were characterized by Fourier Transform Infrared (FT-IR) spectroscopy and Nuclear Magnetic Resonance (NMR) spectroscopy, while the antioxidant, antifungal and antibacterial activities of the chitosan derivatives were tested. The experimental data suggested that the chitosan derivatives had outstanding inhibitory ability against Fusarium graminearum, Fusarium oxysporum f.sp.cucumbrum, Staphylococcus aureus and Escherichia coli. At the same time, some of the compounds showed strong scavenging ability against DPPH radical and superoxide radical. Cytotoxicity experiments have demonstrated that some chitosan derivatives are non-toxic to L929 cells. More importantly, compared to chitosan, these chitosan derivatives have good water solubility and can be used as potential polymers for antifungal and antibacterial biomaterials in agriculture