1,340 research outputs found

    Insect populations across an urban-to-suburban land use gradient.

    Get PDF
    Insect populations, especially those of pollinators, have been steadily declining across the globe in recent decades, a trend that is intensified in cities. Since the conservation of pollinators is crucial for maintaining ecosystems and ecological processes, new approaches are being promoted beyond those of conserving large natural areas. Urban native plant gardens could potentially offset some of these losses locally. This research attempts to set a local baseline for the insect diversity in urban gardens in Louisville and determine whether differences exist in garden insects in cities versus suburbs in Jefferson County, Kentucky. To address the land-use question we established 23 collection sites across the county ranging in degree of “urbanness”, with four being established in local parks to serve as natural reference sites. We also addressed a methodological question concerning the abundance and types of insects caught using different colored bowls set at two different heights. Each collection site consisted of 6 bowls filled with detergent-water. Three were 100-cm above the ground and three were 15-cm above the ground. At each height we set up a blue, white and yellow bowl filled with detergent-water to capture insects. We collected insects caught over a 24-hour period at the end of June and again at the end of July in 2017. Identification was performed to taxonomic order, with additional subcategories below order for certain groupings. The impact of bowl color, bowl height, time period of capture, and degree of “urbanness” (measured by % Impervious Surface) on abundance and diversity of insects captured were assessed. We found little difference in insect abundance at the taxonomic order level among the native plant gardens and between gardens and the meadow reference sites. However, we did find evidence in July that bee abundance was lower in urban vs. suburban and meadow locations. We also found that yellow bowls captured the most insects, while height also played a significant role, with the high bowls capturing more than low bowls. More insects were captured in July than June. Our findings suggest that the creation of more native plant gardens in cities and suburbs may well be a viable conservation strategy for supporting insects, including pollinators

    Development of a healthy biscuit: an alternative approach to biscuit manufacture

    Get PDF
    OBJECTIVE: Obesity (BMI >30) and related health problems, including coronary heart disease (CHD), is without question a public health concern. The purpose of this study was to modify a traditional biscuit by the addition of vitamin B(6), vitamin B(12), Folic Acid, Vitamin C and Prebiotic fibre, while reducing salt and sugar. DESIGN: Development and commercial manufacture of the functional biscuit was carried out in collaboration with a well known and respected biscuit manufacturer of International reputation. The raw materials traditionally referred to as essential in biscuit manufacture, i.e. sugar and fat, were targeted for removal or reduction. In addition, salt was completely removed from the recipe. PARTICIPANTS: University students of both sexes (n = 25) agreed to act as subjects for the study. Ethical approval for the study was granted by the University ethics committee. The test was conducted as a single blind crossover design, and the modified and traditional biscuits were presented to the subjects under the same experimental conditions in a random fashion. RESULTS: No difference was observed between the original and the modified product for taste and consistency (P > 0.05). The modified biscuit was acceptable to the consumer in terms of eating quality, flavour and colour. Commercial acceptability was therefore established. CONCLUSION: This study has confirmed that traditional high-fat and high-sugar biscuits which are not associated with healthy diets by most consumers can be modified to produce a healthy alternative that can be manufactured under strict commercial conditions

    Measurement of triple gauge boson couplings from WW production at LEP energies up to 189 GeV

    Get PDF
    A measurement of triple gauge boson couplings is presented, based on W-pair data recorded by the OPAL detector at LEP during 1998 at a centre-of-mass energy of 189 GeV with an integrated luminosity of 183 pb^-1. After combining with our previous measurements at centre-of-mass energies of 161-183 GeV we obtain k_g=0.97 +0.20 -0.16, g_1^z=0.991 +0.060 -0.057 and lambda_g=-0.110 +0.058 -0.055, where the errors include both statistical and systematic uncertainties and each coupling is determined by setting the other two couplings to their SM values. These results are consistent with the Standard Model expectations.Comment: 28 pages, 8 figures, submitted to Eur. Phys. J.

    Bose-Einstein Correlations of Three Charged Pions in Hadronic Z^0 Decays

    Get PDF
    Bose-Einstein Correlations (BEC) of three identical charged pions were studied in 4 x 10^6 hadronic Z^0 decays recorded with the OPAL detector at LEP. The genuine three-pion correlations, corrected for the Coulomb effect, were separated from the known two-pion correlations by a new subtraction procedure. A significant genuine three-pion BEC enhancement near threshold was observed having an emitter source radius of r_3 = 0.580 +/- 0.004 (stat.) +/- 0.029 (syst.) fm and a strength of \lambda_3 = 0.504 +/- 0.010 (stat.) +/- 0.041 (syst.). The Coulomb correction was found to increase the \lambda_3 value by \~9% and to reduce r_3 by ~6%. The measured \lambda_3 corresponds to a value of 0.707 +/- 0.014 (stat.) +/- 0.078 (syst.) when one takes into account the three-pion sample purity. A relation between the two-pion and the three-pion source parameters is discussed.Comment: 19 pages, LaTeX, 5 eps figures included, accepted by Eur. Phys. J.

    Search for Neutral Higgs Bosons in e+e- Collisions at sqrt(s) ~189GeV

    Full text link
    A search for neutral Higgs bosons has been performed with the OPAL detector at LEP, using approximately 170 pb-1 of e+e- collision data collected at sqrt(s)~189GeV. Searches have been performed for the Standard Model (SM) process e+e- to H0Z0 and the MSSM processes e+e- to H0Z0, A0h0. The searches are sensitive to the b b-bar and tau antitau decay modes of the Higgs bosons, and also to the MSSM decay mode h0 to A0A0. OPAL search results at lower centre-of-mass energies have been incorporated in the limits we set, which are valid at the 95% confidence level. For the SM Higgs boson, we obtain a lower mass bound of 91.0 GeV. In the MSSM, our limits are mh>74.8GeV and mA>76.5GeV, assuming tan(beta)>1, that the mixing of the scalar top quarks is either zero or maximal, and that the soft SUSY-breaking masses are 1 TeV. For the case of zero scalar top mixing, we exclude values of tan(beta) between 0.72 and 2.19.Comment: 38 pages, 15 figures, submitted Euro. Phys. J.

    Measurements of Flavour Dependent Fragmentation Functions in Z^0 -> qq(bar) Events

    Get PDF
    Fragmentation functions for charged particles in Z -> qq(bar) events have been measured for bottom (b), charm (c) and light (uds) quarks as well as for all flavours together. The results are based on data recorded between 1990 and 1995 using the OPAL detector at LEP. Event samples with different flavour compositions were formed using reconstructed D* mesons and secondary vertices. The \xi_p = ln(1/x_E) distributions and the position of their maxima \xi_max are also presented separately for uds, c and b quark events. The fragmentation function for b quarks is significantly softer than for uds quarks.Comment: 29 pages, LaTeX, 5 eps figures (and colour figs) included, submitted to Eur. Phys. J.

    A measurement of the tau mass and the first CPT test with tau leptons

    Full text link
    We measure the mass of the tau lepton to be 1775.1+-1.6(stat)+-1.0(syst.) MeV using tau pairs from Z0 decays. To test CPT invariance we compare the masses of the positively and negatively charged tau leptons. The relative mass difference is found to be smaller than 3.0 10^-3 at the 90% confidence level.Comment: 10 pages, 4 figures, Submitted to Phys. Letts.

    Bose-Einstein Correlations in e+e- to W+W- at 172 and 183 GeV

    Get PDF
    Bose-Einstein correlations between like-charge pions are studied in hadronic final states produced by e+e- annihilations at center-of-mass energies of 172 and 183 GeV. Three event samples are studied, each dominated by one of the processes W+W- to qqlnu, W+W- to qqqq, or (Z/g)* to qq. After demonstrating the existence of Bose-Einstein correlations in W decays, an attempt is made to determine Bose-Einstein correlations for pions originating from the same W boson and from different W bosons, as well as for pions from (Z/g)* to qq events. The following results are obtained for the individual chaoticity parameters lambda assuming a common source radius R: lambda_same = 0.63 +- 0.19 +- 0.14, lambda_diff = 0.22 +- 0.53 +- 0.14, lambda_Z = 0.47 +- 0.11 +- 0.08, R = 0.92 +- 0.09 +- 0.09. In each case, the first error is statistical and the second is systematic. At the current level of statistical precision it is not established whether Bose-Einstein correlations, between pions from different W bosons exist or not.Comment: 24 pages, LaTeX, including 6 eps figures, submitted to European Physical Journal

    W+W- production and triple gauge boson couplings at LEP energies up to 183 GeV

    Get PDF
    A study of W-pair production in e+e- annihilations at Lep2 is presented, based on 877 W+W- candidates corresponding to an integrated luminosity of 57 pb-1 at sqrt(s) = 183 GeV. Assuming that the angular distributions of the W-pair production and decay, as well as their branching fractions, are described by the Standard Model, the W-pair production cross-section is measured to be 15.43 +- 0.61 (stat.) +- 0.26 (syst.) pb. Assuming lepton universality and combining with our results from lower centre-of-mass energies, the W branching fraction to hadrons is determined to be 67.9 +- 1.2 (stat.) +- 0.5 (syst.)%. The number of W-pair candidates and the angular distributions for each final state (qqlnu,qqqq,lnulnu) are used to determine the triple gauge boson couplings. After combining these values with our results from lower centre-of-mass energies we obtain D(kappa_g)=0.11+0.52-0.37, D(g^z_1)=0.01+0.13-0.12 and lambda=-0.10+0.13-0.12, where the errors include both statistical and systematic uncertainties and each coupling is determined setting the other two couplings to the Standard Model value. The fraction of W bosons produced with a longitudinal polarisation is measured to be 0.242+-0.091(stat.)+-0.023(syst.). All these measurements are consistent with the Standard Model expectations.Comment: 48 pages, LaTeX, including 13 eps or ps figures, submitted to European Physical Journal

    Measurement of the B0 Lifetime and Oscillation Frequency using B0->D*+l-v decays

    Full text link
    The lifetime and oscillation frequency of the B0 meson has been measured using B0->D*+l-v decays recorded on the Z0 peak with the OPAL detector at LEP. The D*+ -> D0pi+ decays were reconstructed using an inclusive technique and the production flavour of the B0 mesons was determined using a combination of tags from the rest of the event. The results t_B0 = 1.541 +- 0.028 +- 0.023 ps, Dm_d = 0.497 +- 0.024 +- 0.025 ps-1 were obtained, where in each case the first error is statistical and the second systematic.Comment: 17 pages, 4 figures, submitted to Phys. Lett.
    • …
    corecore