466 research outputs found
Group delay in THz spectroscopy with ultra-wideband log-spiral antennae
We report on the group delay observed in continuous-wave terahertz
spectroscopy based on photomixing with phase-sensitive homodyne detection. We
discuss the different contributions of the experimental setup to the phase
difference \Delta\phi(\nu) between transmitter arm and receiver arm. A simple
model based on three contributions yields a quantitative description of the
overall behavior of \Delta\phi(\nu). Firstly, the optical path-length
difference gives rise to a term linear in frequency. Secondly, the
ultra-wideband log-spiral antennae effectively radiate and receive in a
frequency-dependent active region, which in the most simple model is an annular
area with a circumference equal to the wavelength. The corresponding term
changes by roughly 6 pi between 100 GHz and 1 THz. The third contribution stems
from the photomixer impedance. In contrast, the derivative (d\Delta\phi / d\nu)
is dominated by the contribution of periodic modulations of \Delta\phi(\nu)
caused by standing waves, e.g., in the photomixers' Si lenses. Furthermore, we
discuss the Fourier-transformed spectra, which are equivalent to the waveform
in a time-domain experiment. In the time domain, the group delay introduced by
the log-spiral antennae gives rise to strongly chirped signals, in which low
frequencies are delayed. Correcting for the contributions of antennae and
photomixers yields sharp peaks or "pulses" and thus facilitates a
time-domain-like analysis of our continuous-wave data.Comment: 7 pages, 7 figure
Self-normalizing phase measurement in multimode terahertz spectroscopy based on photomixing of three lasers
Photomixing of two near-infrared lasers is well established for
continuous-wave terahertz spectroscopy. Photomixing of three lasers allows us
to measure at three terahertz frequencies simultaneously. Similar to Fourier
spectroscopy, the spectral information is contained in an nterferogram, which
is equivalent to the waveform in time-domain spectroscopy. We use one fixed
terahertz frequency \nu_ref to monitor temporal drifts of the setup, i.e., of
the optical path-length difference. The other two frequencies are scanned for
broadband high-resolution spectroscopy. The frequency dependence of the phase
is obtained with high accuracy by normalizing it to the data obtained at
\nu_ref, which eliminates drifts of the optical path-length difference. We
achieve an accuracy of about 1-2 microns or 10^{-8} of the optical path length.
This method is particularly suitable for applications in nonideal environmental
conditions outside of an air-conditioned laboratory.Comment: 5 pages, 5 figure
Local seismic cultures: the use of timber frame structures in the south of Portugal
Given the fact that using timber frame structures has proven to improve the seismic behavior of
vernacular architecture, as has been reported in past earthquakes in many countries, its
preservation as a traditional earthquake resistant practice is important. This paper firstly intends
to evaluate whether the use of timber frames as a traditional seismic resistant technique for
vernacular architecture in the South of Portugal, traditionally a seismic region, is still active.
Secondly, the city of Vila Real de Santo AntĂłnio was selected as a case study because it also
followed a Pombaline development contemporary to the reconstruction of Lisbon. The plan
included the provision of timber frame partition walls for some of the buildings and, thus, an
overview of the type of constructions originally conceived is provided. Finally, the alterations
done in the original constructions and the current state of the city center are described and the
effect of these changes on the seismic vulnerability of the city is discussed.The authors wish to express their gratitude to the Portuguese Science and Technology Foundation (FCT) for the scholarship granted in the scope of the research project 'SEISMIC-V-Vernacular Seismic Culture in Portugal' (PTDC/ATP-AQI/3934/2012)
Recommended from our members
Year-round stratospheric aerosol backscatter ratios calculated from lidar measurements above northern Norway
We present a new method for calculating backscatter ratios of the stratospheric sulfate aerosol (SSA) layer from daytime and nighttime lidar measurements. Using this new method we show a first year-round dataset of stratospheric aerosol backscatter ratios at high latitudes. The SSA layer is located at altitudes between the tropopause and about 30 km. It is of fundamental importance for the radiative balance of the atmosphere. We use a state-of-the-art Rayleigh-Mie-Raman lidar at the Arctic Lidar Observatory for Middle Atmosphere Research (ALOMAR) station located in northern Norway (69N, 16E; 380ma.s.l.). For nighttime measurements the aerosol backscatter ratios are derived using elastic and inelastic backscatter of the emitted laser wavelengths 355, 532 and 1064nm. The setup of the lidar allows measurements with a resolution of about 5 min in time and 150 m in altitude to be performed in high quality, which enables the identification of multiple sub-layers in the stratospheric aerosol layer of less than 1 km vertical thickness. We introduce a method to extend the dataset throughout the summer when measurements need to be performed under permanent daytime conditions. For that purpose we approximate the backscatter ratios from color ratios of elastic scattering and apply a correction function. We calculate the correction function using the average backscatter ratio profile at 355nm from about 1700 h of nighttime measurements from the years 2000 to 2018. Using the new method we finally present a year-round dataset based on about 4100 h of measurements during the years 2014 to 2017. © Author(s) 2019
Neonatal pneumococcal colonisation caused by Influenza A infection alters lung function in adult mice
There is emerging epidemiological data to suggest that upper respiratory tract bacterial colonisation in infancy may increase the risk of developing respiratory dysfunction later in life, and respiratory viruses are known to precipitate persistent colonisation. This study utilized a neonatal mouse model of Streptococcus pneumonia (SP) and influenza A virus (IAV) co-infection, where bronchoalveolar leukocyte infiltration had resolved by adulthood. Only co-infection resulted in persistent nasopharyngeal colonisation over 40 days and a significant increase in airway resistance in response to in vivo methacholine challenge. A significant increase in hysteresivity was also observed in IAV and co-infected mice, consistent with ventilatory heterogeneity and structural changes in the adult lung. Airway hyper-responsiveness was not associated with a detectable increase in goblet cell transdifferentiation, peribronchial smooth muscle bulk or collagen deposition in regions surrounding the airways. Increased reactivity was not observed in precision cut lung slices challenged with methacholine in vitro. Histologically, the airway epithelium appeared normal and expression of epithelial integrity markers (ZO-1, occludin-1 and E-cadherin) were not altered. In summary, neonatal co-infection led to persistent nasopharyngeal colonisation and increased airway responsiveness that was not associated with detectable smooth muscle or mucosal epithelial abnormalities, however increased hysteresivity may reflect ventilation heterogeneity
Impaired mucosal defense to acute colonic injury in mice lacking cyclooxygenase-1 or cyclooxygenase-2
To investigate roles in intestinal inflammation for the 2 cyclooxygenase (COX) isoforms, we determined susceptibility to spontaneous and induced acute colitis in mice lacking either the COX-1 or COX-2 isoform. We treated wild-type, COX-1–/–, COX-2–/–, and heterozygous mice with dextran sodium sulfate (DSS) to provoke acute colonic inflammation, and we quantified tissue damage, prostaglandin (PG) E2, and interleukin-1β. No spontaneous gastrointestinal inflammation was detected in mice homozygous for either mutation, despite almost undetectable basal intestinal PGE2 production in COX-1–/– mice. Both COX-1–/– and COX-2–/– mice showed increased susceptibility to a low-dose of DSS that caused mild colonic epithelial injury in wild-type mice. COX-2–/– mice were more susceptible than COX-1–/– mice, and selective pharmacologic blockade of COX-2 potentiated injury in COX-1–/– mice. At a high dose, DSS treatment was fatal to 50% of the animals in each mutant group, but all wild-type mice survived. DSS treatment increased PGE2 intestinal secretion in all groups except COX-2–/– mice. These results demonstrate that COX-1 and COX-2 share a crucial role in the defense of the intestinal mucosa (with inducible COX-2 being perhaps more active during inflammation) and that neither isoform is essential in maintaining mucosal homeostasis in the absence of injurious stimuli
Seismic behaviour of traditional timber frame walls: experimental results on unreinforced walls
Timber frame buildings are well known as an efficient seismic resistant structure
and they are used worldwide. Moreover, they have been specifically adopted in codes and
regulations during the XVIII and XIX centuries in the Mediterranean area. These structures
generally consist of exterior masonry walls with timber elements embedded which tie the
walls together and internal walls which have a timber frame with masonry infill and act as
shearwalls. In order to preserve these structureswhich characterizemany cities in theworld it
is important to better understand their behaviour under seismic actions. Furthermore, historic
technologies could be used even in modern constructions to build seismic resistant buildings
using more natural materials with lesser costs. Generally, different types of infill could be
applied to timber frame walls depending on the country, among which brick masonry, rubble
masonry, hay and mud. The focus of this paper is to study the seismic behaviour of the walls
considering different types of infill, specifically: masonry infill, lath and plaster and timber
frame with no infill. Static cyclic tests have been performed on unreinforced timber frame
walls in order to study their seismic capacity in terms of strength, stiffness, ductility and
energy dissipation. The tests showed how in the unreinforced condition, the infill is able to
guarantee a greater stiffness, ductility and ultimate capacity of the wall.The authors would like to acknowledge Eng. Filipe Ferreira and A.O.F. (Augusto Oliveira Ferreira &
C Lda.) for their expertise and collaboration in the construction of the wall specimens.
The first author would also like to acknowledge the Portuguese Science and Technology
Foundation (FCT) for its financial support through grant SFRH / BD / 61908 / 2009
PetaFLOP Molecular Dynamics for Engineering Applications
Molecular dynamics (MD) simulations enable the investigation of multicomponent and multiphase processes relevant to engineering applications, such as droplet coalescence or bubble formation. These scenarios require the simulation of ensembles containing a large number of molecules. We present recent advances within the MD framework ls1 mardyn which is being developed with particular regard to this class of problems. We discuss several OpenMP schemes that deliver optimal performance at node-level. We have further introduced nonblocking communication and communication hiding for global collective operations. Together with revised data structures and vectorization, these improvements unleash PetaFLOP performance and enable multi-trillion atom simulations on the HLRS supercomputer Hazel Hen. We further present preliminary results achieved for droplet coalescence scenarios at a smaller scale.BMBF, 01IH16008, Verbundprojekt: TaLPas - Task-basierte Lastverteilung und Auto-Tuning in der Partikelsimulatio
- …