High incidence of Angina pectoris in patients treated with 5-fluorouracil - A planned surveillance study with 102 patients

Objective: Angina pectoris, arrhythmic sudden death and myocardial infarction, all these cardiac events have occasionally been reported during 5-fluorouracil (5-FU) chemotherapy. Underlying mechanisms leading to these events are unknown; damage to the myocytes or vasospasms have been discussed. Methods: 102 consecutive and unselected patients were monitored with 12-lead ECG, echocardiography and radionuclide ventriculography prior to the first cycle of 5-FU chemotherapy and 3 months from baseline. Results: 19% of the patients developed reversible symptoms of angina pectoris during treatment which lasted up to 12 h after cessation of the infusion. Most of the 19 patients showed corresponding ECG changes. 6 out of the 19 patients with severe angina pectoris had subsequent coronary angiography. In none of these patients the coronary angiography showed coronary artery disease, but it showed low ventricular function (ejection fraction <50%) in 2 patients. The ejection fraction did not increase overtime. Arrhythmias were screened for with Holter monitoring during 5-FU chemotherapy. The frequency of bradycardia and ventricular extrasystoles increased significantly (p < 0.05) during treatment compared to arrhythmias in Holter monitoring 3 months later. Furthermore the Qtc time in the ECG 3 months later was significantly prolonged (p < 0.05) compared to baseline values. Conclusions:The incidence of angina pectoris in patients during 5-FU treatment seems higher than previously suspected. As myocardial ischemia can be fatal, attentiveness to these symptoms and immediate treatment are crucial. Copyright (C) 2003 S. Karger AG, Basel

Simulative verification of a novel semi-active broadband energy harvester

This paper presents a semi-active broadband vibrational-energy harvesting system. Based on a non-resonant rotational generator, electronic circuitry was used to overcome the physical start-up restrictions. Due to the functional design it remains an energy harvester suitable for battery-less devices. For the first time a vibrational energy harvester is presented that allows standardization and thus higher volume production. A system layout, simulation, and measurement data will be shown

Highly indistinguishable single photons from incoherently and coherently excited GaAs quantum dots

Semiconductor quantum dots are converging towards the demanding requirements of photonic quantum technologies. Among different systems, quantum dots with dimensions exceeding the free-exciton Bohr radius are appealing because of their high oscillator strengths. While this property has received much attention in the context of cavity quantum electrodynamics, little is known about the degree of indistinguishability of single photons consecutively emitted by such dots and on the proper excitation schemes to achieve high indistinguishability. A prominent example is represented by GaAs quantum dots obtained by local droplet etching, which recently outperformed other systems as triggered sources of entangled photon pairs. On these dots, we compare different single-photon excitation mechanisms, and we find (i) a "phonon bottleneck" and poor indistinguishability for conventional excitation via excited states and (ii) photon indistinguishablilities above 90% for both strictly resonant and for incoherent acoustic- and optical-phonon-assisted excitation. Among the excitation schemes, optical phonon-assisted excitation enables straightforward laser rejection without a compromise on the source brightness together with a high photon indistinguishability

Wireless wake-up sensor network for structural health monitoring of large-scale highway bridges

To realize in-situ structural health monitoring of critical infrastructure such as bridges, we present a powerful, but also low power and flexible, wireless sensor node utilizing a wake-up transceiver. The sensor node is equipped with several kinds of sensors, such as temperature, pressure and acceleration for in-situ monitoring of critical infrastructure. In addition to these commonly used sensors in wireless sensor networks, some nodes are equipped with global navigation satellite system receivers (GNSS) and others with tilt and acceleration sensors of very high accuracy that were developed by Nothrop Grumman LITEF GmbH. We present a low power wakeup multi-hop routing protocol that is able to transmit data with little overhead by supporting the use of wake-up receivers in combination with long-range communication radios. The wireless sensor nodes and the routing protocol are tested at a large-scale highway bridge in south-west Germany, where a prototype network was installed in June 2015 following a first test installation earlier in June at the same bridge. A gateway node equipped with a Global System for Mobile Communications (GSM) modem transfers the network data to a remote server located at the University of Freiburg

Fuzzy Supernova Templates I: Classification

Modern supernova (SN) surveys are now uncovering stellar explosions at rates that far surpass what the world's spectroscopic resources can handle. In order to make full use of these SN datasets, it is necessary to use analysis methods that depend only on the survey photometry. This paper presents two methods for utilizing a set of SN light curve templates to classify SN objects. In the first case we present an updated version of the Bayesian Adaptive Template Matching program (BATM). To address some shortcomings of that strictly Bayesian approach, we introduce a method for Supernova Ontology with Fuzzy Templates (SOFT), which utilizes Fuzzy Set Theory for the definition and combination of SN light curve models. For well-sampled light curves with a modest signal to noise ratio (S/N>10), the SOFT method can correctly separate thermonuclear (Type Ia) SNe from core collapse SNe with 98% accuracy. In addition, the SOFT method has the potential to classify supernovae into sub-types, providing photometric identification of very rare or peculiar explosions. The accuracy and precision of the SOFT method is verified using Monte Carlo simulations as well as real SN light curves from the Sloan Digital Sky Survey and the SuperNova Legacy Survey. In a subsequent paper the SOFT method is extended to address the problem of parameter estimation, providing estimates of redshift, distance, and host galaxy extinction without any spectroscopy.Comment: 26 pages, 12 figures. Accepted to Ap

A detector module with highly efficient surface-alpha event rejection operated in CRESST-II Phase 2

The cryogenic dark matter experiment CRESST-II aims at the direct detection of WIMPs via elastic scattering off nuclei in scintillating CaWO$_4$ crystals. We present a new, highly improved, detector design installed in the current run of CRESST-II Phase 2 with an efficient active rejection of surface-alpha backgrounds. Using CaWO$_4$ sticks instead of metal clamps to hold the target crystal, a detector housing with fully-scintillating inner surface could be realized. The presented detector (TUM40) provides an excellent threshold of ${\sim}\,0.60\,$keV and a resolution of $\sigma\,{\approx}\,0.090$ keV (at 2.60$\,$keV). With significantly reduced background levels, TUM40 sets stringent limits on the spin-independent WIMP-nucleon scattering cross section and probes a new region of parameter space for WIMP masses below 3$\,$GeV/c$^2$. In this paper, we discuss the novel detector design and the surface-alpha event rejection in detail.Comment: 9 pages, 6 figure