83 research outputs found
A Time Projection Chamber with GEM-Based Readout
For the International Large Detector concept at the planned International
Linear Collider, the use of time projection chambers (TPC) with micro-pattern
gas detector readout as the main tracking detector is investigated. In this
paper, results from a prototype TPC, placed in a 1 T solenoidal field and read
out with three independent GEM-based readout modules, are reported. The TPC was
exposed to a 6 GeV electron beam at the DESY II synchrotron. The efficiency for
reconstructing hits, the measurement of the drift velocity, the space point
resolution and the control of field inhomogeneities are presented.Comment: 22 pages, 19 figure
Shower development of particles with momenta from 15 GeV to 150 GeV in the CALICE scintillator-tungsten hadronic calorimeter
We present a study of showers initiated by electrons, pions, kaons, and
protons with momenta from 15 GeV to 150 GeV in the highly granular CALICE
scintillator-tungsten analogue hadronic calorimeter. The data were recorded at
the CERN Super Proton Synchrotron in 2011. The analysis includes measurements
of the calorimeter response to each particle type as well as measurements of
the energy resolution and studies of the longitudinal and radial shower
development for selected particles. The results are compared to Geant4
simulations (version 9.6.p02). In the study of the energy resolution we include
previously published data with beam momenta from 1 GeV to 10 GeV recorded at
the CERN Proton Synchrotron in 2010.Comment: 35 pages, 21 figures, 8 table
The Time Structure of Hadronic Showers in highly granular Calorimeters with Tungsten and Steel Absorbers
The intrinsic time structure of hadronic showers influences the timing
capability and the required integration time of hadronic calorimeters in
particle physics experiments, and depends on the active medium and on the
absorber of the calorimeter. With the CALICE T3B experiment, a setup of 15
small plastic scintillator tiles read out with Silicon Photomultipliers, the
time structure of showers is measured on a statistical basis with high spatial
and temporal resolution in sampling calorimeters with tungsten and steel
absorbers. The results are compared to GEANT4 (version 9.4 patch 03)
simulations with different hadronic physics models. These comparisons
demonstrate the importance of using high precision treatment of low-energy
neutrons for tungsten absorbers, while an overall good agreement between data
and simulations for all considered models is observed for steel.Comment: 24 pages including author list, 9 figures, published in JINS
Infrastructure for Detector Research and Development towards the International Linear Collider
The EUDET-project was launched to create an infrastructure for developing and
testing new and advanced detector technologies to be used at a future linear
collider. The aim was to make possible experimentation and analysis of data for
institutes, which otherwise could not be realized due to lack of resources. The
infrastructure comprised an analysis and software network, and instrumentation
infrastructures for tracking detectors as well as for calorimetry.Comment: 54 pages, 48 picture
Recommended from our members
Research and Design of a Routing Protocol in Large-Scale Wireless Sensor Networks
无线传感器网络,作为全球未来十大技术之一,集成了传感器技术、嵌入式计算技术、分布式信息处理和自组织网技术,可实时感知、采集、处理、传输网络分布区域内的各种信息数据,在军事国防、生物医疗、环境监测、抢险救灾、防恐反恐、危险区域远程控制等领域具有十分广阔的应用前景。 本文研究分析了无线传感器网络的已有路由协议,并针对大规模的无线传感器网络设计了一种树状路由协议,它根据节点地址信息来形成路由,从而简化了复杂繁冗的路由表查找和维护,节省了不必要的开销,提高了路由效率,实现了快速有效的数据传输。 为支持此路由协议本文提出了一种自适应动态地址分配算——ADAR(AdaptiveDynamicAddre...As one of the ten high technologies in the future, wireless sensor network, which is the integration of micro-sensors, embedded computing, modern network and Ad Hoc technologies, can apperceive, collect, process and transmit various information data within the region. It can be used in military defense, biomedical, environmental monitoring, disaster relief, counter-terrorism, remote control of haz...学位:工学硕士院系专业:信息科学与技术学院通信工程系_通信与信息系统学号:2332007115216
Occupancy in the CLIC ILD Time Projection Chamber using Pixelised Readout
The occupancy in the CLIC ILD TPC caused by the beam induced background from gamma gamma -> hadrons, e+e- pairs and beam halo muons is very high for conventional pad readout. We show that the occupancy for a pixelised TPC readout is moderate and might be a viable solution to operate a TPC at CLIC
Resolution studies of a GEM-based TPC
The next large collider to be build after the Large Hadron Collider LHC is the electron-positron International Linear Collider ILC. Both collider concepts complement each other. The LHC, reaching centre of mass energies of up to 14 TeV, has a high discovery potential, while the ILC with its well known initial state allows high precision measurements. A detector at the ILC will need a finely segmented calorimeter and a tracking detector with high efficiency and momentum resolution, as well as good particle identification. Currently there are four different concept studies trying to optimise the detector for the requirements at the ILC. In three of these detector concepts a time projection chamber (TPC) is foreseen as the main tracking device. A TPC allows the measurement of several hundred points per track, providing a very good tracking efficiency. With only 3% of a radiation length in the barrel region, the amount of material introduced into the detector is small compared to silicon sensors. This minimises multiple scattering and improves the energy measurement in the calorimeters. The TPC also provides a good measurement of the specific energy loss dE/dx for particle identification. To achieve the intended spatial resolution of 100 micrometres, micro pattern gas detectors (MPGD) are considered for gas amplification. These devices consist of structures with a size of a few hundred micrometres, in contrary to an anode wire readout with a pitch of typically a few millimetres. This improves the granularity of the measurement and minimises ExB effects, resulting in an enhanced spatial and two track resolution. Furthermore the backdrift of ions into the sensitive volume of the TPC is intrinsically suppressed. This is essential, as the established method of gating away the ions after each recorded event will not work at the ILC. Due to the bunch structure there will be data from 150 bunch crossings simultaneously in the TPC. The two different MPGDs discussed for the ILC TPC are Micro-Mesh Gaseous Detectors (Micromegas) and Gas Electron Multiplier foils (GEMs). The current thesis shows resolution studies with a TPC prototype equipped with a triple GEM readout structure. A hodoscope made up of silicon strip sensors gives a precision reference track, allowing an unbiased measurement of the spatial resolution. High statistics measurements have been conducted at the DESY test beam facility, which provides positrons with a tunable energy between 1 GeV and 6 GeV. Using the independent measurement of the hodoscope allows systematic studies of the homogeneity of the TPC's electric field. The fluctuations of the field in the chamber's central region were found to be DeltaE/E = 0.008. Field distortions have been determined and corrected, reducing the remaining deviations to a level well below the spatial resolution of the TPC. One important task is to reduce the number of ions drifting back into the sensitive volume. Special GEM settings with minimised ion backdrift have been examined with respect to their influence on the spatial resolution and it was found that the spatial resolution is not degraded using these special settings. The TPC at the ILC will be operated in high magnetic fields. Thus it is mandatory to show that the anticipated performance can be achieved in magnetic fields. The TPC prototype has been operated in a 4 T magnetic field, provided by a superconducting solenoid located at DESY Hamburg. Again the spatial resolution measured with the ion backdrift optimised settings is compared to that achieved with non-optimised settings. In both cases the measured resolution is approximately 130 micrometres
- …