The oxygen isotopic composition of phosphate in river water and its potential sources in the Upper River Taw catchment, UK

The need to reduce both point and diffuse phosphorus pollution to aquatic ecosystems is widely recognised and in order to achieve this, identification of the different pollutant sources is essential. Recently, a stable isotope approach using oxygen isotopes within phosphate (δ18OPO4) has been used in phosphorus source tracing studies. This approach was applied in a one-off survey in September 2013 to the River Taw catchment in south-west England where elevated levels of phosphate have been reported. River water δ18OPO4 along the main channel varied little, ranging from + 17.1 to + 18.8‰. This was no > 0.3‰ different to that of the isotopic equilibrium with water (Eδ18OPO4). The δ18OPO4 in the tributaries was more variable (+ 17.1 to + 18.8‰), but only deviated from Eδ18OPO4 by between 0.4 and 0.9‰. Several potential phosphate sources within the catchment were sampled and most had a narrow range of δ18OPO4 values similar to that of river Eδ18OPO4. Discharge from two waste water treatment plants had different and distinct δ18OPO4 from one another ranging between + 16.4 and + 19.6‰ and similar values to that of a dairy factory final effluent (+ 16.5 to + 17.8‰), mains tap water (+ 17.8 to + 18.4‰), and that of the phosphate extracted from river channel bed sediment (+ 16.7 to + 17.6‰). Inorganic fertilizers had a wide range of values (+ 13.3 to + 25.9‰) while stored animal wastes were consistently lower (+ 12.0 to + 15.0‰) than most other sources and Eδ18OPO4. The distinct signals from the waste water treatment plants were lost within the river over a short distance suggesting that rapid microbial cycling of phosphate was occurring, because microbial cycling shifts the isotopic signal towards Eδ18OPO4. This study has added to the global inventory of phosphate source δ18OPO4 values, but also demonstrated the limitations of this approach to identifying phosphate sources, especially at times when microbial cycling is high

Changes of oxygen isotope values of soil P pools associated with changes in soil pH

Field data about the effect of soil pH on phosphorus (P) cycling is limited. A promising tool to study P cycling under field conditions is the 18O:16O ratio of phosphate (δ18OP). In this study we investigate whether the δ18OP can be used to elucidate the effect of soil pH on P cycling in grasslands. Soils and plants were sampled from different fertilisation and lime treatments of the Park Grass long term experiment at Rothamsted Research, UK. The soils were sequentially extracted to isolate different soil P pools, including available P and corresponding δ18OP values were determined. We did not observe changes in plant δ18OP value, but soil P δ18OP values changed, and lower δ18OP values were associated with higher soil pH values. At sites where P was not limiting, available P δ18OP increased by up to 3‰ when lime was applied. We show that the δ18OP method is a useful tool to investigate the effect of pH on soil P cycling under field conditions as it highlights that different soil processes must govern P availability as pH shifts. The next challenge is now to identify these underlying processes, enabling better management of soil P at different pH

Micro-Electro-Mechanical-Systems (MEMS) and Fluid Flows

The micromachining technology that emerged in the late 1980s can provide micron-sized sensors and actuators. These micro transducers are able to be integrated with signal conditioning and processing circuitry to form micro-electro-mechanical-systems (MEMS) that can perform real-time distributed control. This capability opens up a new territory for flow control research. On the other hand, surface effects dominate the fluid flowing through these miniature mechanical devices because of the large surface-to-volume ratio in micron-scale configurations. We need to reexamine the surface forces in the momentum equation. Owing to their smallness, gas flows experience large Knudsen numbers, and therefore boundary conditions need to be modified. Besides being an enabling technology, MEMS also provide many challenges for fundamental flow-science research

The stable oxygen isotope ratio of resin extractable phosphate derived from fresh cattle faeces

Phosphorus losses from agriculture pose an environmental threat to watercourses. A new approach using the stable oxygen isotope ratio of oxygen in phosphate (δ18OPO4 value) may help elucidate some phosphorus sources and cycling. Accurately determined and isotopically distinct source values are essential for this process. The δ18OPO4 values of animal wastes have, up to now, received little attention. Methods Phosphate (PO4) was extracted from cattle faeces using anion resins and the contribution of microbial PO4 was assessed. The δ18OPO4 value of the extracted PO4 was measured by precipitating silver phosphate and subsequent analysis on a thermal conversion elemental analyser at 1400°C, with the resultant carbon monoxide being mixed with a helium carrier gas passed through a GC column into a mass spectrometer. Faecal water oxygen isotope ratios (δ18OH2O values) were determined on a dual-inlet mass spectrometer through a process of headspace carbon dioxide equilibration with water samples. Results Microbiological results indicated that much of extracted PO4 was not derived directly from the gut fauna lysed during the extraction of PO4 from the faeces. Assuming that the faecal δ18OH2O values represented cattle body water, the predicted pyrophosphatase equilibrium δ18OPO4 (Eδ18OPO4) values ranged between +17.9 and +19.9‰, while using groundwater δ18OH2O values gave a range of +13.1 to +14.0‰. The faecal δ18OPO4 values ranged between +13.2 and +15.3‰. Conclusions The fresh faecal δ18OPO4 values were equivalent to those reported elsewhere for agricultural animal slurry. However, they were different from the Eδ18OPO4 value calculated from the faecal δ18OH2O value. Our results indicate that slurry PO4 is, in the main, derived from animal faeces although an explanation for the observed value range could not be determined

A rapid ammonium fluoride method to determine the oxygen isotope ratio of available phosphorus in tropical soils

Rationale The isotopic composition of oxygen bound to phosphorus (δ18OP value) offers an opportunity to gain insight into P cycling mechanisms. However, there is little information for tropical forest soils, which presents a challenge for δ18OP measurements due to low available P concentrations. Here we report the use of a rapid ammonium fluoride extraction method (Bray‐1) as an alternative to the widely used anion‐exchange membrane (AEM) method for quantification of δ18OP values of available P in tropical forest soils. Methods We compared P concentrations and δ18OP values of available and microbial P determined by AEM and Bray‐1 extraction for a series of tropical forest soils from Panama spanning a steep P gradient. This involved an assessment of the influence of extraction conditions, including temperature, extraction time, fumigation time and solution‐to‐soil ratio, on P concentrations and isotope ratios. Results Depending on the extraction conditions, Bray‐1 P concentrations ranged from 0.2 to 66.3 mg P kg−1 across the soils. Extraction time and temperature had only minor effects on Bray‐1 P, but concentrations increased markedly as the solution‐to‐soil ratio increased. In contrast, extraction conditions did not affect Bray‐1 δ18OP values, indicating that Bray‐1 provides a robust measure of the isotopic composition of available soil P. For a relatively high P soil, available and fumigation‐released (microbial) δ18OP values determined by Bray‐1 extraction (20‰ and 16‰, respectively) were higher than those determined by the AEM method (18‰ and 12‰, respectively), which we attribute to slightly different P pools extracted by the two methods and/or differences resulting from the longer extraction time needed for the AEM method. Conclusions The short extraction time, insensitivity to extraction conditions and smaller mass of soil required to extract sufficient P for isotopic analysis make Bray‐1extraction a suitable alternative to the AEM method for the determination of δ18OP values of available P in tropical soils

Improvements in survival of the uncemented Nottingham Total Shoulder prosthesis: a prospective comparative study

<p>Abstract</p> <p>Background</p> <p>The uncemented Nottingham Total Shoulder Replacement prosthesis system (Nottingham TSR) was developed from the previous BioModular^®shoulder prosthesis taking into consideration the causes of the initial implant's failure.</p> <p>We investigated the impact of changes in the design of Nottingham TSR prosthesis on its survivorship rate.</p> <p>Methods</p> <p>Survivorship analyses of three types of uncemented total shoulder arthroplasty prostheses (BioModular^®, initial Nottingham TSR and current Nottingham TSR systems with 11, 8 and 4 year survivorship data respectively) were compared. All these prostheses were implanted for the treatment of disabling pain in the shoulder due to primary and secondary osteoarthritis or rheumatoid arthritis. Each type of the prosthesis studied was implanted in consecutive group of patients – 90 patients with BioModular^®system, 103 with the initial Nottingham TSR and 34 patients with the current Nottingham TSR system.</p> <p>The comparison of the annual cumulative survivorship values in the compatible time range between the three groups was done according to the paired <it>t </it>test.</p> <p>Results</p> <p>The 8-year and 11-year survivorship rates for the initially used modified BioModular^®uncemented prosthesis were relatively low (75.6% and 71.7% respectively) comparing to the reported survivorship of the conventional cemented implants. The 8-year survivorship for the uncemented Nottingham TSR prosthesis was significantly higher (81.8%), but still not in the desired range of above 90%, that is found in other cemented designs. Glenoid component loosening was the main factor of prosthesis failure in both prostheses and mainly occurred in the first 4 postoperative years. The 4-year survivorship of the currently re-designed Nottingham TSR prosthesis, with hydroxylapatite coating of the glenoid baseplate, was significantly higher, 93.1% as compared to 85.1% of the previous Nottingham TSR.</p> <p>Conclusion</p> <p>The initial Nottingham shoulder prosthesis showed significantly higher survivorship than the BioModular^®uncemented prosthesis, but lower than expected. Subsequently re-designed Nottingham TSR system presented a high short term survivorship rate that encourages its ongoing use</p

Indication for the disappearance of reactor electron antineutrinos in the Double Chooz experiment

The Double Chooz Experiment presents an indication of reactor electron antineutrino disappearance consistent with neutrino oscillations. A ratio of 0.944 $\pm$ 0.016 (stat) $\pm$ 0.040 (syst) observed to predicted events was obtained in 101 days of running at the Chooz Nuclear Power Plant in France, with two 4.25 GW$_{th}$ reactors. The results were obtained from a single 10 m$^3$ fiducial volume detector located 1050 m from the two reactor cores. The reactor antineutrino flux prediction used the Bugey4 measurement as an anchor point. The deficit can be interpreted as an indication of a non-zero value of the still unmeasured neutrino mixing parameter \sang. Analyzing both the rate of the prompt positrons and their energy spectrum we find \sang = 0.086 $\pm$ 0.041 (stat) $\pm$ 0.030 (syst), or, at 90% CL, 0.015 $<$ \sang $\ <$ 0.16.Comment: 7 pages, 4 figures, (new version after PRL referee's comments

Analysis of the Maize dicer-like1 Mutant, fuzzy tassel, Implicates MicroRNAs in Anther Maturation and Dehiscence

Sexual reproduction in plants requires development of haploid gametophytes from somatic tissues. Pollen is the male gametophyte and develops within the stamen; defects in the somatic tissues of the stamen and in the male gametophyte itself can result in male sterility. The maize fuzzy tassel (fzt) mutant has a mutation in dicer-like1 (dcl1), which encodes a key enzyme required for microRNA (miRNA) biogenesis. Many miRNAs are reduced in fzt, and fzt mutants exhibit a broad range of developmental defects, including male sterility. To gain further insight into the roles of miRNAs in maize stamen development, we conducted a detailed analysis of the male sterility defects in fzt mutants. Early development was normal in fzt mutant anthers, however fzt anthers arrested in late stages of anther maturation and did not dehisce. A minority of locules in fzt anthers also exhibited anther wall defects. At maturity, very little pollen in fzt anthers was viable or able to germinate. Normal pollen is tricellular at maturity; pollen from fzt anthers included a mixture of unicellular, bicellular, and tricellular pollen. Pollen from normal anthers is loaded with starch before dehiscence, however pollen from fzt anthers failed to accumulate starch. Our results indicate an absolute requirement for miRNAs in the final stages of anther and pollen maturation in maize. Anther wall defects also suggest that miRNAs have key roles earlier in anther development. We discuss candidate miRNAs and pathways that might underlie fzt anther defects, and also note that male sterility in fzt resembles water deficit-induced male sterility, highlighting a possible link between development and stress responses in plants.ECU Open Access Publishing Support Fun