Acquisition of control information in a wind shear

When an aircraft encounters a change of air mass it may experience a change in horizontal wind sufficient to cause appreciable change in airspeed and, therefore, in lift. It may also suffer a change in vertical wind and, therefore, in vertical speed. The adverse combination of these effects may result in a significant excursion below the correct vertical profile and this may be especially serious if it happens during the latter part of an approach. Appropriate action should then be taken very quickly to avoid a situation from which the aircraft can scarcely recover, implying that suitable information needs to be readily accessible to the pilot. The purpose of this paper is to explore circumstances in which it is difficult to meet this requirement in conventionally equipped aircraft, because of time factors affecting the flow of information

Head-up display in the non-precision approach

The problem of head-up guidance for an aircraft making an instrument approach without glide slope information is discussed. Requirements for path control are considered for each section of the approach profile and a head-up display is developed to meet these needs. The display is an unreferenced flight director which is modified by adding a ground referenced symbol as an alternative guidance component. The director is used for holding altitude in the first segment and for descent at a controlled rate in the second segment. It is used in the third segment to maintain the minimum decision altitude while assessing the approach situation. This is done by means of occasional brief changes to the referenced symbol. In the final segment a visual approach is made with the referenced symbol used continuously for path control. The display is investigated experimentally in simulated approaches made by three pilots. The results show a fair agreement between objective and subjective estimates of the quality of landing decisions

The work based learning of creative artists: the case of William Shakespeare

This thesis applies work based learning concepts to understanding Shakespeare's professional development and the relationship between his work roles and works. The purposes of this are to enhance understanding about Shakespeare, develop the argument for work based learning as a field of studies and investigate the relevance of the approach to historical and contemporary creative practitioners. To meet these objectives the following research question was formulated: as a creative artist, practising in an evolving occupational area in a period itself fraught with social change and questions about the nature of work, social status and the performing arts, what was the relationship between Shakespeare's work roles and the production of his works. What was the nature of his work based learning? In construing Shakespeare's career in this way the thesis explores previously researched issues in original and illuminating ways. In applying work based learning thinking to Role Theory methodology new instrumentation for collecting and analysing data has been invented; the Time Chart, Map of Role Sets and a three-dimensional analytical framework. This has been necessary to analyse work based learning holistically, acknowledging the importance of the social, historical and cultural context. Shakespeare's career is analysed against key work based learning questions providing new understanding of the work role of sharer and principal playwright. The thesis concludes that the methodology is of value because it can mediate between individual learning and an organisational environment that is specifically contextualised. A major conclusion is that understanding Shakespeare's work based learning as exemplary, through planned and opportunistic projects, in collaboration with his professional peers and supported by socially sophisticated patronage networks were fundamental to his unique success. The considerable implications for further research as a major means of identifying and analysing the work based learning of historical and contemporary creative artists are given

An experimental evaluation of head-up display formats

Three types of head-up display format are investigated. Type 1 is an unreferenced (conventional) flight director, type 2 is a ground referenced flight path display, and type 3 is a ground referenced director. Formats are generated by computer and presented by reflecting collimation against a simulated forward view in flight. Pilots, holding commercial licenses, fly approaches in the instrument flight mode and in a combined instrument and visual flight mode. The approaches are in wind shear with varied conditions of visibility, offset, and turbulence. The displays are equivalent in pure tracking but there is a slight advantage for the unreferenced director in poor conditions. Flight path displays are better for tracking in the combined flight mode, possibly because of poor director control laws and the division of attention between superimposed fields. Workloads is better for the type 2 displays. The flight path and referenced director displays are criticized for effects of symbol motion and field limiting. In the subjective judgment of pilots familiar with the director displays, they are rated clearly better than path displays, with a preference for the unreferenced director. There is a fair division of attention between superimposed fields

Towards an understanding of thermodynamic and kinetic controls on the formation of clay minerals from volcanic glass under various environmental conditions

lmogolite is the kinetically and thermodynamically favoured weathering product from rhyolitic volcanic glass in the soil-forming environment. However, on thermodynamic grounds imogolite would also appear to be the favoured alteration product of rhyolitic glass deposited in the nearshore marine environment. On the basis that the rate of conversion of glass to clay minerals is a function of the solubility of the clay mineral, smectite is expected to be formed under mildly diagenetic conditions, and formed more rapidly than imogolite in soil. The derived activation energies for formation of imogolite from glass in soils are appropriate for a diffusion controlled reaction, and appear consistent with the diffusion of the tetrahedrally co-ordinated species Al[iv](OH)₂(H2Q)⁺. In the marine environment, however the mechanism for all reactions appear to be surface reaction control

Growth and magnetic properties of MnO2−delta nanowire microspheres

We report the synthesis of MnO2−delta microspheres using hydrothermal and conventional chemical reaction methods. The microspheres of MnO2−delta consist of nanowires having a diameter of 20-50 nm and a length of 2-8 micro m. The value of the oxygen vacancy delta estimated from the x-ray photoelectron spectrum (XPS) is 0.3. The magnetization versus temperature curve indicates a magnetic transition at about 13 K. It is found that a parasitic ferromagnetic component is imposed on the antiferromagnetic structure of MnO2−delta, which might result from distortion of the lattice structure due to oxygen vacancies. The magnetic transition temperature TN is about 10 K lower than that of the bulk MnO2 single crystal

Representing Business Contracts in RuleML

This paper presents an approach for the specification and implementation of translating contracts from a human-oriented form into an executable representation for monitoring. This will be done in the setting of RuleML. The task of monitoring contract execution and performance requires a logical account of deontic and defeasible aspects of legal language; currently such aspects are not covered by RuleML; accordingly we show how to extend it to cover such notions. From its logical form, the contract will be thus transformed into a machine readable rule notation and eventually implemented as executable semantics via any mark-up languages depending on the client's preference, for contract monitoring purposes

Megasequence architecture of Taranaki, Wanganui, and King Country basins and Neogene progradation of two continental margin wedges across western New Zealand.

Taranaki, Wanganui and King Country basins (formerly North Wanganui Basin) have been regarded as discrete basins, but they contain a very similar Neogene sedimentary succession and much of their geological history is held in common. Analysis of the stratigraphic architecture of the fill of each basin reveals the occurrence of four 2nd order megasequences of tectonic origin. The oldest is the early-early Miocene (Otaian Stage) Mahoenui Group/megasequence, followed by the late-early Miocene (Altonian Stage) Mokau Group/megasequence (King Country Basin), both of which correspond to the lower part of the Manganui Formation in Taranaki Basin. The third is the middle to late Miocene Whangamomona Group/megasequence, and the fourth is the latest Miocene-Pleistocene Rangitikei Supergroup/megasequence, both represented in the three basins. Higher order sequences (4th, 5th, 6th), having a eustatic origin, are evident in the Whangamomona and Rangitikei megasequences, particularly those of 5th order with 41 ka periodicity. The distribution of the megasequences are shown in a series of cross-section panels built-up from well -to-well correlations, complemented by time-stratigraphic cross-sections. The base of each megasequence is marked by marine flooding and represents a discrete phase in basin development. For the first megasequence this corresponded to rapid subsidence of the King Country Basin in a compressional setting and basement overthrusting on the Taranaki Fault, with the rapid introduction of terrigenous sediment during transgression. The Mahoenui megasequence accumulated mostly at bathyal depths; no regressive deposits are evident, having been eroded during subsequent uplift. The second (Mokau) megasequence accumulated during reverse movement on the Ohura Fault, formation of the Tarata Thrust Zone, and onlap of the basement block between the Taranaki Fault and the Patea-Tongaporutu-Herangi High (PTH). The Whangamomona megasequence accumulated during extensive reflooding of King Country Basin, onlap of the PTH High and of basement in the Wanganui Basin. This is an assymetrical sequence with a thin transgressive part (Otunui Formation) and a thick regressive part (Mount Messenger to Matemateaonga Formations). It represents the northward progradation of a continental margin wedge with bottom-set, slope-set and top-set components through Wanganui and King Country basins, with minor progradation over the PTH High and into Taranaki Basin. The Rangitikei megasequence is marked by extensive flooding at its base (Tangahoe Mudstone) and reflects the pull-down of the main Wanganui Basin depocentre. This megasequence comprises a second progradational margin wedge, which migrated on two fronts, one northward through Wanganui Basin and into King Country Basin, and a second west of the PTH High, through the Toru Trough and into the Central and Northern Grabens of Taranaki Basin and on to the Western Platform as the Giant Foresets Formation, thereby building up the modern shelf and slope. Fifth and 6th order sequences are well expressed in the shelf deposits (top-sets) of the upper parts of the Whangamomona and Rangitikei megasequences. They typically have a distinctive sequence architecture comprising shellbed (TST), siltstone (HST) and sandstone (RST) beds. Manutahi-1, which was continuously cored, provides calibration of this sequence architecture to wireline log character, thereby enabling shelf deposits to be mapped widely in the subsurface via the wireline data for hydrocarbon exploration holes. Similar characterization of slope-sets and bottom-sets is work ongoing. The higher order (eustatic) sequences profoundly influenced the local reservoir architecture and seal properties of formations, whereas the megasequence progradation has been responsible for the regional hydrocarbon maturation and migration. Major late tilting, uplift and erosion affected all three basins and created a regional high along the eastern Margin of Taranaki Basin, thereby influencing the migration paths of hydrocarbons sourced deeper in the basin and allowing late charge of structural and possibly stratigraphic traps

Megasequence architecture of Taranaki, Wanganui, and King Country basins and Neogene progradation of two continental margin wedges across western New Zealand.

Taranaki, Wanganui and King Country basins (formerly North Wanganui Basin) have been regarded as discrete basins, but they contain a very similar Neogene sedimentary succession and much of their geological history is held in common. Analysis of the stratigraphic architecture of the fill of each basin reveals the occurrence of four 2nd order megasequences of tectonic origin. The oldest is the early-early Miocene (Otaian Stage) Mahoenui Group/megasequence, followed by the late-early Miocene (Altonian Stage) Mokau Group/megasequence (King Country Basin), both of which correspond to the lower part of the Manganui Formation in Taranaki Basin. The third is the middle to late Miocene Whangamomona Group/megasequence, and the fourth is the latest Miocene-Pleistocene Rangitikei Supergroup/megasequence, both represented in the three basins. Higher order sequences (4th, 5th, 6th), having a eustatic origin, are evident in the Whangamomona and Rangitikei megasequences, particularly those of 5th order with 41 ka periodicity. The distribution of the megasequences are shown in a series of cross-section panels built-up from well -to-well correlations, complemented by time-stratigraphic cross-sections. The base of each megasequence is marked by marine flooding and represents a discrete phase in basin development. For the first megasequence this corresponded to rapid subsidence of the King Country Basin in a compressional setting and basement overthrusting on the Taranaki Fault, with the rapid introduction of terrigenous sediment during transgression. The Mahoenui megasequence accumulated mostly at bathyal depths; no regressive deposits are evident, having been eroded during subsequent uplift. The second (Mokau) megasequence accumulated during reverse movement on the Ohura Fault, formation of the Tarata Thrust Zone, and onlap of the basement block between the Taranaki Fault and the Patea-Tongaporutu-Herangi High (PTH). The Whangamomona megasequence accumulated during extensive reflooding of King Country Basin, onlap of the PTH High and of basement in the Wanganui Basin. This is an assymetrical sequence with a thin transgressive part (Otunui Formation) and a thick regressive part (Mount Messenger to Matemateaonga Formations). It represents the northward progradation of a continental margin wedge with bottom-set, slope-set and top-set components through Wanganui and King Country basins, with minor progradation over the PTH High and into Taranaki Basin. The Rangitikei megasequence is marked by extensive flooding at its base (Tangahoe Mudstone) and reflects the pull-down of the main Wanganui Basin depocentre. This megasequence comprises a second progradational margin wedge, which migrated on two fronts, one northward through Wanganui Basin and into King Country Basin, and a second west of the PTH High, through the Toru Trough and into the Central and Northern Grabens of Taranaki Basin and on to the Western Platform as the Giant Foresets Formation, thereby building up the modern shelf and slope. Fifth and 6th order sequences are well expressed in the shelf deposits (top-sets) of the upper parts of the Whangamomona and Rangitikei megasequences. They typically have a distinctive sequence architecture comprising shellbed (TST), siltstone (HST) and sandstone (RST) beds. Manutahi-1, which was continuously cored, provides calibration of this sequence architecture to wireline log character, thereby enabling shelf deposits to be mapped widely in the subsurface via the wireline data for hydrocarbon exploration holes. Similar characterization of slope-sets and bottom-sets is work ongoing. The higher order (eustatic) sequences profoundly influenced the local reservoir architecture and seal properties of formations, whereas the megasequence progradation has been responsible for the regional hydrocarbon maturation and migration. Major late tilting, uplift and erosion affected all three basins and created a regional high along the eastern Margin of Taranaki Basin, thereby influencing the migration paths of hydrocarbons sourced deeper in the basin and allowing late charge of structural and possibly stratigraphic traps

Compositional Explanation of Types and Algorithmic Debugging of Type Errors

The type systems of most typed functional programming languages are based on the Hindley-Milner type system. A practical problem with these type systems is that it is often hard to understand why a program is not type correct or a function does not have the intended type. We suggest that at the core of this problem is the difficulty of explaining why a given expression has a certain type. The type system is not defined compositionally. We propose to explain types using a variant of the Hindley-Milner type system that defines a compositional type explanation graph of principal typings. We describe how the programmer understands types by interactive navigation through the explanation graph. Furthermore, the explanation graph can be the foundation for algorithmic debugging of type errors, that is, semi-automatic localisation of the source of a type error without even having to understand the type inference steps. We implemented a prototype of a tool to explore the usefulness of the proposed methods