Responses in bacterial community structure to waste nutrients from aquaculture: an in situ microcosm experiment in a Chilean fjord

Indexación: Web of Science; Scopus.Chilean salmon farms release inorganic nutrients excreted by the fish into the surrounding water in Patagonian fjords. The objective of this experiment from the Comau Fjord (42.2 degrees S) in southern Chile was to study how increased input of ammonium (NH4) and phosphate (PO4) from salmon farms might affect the community structure of bacteria in surface waters where fish farms are located. We used microcosms (35 l) with NH4-N and PO4-P added to the natural seawater in a gradient of nutrient-loading rates, with the same N: P ratio as in salmon aquaculture effluents. Additionally, we measured bacterial community structure at different depths in the Comau Fjord to assess the natural variation to compare with our experiment. We used denaturing gradient gel electrophoresis (DGGE) to create 16S rDNA fingerprints of the bacterial communities and monitored biological and environmental variables (chlorophyll a, inorganic nutrients, pH, microbial abundance). The nutrient- loading rate had a significant impact on the bacterial community structure, and the community dissimilarity between low and high nutrient additions was up to 78%. Of the measured environmental variables, phytoplankton abundance and increased pH from photosynthesis had a significant effect. We observed no significant changes in bacterial diversity, which remained at the same level as in the unmanipulated community. Thus, the bacterial community of the fjord was not resistant, but resilient within the time frame and nutrient gradient of our experiment.http://www.int-res.com/abstracts/aei/v9/p21-32

Protein aggregates nucleate ice: the example of apoferritin

Biological material has gained increasing attention recently as a source of ice-nucleating particles that may account for cloud glaciation at moderate supercooling. While the ice-nucleation (IN) ability of some bacteria can be related to membrane-bound proteins with epitaxial fit to ice, little is known about the IN-active entities present in biological material in general. To elucidate the potential of proteins and viruses to contribute to the IN activity of biological material, we performed bulk freezing experiments with the newly developed drop freezing assay DRoplet Ice Nuclei Counter Zurich (DRINCZ), which allows the simultaneous cooling of 96 sample aliquots in a chilled ethanol bath. We performed a screening of common proteins, namely the iron storage protein ferritin and its iron-free counterpart apoferritin, the milk protein casein, the egg protein ovalbumin, two hydrophobins, and a yeast ice-binding protein, all of which revealed IN activity with active site densities > 0.1 mg−1 at −10 ∘C. The tobacco mosaic virus, a plant virus based on helically assembled proteins, also proved to be IN active with active site densities increasing from 100 mg−1 at −14 ∘C to 10 000 mg−1 at −20 ∘C. Among the screened proteins, the IN activity of horse spleen ferritin and apoferritin, which form cages of 24 co-assembled protein subunits, proved to be outstanding with active site densities > 10 mg−1 at −5 ∘C. Investigation of the pH dependence and heat resistance of the apoferritin sample confirmed the proteinaceous nature of its IN-active entities but excluded the correctly folded cage monomer as the IN-active species. A dilution series of apoferritin in water revealed two distinct freezing ranges, an upper one from −4 to −11 ∘C and a lower one from −11 to −21 ∘C. Dynamic light scattering measurements related the upper freezing range to ice-nucleating sites residing on aggregates and the lower freezing range to sites located on misfolded cage monomers or oligomers. The sites proved to persist during several freeze–thaw cycles performed with the same sample aliquots. Based on these results, IN activity seems to be a common feature of diverse proteins, irrespective of their function, but arising only rarely, most probably through defective folding or aggregation to structures that are IN active.This research has been supported by the Swiss National Foundation (grant nos. IZSEZ0_179149/1 and 200021_156581), the Basque government (Elkartek programmes ng 15 and ng 17), and the Spanish MINECO (grant no. MAT2013- 46006-R, programme MDM-2016-0618)

Experimental test of a trace formula for two-dimensional dielectric resonators

Resonance spectra of two-dimensional dielectric microwave resonators of circular and square shapes have been measured. The deduced length spectra of periodic orbits were analyzed and a trace formula for dielectric resonators recently proposed by Bogomolny et al. [Phys. Rev. E 78, 056202 (2008)] was tested. The observed deviations between the experimental length spectra and the predictions of the trace formula are attributed to a large number of missing resonances in the measured spectra. We show that by taking into account the systematics of observed and missing resonances the experimental length spectra are fully understood. In particular, a connection between the most long-lived resonances and certain periodic orbits is established experimentally.Comment: 14 pages, 12 figures, 1 tabl

Enhancement of photoacoustic detection of inhomogeneities in polymers

We report a series of experiments on laser pulsed photoacoustic excitationin turbid polymer samples addressed to evaluate the sound speed in the samples and the presence of inhomogeneities in the bulk. We describe a system which allows the direct measurement of the speed of the detected waves by engraving the surface of the piece under study with a fiduciary pattern of black lines. We also describe how this pattern helps to enhance the sensitivity for the detection of an inhomogeneity in the bulk. These two facts are useful for studies in soft matter systems including, perhaps, biological samples. We have performed an experimental analysis on Grilon(R) samples in different situations and we show the limitations of the method.Comment: 8 pages, 7 figure

In vivo cranial bone strain and bite force in the agamid lizard Uromastyx geyri

In vivo bone strain data are the most direct evidence of deformation and strain regimes in the vertebrate cranium during feeding and can provide important insights into skull morphology. Strain data have been collected during feeding across a wide range of mammals; in contrast, in vivo cranial bone strain data have been collected from few sauropsid taxa. Here we present bone strain data recorded from the jugal of the herbivorous agamid lizard Uromastyx geyri along with simultaneously recorded bite force. Principal and shear strain magnitudes in Uromastyx geyri were lower than cranial bone strains recorded in Alligator mississippiensis, but higher than those reported from herbivorous mammals. Our results suggest that variations in principal strain orientations in the facial skeleton are largely due to differences in feeding behavior and bite location, whereas food type has little impact on strain orientations. Furthermore, mean principal strain orientations differ between male and female Uromastyx during feeding, potentially because of sexual dimorphism in skull morphology

Estudio de la arcilla expandida como relleno de intercambiadores para enfriamiento evaporativo

Se presenta un estudio de las características y propiedades de la arcilla expandida (LECA) para ser usada como relleno en intercambiadores para enfriamiento evaporativo. Se analizó la posibilidad de aprovechar su porosidad para reducir la circulación de agua. Se realizó un estudio microscópico de su estructura mediante análisis de imágenes. Se plantearon lasecuaciones de balance de calor y masa que gobiernan el proceso de enfriamiento evaporativo. Se ensayó experimentalmente un prototipo de enfriador evaporativo con relleno de bolas de arcilla expandida y se elaboró un programa de simulación. Se concluye que es un material adecuado para relleno de intercambiadores por ser liviano, rígido e inerte. Se encontró que laabsorción de agua ocurre sólo en una delgada capa superficial en la cual se encuentran los poros abiertos.Fil: Gea, M.. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Salta. Instituto de Investigaciones en Energía no Convencional. Universidad Nacional de Salta. Facultad de Ciencias Exactas. Departamento de Física. Instituto de Investigaciones en Energía no Convencional; ArgentinaFil: Hoyos, D.. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Salta. Instituto de Investigaciones en Energía no Convencional. Universidad Nacional de Salta. Facultad de Ciencias Exactas. Departamento de Física. Instituto de Investigaciones en Energía no Convencional; ArgentinaFil: Iriarte, Adolfo Antonio. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Salta. Instituto de Investigaciones en Energía no Convencional. Universidad Nacional de Salta. Facultad de Ciencias Exactas. Departamento de Física. Instituto de Investigaciones en Energía no Convencional; ArgentinaFil: Lesino, Graciela. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Salta. Instituto de Investigaciones en Energía no Convencional. Universidad Nacional de Salta. Facultad de Ciencias Exactas. Departamento de Física. Instituto de Investigaciones en Energía no Convencional; Argentin

Subtropical wetland adaptations in Uruguay during the mid-Holocene: An archaeobotanical perspective

Reproduced with permission of the publisher. © Oxbow Books and the individual auhtors, 2001. Details of the publication are available at: http://www.oxbowbooks.com/bookinfo.cfm/ID/3080

Using multicomponent recycled electronic waste alloys to produce high entropy alloys

The amount of electronic waste (e-waste) recycled worldwide is less than 20% of the total amount produced. In a world where the need for critical and strategic metals is increasing almost exponentially, it is unacceptable that tons of these elements remain unrecycled. One of the causes of this low level of recycling is that recycling is based on an expensive and complex selective sorting of metals. Extracting all metals simultaneously is much simpler and if this were done, it would significantly increase the recycling rate. Meanwhile, it was demonstrated that high entropy alloys (HEAs), which are in great demand in applications where very high performance is required, can be made from mixtures of complex alloys, hence reducing their dependence on pure critical metals. Here, we show that it is possible to obtain competitive HEAs from complex alloy mixtures corresponding to typical electronic waste compositions, combining two needs of high interest in our society, namely: to increase the level of recycling of electronic waste and the possibility of developing high-performance HEAs without the need of using critical and/or strategic metals. To validate our hypothesis that e-waste can be used to produce competitive HEAs, we propose an alloy design strategy combining computational thermodynamics (CalPhaD) exploration of phase diagrams and phenomenological criteria for HEA design based on thermodynamic and structural parameters. A shortlist of selected compositions are then fabricated by arc melting ensuring compositional homogeneity of such complex alloys and, finally, characterised microstructurally, using electron microscopy and diffraction analysis, and mechanically, using hardness testing