Lab-Scale Study of the Calcium Carbonate Dissolution and Deposition by Marine Cyanobacterium Phormidium subcapitatum

Suggestions that calcification in marine organisms changes in response to global variations in seawater chemistry continue to be advanced (Wilkinson, 1979; Degens et al. 1985; Kazmierczak et al. 1986; R. Riding 1992). However, the effect of [Na+] on calcification in marine cyanobacteria has not been discussed in detail although [Na+] fluctuations reflect both temperature and sea-level fluctuations. The goal of these lab-scale studies therefore was to study the effect of environmental pH and [Na+] on CaCO3 deposition and dissolution by marine cyanobacterium Phormidium subcapitatum. Marine cyanobacterium P. subcapitatum has been cultivated in ASN-III medium. [Ca2+] fluctuations were monitored with Ca(2+) probe. Na(+) concentrations were determined by the initial solution chemistry. It was found that the balance between CaCO3 dissolution and precipitation induced by P. subcapitatum grown in neutral ASN III medium is very close to zero. No CaCO3 precipitation induced by cyanobacterial growth occurred. Growth of P. subcapitatum in alkaline ASN III medium, however, was accompanied by significant oscillations in free Ca(2+) concentration within a Na(+) concentration range of 50-400 mM. Calcium carbonate precipitation occurred during the log phase of P. subcapitatum growth while carbonate dissolution was typical for the stationary phase of P. subcapitatum growth. The highest CaCO3 deposition was observed in the range of Na(+) concentrations between 200-400 mM. Alkaline pH also induced the clamping of P. subcapitatum filaments, which appeared to have a strong affinity to envelop particles of chemically deposited CaCO3 followed by enlargement of those particles size. EDS analysis revealed the presence of Mg-rich carbonate (or magnesium calcite) in the solution containing 10-100 mM Na(+); calcite in the solution containing 200 mM Na(+); and aragonite in the solution containing with 400 mM Na(+). Typical present-day seawater contains xxmM Na(+). Early (Archean) seawater was likely less saline. The division of marine cyanobacterium P. subcapitatum is associated with periodic deposition and dissolution of CaCO3, the rhythms and intensity of which are dependent on concentrations of both OH(-) and Na(+). Thus, the role of present-day marine cyanobacteria in the global carbonate cycle might be reduced to aggregation and recrystallization of available CaCO3 particles in marine water rather than long-term precipitation and accumulation of CaCO3 deposits. For lower Na(+) concentrations, precipitation of carbonates by cyanobacteria would be even less significant. These results suggest that the lack of calcified cyanobacteria in stromatalite-bearing Precambrian sequences can be explained not only by high dissolved inorganic carbon concentrations but also by lower salinity, as well as possible lower pH compared to present-day oceans

Prevalence and risk factors of allergies in turkey (PARFAIT): Results of a multicentre cross-sectional study in adults

The Prevalence and Risk Factors of Allergies in Turkey (PARFAIT) study was planned to evaluate the prevalence of and risk factors for asthma and allergic diseases in Turkey. The present analysis used data from 25,843 parents of primary school children, obtained from a cross-sectional questionnaire-based study. A total of 25,843 questionnaires from 14 centres were evaluated. In rural areas, the prevalences asthma, wheezing, allergic rhinitis and eczema in males were: 8.5% (95% confidence interval (CI) 7.9-9.1%), 13.5% (95% CI 12.8-14.2%), 17.5% (95% CI 16.7-18.2%) and 10.8% (95% CI 10.211.4%), respectively; and in females were: 11.2% (95% CI 10.9-11.8%), 14.7% (95% CI 14.315.1%), 21.2% (95% CI 20.4-22.0%) and 13.1% (95% CI 2.4-13.8%), respectively. In urban areas, the corresponding prevalences in males were: 6.2% (95% CI 5.8-6.6%), 10.8% (95% CI 10.311.3%), 11.7% (95% CI 11.4-12.0%) and 6.6% (95% CI 6.2-7.0%), respectively; and in females were: 7.5 % (95% CI 7.9-7.1%), 12.0% (95% CI 11.7-12.3%), 17.0% (95% CI 16.4-17.6%) and 7.3% (95% CI 6.9-7.7%), respectively. Having an atopic first-degree relative or any other atopic diseases had significant effects on the prevalence of allergic diseases. Housing conditions, such as living in a shanty-type house, visible moulds at home and use of wood or biomass as heating or cooking material were associated with one or more allergic diseases. Although genetic susceptibility is strongly associated, country-and population-based environmental factors may contribute to increased prevalence rates of allergic diseases. Copyright © ERS Journals Ltd 2009

Analytical Model for Optimum Warehouse Dimensions

Warehouses are essential components of any supply chain in terms of customer service and cost levels. Warehouses are one of the important players in the success or failure of businesses from not only the customer service levels perspective but also the cost perspective. Warehouses, as one of the important components of supply networks, should be continually improved from design and operation perspectives to increase the performance. All efforts and solutions regarding the performance improvement are important and complex. In other words, warehouses should operate effectively in terms of the costs and technical performance that are determined during the design phase of warehouses. There are a few studies in the literature regarding the calculations of the optimum dimensions of a warehouse along the x, y, and z directions. In this paper, an analytical model is proposed to achieve the optimum warehouse dimensions in terms of the number of stocking zones along each of three dimensional axes directions: the x-, y-, and z-axes as non-linear mathematical modelling is developed to ensure the optimality. The warehouse dimensions (length, width, and height under the rafter of the building) are then calculated according to the results obtained from the model to minimise the average travel time

Novel fusion approach on automatic object extraction from spatial data: case study Worldview-2 and TOPO5000

The automatic extraction of information content from remotely sensed data is always challenging. We suggest a novel fusion approach to improve the extraction of this information from mono-satellite images. A Worldview-2 (WV-2) pan-sharpened image and a 1/5000-scaled topographic vector map (TOPO5000) were used as the sample data. Firstly, the buildings and roads were manually extracted from WV-2 to point out the maximum extractable information content. Subsequently, object-based automatic extractions were performed. After achieving two-dimensional results, a normalized digital surface model (nDSM) was generated from the underlying digital aerial photos of TOPO5000, and the automatic extraction was repeated by fusion with the nDSM to include individual object heights as an additional band for classification. The contribution was tested by precision, completeness and overall quality. Novel fusion technique increased the success of automatic extraction by 7% for the number of buildings and by 23% for the length of roads. © 2017, © 2017 Informa UK Limited, trading as Taylor & Francis Group

Novel fusion approach on automatic object extraction from spatial data: case study Worldview-2 and TOPO5000

The automatic extraction of information content from remotely sensed data is always challenging. We suggest a novel fusion approach to improve the extraction of this information from mono-satellite images. A Worldview-2 (WV-2) pan-sharpened image and a 1/5000-scaled topographic vector map (TOPO5000) were used as the sample data. Firstly, the buildings and roads were manually extracted from WV-2 to point out the maximum extractable information content. Subsequently, object-based automatic extractions were performed. After achieving two-dimensional results, a normalized digital surface model (nDSM) was generated from the underlying digital aerial photos of TOPO5000, and the automatic extraction was repeated by fusion with the nDSM to include individual object heights as an additional band for classification. The contribution was tested by precision, completeness and overall quality. Novel fusion technique increased the success of automatic extraction by 7% for the number of buildings and by 23% for the length of roads

ВИЗНАЧЕННЯ ШИРИНИ ЗАБАРОНЕНОЇ ЗОНИ НАПІВПРОВІДНИКОВОГО МАТЕРІАЛУ В ГОТОВОМУ ВИРОБІ

The paper puts forward a method for determination of semiconductor activation energy in end product. It is illustrated that band gap can be calculated at cutoffs on both axes of graphs ln(I)÷U, measured at different temperatures. Minimum temperature interval is determined depending on measuring accuracy. A new method for determination of value Eg without VAC (volt-ampere characteristics) extrapolation is put forward.Предложен метод определения энергии активации полупроводника в готовом изделии. Показано, что ширину запрещённой зоны можно рассчитать по отсечкам на обеих осях графиков ln(I)÷U, измеренных при разных температурах. Определён минимальный температурный интервал в зависимости от точности измерений. Указан новый способ определения величины E g без экстраполяции ВАХ.Запропоновано метод визначення енергії активації напівпровідника в готовому виробі. Показано, що ширину забороненої зони можливо розрахувати по відсічкам на обох осях графіків ln(I)÷U, виміряних при різних температурах. Визначений мінімальний температурний інтервал в залежності від точності вимірювань. Вказано новий засіб визначення E g без екстраполяції ВАХ