1,472 research outputs found
Recommended from our members
Benchmarking 2D hydraulic models for urban flood simulations
This paper describes benchmark testing of six two-dimensional (2D) hydraulic models (DIVAST, DIVASTTVD, TUFLOW, JFLOW, TRENT and LISFLOOD-FP) in terms of their ability to simulate surface flows in a densely urbanised area. The models are applied to a 1·0 km × 0·4 km urban catchment within the city of Glasgow, Scotland, UK, and are used to simulate a flood event that occurred at this site on 30 July 2002. An identical numerical grid describing the underlying topography is constructed for each model, using a combination of airborne laser altimetry (LiDAR) fused with digital map data, and used to run a benchmark simulation. Two numerical experiments were then conducted to test the response of each model to topographic error and uncertainty over friction parameterisation. While all the models tested produce plausible results, subtle differences between particular groups of codes give considerable insight into both the practice and science of urban hydraulic modelling. In particular, the results show that the terrain data available from modern LiDAR systems are sufficiently accurate and resolved for simulating urban flows, but such data need to be fused with digital map data of building topology and land use to gain maximum benefit from the information contained therein. When such terrain data are available, uncertainty in friction parameters becomes a more dominant factor than topographic error for typical problems. The simulations also show that flows in urban environments are characterised by numerous transitions to supercritical flow and numerical shocks. However, the effects of these are localised and they do not appear to affect overall wave propagation. In contrast, inertia terms are shown to be important in this particular case, but the specific characteristics of the test site may mean that this does not hold more generally
Room temperature sol-gel fabrication and functionalization for sensor applications
The structure and physical properties of a thin titania sol-gel layer prepared on silicon and silica surfaces were examined. Spectroscopic (FTIR, UV-VIS spectroscopy), refractive index (ellipsometry) and microscopic (light microscopy and SEM/EDS) tools were used to examine both chemical uniformity and physical uniformity of the sol-gel glass layers. The conditions for the fabrication of uniform layers were established, and room temperature dopant incorporation was examined. The absorption bands of porphyrin-containing titania sol-gel layers were characterized. By addition of a metal salt to the titania layer, it was possible to metallate the free-base porphyrin within and change the UV-VIS absorbance of the porphyrin, the basis of metal detection using porphyrins. The metalloporphyrins were detected by localized laser ablation inductive coupled mass spectroscopy (LA-ICP-MS), indicating fairly uniform distribution of metals across the titania surface. © 2012 The Author(s)
Comment: A sustainable and equitable response to the cost-of-living crisis is urgently needed
Assessment of extreme and metocean conditions in the Maldives for OTEC applications
This is the final version. Available on open access from Wiley via the DOI in this recordThe Maldives is a group of tropical atolls, considered globally to be one of the most desirable holiday destinations. There is an urgent requirement to decrease their dependency on fossil fuels that are currently the main source of energy, and a number of renewable energy alternatives are being evaluated. Among these, due to the favorable oceanographic and bathymetric conditions, ocean thermal energy conversion (OTEC) systems represent a viable opportunity for clean and reliable power. However, the stresses the OTEC platform will need to endure during adverse environmental conditions are not well defined. The magnitude of these stresses will then have a direct influence on the design of the OTEC device. In order to overcome this uncertainty, this paper uses hindcast data sets from global weather and ocean models to assess the metocean conditions of the Maldives, with particular reference to extreme conditions. After selecting a suitable location for the deployment of the devices, return values calculated using the peaks‐over‐threshold (POT) methodology are estimated for wind, waves, and currents. The 100‐year return value for the significant wave height is found to be 4.5 m, with a joint occurrence of energy periods between 7.5 and 8.5 seconds, whereas the 100‐year return wind has a velocity of 17.8 m/s and the 100‐year return current of 1.9 m/s. The directionality of these extreme events is also considered, showing the southern and western sub‐quadrants as the prevailing sources, which provides essential information for positioning of the platform. Additional evaluations of tropical revolving storms (TRS) and variations in temperature and salinity patterns are also provided over a 1500‐m water column; temperature varies by approximately 24°C, and salinity by around 2 ppt, showing the suitability of OTEC platforms in the Maldives. This work is therefore of interest to offshore renewable energy stakeholders interested in developing a project in the Maldives or those conducting an analogous analysis in other locations.European Regional Development Fund (ERDF
Psychopolitics: Peter Sedgwick’s legacy for mental health movements
This paper re-considers the relevance of Peter Sedgwick's Psychopolitics (1982) for a politics of mental health. Psychopolitics offered an indictment of ‘anti-psychiatry’ the failure of which, Sedgwick argued, lay in its deconstruction of the category of ‘mental illness’, a gesture that resulted in a politics of nihilism. ‘The radical who is only a radical nihilist’, Sedgwick observed, ‘is for all practical purposes the most adamant of conservatives’. Sedgwick argued, rather, that the concept of ‘mental illness’ could be a truly critical concept if it was deployed ‘to make demands upon the health service facilities of the society in which we live’. The paper contextualizes Psychopolitics within the ‘crisis tendencies’ of its time, surveying the shifting welfare landscape of the subsequent 25 years alongside Sedgwick's continuing relevance. It considers the dilemma that the discourse of ‘mental illness’ – Sedgwick's critical concept – has fallen out of favour with radical mental health movements yet remains paradigmatic within psychiatry itself. Finally, the paper endorses a contemporary perspective that, while necessarily updating Psychopolitics, remains nonetheless ‘Sedgwickian’
Ferroelectric precursor behavior in PbSc0.5Ta0.5O3 detected by field-induced resonant piezoelectric spectroscopy
A novel experimental technique, resonant piezoelectric spectroscopy (RPS), has been applied to investigate polar precursor effects in highly (65%) B-site ordered PbSc0.5Ta0.5O3 (PST), which undergoes a ferroelectric phase transition near 300 K. The cubic-rhombohedral transition is weakly first order, with a coexistence interval of ∼4 K, and is accompanied by a significant elastic anomaly over a wide temperature interval. Precursor polarity in the cubic phase was detected as elastic vibrations generated by local piezoelectric excitations in the frequency range 250–710 kHz. The RPS resonance frequencies follow exactly the frequencies of elastic resonances generated by conventional resonant ultrasound spectroscopy (RUS) but RPS signals disappear on heating beyond an onset temperature, Tonset, of 425 K. Differences between the RPS and RUS responses can be understood if the PST structure in the precursor regime between Tonset and the transition point, Ttrans=300 K, has locally polar symmetry even while it remains macroscopically cubic. It is proposed that this precursor behavior could involve the development of a tweed microstructure arising by coupling between strain and multiple order parameters, which can be understood from the perspective of Landau theory. As a function of temperature the transition is driven by the polar displacement P and the order parameter for cation ordering on the crystallographic B site Qod. Results in the literature show that, as a function of pressure, there is a separate instability driven by octahedral tilting for which the assigned order parameter is Q. The two mainly displacive order parameters, P and Q, are unfavorably coupled via a biquadratic term Q2P2, and complex tweedlike fluctuations in the precursor regime would be expected to combine aspects of all the order parameters. This would be different from the development of polar nanoregions, which are more usually evoked to explain relaxor ferroelectric behavior, such as occurs in PST with a lower degree of B-site order
Activation of sea urchin eggs by inositol phosphates is independent of external calcium
Ferroelectric precursor behavior in PbSc0.5Ta0.5O3 detected by field-induced resonant piezoelectric spectroscopy
A novel experimental technique, resonant piezoelectric spectroscopy (RPS), has been applied to investigate polar precursor effects in highly (65%) B-site ordered PbSc0.5Ta0.5O3 (PST), which undergoes a ferroelectric phase transition near 300 K. The cubic-rhombohedral transition is weakly first order, with a coexistence interval of ∼4 K, and is accompanied by a significant elastic anomaly over a wide temperature interval. Precursor polarity in the cubic phase was detected as elastic vibrations generated by local piezoelectric excitations in the frequency range 250–710 kHz. The RPS resonance frequencies follow exactly the frequencies of elastic resonances generated by conventional resonant ultrasound spectroscopy (RUS) but RPS signals disappear on heating beyond an onset temperature, Tonset, of 425 K. Differences between the RPS and RUS responses can be understood if the PST structure in the precursor regime between Tonset and the transition point, Ttrans=300 K, has locally polar symmetry even while it remains macroscopically cubic. It is proposed that this precursor behavior could involve the development of a tweed microstructure arising by coupling between strain and multiple order parameters, which can be understood from the perspective of Landau theory. As a function of temperature the transition is driven by the polar displacement P and the order parameter for cation ordering on the crystallographic B site Qod. Results in the literature show that, as a function of pressure, there is a separate instability driven by octahedral tilting for which the assigned order parameter is Q. The two mainly displacive order parameters, P and Q, are unfavorably coupled via a biquadratic term Q2P2, and complex tweedlike fluctuations in the precursor regime would be expected to combine aspects of all the order parameters. This would be different from the development of polar nanoregions, which are more usually evoked to explain relaxor ferroelectric behavior, such as occurs in PST with a lower degree of B-site order
How often should we monitor for reliable detection of atrial fibrillation recurrence? Efficiency considerations and implications for study design
OBJECTIVE: Although atrial fibrillation (AF) recurrence is unpredictable in terms of onset and duration, current intermittent rhythm monitoring (IRM) diagnostic modalities are short-termed and discontinuous. The aim of the present study was to investigate the necessary IRM frequency required to reliably detect recurrence of various AF recurrence patterns. METHODS: The rhythm histories of 647 patients (mean AF burden: 12±22% of monitored time; 687 patient-years) with implantable continuous monitoring devices were reconstructed and analyzed. With the use of computationally intensive simulation, we evaluated the necessary IRM frequency to reliably detect AF recurrence of various AF phenotypes using IRM of various durations. RESULTS: The IRM frequency required for reliable AF detection depends on the amount and temporal aggregation of the AF recurrence (p<0.0001) as well as the duration of the IRM (p<0.001). Reliable detection (>95% sensitivity) of AF recurrence required higher IRM frequencies (>12 24-hour; >6 7-day; >4 14-day; >3 30-day IRM per year; p<0.0001) than currently recommended. Lower IRM frequencies will under-detect AF recurrence and introduce significant bias in the evaluation of therapeutic interventions. More frequent but of shorter duration, IRMs (24-hour) are significantly more time effective (sensitivity per monitored time) than a fewer number of longer IRM durations (p<0.0001). CONCLUSIONS: Reliable AF recurrence detection requires higher IRM frequencies than currently recommended. Current IRM frequency recommendations will fail to diagnose a significant proportion of patients. Shorter duration but more frequent IRM strategies are significantly more efficient than longer IRM durations. CLINICAL TRIAL REGISTRATION URL: Unique identifier: NCT00806689
- …