Direct Metal Laser-sintered Stainless Steel: Comparison Of Microstructure And Hardness Between Different Planes

Microstructural analysis and micro-hardness measurements were performed on different planes of 316L stainless steel fabricated by direct metal laser sintering (DMLS) technique. A fine cellular network was observed within the steel microstructure, where morphology of most cells changed from columnar on XZ-plane (vertical section) to equiaxed on XY-plane (horizontal section). Correspondingly, morphology of most grains was found to alter from columnar for the XZ-plane to equiaxed in the case of the XY-plane. Moreover, X-ray diffraction (XRD) analysis revealed a fully austenitic structure for both the planes. The average micro-hardness value for the XZ-plane and XY-plane was insignificantly (≈ 3%) different, which was attributed to the random grain orientation observed on both the planes. However, the average micro-hardness of the DMLS-fabricated 316L stainless steel in this contribution was approximately 25% higher than that of the as-cast one

Invariant Two-Component Structure of the Repeatable Battery for the Assessment of Neuropsychological Status (RBANS)

The Repeatable Battery for the Assessment of Neuropsychological Status is a brief neurocognitive instrument used to evaluate cognitive functioning in clinical settings. Prior investigations of the factor structure have revealed subtle differences across samples. It was hypothesized that these differences are primarily the result of methodological decisions made by researchers. The present study utilized empirically supported extraction criteria (parallel analysis; minimum average partial procedure) and uniformly investigated 5 samples. RBANS data from 4 previously published studies (Carlozzi, Horner, Yang, & Tilley, 2008; Duff, Hobson, Beglinger, & O\u27Bryant, 2010; Duff et al., 2006; Wilde, 2006) were reanalyzed, and a new clinical sample was obtained from the Gundersen Health System Memory Center. The congruence of factor structures was investigated by conducting orthogonal vector matrix comparisons (Barrett, 2005), and a robust 2-factor structure reliably emerged across samples. The invariant RBANS 2-factor structure primarily emphasized memory and visuospatial functioning. This finding offered further support for a 2-factor RBANS structure identified in previous studies and additionally provided empirical documentation of replication across diverse samples. Due to the expansive use of the RBANS, this psychometric knowledge has significant clinical implications. It should facilitate accurate interpretation of test data and allow clinicians to make more informed decisions regarding whether the instrument is appropriate to use in various clinical settings

Experimental Measurement Of Residual Stress And Distortion In Additively Manufactured Stainless Steel Components With Various Dimensions

Disk-shaped 316L stainless steel parts with various diameters and heights were additively manufactured using a direct metal laser sintering (DMLS) technique. Neutron diffraction was used to profile the residual stresses in the samples before and after removal of the build plate and support structures. Moreover, distortion level of the parts before and after the removal was quantified using a coordinate measuring machine (CMM). Large tensile in-plane stresses (up to ≈ 400 MPa) were measured near the as-built disk top surfaces, where the stress magnitude decreased from the disk center to the edges. The stress gradient was steeper for the disks with smaller diameters and heights. Following the removal of the build plate and support structures, the magnitude of the in-plane residual stresses decreased dramatically (up to 330 MPa) whereas the axial stress magnitude did not change significantly. The stress relaxation caused the disks to distort, where the distortion metric was higher for the disks with smaller diameters and heights. The distribution of the residual stresses revealed a marked breakdown of self-similarity in their distribution even comparing disk-shaped samples that were fabricated under identical printing parameters; the stress field profiles were not linearly scaled as a function of height and diameter

Re-establishing glacier monitoring in Kyrgyzstan and Uzbekistan, Central Asia

Glacier mass loss is among the clearest indicators of atmospheric warming. The observation of these changes is one of the major objectives of the international climate monitoring strategy developed by the Global Climate Observing System (GCOS). Long-term glacier mass balance measurements are furthermore the basis for calibrating and validating models simulating future runoff of glacierised catchments. This is essential for Central Asia, which is one of the driest continental regions of the Northern Hemisphere. In the highly populated regions, water shortage due to decreased glacierisation potentially leads to pronounced political instability, drastic ecological changes and endangered food security. As a consequence of the collapse of the former Soviet Union, however, many valuable glacier monitoring sites in the Tien Shan and Pamir Mountains were abandoned. In recent years, multinational actors have re-established a set of important in situ measuring sites to continue the invaluable long-term data series. This paper introduces the applied monitoring strategy for selected glaciers in the Kyrgyz and Uzbek Tien Shan and Pamir, highlights the existing and the new measurements on these glaciers, and presents an example for how the old and new data can be combined to establish multi-decadal mass balance time series. This is crucial for understanding the impact of climate change on glaciers in this region

An investigation on the presence of Chlamydiaceae in Swedish dogs

<p>Abstract</p> <p>Background</p> <p>Bacteria belonging to the family <it>Chlamydiaceae </it>cause a broad spectrum of diseases in a wide range of hosts, including man, other mammals, and birds. Upper respiratory and genital diseases are common clinical problems caused by <it>Chlamydiaceae</it>. Very little is known about chlamydial infections in dogs. Few clinical reports on natural disease in dogs describe mainly conjunctival and upper respiratory signs, and the role of <it>Chlamydiaceae </it>in genital disease is unclear. The present study aimed at studying the prevalence of <it>Chlamydiaceae </it>in healthy dogs and in dogs with genital or upper respiratory disease, including conjunctivitis.</p> <p>Methods</p> <p>A real-time polymerase chain reaction (PCR) for <it>Chlamydiaceae </it>was used to detect any chlamydial species within this family. Swab samples from the conjunctiva and the mucosal membranes of the oropharynx, rectum and genital tract were taken from 79 dogs: 27 clinically healthy dogs, 25 dogs with clinical signs from the genital tract and 28 dogs with conjunctivitis. There were 52 female and 27 male dogs. From 7 of the male dogs, additional semen samples were analysed.</p> <p>Results</p> <p>No <it>Chlamydiaceae </it>were detected from any dog.</p> <p>Conclusions</p> <p>Although the number of dogs that was included is limited, the results suggest that cases of <it>Chlamydiaceae </it>in dogs probably are related to infection from other species, and that dogs in general do not harbour <it>Chlamydiaceae</it>. Bacteria belonging to the family <it>Chlamydiaceae </it>do not seem to be of major importance for genital or ocular disease in Swedish dogs.</p

Potential climatic transitions with profound impact on Europe

We discuss potential transitions of six climatic subsystems with large-scale impact on Europe, sometimes denoted as tipping elements. These are the ice sheets on Greenland and West Antarctica, the Atlantic thermohaline circulation, Arctic sea ice, Alpine glaciers and northern hemisphere stratospheric ozone. Each system is represented by co-authors actively publishing in the corresponding field. For each subsystem we summarize the mechanism of a potential transition in a warmer climate along with its impact on Europe and assess the likelihood for such a transition based on published scientific literature. As a summary, the ‘tipping’ potential for each system is provided as a function of global mean temperature increase which required some subjective interpretation of scientific facts by the authors and should be considered as a snapshot of our current understanding. <br/

Periglacial environments and frozen ground in the central Pyrenean high mountain area: Ground thermal regime and distribution of landforms and processes

Producción CientíficaThe periglacial belt is located in the highest parts of temperate mountains. The balance between mean air and ground temperatures and the presence of water determine the effectiveness of periglacial processes related to permafrost, the active layer or seasonally frozen ground (SFG). This study combines thermal and geomorphological data obtained in four Pyrenean massifs (Infierno‐Argualas, Posets, Maladeta and Monte Perdido) to improve knowledge on the occurrence and distribution of frozen ground. The methodology used is based on the study of landforms as frozen ground indicators, mapping processes, ground temperature analysis, basal temperature of snow, thermal mapping and geomatic surveys on rock glaciers and protalus lobes. In the Pyrenean high mountain areas the lower limit of frozen ground is at ~2,650m a.s.l., possible permafrost appears above 2,650m a.s.l. on north‐ and south‐facing slopes, and probable permafrost is dominant above 2,900m a.s.l. Unfrozen ground with cold‐associated geomorphological processes reach 2,900m a.s.l. and unfrozen and frozen ground distribution points to a patchy pattern throughout the periglacial belt. The most widespread frozen grounds are SFG. The thermal data, mean annual ground temperature, cold season temperatures, bottom temperature snow measurements, freeze/thaw cycles and distribution of landforms permit the establishment of a periglacial land system divided into three main belts: infraperiglacial, middle periglacial and supraperiglacial. The large number of processes and landforms that are involved and their altitudinal and spatial organization make up a complex environment that determines the geoecological dynamics of high mountain areas.Ministerio de Economía, Industria y Competitividad - Fondo Europeo de Desarrollo Regional (projects CGL2015-68144-R / GL2017- 82216-R

Phosphoinositide-binding interface proteins involved in shaping cell membranes

The mechanism by which cell and cell membrane shapes are created has long been a subject of great interest. Among the phosphoinositide-binding proteins, a group of proteins that can change the shape of membranes, in addition to the phosphoinositide-binding ability, has been found. These proteins, which contain membrane-deforming domains such as the BAR, EFC/F-BAR, and the IMD/I-BAR domains, led to inward-invaginated tubes or outward protrusions of the membrane, resulting in a variety of membrane shapes. Furthermore, these proteins not only bind to phosphoinositide, but also to the N-WASP/WAVE complex and the actin polymerization machinery, which generates a driving force to shape the membranes