892 research outputs found
Effect of the ionic liquid [bmim]Cl and high pressure on the activity of cellulase
The effect of the ionic liquid 1-butyl-3-methylimidazolium chloride ([bmim]Cl) and of high pressure on the activity of cellulase from Aspergillus niger were studied separately and in combination. The enzyme activity decreased with increasing concentrations of [bmim]Cl, reaching
50% the value in aqueous buffer with 20% [bmim]Cl. However, when the enzyme is held in 10% [bmim]Cl and is then assayed in 1% [bmim]Cl, it showed only 8% reduction of activity. These results can be explained by the fact that the activity of the enzyme in [bmim]Cl is linearly correlated with the decrease of the thermodynamic water activity (aw). Under pressure the enzyme
activity varied from less 60% (at 200MPa) to equal (at 400 MPa), compared to atmospheric
pressure. In 10% [bmim]Cl under pressure, cellulase activity is improved compared to atmospheric pressure, varying from equal (at 600 MPa) to 1.7-fold higher (at 100 MPa). This opens the possibility to improve cellulase activity in ionic liquids, and possibly of other enzymes, by carrying out the reaction under pressure
Different environmental variables predict distribution and cover of the introduced red seaweed Eucheuma denticulatum in two geographical locations
In this study we examined abiotic and biotic factors that could potentially influence the presence of a non-indigenous seaweed, Eucheuma denticulatum, in two locations, one outside (Kane'ohe Bay, Hawai'i, USA) and one within (Mafia Island, Tanzania) its natural geographical range. We hypothesized that the availability of hard substrate and the amount of wave exposure would explain distribution patterns, and that higher abundance of herbivorous fishes in Tanzania would exert stronger top-down control than in Hawai'i. To address these hypotheses, we surveyed E. denticulatum in sites subjected to different environmental conditions and used generalized linear mixed models (GLMM) to identify predictors of E. denticulatum presence. We also estimated grazing intensity on E. denticulatum by surveying the type and the amount of grazing scars. Finally, we used molecular tools to distinguish between indigenous and non-indigenous strains of E. denticulatum on Mafia Island. In Kane'ohe Bay, the likelihood of finding E. denticulatum increased with wave exposure, whereas on Mafia Island, the likelihood increased with cover of coral rubble, and decreased with distance from areas of introduction (AOI), but this decrease was less pronounced in the presence of coral rubble. Grazing intensity was higher in Kane'ohe Bay than on Mafia Island. However, we still suggest that efforts to reduce non-indigenous E. denticulatum should include protection of important herbivores in both sites because of the high levels of grazing close to AOI. Moreover, we recommend that areas with hard substrate and high structural complexity should be avoided when farming non-indigenous strains of E. denticulatum
Synthesis of medium-chain glycerides using lipase from Candida rugosa
Enzymatic synthesis of medium-chain glycerides (MCG) from capric acid and glycerol was studied using lipase from Candida rugosa. The effects of various reaction parameters such as time, molar ratio of substrates (mmol capric acid/mmol glycerol), amount of lipase, type of organic solvents, and initial water activity (a w ) were studied. The best conditions tested for MCG synthesis at 37°C were, respectively, time, 24 h; molar ratio of substrates, 2.5; and amount of lipase, 100.0 mg. The use of organic solvents greatly influenced the activity of lipase in the synthesis of MCG. Generally, activity of lipase was high in nonpolar solvents with log P values from 3.50 to 4.50, where P is the partition coefficient between water and 1-octanol. The enzymatic synthesis of MCG was preferably carried out at an initial a w of 0.328, which resulted in maximal yield. Analysis of the products of reaction using gas chromatography showed that lipase from Candida rugosa seemed to produce more dicaprin and tricaprin than monocaprin
Measurement of the Ds Lifetime
We report the results of a precise measurement of the Ds meson lifetime based
on 1662 +/- 56 fully reconstructed Ds -> phi pi decays, from the charm
hadroproduction experiment E791 at Fermilab. Using an unbinned maximum
likelihood fit, we measure the Ds lifetime to be 0.518 +/- 0.014 +/- 0.007 ps.
The ratio of the measured Ds lifetime to the world average D0 lifetime is 1.25
+/- 0.04. This result differs from unity by six standard deviations, indicating
significantly different lifetimes for the Ds and the D0.Comment: 12 pages, 3 figures, 2 table. LaTe
Search for the Flavor-Changing Neutral-Current Decays and
We report the results of a search for the flavor-changing neutral-current
decays and in
data from Fermilab charm hadroproduction experiment E791. No signal above
background is found, and we obtain upper limits on branching fractions,
and
, at the 90\% confidence
level.Comment: nine pages with figures; compressed, uuencoded postscrip
Study of the decay and measurement of masses and widths
From a sample of 848 44 decays, we find
. Using a Dalitz plot analysis of this
three body decay, we find significant contributions from the channels
, , , , and
. We present also the values obtained for masses and widths of
the resonances and .Comment: 10 pages, 3 eps figure
Fermilab E791
Fermilab E791, a very high statistics charm particle experiment, recently
completed its data taking at Fermilab's Tagged Photon Laboratory. Over 20
billion events were recorded through a loose transverse energy trigger and
written to 8mm tape in the the 1991-92 fixed target run at Fermilab. This
unprecedented data sample containing charm is being analysed on many-thousand
MIP RISC computing farms set up at sites in the collaboration. A glimpse of the
data taking and analysis effort is presented. We also show some preliminary
results for common charm decay modes. Our present analysis indicates a very
rich yield of over 200K reconstructed charm decays.Comment: 4 pages, 1 figure, LaTe
Dalitz Plot Analysis of the Decay D^+ --> K^- pi^+ pi^+ and Indication of a Low-Mass Scalar K pi Resonance
We study the Dalitz plot of the decay D^+ --> K^- pi^+ pi^+ with a sample of
15090 events from Fermilab experiment E791. Modeling the decay amplitude as the
coherent sum of known K pi resonances and a uniform nonresonant term, we do not
obtain an acceptable fit. If we allow the mass and width of the K^*_0(1430) to
float, we obtain values consistent with those from PDG but the chi^2 per degree
of freedom of the fit is still unsatisfactory. A good fit is found when we
allow for the presence of an additional scalar resonance, with mass 797 +/- 19
+/- 43 MeV/c^2 and width 410 +/- 43 +/- 87 MeV/c^2. The mass and width of the
K^*_0(1430) become 1459 +/- 7 +/- 5 MeV/c^2 and 175 +/- 12 +/- 12 MeV/c^2,
respectively. Our results provide new information on the scalar sector in
hadron spectroscopy.Comment: Accepted for publication in Physical Review Letter
- …