Power to detect normal mixtures: Simulation results

Twenty tests for normality were compared for the purpose of detecting mixtures of two normal components with unequal means but equal variance. The purpose of this study was to determine the power of tests specifically designed to detect mixtures, i.e., the likelihood ratio and Engelman-Hartigan tests, relative to other tests for normality. We considered the entire range of mixing proportions {pi}, 0 0.85 or {pi} < 0.15, {radical}b{sub 1} was among the best tests. For intermediate mixing proportions, the likelihood ratio test was best. For situations in which the preferred test had power 50% or more, the power of the likelihood ratio test was also above 50% and within 15 percentage points of the preferred test

The isotopic composition of normal krypton and xenon

Recently a mass-spectrometer investigation of the isotopes of krypton and xenon resulting from the fission of uranium-235 by thermal neutrons was reported.(1) This investigation was carried out with a 180°-deflection Nier-type mass spectrometer.(2

Comparison of energy spreads induced by a wakefield in a cavity

The energy spread of a beam bunch induced in a linear accelerator can be reduced to a minimum if the amplitude and the phase of the RF voltage are optimized. The energy spread is induced by the longitudinal wakefield and by the sinusoidal profile of the accelerating voltage acting on the beam. The cavity shape, the bunch profile, and the charge in the bunch determine the wake function. Aiming to have an approximately constant net voltage acting across the beam bunch, we optimize the amplitude and the phase of the RF voltage. The minimum energy spread, the required RF voltage, and the required RF phase are calculated as a function of the net charge and the length of the bunch. To find out the effect of cavity shape on the minimum energy spread, the optimization was performed for several types of cavities. 4 refs., 8 figs

Accommodating false positives within acoustic spatial capture–recapture, with variable source levels, noisy bearings and an inhomogeneous spatial density

Funding: Tiago Marques was partly supported by CEAUL (funded by FCT - Fundação para a Ciência e a Tecnologia, Portugal, through the project UIDB/00006/2020).Passive acoustic monitoring is a promising method for surveying wildlife populations that are easier to detect acoustically than visually. When animal vocalisations can be uniquely identified on an array of sensors, the potential exists to estimate population density through acoustic spatial capture–recapture (ASCR). However, sound classification is imperfect, and in some situations, a high proportion of sounds detected on just a single sensor (‘singletons’) are not from the target species. We present a case study of bowhead whale calls (Baleana mysticetus) collected in the Beaufort Sea in 2010 containing such false positives. We propose a novel extension of ASCR that is robust to false positives by truncating singletons and conditioning on calls being detected by at least two sensors. We allow for individual-level detection heterogeneity through modelling a variable sound source level, model inhomogeneous call spatial density, and include bearings with varying measurement error. We show via simulation that the method produces near-unbiased estimates when correctly specified. Ignoring source-level variation resulted in a strong negative bias, while ignoring inhomogeneous density resulted in severe positive bias. The case study analysis indicated a band of higher call density approximately 30 km from shore; 59.8% of singletons were estimated to have been false positives.Publisher PDFPeer reviewe

A comparison of three methods for estimating call densities of migrating bowhead whales using passive acoustic monitoring

TAM thanks partial support by Centro de Estatistica e Aplicações, Universidade de Lisboa (funded by FCT—Fundação para a Ciência e a Tecnologia, Portugal, through the project UID/MAT/00006/2013).Various methods for estimating animal density from visual data, including distance sampling (DS) and spatially explicit capture-recapture (SECR), have recently been adapted for estimating call density using passive acoustic monitoring (PAM) data, e.g., recordings of animal calls. Here we summarize three methods available for passive acoustic density estimation: plot sampling, DS, and SECR. The first two require distances from the sensors to calling animals (which are obtained by triangulating calls matched among sensors), but SECR only requires matching (not localizing) calls among sensors. We compare via simulation what biases can arise when assumptions underlying these methods are violated. We use insights gleaned from the simulation to compare the performance of the methods when applied to a case study: bowhead whale call data collected from arrays of directional acoustic sensors at five sites in the Beaufort Sea during the fall migration 2007–2014. Call detections were manually extracted from the recordings by human observers simultaneously scanning spectrograms of recordings from a given site. The large discrepancies between estimates derived using SECR and the other two methods were likely caused primarily by the manual detection procedure leading to non-independent detections among sensors, while errors in estimated distances between detected calls and sensors also contributed to the observed patterns. Our study is among the first to provide a direct comparison of the three methods applied to PAM data and highlights the importance that all assumptions of an analysis method need to be met for correct inference.Publisher PDFPeer reviewe

Aspectos associados à degradação ambiental e ao uso de efluentes na agricultura do Brasil.

A exploração dos recursos naturais ao longo da história desconsiderou os impactos causados sobre a sua continuidade no atendimento às necessidades humanas. A água apresenta a maior preocupação a nível mundial, e a sua escassez torna o uso racional uma atitude inevitável. A utilização de efluentes na agricultura pode contribuir na redução da exploração dos recursos hídricos. Esse estudo apresentou uma discussão e levantamento bibliográfico sobre reaproveitamento de resíduo - efluente/água residuária na agricultura - utilizando como ferramentas: o histórico da exploração e a degradação dos recursos naturais em áreas urbanas e rurais; e um panorama do uso de efluentes na agricultura. Conclui-se que a degradação dos recursos naturais, aliada as mudanças climáticas e ao constante aumento da população e de suas necessidades, são os subsídios básicos para que se estimulem as pesquisas quanto ao uso de efluentes, na agricultura e atividades afins

Phylogeny of Lantana, Lippia, and related genera (Lantaneae: Verbenaceae)

Premise: Lantana and Lippia (Verbenaceae) are two large Linnean genera whose classification has been based on associated fruit traits: fleshy vs. dry fruits and one vs. two seed-bearing units. We reconstruct evolutionary relationships and the evolution of the two fruit traits to test the validity of these traits for classification. Methods: Previous studies of plastid DNA sequences provided limited resolution for this group. Consequently, seven nuclear loci, including ITS, ETS, and five PPR loci, were sequenced for 88 accessions of the Lantana/Lippia clade and three outgroups. Results: Neither Lantana nor Lippia is monophyletic. Burroughsia, Nashia, Phyla, and several Aloysia species are included within the clade comprising Lantana and Lippia. We provide a hypothesis for fruit evolution and biogeographic history in the group and their relevance for classification. Conclusions: Fleshy fruits evolved multiple times in the Lantana/Lippia clade and thus are not suitable taxonomic characters. Several sections of Lantana and Lippia and the small genera are monophyletic, but Lippia section Zappania is broadly paraphyletic, making circumscription of genera difficult. Lippia sect. Rhodolippia is a polyphyletic group characterized by convergence in showy bracts. Species of Lantana sect. Sarcolippia, previously transferred to Lippia, are not monophyletic. The clade originated and diversified in South America, with at least four expansions into both Central America and the Caribbean and two to Africa. The types species of Lantana and Lippia occur in small sister clades, rendering any taxonomy that retains either genus similar to its current circumscription impossible.Fil: Lu Irving, Patricia. University of Washington; Estados UnidosFil: Bedoya, Ana M.. University of Washington; Estados UnidosFil: Salimena, Fátima R. G.. Universidade Federal de Juiz de Fora; BrasilFil: dos Santos Silva, Tânia R.. Universidade Estadual de Feira de Santana; BrasilFil: Viccini, Lyderson F.. Universidade Federal de Juiz de Fora; BrasilFil: Bitencourt, Cássia. Universidade Estadual de Feira de Santana; BrasilFil: Thode, Verônica. Universidade Federal do Rio Grande do Sul; BrasilFil: Cardoso, Pedro H.. Universidade Federal Do Rio de Janeiro. Museu Nacional; BrasilFil: O'Leary, Nataly Cristina. Consejo Nacional de Investigaciones Científicas y Técnicas. Instituto de Botánica Darwinion. Academia Nacional de Ciencias Exactas, Físicas y Naturales. Instituto de Botánica Darwinion; ArgentinaFil: Olmstead, Richard. University of Washington; Estados Unido