162 research outputs found

    Investigation of element-specific and bulk magnetism, electronic and crystal structures of La{0.70}Ca{0.30}Mn{1-x}Cr{x}O{3}

    Get PDF
    The magnetic interactions in La{0.70}Ca{0.30}Mn{1-x}Cr{x}O{3} (x = 0.15, 0.50 and 0.70) are investigated by x-ray absorption spectroscopy (XAS), x-ray magnetic circular dichroism (XMCD), high-resolution x-ray powder diffraction, and bulk magnetization measurements. XAS in the Mn and Cr L{2,3} edges support stable single valent Cr{3+} ions and a varying Mn valence state with x, while the O K edge XAS spectrum reveals local maxima in the O 2p density of states close to the Fermi level due to mixing with Mn and Cr 3d states. A robust antiferromagnetic state is found for x=0.70 below TN = 258 K. For x=0.15, combined XMCD and bulk magnetization measurements indicate a fully polarized ferrimagnetic state for the Mn and Cr spins below Tc=224 K. For x=0.50, a reduced ferrimagnetic component dominated by Mn spins is present below Tc=154 K. No evidence of lattice anomalies due to cooperative charge and orbital orderings is found by x-ray diffraction for all samples. The magnetic properties of this system are rationalized in terms of a competition of ferromagnetic Mn-Mn double exchange and antiferromagnetic Cr-Cr and Cr-Mn superexchange interactions.Comment: 25 pages, 9 figure

    Doping Dependence of Polaron Hopping Energies in La(1-x)Ca(x)MnO(3) (0<= x<= 0.15)

    Full text link
    Measurements of the low-frequency (f<= 100 kHz) permittivity at T<= 160 K and dc resistivity (T<= 430 K) are reported for La(1-x)Ca(x)MnO(3) (0<= x<= 0.15). Static dielectric constants are determined from the low-T limiting behavior of the permittivity. The estimated polarizability for bound holes ~ 10^{-22} cm^{-3} implies a radius comparable to the interatomic spacing, consistent with the small polaron picture established from prior transport studies near room temperature and above on nearby compositions. Relaxation peaks in the dielectric loss associated with charge-carrier hopping yield activation energies in good agreement with low-T hopping energies determined from variable-range hopping fits of the dc resistivity. The doping dependence of these energies suggests that the orthorhombic, canted antiferromagnetic ground state tends toward an insulator-metal transition that is not realized due to the formation of the ferromagnetic insulating state near Mn(4+) concentration ~ 0.13.Comment: PRB in press, 5 pages, 6 figure

    Spin-Electron-Phonon Excitation in Re-based Half-Metallic Double Perovskites

    Get PDF
    A remarkable hardening (~ 30 cm-1) of the normal mode of vibration associated with the symmetric stretching of the oxygen octahedra for the Ba2FeReO6 and Sr2CrReO6 double perovskites is observed below the corresponding magnetic ordering temperatures. The very large magnitude of this effect and its absence for the anti-symmetric stretching mode provide evidence against a conventional spin-phonon coupling mechanism. Our observations are consistent with a collective excitation formed by the combination of the vibrational mode with oscillations of local Fe or Cr 3d and Re 5d occupations and spin magnitudes.Comment: 12 pages, 4 figure

    Pressure and chemical substitution effects in the local atomic structure of BaFe2As2

    Get PDF
    The effects of K and Co substitutions and quasi-hydrostatic applied pressure (P<9 GPa) in the local atomic structure of BaFe2As2, Ba(Fe{0.937}Co{0.063})2As2 and Ba{0.85}K{0.15}Fe2As2 superconductors were investigated by extended x-ray absorption fine structure (EXAFS) measurements in the As K absorption edge. The As-Fe bond length is found to be slightly reduced (<~ 0.01 Angstroms) by both Co and K substitutions, without any observable increment in the corresponding Debye Waller factor. Also, this bond is shown to be compressible (k = 3.3(3)x10^{-3} GPa^{-1}). The observed contractions of As-Fe bond under pressure and chemical substitutions are likely related with a reduction of the local Fe magnetic moments, and should be an important tuning parameter in the phase diagrams of the Fe-based superconductors.Comment: 7 pages, 6 figure

    Design methodology using topology optimization for anti- vibration reinforcement of generators in a ship’s engine room

    Get PDF
    Structural optimization for reinforcing the anti-vibration characteristics of the generators in the engine room of a ship is presented. To improve the vibration characteristics of the structures, topology optimization methods can be effective because they can optimize the fundamental characteristics of the structure with their ability to change the topology of the target structure. Topology optimization is used to improve the characteristics of the anti-vibration reinforcement of the generators in the engine room. First, an experimentally observed vibration phenomenon is simulated using the finite element method for frequency response problems. Next, the objective function used in topology optimization is set as the dynamic work done by the load based on the energy equilibrium of the structural vibration. The optimization problem is then constructed by adding the volume constraint. Finally, based on finite element analysis and the optimization problem, topology optimization is performed on several vibration cases to improve their performance and reduce weight.This work was supported by the JSPS KAKENHI Grant Numbers 24360356 and 25820422

    Willingness to pay for municipality hospital services in rural Japan: a contingent valuation study

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>The Japanese healthcare system has undergone reforms to address the struggles that municipality hospitals face. Reform guidelines clearly define criteria for administrative improvement. However, criteria to evaluate the demand for healthcare provisions in rural Japan, including the needs of rural residents for municipality hospitals in particular have not been specified. The purpose of this paper is to measure residents' willingness to pay (WTP) for municipality hospital services using the contingent valuation method, and to evaluate municipality hospital valuation on the basis of WTP. K town, located in the Hokkaido prefecture of Japan, was selected as the location for this study. Participants were recruited by a town hall healthcare administrator, hospital and clinic staff, and a local dentist. Participants were asked what amount they would be willing to pay as taxes to continue accessing the services of the municipality hospital for one year by using open-ended questions in face-to-face interviews.</p> <p>Findings</p> <p>Forty-eight residents were initially recruited, and 40 participants were selected for the study (response rate 83%). As compared to K town's population, this data slanted toward the elderly, although there was no significant difference in frequency among the characteristics. The median WTP was estimated at 39,484 yen (438.71),witha95438.71), with a 95% confidence interval 27,806-55,437 yen (308.95-615.96). Logistic regression revealed no significant factors affecting WTP.</p> <p>Conclusions</p> <p>If the total amount of residents' WTP for the municipality hospital were to be estimated by this result, it would calculate with 129,586,000 yen ($1,439,844). This is approximately equal to the amount of money to be transferred from the general account of the government of K town, more than one-half of the town tax of K town, and about two-fold in comparison to Japan as a whole. This showed that K town's residents placed a high valuation on the municipality hospital, which nearly equalled the amount that the K town government provided to the municipality hospital to cover its annual deficit. K town residents had come to expect not only general clinical practice, but also emergency medical services and night practice provided by their own town's municipality hospital. WTP can be used as a measure of hospital evaluation because it reflects the importance of the hospital to the residents in its region.</p

    Tricholoma matsutake 1-Ocen-3-ol and methyl cinnamate repel mycophagous Proisotoma minuta (Collembola: Insecta)

    Get PDF
    Two major volatiles produced by the mycelia and fruiting bodies of Tricholoma matsutake (1-octen-3-ol and methyl cinnamate) repel a mycophagous collembolan, Proisotoma minuta. Aggregation of the collembolans on their diet was significantly inhibited by exposure to 1 ppm methyl cinnamate or 10 to 100 ppm 1-octen-3-ol. The aggregation activity decreased dose-dependently upon exposure to 1-octen-3-ol at concentrations higher than 0.01 ppm. Aggregation in the presence of methyl cinnamate exhibited three phases: no significant effect at concentrations ranging from 0.001 to 0.1 ppm, significant inhibition from 1 to 100 ppm, and strong inhibition at 1,000 ppm. These results may explain why certain collembolan species do not prefer T. matsutake fruiting bodies
    • 

    corecore