Resistive damping implementation as a method to improve controllability in stiff ohmic RF-MEMS switches

This paper presents in detail the entire procedure of calculating the bias resistance of an ohmic RF-MEMS switch, controlled under resistive damping (charge drive technique). In case of a very stiff device, like the North Eastern University switch, the actuation control under resistive damping is the only way to achieve controllability. Due to the short switching time as well as the high actuation voltage, it is not practical to apply a tailored control pulse (voltage drive control technique). Implementing a bias resistor of 33 MΩ in series with the voltage source, the impact velocity of the cantilever has been reduced 80 % (13.2 from 65.9 cm/s), eliminating bouncing and high initial impact force during the pull-down phase. However, this results in an affordable cost of switching time increase from 2.38 to 4.34 μs. During the release phase the amplitude of bouncing has also been reduced 34 % (174 from 255 nm), providing significant improvement in both switching operation phases of the switch. © 2013 Springer-Verlag Berlin Heidelberg

Estudio bibliométrico de la evolución de la revista Enseñanza de las ciencias a partir de sus fuentes de información

Science learning research development in Spain can be bibliometrically analyzed using Enseñanza de las Ciencias as indicator, because of the incidence level of this journal in researchers with interest in scientific education. The references which are cited in the articles have been studied in order to analyze the main sources and the most productive authors, using the Bradford model. The evolution of the type of sources and articles which are cited during the period of time studied are considered

Human Indoor Exposure to Airborne Halogenated Flame Retardants: Influence of Airborne Particle Size

Inhalation of halogenated flame-retardants (HFRs) released from consumer products is an important route of exposure. However, not all airborne HFRs are respirable, and thus interact with vascular membranes within the gas exchange (alveolar) region of the lung. HFRs associated with large (\u3e 4 mu m), inhalable airborne particulates are trapped on the mucosal lining of the respiratory tract and then are expelled or swallowed. The latter may contribute to internal exposure via desorption from particles in the digestive tract. Exposures may also be underestimated if personal activities that re-suspend particles into the breathing zone are not taken into account. Here, samples were collected using personal air samplers, clipped to the participants\u27 shirt collars (n = 18). We observed that the larger, inhalable air particulates carried the bulk (\u3e92%) of HFRs. HFRs detected included those removed from commerce (i.e., polybrominated diphenyl ethers (Penta-BDEs: BDE-47, -85, -100, -99, and -153)), their replacements; e.g., 2-ethylhexyl 2,3,4,5-tetrabromobenzoate (TBB or EH-TBB); bis(2-ethylhexyl) 3,4,5,6-tetrabromophthalate (TBPH or BEH-TEBP) and long-produced chlorinated organophosphate-FRs (ClOPFRs): tris(2-chloroethyl) phosphate (TCEP), tris(1-chloro-2-propyl) phosphate (TCPP or TCIPP), and tris(1,3-dichloro-2-propyl) phosphate (TDCPP or TDCIPP). Our findings suggest estimates relying on a single exposure route, i.e., alveolar gas exchange, may not accurately estimate HFR internal dosage, as they ignore contributions from larger inhalable particulates that enter the digestive tract. Consideration of the fate and bioavailability of these larger particulates resulted in higher dosage estimates for HFRs with log K-oa \u3c 12 (i.e., Penta-BDEs and ClOPFRs) and lower estimates for those with log Koa \u3e 12 (i.e., TBB and TBPH) compared to the alveolar route exposure alone. Of those HFRs examined, the most significant effect was the lower estimate by 41% for TBPH. The bulk of TBPH uptake from inhaled particles was estimated to be through the digestive tract, with lower bioavailability. We compared inhalation exposure estimates to chronic oral reference doses (RfDs) established by several regulatory agencies. The U.S. Environmental Protection Agency (EPA) RfD levels for several HFRs are considered outdated; however, BDE-99 levels exceeded those suggested by the Dutch National Institute for Public Health and the Environment (RIVM) by up to 26 times. These findings indicate that contributions and bioavailability of respirable and inhalable airborne particulates should both be considered in future risk assessments

Behavior of a Model Dynamical System with Applications to Weak Turbulence

We experimentally explore solutions to a model Hamiltonian dynamical system derived in Colliander et al., 2012, to study frequency cascades in the cubic defocusing nonlinear Schr\"odinger equation on the torus. Our results include a statistical analysis of the evolution of data with localized amplitudes and random phases, which supports the conjecture that energy cascades are a generic phenomenon. We also identify stationary solutions, periodic solutions in an associated problem and find experimental evidence of hyperbolic behavior. Many of our results rely upon reframing the dynamical system using a hydrodynamic formulation.Comment: 22 pages, 14 figure

Mechanical robustness of HL-LHC collimator designs

Two new absorbing materials were developed as collimator inserts to fulfil the requirements of HL-LHC higher brightness beams: molybdenum-carbide graphite (MoGr) and copper-diamond (CuCD). These materials were tested under intense beam impacts at CERN HiRadMat facility in 2015, when full jaw prototypes were irradiated. Additional tests in HiRadMat were performed in 2017 on another series of material samples, including also improved grades of MoGr and CuCD, and different coating solutions. This paper summarizes the main results of the two experiments, with a main focus on the behaviour of the novel composite blocks, the metallic housing, as well as the cooling circuit. The experimental campaign confirmed the final choice for the materials and the design solutions for HL-LHC collimators, and constituted a unique chance of benchmarking numerical models. In particular, the tests validated the selection of MoGr for primary and secondary collimators, and CuCD as a valid solution for robust tertiary collimators

Ultrassonografia cardíaca en individus adietes a l'heroína intravenosa assimptomàtics: evidencia de lesions valvulars induïdes per l'adicció

Echocardiograph

Computing Linear Matrix Representations of Helton-Vinnikov Curves

Helton and Vinnikov showed that every rigidly convex curve in the real plane bounds a spectrahedron. This leads to the computational problem of explicitly producing a symmetric (positive definite) linear determinantal representation for a given curve. We study three approaches to this problem: an algebraic approach via solving polynomial equations, a geometric approach via contact curves, and an analytic approach via theta functions. These are explained, compared, and tested experimentally for low degree instances.Comment: 19 pages, 3 figures, minor revisions; Mathematical Methods in Systems, Optimization and Control, Birkhauser, Base

Has cupper ion any effect on Sinorhizobium Melitoili bacteria?

Proceedings of the I Congress PIIISA celebrado en la Estación Experimental del Zaidín, Granada, el 26 de abril de 2012.Sinorhizobium meliloti is a soil bacterium that in symbiosis with Alfalfa leguminous plants fixes N2 to ammonia. This process occurs after an intimate communication between host and microsimbiont in the rhizosphere niche. This soil bacterium may suffer biotic and abiotic stresses in this complex environment. Resistance to any of this stresses can be an advantage for this type of bacteria. In this work we test the effects of Cupper ion in the bacterium Sinorhizobium meliloti. We found an effect on pigmentation and this effect is specific of each isolate (i.e. it is very pronounced for the isolate AK83 from Aral sea in Russia). On the other hand, comparison of Cupper ion resistance phenotype between isolates 1021 and GR4 suggests that the resistance of GR4 could be due to a set of 10 genes found in the cryptic plasmid pRmeGR4a of this strain. However, this resistance phenotype also appears in other isolates, and it could be explained by an alternative phenotype as Exopolysaccaride production (EPS+).It was supported mainly by research project MICINN Consolider‐Ingenio 2010. CSD2009‐00006; Scientific research by Young Students in Science (PIIISA2012; http://emc2astronomy.blogspot.com/).Peer reviewe