Electrical writing, deleting, reading, and moving of magnetic skyrmioniums in a racetrack device

A magnetic skyrmionium (also called 2$\pi$-skyrmion) can be understood as a skyrmion - a topologically non-trivial magnetic whirl - which is situated in the center of a second skyrmion with reversed magnetization. Here, we propose a new optoelectrical writing and deleting mechanism for skyrmioniums in thin films, as well as a reading mechanism based on the topological Hall voltage. Furthermore, we point out advantages for utilizing skyrmioniums as carriers of information in comparison to skyrmions with respect to the current-driven motion. We simulate all four constituents of an operating skyrmionium-based racetrack storage device: creation, motion, detection and deletion of bits. The existence of a skyrmionium is thereby interpreted as a '1' and its absence as a '0' bit.Comment: This is a post-peer-review, pre-copyedit version of an article published in Scientific Reports. The final authenticated version is available online at [DOI

Intuitive Analyses via Drift Theory

Humans are bad with probabilities, and the analysis of randomized algorithms offers many pitfalls for the human mind. Drift theory is an intuitive tool for reasoning about random processes. It allows turning expected stepwise changes into expected first-hitting times. While drift theory is used extensively by the community studying randomized search heuristics, it has seen hardly any applications outside of this field, in spite of many research questions which can be formulated as first-hitting times. We state the most useful drift theorems and demonstrate their use for various randomized processes, including approximating vertex cover, the coupon collector process, a random sorting algorithm, and the Moran process. Finally, we consider processes without expected stepwise change and give a lemma based on drift theory applicable in such scenarios without drift. We use this tool for the analysis of the gambler's ruin process, for a coloring algorithm, for an algorithm for 2-SAT, and for a version of the Moran process without bias

To relate surface properties and surface elemental composition - Application of XPS in soil science

Soil particles always are coated by thin layers (nm to µm) of predominantly organic compounds that form the interface between particle and pore space and govern soil functioning (e.g. liquid transport, sorption, respiration). Chemical modification of the surface layer can change surface properties such as wettability (quantified in terms of contact angle CA) with implications for e.g. liquid distribution and sorption capacity. This points to the importance to specifically analyze the coating's chemical composition in order to better understand soil functioning. The shallow analysis depth (max. 10 nm) indicates X ray photoelectron spectroscopy (XPS) as a suitable tool. Here, all elements with Z ≥ 3 will be identified by the binding energy of the photoelectrons emitted after irradiation of the surface by X rays. In sensu stricto only applicable to flat and smooth surfaces our results so far prove applicability of XPS as well to rough surfaces such as soil particles. For XPS no sample pre-treatment is needed, i.e. the surfaces analyzed are those governing e.g. CA and sorption. The relation between surface elemental composition and CA could be demonstrated within a soil chronosequence where the changes of surface element contents due to an increasing coating of the particles by organic compounds and microorganisms were correlated to increasing CA. The surface O/C ratio could be identified as a general parameter linking surface chemical composition and CA for a wide range of different materials including hydrophobized glass slides while the amount of non-polar C species was indicated to define CA. Artificially induced modifications of surface properties became visible by changes in the surface elemental composition. Gentle crushing of soil microaggregates (SMA) resulted in slightly increased N contents hinting on a preferred location of N compounds within SMA. Exposition to HCl gas to decrease soil pH or cleaning of quartz sand by HCl treatment resulted in addition of Cl and removal of Fe, respectively. However, due to its high surface sensitivity XPS measures the presence of C species on all surfaces exposed to the environment (adventitious carbon AC). AC was found to complicate the verification of sorption of small amounts of organic acids to montmorillonite, pointing on the necessity to estimate the influence of AC in certain cases. On the other hand, detection of AC indicates AC as a factor to be considered when discussing surface properties

Electron-phonon renormalization of the absorption edge of the cuprous halides

Compared to most tetrahedral semiconductors, the temperature dependence of the absorption edges of the cuprous halides (CuCl, CuBr, CuI) is very small. CuCl and CuBr show a small increase of the gap $E_0$ with increasing temperature, with a change in the slope of $E_0$ vs. $T$ at around 150 K: above this temperature, the variation of $E_0$ with $T$ becomes even smaller. This unusual behavior has been clarified for CuCl by measurements of the low temperature gap vs. the isotopic masses of both constituents, yielding an anomalous negative shift with increasing copper mass. Here we report the isotope effects of Cu and Br on the gap of CuBr, and that of Cu on the gap of CuI. The measured isotope effects allow us to understand the corresponding temperature dependences, which we also report, to our knowledge for the first time, in the case of CuI. These results enable us to develop a more quantitative understanding of the phenomena mentioned for the three halides, and to interpret other anomalies reported for the temperature dependence of the absorption gap in copper and silver chalcogenides; similarities to the behavior observed for the copper chalcopyrites are also pointed out.Comment: 14 pages, 5 figures, submitted to Phys. Rev.

Thermal ageing phenomena and strategies towards reactivation of NO x - storage catalysts

The thermal ageing and reactivation of Ba/CeO2 and Ba/Al2O3 based NO x -storage/ reduction (NSR) catalysts was studied on model catalysts and catalyst systems at the engine. The mixed oxides BaAl2O4 and BaCeO3, which lower the storage activity, are formed during ageing above 850°C and 900°C, respectively. Interestingly, the decomposition of BaCeO3 in an atmosphere containing H2O/NO2 leads again to NO x -storage active species, as evidenced by comparison of fresh, aged and reactivated Pt-Ba/CeO2 based model catalysts. This can be technically exploited, particularly for the Ba/CeO2 catalysts, as reactivation studies on thermally aged Ba/CeO2 and Ba/Al2O3 based NSR catalysts on an engine bench showed. An on-board reactivation procedure is presented, that improved the performance of a thermally aged catalyst significantl

Which game narratives do adolescents of different gameplay and sociodemographic backgrounds prefer? a mixed-methods analysis

OBJECTIVE: The aim of this study was to investigate which narrative elements of digital game narratives are preferred by the general adolescent population, and to examine associations with gender, socioeconomic status (SES), and gameplay frequency. Further, the study aims to discuss how results can be translated to serious digital games. MATERIALS AND METHODS: Adolescents were recruited through school to complete a survey on narrative preferences in digital games. The survey included questions on sociodemographic information, frequency of gameplay, and an open-ended question on what could be an appealing narrative for them. Data were analyzed in a mixed-methods approach, using thematic analysis and chi-square analyses to determine narrative preferences and the associations between game narrative elements and player characteristics (gender, SES, and frequency of gameplay). RESULTS: The sample consisted of 446 adolescents (12-15 years old) who described 30 narrative subthemes. Preferences included human characters as protagonists; nonhuman characters only as antagonists; realistic settings, such as public places or cities; and a strong conflict surrounding crime, catastrophe, or war. Girls more often than boys defined characters by their age, included avatars, located the narrative in private places, developed profession-related skills, and included a positive atmosphere. Adolescents of nonacademic education more often than adolescents of academic education defined characters by criminal actions. Infrequent players more often included human characters defined by their age than frequent players. After performing a Bonferroni correction, narrative preferences for several gender differences remained. CONCLUSION: Different narrative elements related to subgroups of adolescents by gender, SES, and frequency of gameplay. Customization of narratives in serious digital health games should be warranted for boys and girls; yet, further research is needed to specify how to address girls in particular

Stochastic optimization of a cold atom experiment using a genetic algorithm

We employ an evolutionary algorithm to automatically optimize different stages of a cold atom experiment without human intervention. This approach closes the loop between computer based experimental control systems and automatic real time analysis and can be applied to a wide range of experimental situations. The genetic algorithm quickly and reliably converges to the most performing parameter set independent of the starting population. Especially in many-dimensional or connected parameter spaces the automatic optimization outperforms a manual search.Comment: 4 pages, 3 figure