The Herschel Exploitation of Local Galaxy Andromeda (HELGA) II: Dust and Gas in Andromeda

We present an analysis of the dust and gas in Andromeda, using Herschel images sampling the entire far-infrared peak. We fit a modified-blackbody model to ~4000 quasi-independent pixels with spatial resolution of ~140pc and find that a variable dust-emissivity index (beta) is required to fit the data. We find no significant long-wavelength excess above this model suggesting there is no cold dust component. We show that the gas-to-dust ratio varies radially, increasing from ~20 in the center to ~70 in the star-forming ring at 10kpc, consistent with the metallicity gradient. In the 10kpc ring the average beta is ~1.9, in good agreement with values determined for the Milky Way (MW). However, in contrast to the MW, we find significant radial variations in beta, which increases from 1.9 at 10kpc to ~2.5 at a radius of 3.1kpc and then decreases to 1.7 in the center. The dust temperature is fairly constant in the 10kpc ring (ranging from 17-20K), but increases strongly in the bulge to ~30K. Within 3.1kpc we find the dust temperature is highly correlated with the 3.6 micron flux, suggesting the general stellar population in the bulge is the dominant source of dust heating there. At larger radii, there is a weak correlation between the star formation rate and dust temperature. We find no evidence for 'dark gas' in M31 in contrast to recent results for the MW. Finally, we obtained an estimate of the CO X-factor by minimising the dispersion in the gas-to-dust ratio, obtaining a value of (1.9+/-0.4)x10^20 cm^-2 [K kms^-1]^-1.Comment: 19 pages, 18 figures. Submitted to ApJ April 2012; Accepted July 201

On high-speed turning of a third-generation gamma titanium aluminide

Gamma titanium aluminides are heat-resistant intermetallic alloys predestined to be employed in components suffering from high mechanical stresses and thermal loads. These materials are regarded as difficult to cut, so this makes process adaptation essential in order to obtain high-quality and defect-free surfaces suitable for aerospace and automotive parts. In this paper, an innovative approach for longitudinal external high-speed turning of a third-generation Ti-45Al-8Nb- 0.2C-0.2B gamma titanium aluminide is presented. The experimental campaign has been executed with different process parameters, tool geometries and lubrication conditions. The results are discussed in terms of surface roughness/integrity, chip morphology, cutting forces and tool wear. Experimental evidence showed that, due to the high cutting speed, the high temperatures reached in the shear zone improve chip formation, so a crack-free surface can be obtained. Furthermore, the use of a cryogenic lubrication system has been identified in order to reduce the huge tool wear, which represents the main drawback when machining gamma titanium aluminides under the chosen process condition

A Learning Management System-Based Early Warning System for Academic Advising in Undergraduate Engineering

This chapter describes a design-based research project that developed an early warning system for an undergraduate engineering mentoring program. Using near real-time data from a university’s learning management system, we provided academic advisors with timely and targeted data on students’ academic progress. We discuss the development of the early warning system and detail how academic advisors used it. Our findings point to the value of providing academic advisors with performance data that can be used to direct students to appropriate sources of support.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/107974/1/Krumm_etal_2014_LA.pd

Chronic non-specific low back pain - sub-groups or a single mechanism?

Copyright 2008 Wand and O'Connell; licensee BioMed Central Ltd. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.Background: Low back pain is a substantial health problem and has subsequently attracted a considerable amount of research. Clinical trials evaluating the efficacy of a variety of interventions for chronic non-specific low back pain indicate limited effectiveness for most commonly applied interventions and approaches. Discussion: Many clinicians challenge the results of clinical trials as they feel that this lack of effectiveness is at odds with their clinical experience of managing patients with back pain. A common explanation for this discrepancy is the perceived heterogeneity of patients with chronic non-specific low back pain. It is felt that the effects of treatment may be diluted by the application of a single intervention to a complex, heterogeneous group with diverse treatment needs. This argument presupposes that current treatment is effective when applied to the correct patient. An alternative perspective is that the clinical trials are correct and current treatments have limited efficacy. Preoccupation with sub-grouping may stifle engagement with this view and it is important that the sub-grouping paradigm is closely examined. This paper argues that there are numerous problems with the sub-grouping approach and that it may not be an important reason for the disappointing results of clinical trials. We propose instead that current treatment may be ineffective because it has been misdirected. Recent evidence that demonstrates changes within the brain in chronic low back pain sufferers raises the possibility that persistent back pain may be a problem of cortical reorganisation and degeneration. This perspective offers interesting insights into the chronic low back pain experience and suggests alternative models of intervention. Summary: The disappointing results of clinical research are commonly explained by the failure of researchers to adequately attend to sub-grouping of the chronic non-specific low back pain population. Alternatively, current approaches may be ineffective and clinicians and researchers may need to radically rethink the nature of the problem and how it should best be managed

Development of a video-based education and process change intervention to improve advance cardiopulmonary resuscitation decision-making

Background: Advance cardiopulmonary resuscitation (CPR) decision-making and escalation of care discussions are variable in routine clinical practice. We aimed to explore physician barriers to advance CPR decision-making in an inpatient hospital setting and develop a pragmatic intervention to support clinicians to undertake and document routine advance care planning discussions. Methods: Two focus groups, which involved eight consultants and ten junior doctors, were conducted following a review of the current literature. A subsequent iterative consensus process developed two intervention elements: (i) an updated ‘Goals of Patient Care’ (GOPC) form and process; (ii) an education video and resources for teaching advance CPR decision-making and communication. A multidisciplinary group of health professionals and policymakers with experience in systems development, education and research provided critical feedback. Results: Three key themes emerged from the focus groups and the literature, which identified a structure for the intervention: (i) knowing what to say; (ii) knowing how to say it; (iii) wanting to say it. The themes informed the development of a video to provide education about advance CPR decision-making framework, improving communication and contextualising relevant clinical issues. Critical feedback assisted in refining the video and further guided development and evolution of a medical GOPC approach to discussing and recording medical treatment and advance care plans. Conclusion: Through an iterative process of consultation and review, video-based education and an expanded GOPC form and approach were developed to address physician and systemic barriers to advance CPR decisionmaking and documentation. Implementation and evaluation across hospital settings is required to examine utility and determine effect on quality of care

The role of agonist and antagonist muscles in explaining isometric knee extension torque variation with hip joint angle.

PURPOSE: The biarticular rectus femoris (RF), operating on the ascending limb of the force-length curve, produces more force at longer lengths. However, experimental studies consistently report higher knee extension torque when supine (longer RF length) compared to seated (shorter RF length). Incomplete activation in the supine position has been proposed as the reason for this discrepancy, but differences in antagonistic co-activation could also be responsible due to altered hamstrings length. We examined the role of agonist and antagonist muscles in explaining the isometric knee extension torque variation with changes in hip joint angle. METHOD: Maximum voluntary isometric knee extension torque (joint MVC) was recorded in seated and supine positions from nine healthy males (30.2 ± 7.7 years). Antagonistic torque was estimated using EMG and added to the respective joint MVC (corrected MVC). Submaximal tetanic stimulation quadriceps torque was also recorded. RESULT: Joint MVC was not different between supine (245 ± 71.8 Nm) and seated (241 ± 69.8 Nm) positions and neither was corrected MVC (257 ± 77.7 and 267 ± 87.0 Nm, respectively). Antagonistic torque was higher when seated (26 ± 20.4 Nm) than when supine (12 ± 7.4 Nm). Tetanic torque was higher when supine (111 ± 31.9 Nm) than when seated (99 ± 27.5 Nm). CONCLUSION: Antagonistic co-activation differences between hip positions do not account for the reduced MVC in the supine position. Rather, reduced voluntary knee extensor muscle activation in that position is the major reason for the lower MVC torque when RF is lengthened (hip extended). These findings can assist standardising muscle function assessment and improving musculoskeletal modelling applications

The conservation value of human-modified landscapes for the world's primates

Land-use change pushes biodiversity into human-modified landscapes, where native ecosystems are surrounded by anthropic land covers (ALCs). Yet, the ability of species to use these emerging covers remains poorly understood. We quantified the use of ALCs by primates worldwide, and analyzed species' attributes that predict such use. Most species use secondary forests and tree plantations, while only few use human settlements. ALCs are used for foraging by at least 86 species with an important conservation outcome: those that tolerate heavily modified ALCs are 26% more likely to have stable or increasing populations than the global average for all primates. There is no phylogenetic signal in ALCs use. Compared to all primates on Earth, species using ALCs are less often threatened with extinction, but more often diurnal, medium or large-bodied, not strictly arboreal, and habitat generalists. These findings provide valuable quantitative information for improving management practices for primate conservation worldwide

Scrotal cancer: Incidence, survival and second primary tumours in the Netherlands since 1989

Background: Since the 1970s there have been few epidemiological studies of scrotal cancer. We report on the descriptive epidemiology of scrotal cancer in the Netherlands. Methods: Data on all scrotal cancer patients were obtained from the Netherlands Cancer Registry (NCR) in the period 1989-2006 and age-standardised incidence rates were calculated also according to histology and stage. Relative survival was calculated and multiple primary tumours were studied. Results: The overall incidence rate varied around 1.5 per 1 000 000 person-years, most frequently being squamous cell carcinoma (27%), basal cell carcinoma (19%) and Bowen's disease (15%). Overall 5-year relative survival was 82%, being 77% and 95% for patients with squamous and basal cell carcinoma, respectively. In all, 18% of the patients were diagnosed with a second primary tumour. Conclusion: The incidence rate of scrotal cancer did not decrease, although this was expected; affected patients might benefit from regular checkups for possible new cancers

Step by step: reconstruction of terrestrial animal movement paths by dead-reckoning

Background: Research on wild animal ecology is increasingly employing GPS telemetry in order to determine animal movement. However, GPS systems record position intermittently, providing no information on latent position or track tortuosity. High frequency GPS have high power requirements, which necessitates large batteries (often effectively precluding their use on small animals) or reduced deployment duration. Dead-reckoning is an alternative approach which has the potential to ‘fill in the gaps’ between less resolute forms of telemetry without incurring the power costs. However, although this method has been used in aquatic environments, no explicit demonstration of terrestrial dead-reckoning has been presented.Results: We perform a simple validation experiment to assess the rate of error accumulation in terrestrial dead-reckoning. In addition, examples of successful implementation of dead-reckoning are given using data from the domestic dog Canus lupus, horse Equus ferus, cow Bos taurus and wild badger Meles meles.Conclusions: This study documents how terrestrial dead-reckoning can be undertaken, describing derivation of heading from tri-axial accelerometer and tri-axial magnetometer data, correction for hard and soft iron distortions on the magnetometer output, and presenting a novel correction procedure to marry dead-reckoned paths to ground-truthed positions. This study is the first explicit demonstration of terrestrial dead-reckoning, which provides a workable method of deriving the paths of animals on a step-by-step scale. The wider implications of this method for the understanding of animal movement ecology are discussed

Facial Cosmetics and Attractiveness: Comparing the Effect Sizes of Professionally-Applied Cosmetics and Identity

Forms of body decoration exist in all human cultures. However, in Western societies, women are more likely to engage in appearance modification, especially through the use of facial cosmetics. How effective are cosmetics at altering attractiveness? Previous research has hinted that the effect is not large, especially when compared to the variation in attractiveness observed between individuals due to differences in identity. In order to build a fuller understanding of how cosmetics and identity affect attractiveness, here we examine how professionally-applied cosmetics alter attractiveness and compare this effect with the variation in attractiveness observed between individuals. In Study 1, 33 YouTube models were rated for attractiveness before and after the application of professionally-applied cosmetics. Cosmetics explained a larger proportion of the variation in attractiveness compared with previous studies, but this effect remained smaller than variation caused by differences in attractiveness between individuals. Study 2 replicated the results of the first study with a sample of 45 supermodels, with the aim of examining the effect of cosmetics in a sample of faces with low variation in attractiveness between individuals. While the effect size of cosmetics was generally large, between-person variability due to identity remained larger. Both studies also found interactions between cosmetics and identity-more attractive models received smaller increases when cosmetics were worn. Overall, we show that professionally- applied cosmetics produce a larger effect than self-applied cosmetics, an important theoretical consideration for the field. However, the effect of individual differences in facial appearance is ultimately more important in perceptions of attractiveness