629 research outputs found
Recommended from our members
Influence of semicon shields on the dielectric loss of XLPE cables
Dielectric response measurement techniques in both time and frequency domains are studied in order to measure the dielectric loss of XLPE cables, which have very low losses. A high sensitivity transformer ratio bridge system, which can measure loss tangents as low as 10-5, has been developed with the ability to measure these cables. A tuned amplifier was designed to help to extend the frequency range from 200Hz to 20kHz. Different model cables from Borealis AB with different semiconducting materials have been measured in the temperature range 15â°C to 120â°C. It is found that the semiconducting layers dominate the dielectric loss in the insulation system of the XLPE cables, when the outer semicon is treated as measuring electrode. In this case, steadily increasing dielectric loss has been measured at higher frequencies. The resistivity of the semiconducting materials was measured, which confirmed that the increasing slope is due to the semiconducting layers. After using conductive tapes to wrap the cable samples, monotonically decreasing losses were measured, corresponding to the actual dielectric frequency response of the XLPE cables. It is concluded that the axial resistance of semiconducting shields have a substantial influence on the dielectric loss of XLPE cables, especially for dielectric response in high frequency range. A device on measuring the loss of such cables is presented
Recommended from our members
The measurement of very low conductivity and dielectric loss in XLPE cables: A possible method to detect degradation due to thermal aging
The dielectric response of crosslinked polyethylene (XLPE) insulated, miniature power cables, extruded with inner and outer semicons, was measured over the frequency range 10-4 to 104 Hz at temperatures from 20 to 100 °C. A dielectric spectrometer was used for the frequency range 10-4 to 10-2 Hz. A bespoke noise-free power supply was constructed and used to measure the dc conductivity and, using a Fourier transform technique, it was also used to measure the very low dielectric tanδ losses encountered at frequencies of 1 to 100 Hz. Tanδ measurements of <;10-5 were found in this frequency range and attributed to a β-mode dielectric relaxation lying above 100 Hz due to motion of chain segments in the amorphous region and an β-mode relaxation lying below 1 Hz window due to twists of chains in the crystal lamellae. The dc conductivity measurements were consistent with those of the dielectric spectrometer and indicate lower dc conductivities in vacuum degassed cables than have been previously reported for XLPE (less than 10-17 S.m-1). The conduction process is thermally activated with an activation energy of approximately 1.1 eV. Higher conductivities were found for non-degassed cables. A transformer ratio bridge was used for measurements in the range 1 to 10 kHz; loss in this region was shown to be due to the series resistance of the semicon layers. Thermal ageing of the cables at 135 °C for 60 days caused significant increases in the conductivity and tanδ and it is considered that such measurements may be a sensitive way of measuring electrical degradation due to thermal aging
Recommended from our members
Dielectric spectroscopy study of thermally-aged extruded model power cables
âModelâ extruded power cables, having a much reduced geometry but using the same extrusion techniques and materials as full-sized cables, have been examined using dielectric spectroscopy techniques to study their thermal ageing effects. Cables insulated with homo-polymer XLPE and co-polymer of XLPE with micron-sized ethylene-butyl-acrylate (EBA) islands were studied by both frequency-domain and time-domain dielectric spectroscopy techniques after accelerated thermal ageing under 135°C for 60 days. In the frequency domain, a frequency response analyzer (FRA) was used to measure the frequency range from 10-4Hz to 1Hz at temperatures from 20°C to 80°C. In the time domain, a special charging/discharging current measurement system was developed to measure the frequencies from 10-1Hz to 102Hz. These techniques were chosen to cope with the extremely low dielectric losses of the model cables. The results are compared with those from new model power cables that were degassed at 80°C for 5 days. Thermal ageing was found to increase the low-frequency conductivity, permittivity and the discharging current. Both homo- and co-polymer cables have substantial increase of dielectric loss after ageing
Recommended from our members
Space charge behaviour in epoxy laminates under high constant electric field
The development of space charge in insulating materials is one of the main causes of their electrical ageing. The pulsed electro-acoustic method is often used to determine space charge distribution, but the signal analysis in the case of laminate structures is much more complex to analyse. In this paper the authors describe and use a simulated signal in order to study laminates made of epoxy resin and fibre mat. The relatively large conductivity of the fibres compared with that of the resin seems to produce a rapid charge dissociation and recombination in the fibres. Under voltage the presence of fibres close to an electrode seems to promote charge injection
Comparative genomics of isolates of a pseudomonas aeruginosa epidemic strain associated with chronic lung infections of cystic fibrosis patients
Pseudomonas aeruginosa is the main cause of fatal chronic lung infections among individuals suffering from cystic fibrosis (CF). During the past 15 years, particularly aggressive strains transmitted among CF patients have been identified, initially in Europe and more recently in Canada. The aim of this study was to generate high-quality genome sequences for 7 isolates of the Liverpool epidemic strain (LES) from the United Kingdom and Canada representing different virulence characteristics in order to: (1) associate comparative genomics results with virulence factor variability and (2) identify genomic and/or phenotypic divergence between the two geographical locations. We performed phenotypic characterization of pyoverdine, pyocyanin, motility, biofilm formation, and proteolytic activity. We also assessed the degree of virulence using the Dictyostelium discoideum amoeba model. Comparative genomics analysis revealed at least one large deletion (40-50 kb) in 6 out of the 7 isolates compared to the reference genome of LESB58. These deletions correspond to prophages, which are known to increase the competitiveness of LESB58 in chronic lung infection. We also identified 308 non-synonymous polymorphisms, of which 28 were associated with virulence determinants and 52 with regulatory proteins. At the phenotypic level, isolates showed extensive variability in production of pyocyanin, pyoverdine, proteases and biofilm as well as in swimming motility, while being predominantly avirulent in the amoeba model. Isolates from the two continents were phylogenetically and phenotypically undistinguishable. Most regulatory mutations were isolate-specific and 29% of them were predicted to have high functional impact. Therefore, polymorphism in regulatory genes is likely to be an important basis for phenotypic diversity among LES isolates, which in turn might contribute to this strain's adaptability to varying conditions in the CF lung
Coaxial multi-mode cavities for fundamental SRF research in an unprecedented parameter space
Recent developments in superconducting radio-frequency (SRF) research have
focused primarily on high frequency elliptical cavities for electron
accelerators. Advances have been made in both reducing RF surface resistance
and pushing the readily achievable accelerating gradient by using novel SRF
cavity treatments including surface processing, custom heat treatments, and
flux expulsion. Despite the global demand for SRF based hadron accelerators,
the advancement of TEM mode cavities has lagged behind. To address this, two
purpose-built research cavities, one quarter-wave and one half-wave resonator,
have been designed and built to allow characterization of TEM-mode cavities
with standard and novel surface treatments. The cavities are intended as the
TEM mode equivalent to the 1.3GHz single cell cavity, which is the essential
tool for high frequency cavity research. Given their coaxial structure, the
cavities allow testing at the fundamental mode and higher harmonics, giving
unique insight into the role of RF frequency on fundamental loss mechanisms
from intrinsic and extrinsic sources. In this paper, the cavities and testing
infrastructure are described and the first performance measurements of both
cavities are presented
Recommended from our members
Internal charge behaviour of nanocomposites
The incorporation of 23 nm titanium dioxide nanoparticles into an epoxy matrix to form a nanocomposite structure is described. It is shown that the use of nanometric particles results in a substantial change in the behaviour of the composite, which can be traced to the mitigation of internal charge when a comparison is made with conventional TiO2 fillers. A variety of diagnostic techniques (including dielectric spectroscopy, electroluminescence, thermally stimulated current, photoluminescence) have been used to augment pulsed electro-acoustic space charge measurement to provide a basis for understanding the underlying physics of the phenomenon. It would appear that, when the size of the inclusions becomes small enough, they act co-operatively with the host structure and cease to exhibit interfacial properties leading to Maxwell-Wagner polarization. It is postulated that the particles are surrounded by high charge concentrations in the Gouy-Chapman-Stern layer. Since nanoparticles have very high specific areas, these regions allow limited charge percolation through nano-filled dielectrics. The practical consequences of this have also been explored in terms of the electric strength exhibited. It would appear that there was a window in which real advantages accrue from the nano-formulated material. An optimum loading of about 10% (by weight) is indicated
Quality Legume-Based Forage Systems for Contrasting Environments: COST Action 852
Agricultural systems that reduce environmental degradation, sustain agricultural productivity and economic viability, maintain stable rural communities, enhance the quality of life and respond to increasing demand for livestock products are promoted in developed countries. Though major challenges exist, forage legumes, adapted to a wide range of soil types, climatic conditions and management systems, will become increasingly important components of sustainable agricultural production systems in Europe. Temporal and spatial variation in legume performance often occurs. Compared to pure grass systems, legume-based systems may lead to increased N losses. To what extent ruminants can use the protein from forage legumes, and whether there are differences among species and cultivars are unknown. To improve reliability and the range of forage legumes, we must understand the constraints of environment, the reasons for divergence between species potential and actual performance and the most efficient way to use the herbage. The COST Action 852 - Quality legume-based forage systems for contrasting environments was set up to help resolve some of these questions
Counting Roman chickens: multidisciplinary approaches to human-chicken interactions in Roman Britain.
This paper discusses some of the approaches and results from two multi-disciplinary projects. The first is the AHRC-funded âCultural and Scientific Perceptions of Human-Chicken Interactionsâ Project. This is investigating the history of the exploitation of chickens in Europe. The second is the Leverhulme Trust-funded âRural Settlement of Roman Britainâ Project, which has collated evidence from excavation reports from thousands of sites. This paper updates the evidence for the exploitation of chickens in Roman Britain, showing that there were significant variations in the abundance of chicken bones found on different types of settlement. There was also a modest increase in their abundance during the Roman period suggesting chickens became slightly more frequent contributors to the diet, albeit still only a rare commodity. However, they continued to be frequently represented in graves, shrines and other ritual deposits. The paper also discusses evidence of egg production and avian osteopetrosis, demonstrating that when traditional zooarchaeological research is integrated with scientific analyses, a deeper understanding of past human diet can be acquired
Exploiting lung adaptation and phage steering to clear pan-resistant Pseudomonas aeruginosa infections in vivo
Pseudomonas aeruginosa is a major nosocomial pathogen that causes severe disease including sepsis. Carbapenem-resistant P. aeruginosa is recognised by the World Health Organisation as a priority 1 pathogen, with urgent need for new therapeutics. As such, there is renewed interest in using bacteriophages as a therapeutic. However, the dynamics of treating pan-resistant P. aeruginosa with phage in vivo are poorly understood. Using a pan-resistant P. aeruginosa in vivo infection model, phage therapy displays strong therapeutic potential, clearing infection from the blood, kidneys, and spleen. Remaining bacteria in the lungs and liver displays phage resistance due to limiting phage adsorption. Yet, resistance to phage results in re-sensitisation to a wide range of antibiotics. In this work, we use phage steering in vivo, pre-exposing a pan resistant P. aeruginosa infection with a phage cocktail to re-sensitise bacteria to antibiotics, clearing the infection from all organs
- âŚ