92 research outputs found
Observation of microwave radiation using low-cost detectors at the anka storage ring
Synchrotron light sources emit Coherent Synchrotron Radiation (CSR) for wavelengths longer than or equal to the bunch length. At most storage rings CSR cannot be observed, because the vacuum chamber cuts off radiation with long wavelengths. There are different approaches for shifting the CSR to shorter wavelengths that can propagate through the beam pipe, e.g.: the accelerator optics can be optimized for a low momentum compaction factor, thus reducing the bunch length. Alternatively, laser slicing can modulate substructures on long bunches [1]. Both techniques extend the CSR spectrum to shorter wavelengths, so that CSR is emitted at wavelengths below the waveguide shielding cut off. Usually fast detectors, like superconducting bolometer detector systems or Schottky barrier diodes, are used for observation of dynamic processes in accelerator physics. In this paper, we present observations of microwave radiation at ANKA using an alternative detector, a LNB (Low Noise Block) system. These devices are usually used in standard TV-SAT-receivers and are very cheap. We determined the time response of LNBs to be below 100 ns. The sensitivity of LNBs is optimized to detect very low intensity ânoise-likeâ signals. This microwave radiation study shows the possibility to apply the LNB for bunch length monitoring
CdSe-single-nanoparticle based active tips for near-field optical microscopy
We present a method to realize active optical tips for use in near-field
optics that can operate at room temperature. A metal-coated optical tip is
covered with a thin polymer layer stained with CdSe nanocrystals or nanorods at
low density. The time analysis of the emission rate and emission spectra of the
active tips reveal that a very small number of particles - possibly down to
only one - can be made active at the tip apex. This opens the way to near-field
optics with a single inorganic nanoparticle as a light source
CuInSe2 thin films produced by rf sputtering in Ar/H2 atmospheres
Structural, compositional, optical, and electrical properties of CuInSe2thin filmsgrown by rf reactive sputtering from a Se excess target in Ar/H2 atmospheres are presented. The addition of H2 to the sputtering atmospheres allows the control of stoichiometry of films giving rise to remarkable changes in the film properties. Variation of substrate temperature causes changes in film composition because of the variation of hydrogen reactivity at the substrate. Measurements of resistivity at variable temperatures indicate a hopping conduction mechanism through gap states for films grown at low temperature (100â250â°C), the existence of three acceptor levels at about 0.046, 0.098, and 0.144 eV above valence band for films grown at intermediate temperature (250â350â°C), and a pseudometallic behavior for film grown at high temperatures (350â450â°C). Chalcopyrite polycrystalline thin films of CuInSe2 with an average grain size of 1 ÎŒm, an optical gap of 1.01 eV, and resistivities from 10â 1 to 103 Ωâcm can be obtained by adding 1.5% of H2 to the sputtering atmosphere and by varying the substrate temperature from 300 to 400â°C
Dark-field digital holographic microscopy for 3D-tracking of gold nanoparticles
We present a new technique that combines off-axis Digital Holography and Dark
Field Microscopy to track 100nm gold particles diffusing in water. We show that
a single hologram is sufficient to localize several particles in a thick sample
with a localization accuracy independent of the particle position. From our
measurements we reconstruct the trajectories of the particles and derive their
3D diffusion coefficient. Our results pave the way for quantitative studies of
the motion of single nanoparticle in complex media
In situ biospectroscopic investigation of rapid ischemic and postmortem induced biochemical alterations in the rat brain
© 2014 American Chemical Society. Rapid advances in imaging technologies have pushed novel spectroscopic modalities such as Fourier transform infrared spectroscopy (FTIR) and X-ray absorption spectroscopy (XAS) at the sulfur K-edge to the forefront of direct in situ investigation of brain biochemistry. However, few studies have examined the extent to which sample preparation artifacts confound results. Previous investigations using traditional analyses, such as tissue dissection, homogenization, and biochemical assay, conducted extensive research to identify biochemical alterations that occur ex vivo during sample preparation. In particular, altered metabolism and oxidative stress may be caused by animal death. These processes were a concern for studies using biochemical assays, and protocols were developed to minimize their occurrence. In this investigation, a similar approach was taken to identify the biochemical alterations that are detectable by two in situ spectroscopic methods (FTIR, XAS) that occur as a consequence of ischemic conditions created during humane animal killing. FTIR and XAS are well suited to study markers of altered metabolism such as lactate and creatine (FTIR) and markers of oxidative stress such as aggregated proteins (FTIR) and altered thiol redox (XAS). The results are in accordance with previous investigations using biochemical assays and demonstrate that the time between animal death and tissue dissection results in ischemic conditions that alter brain metabolism and initiate oxidative stress. Therefore, future in situ biospectroscopic investigations utilizing FTIR and XAS must take into consideration that brain tissue dissected from a healthy animal does not truly reflect the in vivo condition, but rather reflects a state of mild ischemia. If studies require the levels of metabolites (lactate, creatine) and markers of oxidative stress (thiol redox) to be preserved as close as possible to the in vivo condition, then rapid freezing of brain tissue via decapitation into liquid nitrogen, followed by chiseling the brain out at dry ice temperatures is required
CdSe single-nanocrystal-based active optical tips for near-field optics: Towards a nanosource of light
International audienc
- âŠ