A state-of-the-art review and feasibility analysis of high altitude wind power in Northern Ireland

AbstractIn many countries wind energy has become an indispensable part of the electricity generation mix. The opportunity for ground based wind turbine systems are becoming more and more constrained due to limitations on turbine hub heights, blade lengths and location restrictions linked to environmental and permitting issues including special areas of conservation and social acceptance due to the visual and noise impacts. In the last decade there have been numerous proposals to harness high altitude winds, such as tethered kites, airfoils and dirigible based rotors. These technologies are designed to operate above the neutral atmospheric boundary layer of 1300m, which are subject to more powerful and persistent winds thus generating much higher electricity capacities. This paper presents an in-depth review of the state-of-the-art of high altitude wind power, evaluates the technical and economic viability of deploying high altitude wind power as a resource in Northern Ireland and identifies the optimal locations through considering wind data and geographical constraints. The key findings show that the total viable area over Northern Ireland for high altitude wind harnessing devices is 5109.6km2, with an average wind power density of 1998W/m2 over a 20-year span, at a fixed altitude of 3000m. An initial budget for a 2MW pumping kite device indicated a total cost £1,751,402 thus proving to be economically viable with other conventional wind-harnessing devices

Analyzing the impact of demand response and reserves in islands energy planning

Small Islands usually rely on fossil fuels for their energy supply and face common challenges such as high energy costs and carbon dioxide emissions. For these reasons they represent interesting cases for analysing the transition towards a clean and secure energy system. Nevertheless, integrating non-dispatchable Renewable Energy Sources in the power grid causes stability issues and this is particularly true for island grids. Such issue is not fully considered in long-term energy planning; indeed, an important factor that should be considered in order to ensure the reliability of the grid are Reserves. There are different types of Reserves depending on the reactiveness/response time and the duration of the service. In this paper, primary and secondary reserves have been analysed in order to plan the long-term energy transition of the small island of Favignana, Italy by means of the new version of H2RES, a Linear Programming single-objective optimisation model able to provide a long-term capacity investment and dispatching optimisation. It has been found that biomass generators are favoured to both photovoltaic and wind turbines for their ability to provide reserves and also decrease the unpredictability of the supply. Batteries and Electrolysers are also used mostly for reserve provision

Climate change mitigation by means of sustainable development of energy, water and environment systems

Integrated approaches in energy, water and environmental systems can improve the climate change reduction process. New scientific developments and advancements have provided numerous opportunities in the comprehensive human progress direction. In this regard, we have reviewed the 16th Conference on Sustainable Development of Energy, Water and Environment Systems presented in this editorial. Examining recent scientific developments, eight research articles on this special issue are related to eight main topics. The solar energy technology and storage section reviewed the first four articles. These articles include topics such as: 1) advanced technologies to form a new TT PS-TIM window system for adaptive daylight control and advanced thermal insulation combination, 2) using experimental data for field testing located in an area with Mediterranean climate conditions, of newly installed FPVS in these areas, 3) possibilities described in short rotation of willow type and energy crop Miscanthus cultivation dedicated to former coal mining areas, 4) using solar and geothermal energy with boiling water purification and reverse osmosis. Furthermore, the following four articles are reviewed in the energy management systems section. These articles include topics such as, 5) deep analysis of facial expression and eye tracking using samples of non-expert participants to determine emotions caused by electricity consumption graphs in different time scales, 6) studying the electric vehicles (EVs) main life cycle activities using an exploratory survey and their potential inequities, 7) the biodiesel fuel production from waste sardine fish oil using methanol, ethanol or isopropanol and a solid heterogeneous catalyst prepared using eggshell and copper oxide [CaCu(OCH3)2] is analyzed. Finally, 8) biotechnology microalgae have been studied in 70-litre vertical photobioreactors that use unsupplemented secondary brewery wastewater as growth media using two collecting cells mechanically methods under hydrothermal (autohydrolysis) and dilute acid hydrolysis

Fast photon detection for the COMPASS RICH detector

The COMPASS experiment at the SPS accelerator at CERN uses a large scale Ring Imaging CHerenkov detector (RICH) to identify pions, kaons and protons in a wide momentum range. For the data taking in 2006, the COMPASS RICH has been upgraded in the central photon detection area (25% of the surface) with a new technology to detect Cherenkov photons at very high count rates of several 10^6 per second and channel and a new dead-time free read-out system, which allows trigger rates up to 100 kHz. The Cherenkov photons are detected by an array of 576 visible and ultra-violet sensitive multi-anode photomultipliers with 16 channels each. The upgraded detector showed an excellent performance during the 2006 data taking.Comment: Proceeding of the IPRD06 conference (Siena, Okt. 06

Fast Photon Detection for Particle Identification with COMPASS RICH-1

Particle identification at high rates is an important challenge for many current and future high-energy physics experiments. The upgrade of the COMPASS RICH-1 detector requires a new technique for Cherenkov photon detection at count rates of several $10^6$ per channel in the central detector region, and a read-out system allowing for trigger rates of up to 100 kHz. To cope with these requirements, the photon detectors in the central region have been replaced with the detection system described in this paper. In the peripheral regions, the existing multi-wire proportional chambers with CsI photocathode are now read out via a new system employing APV pre-amplifiers and flash ADC chips. The new detection system consists of multi-anode photomultiplier tubes (MAPMT) and fast read-out electronics based on the MAD4 discriminator and the F1-TDC chip. The RICH-1 is in operation in its upgraded version for the 2006 CERN SPS run. We present the photon detection design, constructive aspects and the first Cherenkov light in the detector.Comment: Proceedings of the Imaging 2006 conference, Stockholm, Sweden, 27-30 June 2006, 5 pages, 6 figures, to appear in NIM A; corrected typo in caption of Fig.

The Fast Read-out System for the MAPMTs of COMPASS RICH-1

A fast readout system for the upgrade of the COMPASS RICH detector has been developed and successfully used for data taking in 2006 and 2007. The new readout system for the multi-anode PMTs in the central part of the photon detector of the RICH is based on the high-sensitivity MAD4 preamplifier-discriminator and the dead-time free F1-TDC chip characterized by high-resolution. The readout electronics has been designed taking into account the high photon flux in the central part of the detector and the requirement to run at high trigger rates of up to 100 kHz with negligible dead-time. The system is designed as a very compact setup and is mounted directly behind the multi-anode photomultipliers. The data are digitized on the frontend boards and transferred via optical links to the readout system. The read-out electronics system is described in detail together with its measured performances.Comment: Proceeding of RICH2007 Conference, Trieste, Oct. 2007. v2: minor change

First Measurement of the Transverse Spin Asymmetries of the Deuteron in Semi-Inclusive Deep Inelastic Scattering

First measurements of the Collins and Sivers asymmetries of charged hadrons produced in deep-inelastic scattering of muons on a transversely polarized 6-LiD target are presented. The data were taken in 2002 with the COMPASS spectrometer using the muon beam of the CERN SPS at 160 GeV/c. The Collins asymmetry turns out to be compatible with zero, as does the measured Sivers asymmetry within the present statistical errors.Comment: 6 pages, 2 figure

Longitudinal double spin asymmetries in single hadron quasi-real photoproduction at high pTp_T

We measured the longitudinal double spin asymmetries $A_{LL}$ for single hadron muo-production off protons and deuterons at photon virtuality $Q^2$ < 1(GeV/$\it c$)$^2$ for transverse hadron momenta $p_T$ in the range 0.7 GeV/$\it c$ to 4 GeV/$\it c$ . They were determined using COMPASS data taken with a polarised muon beam of 160 GeV/$\it c$ or 200 GeV/$\it c$ impinging on polarised $\mathrm{{}^6LiD}$ or $\mathrm{NH_3}$ targets. The experimental asymmetries are compared to next-to-leading order pQCD calculations, and are sensitive to the gluon polarisation $\Delta G$ inside the nucleon in the range of the nucleon momentum fraction carried by gluons $0.05 < x_g < 0.2$

Interplay among transversity induced asymmetries in hadron leptoproduction

In the fragmentation of a transversely polarized quark several left-right asymmetries are possible for the hadrons in the jet. When only one unpolarized hadron is selected, it exhibits an azimuthal modulation known as Collins effect. When a pair of oppositely charged hadrons is observed, three asymmetries can be considered, a di-hadron asymmetry and two single hadron asymmetries. In lepton deep inelastic scattering on transversely polarized nucleons all these asymmetries are coupled with the transversity distribution. From the high statistics COMPASS data on oppositely charged hadron-pair production we have investigated for the first time the dependence of these three asymmetries on the difference of the azimuthal angles of the two hadrons. The similarity of transversity induced single and di-hadron asymmetries is discussed. A new analysis of the data allows to establish quantitative relationships among them, providing for the first time strong experimental indication that the underlying fragmentation mechanisms are all driven by a common physical process.Comment: 6 figure

Interplay among transversity induced asymmetries in hadron leptoproduction

In the fragmentation of a transversely polarized quark several left-right asymmetries are possible for the hadrons in the jet. When only one unpolarized hadron is selected, it exhibits an azimuthal modulation known as Collins effect. When a pair of oppositely charged hadrons is observed, three asymmetries can be considered, a di-hadron asymmetry and two single hadron asymmetries. In lepton deep inelastic scattering on transversely polarized nucleons all these asymmetries are coupled with the transversity distribution. From the high statistics COMPASS data on oppositely charged hadron-pair production we have investigated for the first time the dependence of these three asymmetries on the difference of the azimuthal angles of the two hadrons. The similarity of transversity induced single and di-hadron asymmetries is discussed. A new analysis of the data allows to establish quantitative relationships among them, providing for the first time strong experimental indication that the underlying fragmentation mechanisms are all driven by a common physical process.Comment: 6 figure