Performance evaluation of a pulsatile ventricular assist device under non physiologic pumping frequencies by means FEM and 2D approach

A ventricular assist device (VAD) is a blood pump that works in parallel with heart. It is used as a mechanical assistance for patients that suffer cardiac insufficiency: as a therapy, as a bridge to transplant or to extend life. The blood flow simulation into VAD is of great interest for the design and evaluation, mainly before building the prototypes. In previous works, by means of blood flow simulation, was evaluated a new concept of implantable VAD consisting on a pump with a double effect piston, driven without contact and four active valves. In this work, the flow into VAD is analyzed for four frequencies values: 1.05, 2.10, 3.15 and 4.20 Hz. The former is the physiologic frequency, the second allows the basal flow rate (5 l/min), while the others are higher in order to assure an increase in flow rates. The analysis is carried out comparing variables as velocity and pressure distribution into VAD and evaluating blood damage due to acting shear stress over cells. The blood flow simulation is performed on a 2D simplified geometry using COMSOL Multiphysics software to resolve NavierStokes and continuity equations, assuming blood as a Newtonian incompressible fluid. The blood damage is evaluated by means of platelet activation state index and a cumulative damage model. The global variables as flow rate, force and power to impel fluid, are shown in agreement with theoretical predictions. The risk of blood damage raises for higher frequencies, however, the predictions shown that the VAD analyzed is comparable and best to other VAD and mechanical heart valves

A Low-Cost FPGA-Based Test and Diagnosis Architecture for SRAMs

The continues improvement of manufacturing technologies allows the realization of integrated circuits containing an ever increasing number of transistors. A major part of these devices is devoted to realize SRAM blocks. Test and diagnosis of SRAM circuits are therefore an important challenge for improving quality of next generation integrated circuits. This paper proposes a flexible platform for testing and diagnosis of SRAM circuits. The architecture is based on the use of a low cost FPGA based board allowing high diagnosability while keeping costs at a very low leve

Progress in THz Rectifier Technology: Research and Perspectives

Schottky diode (SD) has seen great improvements in the past few decades and, for many THz applications, it is the most useful device. However, the use and recycling of forms of energy such as solar energy and the infrared thermal radiation that the Earth continuously emits represent one of the most relevant and critical issues for this diode, which is unable to rectify signals above 5 THz. The goal is to develop highly efficient diodes capable of converting radiation from IR spectra to visible ones in direct current (DC). A set of performance criteria is investigated to select some of the most prominent materials required for developing innovative types of electrodes, but also a wide variety of insulator layers is required for the rectification process, which can affect the performance of the device. The current rectifying devices are here reviewed according to the defined performance criteria. The main aim of this review is to provide a wide overview of recent research progress, specific issues, performance, and future directions in THz rectifier technology based on quantum mechanical tunneling and asymmetric structure

Defective Behaviour of an 8T SRAM Cell with Open Defects

The defective behaviour of an 8T SRAM cell with open defects is analyzed. Full and resistive open defects have been considered in the electrical characterization of the defective cell. Due to the similarity between the classical 6T SRAM cell and the 8T cell, only defects affecting the read port transistors have been considered. In the work, it is shown how an open in a defective cell may influence the correct operation of a victim cell sharing the same read circuitry. Also, it is shown that the sequence of bits written on the defective cell prior to a read action can mask the presence of the defect. Different orders of critical resistance have been found depending on the location of the open defect. A 45nm technology has been used for the illustrative example presented in the wor

System Reliability Evaluation Using Concurrent Multi-Level Simulation of Structural Faults

This paper provides a methodology that leverages state-of-the-art techniques for efficient fault simulation of structural faults together with transaction level modeling. This way it is possible to accurately evaluate the impact of the faults on the entire hardware/software syste

Cap rock efficiency of geothermal systems in fold-and-thrust belts: Evidence from paleo-thermal and structural analyses in Rosario de La Frontera geothermal area (NW Argentina)

Cap rock characterization of geothermal systems is often neglected despite fracturing may reduce its efficiency and favours fluid migration. We investigated the siliciclastic cap rock of Rosario de La Frontera geothermal system (NW Argentina) in order to assess its quality as a function of fracture patterns and related thermal alteration. Paleothermal investigations (XRD on fine-grained fraction of sediments, organic matter optical analysis and fluid inclusions on veins) and 1D thermal modelling allowed us to distinguish the thermal fingerprint associated to sedimentary burial from that related to fluid migration. The geothermal system is hosted in a Neogene N-S anticline dissected by high angle NNW- and ENE-striking faults. Its cap rock can be grouped into two quality categories: • rocks acting as good insulators, deformed by NNW–SSE and E–W shear fractures, NNE-SSW gypsum- and N-S-striking calcite-filled veins that developed during the initial stage of anticline growth. Maximum paleo-temperatures (< 60 °C) were experienced during deposition to folding phases.• rocks acting as bad insulators, deformed by NNW-SSE fault planes and NNW- and WNW-striking sets of fractures associated to late transpressive kinematics. Maximum paleo-temperatures higher than about 115 °C are linked to fluid migration from the reservoir to surface (with a reservoir top at maximum depths of 2.5 km) along fault damage zones.This multi-method approach turned out to be particularly useful to trace the main pathways of hot fluids and can be applied in blind geothermal systems where either subsurface data are scarce or surface thermal anomalies are lacking.Fil: Maffucci, R.. Universita Degli Studi Della Tuscia; Italia. Universita Degli Studi Roma Tre; ItaliaFil: Corrado, Sveva. Universita Degli Studi Roma Tre; ItaliaFil: Aldega, L.. Instituto de Investigaciones Universitarias Roma la Sapienza; ItaliaFil: Bigi, S.. Instituto de Investigaciones Universitarias Roma la Sapienza; ItaliaFil: Chiodi, Agostina Laura. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Salta. Instituto de Investigaciones en Energía no Convencional. Universidad Nacional de Salta. Facultad de Ciencias Exactas. Departamento de Física. Instituto de Investigaciones en Energía no Convencional; ArgentinaFil: Di Paolo, L.. Eni E&P Division; ItaliaFil: Giordano, G.. Universita Degli Studi Roma Tre; ItaliaFil: Invernizzi, C.. Universita Degli Di Camerino; Itali

Efficient Simulation of Structural Faults for the Reliability Evaluation at System-Level

In recent technology nodes, reliability is considered a part of the standard design ¿ow at all levels of embedded system design. While techniques that use only low-level models at gate- and register transfer-level offer high accuracy, they are too inefficient to consider the overall application of the embedded system. Multi-level models with high abstraction are essential to efficiently evaluate the impact of physical defects on the system. This paper provides a methodology that leverages state-of-the-art techniques for efficient fault simulation of structural faults together with transaction-level modeling. This way it is possible to accurately evaluate the impact of the faults on the entire hardware/software system. A case study of a system consisting of hardware and software for image compression and data encryption is presented and the method is compared to a standard gate/RT mixed-level approac

Non-linear unbalanced Bessel beams: Stationary conical waves supported by nonlinear losses

Nonlinear losses accompanying Kerr self-focusing substantially impacts the dynamic balance of diffraction and nonlinearity, permitting the existence of localized and stationary solutions of the 2D+1 nonlinear Schrodinger equation which are stable against radial collapse. These are featured by linear conical tails that continually refill the nonlinear, central spot. An experiment shows that the discovered solution behaves as strong attractor for the self-focusing dynamics in Kerr media.Comment: 4 pages, 2 figures; experimental verification adde

"Do the right thing" for whom? An experiment on ingroup favouritism, group assorting and moral suasion

In this paper we investigate the effect of moral suasion on ingroup favouritism. We report a well-powered, pre-registered, two-stage 2x2 mixed-design experiment. In the first stage, groups are formed on the basis of how participants answer to a set of questions, concerning non-morally relevant issues in one treatment (assorting on non-moral preferences), and morally relevant issues in another treatment (assorting on moral preferences). In the second stage, participants choose how to split a given amount of money between participants of their own group and participants of the other group, first in the baseline setting and then in a setting where they are told to do what they believe to be morally right (moral suasion). Our main results are: (i) in the baseline, participants tend to favour their own group to a greater extent when groups are assorted according to moral preferences, compared to when they are assorted according to non-moral preferences; (ii) the net effect of moral suasion is to decrease ingroup favouritism, but there is also a non-negligible proportion of participants for whom moral suasion increases ingroup favouritism; (iii) the effect of moral suasion is substantially stable across group assorting and four pre-registered individual characteristics (gender, political orientation, religiosity, pro-life vs pro-choice ethical convictions)